Evidence of new particle formation during post monsoon season over a high-altitude site of the Western Ghats,India

The formation of ultrafine particles, their growth, and associated characteristic features has been studied during new particle formation events over a high-altitude station of the Western Ghats during the 2014 post-monsoon season. Most of the events were observed during noon time where particle bursts in the nucleation-mode size range from 5 to 25 nm followed by sustained growth in size. This phenomenon persists for ～4–8 h with a growth rate of 1–2 nm h^–1. Peak concentrations of nucleation-mode particles during the event generally vary from 2300 to 5000 cm^–3. The mean growth rate is 1.4 ± 0.42 nm h^–1, particle formation rate is 1.14 ± 0.22 cm^–3 s^–1, coagulation sink is 0.35 ± 0.22 cm^–3 s^–1, and condensational sink is 15.4 ± 2.6?×?10^–3 s^–1. All these values are comparable with earlier results from Indian region. Comparison of size-segregated particle number concentration during days of new particle formation events and those without new particle formation were carried out showing a distinct variation in nucleation and Aitken mode with least variability associated with the accumulation mode.     

Bioreduction of hexavalent chromium by Exiguobacterium indicum strain MW1 isolated from marine water of Paradip Port,Odisha, India

Hexavalent chromium-tolerant (1500?mg/L) bacterium MW1 was isolated from harbour water of Paradip Port and evaluated for Cr(VI) reduction potential. The isolate was identified as Exiguobacterium indicum by biochemical and 16S rRNA gene sequence methods. Salt tolerance of the bacterium was evaluated in a wide range of NaCl concentrations (0.5–13%, w/v). The Cr(VI) reduction of the strain was evaluated and optimised with varied Cr(VI) concentrations (100–1000?mg/L), pH (5.0–9.0), temperature (30–40°C) and shaking velocity (100–150?rpm) in two different minimal media (M9 and Acetate). Under optimised conditions, after 192?h of incubation nearly 92%, 50% and 46% reduction in the M9 minimal medium and 91%, 47% and 40% reduction in the acetate minimal medium were observed for 100, 500 and 1000?mg/L of Cr(VI), respectively. The exponential rate equation for Cr(VI) reduction yielded higher rate constant value, that is, 1.27?×?10^?2?h^?1 (M9) and 1.17?×?10^?2?h^?1 (Acetate) in case of 100?mg/L and became lower for 500 and 1000?mg/L Cr(VI) concentrations. Further, the association of bacterial cells with reduced product was ascertained by Fourier transform infrared spectrometer, UV–Vis–DRS and field-emission scanning electron microscope–energy-dispersive X-ray analyses. The above study suggests that the higher reducing ability of the marine bacterium E. indicum MW1 will be suitable for Cr(VI) reduction from saline effluents.     

Trace elements in surface sediments of the Hooghly (Ganges) estuary: distribution and contamination risk assessment

Our objective was to evaluate distribution and accumulation of trace elements (TEs) in surface sediments along the Hooghly (Ganges) River Estuary, India, and to assess the potential risk with view to human health. The TE concentrations (mg kg^?1 dry weight) exhibited a wide range in the following order: Al (31.801 ± 15.943) > Fe (23.337 ± 7584) > Mn (461 ± 147) > S (381 ± 235) > Zn (54 ± 18) > V (43 ± 14) > Cr (39 ± 15) > As (34 ± 15) > Cu (27 ± 11) > Ni (24 ± 9) > Se (17 ± 8) > Co (11 ± 3) > Mo (10 ± 2) > Hg (0.02 ± 0.01). Clay, silt, iron, manganese and sulphur were important for the accumulation of TE in the sediments as confirmed by factor analysis and Pearson correlation. The accumulation and dispersal of TEs were most likely to be governed by both tide-induced processes and anthropogenic inputs from point and non-point sources. Enrichment factor analysis and geoaccumulation index revealed serious contamination of the sediments with Se and As, while comparing the consensus-based sediment quality guidelines (SQGs), adverse biological effects to benthic fauna might be caused by As, Cu, Ni and Cr. This investigation may serve as a model study and recommends continuous monitoring of As, Se, Cu, Ni and Cr to ascertain that SQGs with respect to acceptable levels of TEs to safeguard geochemical health and ecology in the vicinity of this estuary.     

