Tree bark as a passive air sampler to indicate atmospheric polybrominated diphenyl ethers (PBDEs) in southeastern China

The different barks were sampled to discuss the influence of the tree species, trunk circumference, and bark thickness on the accumulation processes of polybrominated diphenyl ethers (PBDEs) from air into the bark. The results of different PBDE concentrations indicated that barks with a thickness of 0–3 mm collected from weeping willow, Camphor tree, and Masson pine, the trunk circumferences of which were 100 to 150 cm, were better PBDEs passive samplers. Furthermore, tree bark and the corresponding air samples were collected at Anji (AJ), Hangzhou (HZ), Shanghai (SH), and Wenling (WL) to investigate the relationship between the PBDE concentrations in bark and those in air. In addition, the significant correlation (r ²?=?0.906; P?<?0.05) indicated that atmospheric PBDEs were the principle source for the accumulation of PBDEs in the barks. In this study, the log K _BA (bark–air partition coefficient) of individual PBDE congeners at the four sites were in the range from 5.69 to 6.79. Finally, the total PBDE concentration in WL was 5 to 20 times higher than in the other three cities. The result indicated that crude household workshops contributed a heavy amount of PBDEs pollution to the environment, which had been verified by the spatial distribution of PBDEs levels in barks collected at Wenling (range, 26.53–1317.68 ng/g dw). The good correlation between the PBDE concentrations in the barks and the air samples and the variations of the PBDE concentrations in tree barks collected from different sites reflected that the bark could be used as a passive sampler to indicate the atmospheric PBDEs.     

微生物絮凝剂与聚合氯化铝复配处理涂料废水的响应面优化

采用响应面分析法对聚合氯化铝(PAC)与污泥生产的微生物絮凝剂复配处理涂料废水的过程进行了优化,设定的响应值为COD和色度去除率。实验分别拟合了关于COD去除率和色度去除率的二次模型,根据响应值的分布情况,确定涂料废水的最佳絮凝条件为微生物絮凝剂浓度47 mg/L,PAC浓度39 mg/L,pH为8.2,CaCl2浓度0.38 g/L,搅拌速度210 r/min。最佳絮凝条件下,微生物絮凝剂对涂料废水中COD和色度的去除率分别达到77.6%和68.9%。     

Fenton法处理垃圾渗滤液的参数优化及反应动力学模型

采用Fenton法处理垃圾渗滤液,研究反应时间、初始浓度、pH、Fenton试剂用量对垃圾渗滤液TOC去除率的影响。研究结果表明,最优反应条件是反应时间30 min,初始pH为3.0,初始[H2O2]0=7 310 mg/L,最佳[H2O2]/[Fe2+]摩尔比为5,反应温度为室温,此时渗滤液的TOC去除率达到70.3%。渗滤液矿化过程符合一级反应动力学,并建立了符合该渗滤液的反应动力学模型。     

Bioaccumulation and tissue distribution of organochlorine pesticides (OCPs) in freshwater fishes: a case study performed in Poyang Lake,China’s largest lake

Concentrations and tissue distribution of organochlorine pesticides (OCPs) in different tissues of freshwater fish, silver carp (Hypophthalmichthys molitrix) and bighead carp (Aristichthys nobilis), collected from Poyang Lake, China’s largest shallow lake, and were studied. OCPs were detected with the observed concentrations ranging from 280.67 to 1,006.58 ng/g wet weight (ww) for bighead carp and from 67.28 to 930.06 ng/g ww for silver carp. Composition analysis demonstrated OCPs in both fish were from the same polluted environment, and then, the species-specific bioaccumulation might be mainly due to the different fish age as well as the different feeding habits elucidating from the stable carbon (δ¹³C) and nitrogen (δ¹⁵N) isotope analysis. Tissue distribution indicated that dietary intake was the major exposure route of OCPs for both fish and higher accumulation potency of OCPs by the hepatobiliary-related tissues (such as liver, kidney, bile, and heart). The higher metabolic activities of these tissues elucidating from the higher values of δ¹⁵N might be the potential-determined factor responsible for the tissue-specific accumulation.     

