Laboratory-polluted soils: a methodological approach to establish equilibrium conditions for different metal chemical forms in soils

An approach based on the number of extractions performed over time was applied to study the time necessary to attain equilibrium conditions between the different chemical forms present in two natural soils laboratory-loaded with heavy metals (Cu(II), Pb(II), Zn(II)). The influence of some soil parameters, such as pH value, cation exchange capacity and organic matter content, on the equilibrium time was evidenced both by the different nature of the soils and by the treatment of soils with paper mill sludge. Equilibrium conditions were determined by studying the metal partitioning in the soil on a case by case basis. The behaviour of the three metals was not the same, and the conditions of equilibrium among the different chemical forms were the result of the amount of heavy metals added as well as of the nature of the soil.     

Impact of automobile emissions on the levels of platinum and lead in Accra,Ghana

Examination of car fleet records in Accra demonstrates an increasing proportion of catalytic converter-equipped cars in the relatively old car fleet (average age 13 years) due to their import from developed countries. However, only leaded petrol is sold in Ghana. Lead anti-knocking additives, which are known to affect catalyst activity and promote thermal sintering and mechanical abrasion, may increase Pt emissions. This possible synergism prompted the concomitant determination of Pb and Pt levels in road dust and roadside soils in Ghana. Both metals followed traffic density with higher concentrations in urban areas compared to remote sites. In urban areas, the range for Pb (365 +/- 93 microg g(-1) for dust and 291 +/- 76 microg g(-1) for soil) reflects precatalyst levels in Europe and the US, while the range for Pt (39 +/- 24 ng g(-1) for dust and 15 +/- 5.3 ng g(-1) for soil) is typical for the same countries. The elevated Pt concentrations were unexpected due to recent introduction of catalysts to Ghana compared to the prolonged use of catalysts in Europe and the US.     

Suspended particulates and bioaerosols emitted from an agricultural non-point source

Suspended particulate and bioaerosol levels were measured at three sites downwind of an agricultural non-point source during the wheat harvesting season. Suspended particulates were detected at mean values ranging from 10000 to 2420 micrograms m-3 at distances of from 20 to 60 m downwind of the source, respectively. Airborne viable bacterial counts were recorded at mean values ranging between 10(4) and 10(6) colony forming units (cfu) m-3, whereas, Gram negative (Gram -ve) bacteria varied between 10(3) and 10(5) cfu m-3. Fungi levels were detected at mean values varying between 10(5) and 10(6) cfu m-3. However, streptomycetes were found at lower counts than those recorded for viable bacteria and fungi. Total viable bacteria, Gram -ve bacteria, fungi and streptomycetes associated hay fragments were determined at mean values of 1.5 x 10(6), 1.6 x 10(3), 2.2 x 10(4) and 6 x 10(3) cfu g-1 of hay, respectively. Cladosporium, white and red yeasts as well as Alternaria were the predominant airborne fungi, whereas, Alternaria was the dominant species associated with hay fragments. Pseudomonas, Acinetobacter and Enterobacteriaceae were the dominant Gram -ve bacteria. The most common fungal genera, such as Cladosporium and Fusarium (minor short axis), as well as Streptomyces species have an aerodynamic diameter (dae) of less than 5 microns, which can penetrate and deposit in the alveoli. Farmers and nearby residents are exposed to high levels of organic dust and bioaerosols during the wheat harvesting season. This may cause health problems in exposed persons based on toxic or allergic reactions.     

Arsenic speciation in human hair: a new perspective for epidemiological assessment in chronic arsenicism

The analysis for arsenic in hair is commonly used in epidemiological studies to assess exposure to this toxic element. However, poor correlation between total arsenic concentration in hair and water sources have been found in previous studies. Exclusive determination of endogenous arsenic in the hair, excluding external contamination has become an analytical challenge. Arsenic speciation in hair appears as a new possibility for analytical assessing in As-exposure studies. This study applied a relative simple method for arsenic speciation in human hair based on water extraction and HPLC-HG-ICP-MS. The concentration of arsenic species in human hair was assessed in chronically As(V)-exposed populations from two villages (Esqui?a and Illapata) of the Atacama Desert, Chile. The arsenic concentrations in drinking water are 0.075 and 1.25 mg L(-1), respectively, where As(V) represented between 92 and 99.5% of the total arsenic of the consumed waters. On average, the total arsenic concentrations in hair from individuals of Esqui?a and Illapata were 0.7 and 6.1 microg g(-1), respectively. Four arsenic species, As(III), DMA(V), MMA(V) and As(V), were detected and quantified in the hair extracts. Assuming the found species in extracts represent the species in hair, more than 98% of the total arsenic in hair corresponded to inorganic As. On average, As(III) concentrations in hair were 0.25 and 3.75 microg g(-1) in Esqui?a and Illapata, respectively; while, the As(V) average concentrations were 0.15 and 0.45 microg g(-1) in Esqui?a and Illapata, respectively. Methylated species represent less than 2% of the extracted As (DMA(V)+ MMA(V)) in both populations. As(III) in hair shows the best correlation with chronic exposure to As(V) in comparison to other species and total arsenic. In fact, concentrations of As(total), As(III) and As(V) in hair samples are correlated with the age of the exposed individuals from Illapata (R= 0.65, 0.69, 0.57, respectively) and with the time of residence in this village (R= 0.54, 0.71 and 0.58, respectively).     

