Knowledge based ranking algorithm for comparative assessment of post-closure care needs of closed landfills

Post-closure care (PCC) activities at landfills include cap maintenance; water quality monitoring; maintenance and monitoring of the gas collection/control system, leachate collection system, groundwater monitoring wells, and surface water management system; and general site maintenance. The objective of this study was to develop an integrated data and knowledge based decision making tool for preliminary estimation of PCC needs at closed landfills. To develop the decision making tool, 11 categories of parameters were identified as critical areas which could affect future PCC needs. Each category was further analyzed by detailed questions which could be answered with limited data and knowledge about the site, its history, location, and site specific characteristics. Depending on the existing knowledge base, a score was assigned to each question (on a scale 1-10, as 1 being the best and 10 being the worst). Each category was also assigned a weight based on its relative importance on the site conditions and PCC needs. The overall landfill score was obtained from the total weighted sum attained. Based on the overall score, landfill conditions could be categorized as critical, acceptable, or good. Critical condition indicates that the landfill may be a threat to the human health and the environment and necessary steps should be taken. Acceptable condition indicates that the landfill is currently stable and the monitoring should be continued. Good condition indicates that the landfill is stable and the monitoring activities can be reduced in the future. The knowledge base algorithm was applied to two case study landfills for preliminary assessment of PCC performance.     

Solvent tolerant marine bacterium Bacillus aquimaris secreting organic solvent stable alkaline cellulase

The organic solvent tolerant bacteria with their physiological abilities to decontaminate the organic pollutants have potentials to secrete extracellular enzymes of commercial importance. Of the 19 marine bacterial isolates examined for their solvent tolerance at 10 vol.% concentration, one had the significant tolerance and showed a relative growth yield of 86% for acetone, 71% for methanol, 52% for benzene, 35% for heptane, 24% for toluene and 19% for ethylacetate. The phylogenetic analysis of this strain using 16S rDNA sequence revealed 99% homology with Bacillus aquimaris. The cellulase enzyme secreted by this strain under normal conditions showed an optimum activity at pH 11 and 45 °C. The enzyme did show functional stability even at higher pH (12) and temperature (75 °C) with residual activity of 85% and 95% respectively. The enzyme activity in the presence of different additives were in the following order: Co⁺² > Fe⁺² > NaOCl₂ > CuSO₄ > KCl > NaCl. The enzyme stability in the presence of solvents at 20 vol.% concentration was highest in benzene with 122% followed by methanol (85%), acetone (75%), toluene (73%) and heptane (42%). The pre-incubation of enzyme in ionic liquids such as 1-ethyl-3-methylimidazolium methanesulfonate and 1-ethyl-3-methylimidazolium bromide increased its activity to 150% and 155% respectively. The change in fatty acid profile with different solvents further elucidated the physiological adaptations of the strain to tolerate such extreme conditions.     

Levels of chemical and microbiological pollutants in the vicinity of a waste incineration plant and human health risks: temporal trends

In 2007, a program was initiated to monitor air levels of volatile organic compounds (VOCs) and bioaerosols in the vicinity of a municipal solid waste incinerator (MSWI) (Tarragona, Catalonia, Spain). To investigate the temporal trends of chemical and microbiological pollutants, four 6-monthly campaigns were performed. Air samples were collected at different distances and directions from the facility, as well as in reference sites. In general terms, the concentrations of microbiological agents were very similar to those found in urban zones worldwide. The seasonal evaluation of the results showed higher levels of gram-negative bacteria in winter, contrasting with the increase of the airborne amount of total bacteria in summer. On the other hand, the concentrations of VOCs (mean range: 7.6-18.2 μgm⁻³) were typical of suburban zones. The current exposure to those compounds should not mean additional health risks for the population living nearby.     

Isolation and Characterization of a <Emphasis Type="Italic">Burkholderia</Emphasis> sp. USM (JCM15050) Capable of Producing Polyhydroxyalkanoate (PHA) from Triglycerides,Fatty Acids and Glycerols