Recycling polymeric waste from electronic and automotive sectors into value added products

The environmentally sustainable disposal and recycling of ever increasing volumes of electronic waste has become a global waste management issue. The addition of up to 25% polymeric waste PCBs (printed circuit boards) as fillers in polypropylene (PP) composites was partially successful: while the tensile modulus, flexural strength and flexural modulus of composites were enhanced, the tensile and impact strengths were found to decrease. As a lowering of impact strength can significantly limit the application of PP based composites, it is necessary to incorporate impact modifying polymers such as rubbery particles in the mix. We report on a novel investigation on the simultaneous utilization of electronic and automotive rubber waste as fillers in PP composites. These composites were prepared by using 25 wt.% polymeric PCB powder, up to 9% of ethylene propylene rubber (EPR), and PP: balance. The influence of EPR on the structural, thermal, mechanical and rheological properties of PP/PCB/ EPR composites was investigated. While the addition of EPR caused the nucleation of the β crystalline phase of PP, the onset temperature for thermal degradation was found to decrease by 8%. The tensile modulus and strength decreased by 16% and 19%, respectively; and the elongation at break increased by ~71%. The impact strength showed a maximum increase of ~18% at 7 wt.%–9 wt.% EPR content. Various rheological properties were found to be well within the range of processing limits. This novel eco-friendly approach could help utilize significant amounts of polymeric electronic and automotive waste for fabricating valuable polymer composites.

Open image in new window

     

Evaluation of existing equations for temporal scour depth around circular bridge piers

Scour is defined as the processes of removal of sediment particles from water stream bed by the erosive action of activated water, and also carries sediment away from the hydraulic structures. Scour is the main cause of pier failure. Numerous equations are available for estimating temporal and equilibrium scour depth. The present study describes the phenomenon of temporal scour depth variation at bridge piers and deals with the methods for its estimation. The accuracy of six temporal scour depth equations are also checked in this study. After graphical and statistical analysis, it was found that the relationship proposed by Oliveto and Hager (J Hydraul Eng (ASCE) 128(9):811–520, 2002) predicts temporal scour depth better than other equations. Three equations of equilibrium time of scour are also used for computing equilibrium time. Equilibrium time equation proposed by Choi and Choi (Water Environ J 30(1–2):14–21, 2016) gives better agreements with observed values.     

Prevalence of multidrug-resistant,coagulase-positive Staphylococcus aureus in nasal carriage,food, wastewater and paper currency in Jalandhar city (north-western), an Indian state of Punjab

Eighteen sites impacted by abandoned mine drainage (AMD) in Pennsylvania were sampled and measured for pH, acidity, alkalinity, metal ions, and sulfate. This study compared the accuracy of four acidity calculation methods with measured hot peroxide acidity and identified the most accurate calculation method for each site as a function of pH and sulfate concentration. Method E1 was the sum of proton and acidity based on total metal concentrations; method E2 added alkalinity; method E3 also accounted for aluminum speciation and temperature effects; and method E4 accounted for sulfate speciation. To evaluate errors between measured and predicted acidity, the Nash-Sutcliffe efficiency (NSE), the coefficient of determination (R ²), and the root mean square error to standard deviation ratio (RSR) methods were applied. The error evaluation results show that E1, E2, E3, and E4 sites were most accurate at 0, 9, 4, and 5 of the sites, respectively. Sites where E2 was most accurate had pH greater than 4.0 and less than 400 mg/L of sulfate. Sites where E3 was most accurate had pH greater than 4.0 and sulfate greater than 400 mg/L with two exceptions. Sites where E4 was most accurate had pH less than 4.0 and more than 400 mg/L sulfate with one exception. The results indicate that acidity in AMD-affected streams can be accurately predicted by using pH, alkalinity, sulfate, Fe(II), Mn(II), and Al(III) concentrations in one or more of the identified equations, and that the appropriate equation for prediction can be selected based on pH and sulfate concentration.     