Hexabromocyclododecanes in surface sediments and a sediment core from Rivers and Harbor in the northern Chinese city of Tianjin

In the present study, hexabromocyclododecanes (HBCDs) were investigated in the sediment from Haihe River (HR), Dagu Dainage Canal (DDC) and Tianjin Harbor (TH) at Bohai Bay using a total of 51 samples of surface sediments and a sediment core collected from May to September in 2010, and its diastereomer- and enantiomer-specific profiles were analyzed. The concentration of total HBCDs were generally high, with mean value and ranges of 31.0 and 1.35–634 ng g^?1 dw, respectively. The contamination followed the order of TH > DDC > HR. Higher levels (up to 634 ng g^?1 dw) occurred in the lower reach of HR and DDC located in an industrial area of Tianjin. This is the first time to report so high concentration of HBCDs in sediment in Southeast Asia. The γ-diastereomer dominated in most samples (44 out of 51), and this is in agreement with the diastereomer distribution pattern in industrial products, while α-HBCD was the dominant diastereomer in the other seven samples. However, only few samples exhibited γ-diastereomer ratio similar to that (75–89%) in technical products, indicating the inter-transformation and variable degradation of the different isomers. The high ratio of γ-diastereomer could be used as an indicator for fresh contamination input. Enantiomeric factors (EFs) of HBCD isomers in most of the samples were statistically different from technical products (p < 0.05), showing a trend of more easily enrichment of the (?)-HBCD-enantiomer compared to the (+)-HBCD-enantiomer. The δ- and ε-diastereomers were frequently detected but at low level. The HBCDs in the sediment core showed several peaks, and the greatest value occurred in 2005, when a plastic manufacture plant using HBCD was set up nearby.     

In vitro biotransformation of PBDEs by root crude enzyme extracts: Potential role of nitrate reductase (NaR) and glutathione S-transferase (GST) in their debromination

In order to investigate the enzyme transformation of PBDEs and to track the key enzymes involved in PBDE degradation in plants, in vivo exposure of plants of ryegrass, pumpkin and maize and in vitro exposure of their root crude enzyme extracts to PBDEs were conducted. Degradation of PBDEs in the root crude enzyme solutions fit well with the first order kinetics (R² = 0.52–0.97, P < 0.05), and higher PBDEs degraded faster than the lower ones. PBDEs could be transformed to lower brominated PBDEs and hydroxylated-PBDEs by the root crude enzyme extracts with debromination as the main pathway which contributed over 90% of PBDE depletion. In vitro and in vivo exposure to PBDEs produced similar responses in root enzyme activities of which the nitroreductase (NaR) and glutathione-transferase (GST) activities decreased significantly, while the peroxidase, catalase and cytochrome P-450 activities had no significant changes. Furthermore, higher enzyme concentrations of NaR and GST led to higher PBDE debromination rates, and the time-dependent activities of NaR and GST in the root crude enzyme extracts were similar to the trends of PBDE depletion. All these results suggest that NaR and GST were the key enzymes responsible for PBDE degradation. This conclusion was further confirmed by the in vitro debromination of PBDEs with the commercial pure NaR and GST.     

A comparison of statistical methods for deriving freshwater quality criteria for the protection of aquatic organisms

Species sensitivity distributions (SSDs) are increasingly used in both ecological risk assessment and derivation of water quality criteria. However, there has been debate about the choice of an appropriate approach for derivation of water quality criteria based on SSDs because the various methods can generate different values. The objective of this study was to compare the differences among various methods. Data sets of acute toxicities of 12 substances to aquatic organisms, representing a range of classes with different modes of action, were studied. Nine typical statistical approaches, including parametric and nonparametric methods, were used to construct SSDs for 12 chemicals. Water quality criteria, expressed as hazardous concentration for 5 % of species (HC₅), were derived by use of several approaches. All approaches produced comparable results, and the data generated by the different approaches were significantly correlated. Variability among estimates of HC₅ of all inclusive species decreased with increasing sample size, and variability was similar among the statistical methods applied. Of the statistical methods selected, the bootstrap method represented the best-fitting model for all chemicals, while log-triangle and Weibull were the best models among the parametric methods evaluated. The bootstrap method was the primary choice to derive water quality criteria when data points are sufficient (more than 20). If the available data are few, all other methods should be constructed, and that which best describes the distribution of the data was selected.     