Reduction of SO2 emissions by ammonia gas during unstaged combustion

The reduction of SO₂ by the addition of ammonia gas has been studied in a 2 m high fluidized bed combustor having a 30 cm static bed height and a freeboard height of 170 cm. Ammonia gas was injected at 52 cm above the distributor where the temperature is ca. 700° C by an uncooled stainless steel tube injector. Experiments were carried out to investigate the effects of amminia gas injection on sulphur dioxide emissions at unstaged conditions of: (i) excess air level, (ii) NH₃:SO₂ molar ratio, (iii) fluidizing velocity and (iv) bed height.A maximum reduction of 75% in SO₂ emissions was found at 40% excess air, at an NH₃:SO₂ molar ratio of 5.4. The onset of SO₂ reduction occurred at an NH₃:SO₂ ratio of 1.5 However, the most effective ratio was found to be between 3 and 5. Fluidizing velocity and bed height were also found to have significant influence on SO₂ reduction.It is difficult to determine how the SO₂ reduction varied with operating conditions. When ammonia is added in the main combustor zone, the temperature is much higher than that required for the occurrence of sulphur dioxide-ammonia and sulphur trioxide-ammonia reactions. However, this paper points out the significance of ammonia addition in the reduction of sulphur dioxide.     

Regional landscape-ecological planning and desertification control in arid regions of the Commonwealth of Independent States

Scale-dependent present-day landscape mapping and assessment were used to study the relationship among physical environment, land use, and degree of landscape modification in the Aral Sea region and the Karakum Desert, areas prone to desertification in the Commonwealth of Independent States (CIS). Applying geographic information system (GIS) techniques at global (1:15,000,000), regional (1:1,000,000), and local (1:300,000) scales, researchers found that large-scale landscape assessment and mapping allow them to recognize landscape changes under desertification processes and assess the type and intensity of these processes. Remote sensing has been widely used to evaluate data reliability, to fill information gaps, and to reveal the dynamics of land use types resulting from landscape changes.     

A simple,cost-effective multispecies toxicity test using organisms with a cosmopolitan distribution

Difficulties in making accurate, ecosystem-level predictions of environmental effects of chemicals, mixtures, and effluents based solely on the results of tests on single species have necessitated the development of more environmentally realistic, predictive testing methods. This paper describes a multispecies, community-level toxicity test based on the colonization of artificial substrates by microbial species. Tests examined the colonization of initially barren polyurethane foam artificial substrates by Protozoa from a species source colonized in a natural system. Differences in colonization were examined in microecosystems amended with low levels of cadmium, a very toxic heavy metal, and TFM, an organic biocide used against larval sea lamprey. Tests examined differences in colonization over 28 days. For cadmium, effect levels were estimated to be near 1 g 1^–1, in the low range of effect levels determined from chronic single species tests. For TFM, effect levels were estimated to be between 1 and 10 ppm, overlapping the concentrations used in environmental applications. The colonization response, which depends on naked microbial cells reproducing and migrating through toxicant amended water to new substrates, is very sensitive. Tests based on colonization can be adapted to use species from a target receiving system or can use species from a designated natural source. Field validation of these tests can employ nearly identical methods to those used in laboratory studies to assess the accuracy of predictions based on test system data.     

Pesticide burden on some insects of economic importance in Lucknow (India)

Some insects of economic importance from Lucknow (India) have been investigated for their pesticide burden. Chlorinated pesticide residues of DDT, BHC and aldrin along with their metabolites and isomers have been detected in crop pollinating insects, honeybees (Apis indica) and butterflies (Danais chrysippus and Eurema sp.) and predators, dragonfly (Platythemis sp.) and wasps (Polistes herebreus). DDT and their metabolites were present in concentrations which varied from 231–796 ng g^–1, followed by BHC (10–60 ng g^–1), and aldrin (0.26–6.68 ng g^–1). This finding is likely to stimulate newer interest in the area of pesticide research and start meaningful investigation to find if bioaccumulated pesticides would have adverse impact on otherwise beneficial potentials of such insects in our ecosystems.