广州市城区站点冬季PM2.5时间变化及碳氮同位素组成特征

于2018年冬季在广州城区磨碟沙站点开展细颗粒物(PM_2.5)样品采集,并获得PM_2.5中水溶性离子、含碳组分、稳定碳氮同位素的组成及时间变化特征,重点讨论了PM_2.5浓度升高时段的化学组成特征变化,进而利用稳定碳氮同位素变化特征探究了主要污染来源。结果表明：采样期间,研究站点PM_2.5平均质量浓度为22.1μg/m³,共出现两个PM_2.5浓度水平升高时段,所对应的平均质量浓度分别达46.0μg/m³和63.0μg/m³。风速降低、温度升高等不利气象条件是导致上述时段PM_2.5浓度上升的重要原因。在上述时段,伴随着PM_2.5浓度的升高,NO^-₃和NH⁺₄浓度均出现显著升高,NO^-₃与SO^2-₄的摩...     

Simultaneous analysis of endosulfan, chlorpyrifos, and their metabolites in natural soil and water samples using gas chromatography-tandem mass spectrometry

Analysis of endosulfan, chlorpyrifos, and their nonpolar metabolites in extracts from environmental aqueous and soil samples was performed using a gas chromatography-tandem mass spectrometry (GC–MS/MS) technique. Full-scan GC–MS analysis showed poor sensitivity for some of the metabolites (endodiol and endosulfan ether). A multisegment MS/MS method was developed and MS/MS parameter isolation time, excitation time, excitation voltage, and maximum excitation energy were optimized for chosen precursor ions to enhance selectivity and sensitivity of the analysis. The use of MS/MS with optimized parameters quantified analytes with significantly higher accuracy, and detection limits were lowered to ~1/6th compared with the full-scan method. Co-eluting compounds, chlorpyrifos and chlorpyrifos oxon, were also analyzed successfully in the MS/MS mode by choosing exclusive precursor ions. Analysis of soil and water phase samples from contaminated soil slurry bioreactors showed that the MS/MS method could provide more reliable estimates of these pesticide and metabolites (especially those present in low concentrations) by annulling interferences from soil organic matter.     

The use of multiple tracers for tracking wastewater discharges in freshwater systems

The assessment of potential impacts of wastewater effluent discharges in freshwater systems requires an understanding of the likely degrees of dilution and potential zones of influence. In this study, four tracers commonly present in wastewater effluents were monitored to compare their relative effectiveness in determining areas in freshwater systems that are likely to be impacted by effluent discharges. The four tracers selected were the human pharmaceutical carbamazepine, anthropogenic gadolinium, fluorescent-dissolved organic matter (fDOM), and electrical conductivity (EC). The four tracers were monitored longitudinally in two distinct freshwater systems receiving wastewater effluents, where one site had a high level of effluent dilution (effluent <1 % of total flow) and the other site had a low level of effluent dilution (effluent ～50 % of total flow). At both sites, the selected tracers exhibited a similar pattern of response intensity downstream of discharge points relative to undiluted wastewater effluent, although a number of anomalies were noted between the tracers. Both EC and fDOM are non-specific to human influences, and both had a high background response, relative to the highly sensitive carbamazepine and anthropogenic gadolinium responses, although the ease of measuring EC and fDOM would make them more adaptable in highly variable systems. However, the greater sensitivity and selectivity of carbamazepine and gadolinium would make their combination with EC and fDOM as tracers of wastewater effluent discharges highly desirable to overcome potential limitations of individual tracers.