Adsorption of multi-heavy metals Zn and Cu onto surficial sediments: modeling and adsorption capacity analysis

Improved multiple regression adsorption models (IMRAMs) was developed to estimate the adsorption capacity of the components [Fe oxides (Fe), Mn oxides (Mn), organic materials (OMs), residuals] in surficial sediments for multi-heavy metal Zn and Cu. IMRAM is an improved version over MRAM, which introduces a computer program in the model developing process. As MRAM, Zn(Cu) IMRAM, and Cu(Zn) IMRAM again confirmed that there is significant interaction effects that control the adsorption of compounded Zn and Cu, which was neglected by additional adsorption model. The verification experiment shows that the relative deviation of the IMRAMs is less than 13 %. It is revealed by the IMRAMs that Mn, which has the greatest adsorption capability for compounded Zn and Cu (54.889 and 161.180 mg/l, respectively), follows by interference adsorption capacity of Fe/Mn (?1.072 and ?24.591 mg/l respectively). Zn and Cu influence each other through different mechanisms. When Zn is the adsorbate, compounded Cu mainly affects the adsorption capacities of Fe/Mn and Fe/Mn/OMs; while when Cu is the adsorbate, compounded Zn mainly exerts its effect on Mn, Fe/Mn, and Mn/OMs. It also shows that the compounded Zn or Cu weakened the interference adsorption of Fe/Mn, and meanwhile, strengthened the interference adsorption of Mn/OMs.     

Physicochemical and biological quality of soil in hexavalent chromium-contaminated soils as affected by chemical and microbial remediation

Chemical and microbial methods are the main remediation technologies for chromium-contaminated soil. These technologies have progressed rapidly in recent years; however, there is still a lack of methods for evaluating the chemical and biological quality of soil after different remediation technologies have been applied. In this paper, microbial remediation with indigenous bacteria and chemical remediation with ferrous sulphate were used for the remediation of soils contaminated with Cr(VI) at two levels (80 and 1,276 mg kg^?1) through a column leaching experiment. After microbial remediation with indigenous bacteria, the average concentration of water-soluble Cr(VI) in the soils was reduced to less than 5.0 mg kg^?1. Soil quality was evaluated based on 11 soil properties and the fuzzy comprehensive assessment method, including fuzzy mathematics and correlative analysis. The chemical fertility quality index was improved by one grade using microbial remediation with indigenous bacteria, and the biological fertility quality index increased by at least a factor of 6. Chemical remediation with ferrous sulphate, however, resulted in lower levels of available phosphorus, dehydrogenase, catalase and polyphenol oxidase. The result showed that microbial remediation with indigenous bacteria was more effective for remedying Cr(VI)-contaminated soils with high pH value than chemical remediation with ferrous sulphate. In addition, the fuzzy comprehensive evaluation method was proven to be a useful tool for monitoring the quality change in chromium-contaminated soils.     

Comparative quantification of oxygen release by wetland plants: electrode technique and oxygen consumption model

Understanding oxygen release by plants is important to the design of constructed wetlands for wastewater treatment. Lab-scale systems planted with Phragmites australis were studied to evaluate the amount of oxygen release by plants using electrode techniques and oxygen consumption model. Oxygen release rate (0.14 g O₂/m²/day) measured using electrode techniques was much lower than that (3.94–25.20 gO₂/m²/day) calculated using the oxygen consumption model. The results revealed that oxygen release by plants was significantly influenced by the oxygen demand for the degradation of pollutants, and the oxygen release rate increased with the rising of the concentration of degradable materials in the solution. The summary of the methods in qualifying oxygen release by wetland plants demonstrated that variations existed among different measuring methods and even in the same measuring approach. The results would be helpful for understanding the contribution of plants in constructed wetlands toward actual wastewater treatment.