A consortium of microorganisms from oil polluted wastewater sample was cultivated to promote polyhydroxyalkanoate (PHA) accumulation before subjecting the mixed cultures to sucrose density gradient ultracentrifugation. This resulted in the fractionation of the bacterial cells according to their physical features such as size, morphology and/or densities. An isolate was identified as Burkholderia sp. USM (JCM15050), which was capable of converting palm oil products [crude palm kernel oil (CPKO), palm olein (PO), palm kernel acid oil (PKAO), palm stearin (PS), crude palm oil (CPO), palm acid oil (PAO) and palm fatty acid distillate (PFAD)], fatty acids and various glycerol by-products into poly(3-hydroxybutyrate) [P(3HB)]. Up to 70 and 60 wt% of P(3HB) could be obtained when 0.5%(v/v) CPKO and glycerol was fed, respectively. Among the various fatty acids tested, lauric acid followed by oleic acid and myristic acid gave the best cell growth and PHA accumulation. Compared to Cupriavidus necator H16, the present isolate showed better ability to grow on and produce PHA from various glycerol by-products generated by the palm oil industry. This study demonstrated for the first time an isolate that has the potential to utilize palm oil and glycerol derivatives for the biosynthesis of PHA.     

A new apparatus to enhance the rate of gas hydrate formation: Application to capture of carbon dioxide

A new apparatus employing a modular, mechanically agitated gas-inducing crystallizer is used to demonstrate the capture of CO₂ via hydrate crystallization. The crystallizer enhances the contact of hydrate forming gases with water and thus the rate of hydrate crystallization increases. Flue gas (CO₂/N₂) and fuel gas (CO₂/H₂) mixtures were used to represent post- and precombustion capture. A comparison between the rates of hydrate formation in different crystallizers is presented by defining a metric called the normalized rate of hydrate formation. The gas uptake and the separation efficiency for the fuel and flue gas mixtures were found to be greater compared to the results obtained in a smaller scale stirred tank reactor (Kumar et al., 2009c, Linga et al., 2008). The gas uptake and CO₂ recovery for flue gas mixture in the presence of THF obtained in this work was higher than that reported in the literature with tetra-n-butyl ammonium bromide and tetra-n-butyl ammonium fluoride (Fan et al., 2009, Li et al., 2009). Although hydrate crystallization is able to capture CO₂, the power required for mechanical agitation was found to be very significant. If the hydrate process is to be used industrially then hydrate crystallization must be carried out without mechanical agitation.     

Application of enzyme-linked immunosorbent assay analysis for determination of monensin in environmental samples

There is growing concern that antibiotic use in livestock production is contributing to contamination of soil and aquatic environments. Monensin, a polyether ionophore antibiotic, accounts for approximately 13% of total subtherapeutic livestock antibiotic usage in the USA and has been widely detected in aquatic environments. Due to insufficient ultraviolet absorbance, liquid chromatography analysis of monensin in environmental samples is limited to equipment with mass spectrometry (e.g., liquid chomatography-mass spectrometry [LC-MS]). However, LC-MS equipment is costly, and extensive sample preparation and clean-up is often required. Rapid, low-cost analytical techniques are needed to monitor for monensin residues in the environment. In this study, a commercially available enzyme-linked immunosorbent assay (ELISA) for detecting monensin in animal feed extracts was evaluated for determination of monensin in water, soil, and manure. The monensin ELISA was highly sensitive, with limits of detection and quantification at 1.5 and 3.0 microg L(-1), respectively. Recovery of monensin in spiked water samples was approximately 100%. Cross-reactivity was not observed with similar polyether ionophores, tetracyclines, macrolides, or sulfonamides. Concentrations of monensin using ELISA were greater than concentrations measured with LC-MS. This is attributed to cross-reactivity of the monensin ELISA toward structurally similar monensin compounds, such as factors (slight naturally produced structural variants) and metabolites. Results from this study showed that ELISA can be a reliable, rapid, and low-cost alternative to LC-MS analysis of environmental samples.     

Degradation of anionic surfactants during drying of UASBR sludges on sand drying beds

Anionic surfactant (AS) concentrations in wet up-flow anaerobic sludge blanket reactor (UASBR) sludges from five sewage treatment plants (STPs) were found to range from 4480 to 9233mgkg(-1)drywt. (average 7347mgkg(-1)drywt.) over a period of 18 months. After drying on sand drying beds (SDBs), AS in dried-stabilized sludges averaged 1452mgkg(-1)drywt., a reduction of around 80%. The kinetics of drying followed simple first-order reduction of moisture with value of drying constant (k(d))=0.051d(-1). Reduction of AS also followed first-order kinetics. AS degradation rate constant (k(AS)) was found to be 0.034d(-1) and half-life of AS as 20 days. The order of rates of removal observed was k(d)>k(AS)>k(COD)>k(OM) (drying >AS degradation>COD reduction>organic matter reduction). For the three applications of dried-stabilized sludges (soil, agricultural soil, grassland), values of risk quotient (RQ) were found to be <1, indicating no risk.     

Analytic hierarchy process helps select site for limestone quarry expansion in Barbados

Site selection is a key activity for quarry expansion to support cement production, and is governed by factors such as resource availability, logistics, costs, and socio-economic-environmental factors. Adequate consideration of all the factors facilitates both industrial productivity and sustainable economic growth. This study illustrates the site selection process that was undertaken for the expansion of limestone quarry operations to support cement production in Barbados. First, alternate sites with adequate resources to support a 25-year development horizon were identified. Second, technical and socio-economic-environmental factors were then identified. Third, a database was developed for each site with respect to each factor. Fourth, a hierarchical model in analytic hierarchy process (AHP) framework was then developed. Fifth, the relative ranking of the alternate sites was then derived through pair wise comparison in all the levels and through subsequent synthesizing of the results across the hierarchy through computer software (Expert Choice). The study reveals that an integrated framework using the AHP can help select a site for the quarry expansion project in Barbados.     

Nitrate reductase, arginine deaminase, urease and dehydrogenase activities in natural soil (ridges with forest) and in cotton soil after acetamiprid treatments

Soil enzymes are indicators of microbial activities in soil and are often considered as an indicator of soil health and fertility. They are very sensitive to the agricultural practices, pH of the soil, nutrients, inhibitors and weather conditions. To understand the effect of an insecticide, acetamiprid (IUPAC Name: (E)-N1-[(6-chloro-3-pyridyl) methyl]-N2-cyano-N1-methyl acetamidine) on different soil enzyme activities, the experiments were conducted for three consecutive years (2003--2005) at control and cotton experimental fields of Indian Agricultural Research Institute (IARI) and natural area (ridges with forest) in Delhi. The combined results for all three years were presented here to understand the impact of acetamiprid on soil enzyme activities. Acetamiprid was applied three times in one crop season after 41, 48 and 73 days of sowing, to control the pest. Soil of treated fields was analyzed for insecticide residues immediately after first insecticide treatment and thereafter at definite period. The residues of acetamiprid in experimental soil was varied from 0.30+/-0.13 to 22.67+/-0.2 microg g(-1)d.wt. soil, during the crop period of 2003. The insecticide residues for 2004 ranged between 0.59+/-0.38 and 13.42+/-0.71 microg g(-1)d.wt. soil and for 2005 it ranged between 0.48+/-0.22 and 19.81+/-0.33 microg g(-1)d.wt. soil. An average half life of acetamiprid in our treated field was 11.2+/-1.7 days for all three years. Similarly, the soil from natural area and control were also tested for insecticide residues. No detectable insecticide residues had been found. Soil from three localities i.e. natural, control and experimental fields were tested for different enzyme activities. Nitrate reductase, arginine deaminase, urease and dehydrogenase activities were high in natural soil in comparison to control soil and insecticide treated soil in all three experimental years. At the same time, nitrate reductase activity was all time low in acetamiprid treated soil. Acetamiprid had inhibitory effects on nitrate reductase, arginine deaminase and urease activities. After first treatment (43 days after crop sowing), nitrate reductase (41%), arginine deaminase (22%) and urease (35%) activities were declined. Dehydrogenase activity increased to 22% after first insecticide application. Enzyme activities were recovered at the end of each crop season. Therefore, it can be attributed that agricultural practices, weather conditions and use of acetamiprid might be responsible for the different level of enzyme activities in soil.     

Influence of plant growth promoting bacteria and its mutant on heavy metal toxicity in Brassica juncea grown in fly ash amended soil

In this study a metal tolerant plant growth promoting bacteria, NBRI K28 Enterobacter sp. was isolated from fly ash (FA) contaminated soils. The strain NBRI K28 and its siderophore overproducing mutant NBRI K28 SD1 were found capable of stimulating plant biomass and enhance phytoextraction of metals (Ni, Zn and Cr) from FA by metal accumulating plant i.e. Brassica juncea (Indian mustard). Concurrent production of siderophores, Indole acetic acid (IAA) and phosphate solubilization revealed its plant growth promotion potential. The strain also exhibited 1-aminocyclopropane-1-carboxylic acid (ACC) deaminase activity. In most of the cases mutant of NBRI K28, exerted more pronounced effect on metal accumulation and growth performance of B. juncea plants than wild type.