Mechanical,Barrier and Antioxidant Properties of Chitosan Films Incorporating Cinnamaldehyde

Chitosan films (CF) [1 and 2% w/v] alone and with cinnamaldehyde (CNE) [0.25, 0.5 and 1% v/v] were prepared using an emulsion method, and the obtained films were characterized in terms of water vapor permeability (WVP), water solubility and optical, mechanical and antioxidant properties. The incorporation of CNE at 1% (v/v) significantly decreased the water solubility of the film by approximately 4% for the 1 and 2% CF films, whereas the WVP increased (2.5–3.5 times). The incorporation of CNE (0.25 and 0.5%) into 2% CF significantly increased the tensile strength (TS) (62 and 34%, respectively) and the percent elongation (%E) values, 26, 30 and 52% for CF that contained 0.25, 0.5 and 1% CNE, respectively. The largest value of the elasticity modulus (EM) was observed for 2% CF with 0.25% CNE. All films exhibited a yellow appearance (b*), but the CNE content had a marked impact on the coloration of the films. The CNE recoveries of the CF films (1 and 2%) with 1% of CNE were high (43 and 67%). The antioxidant activities indicated that the incorporation of 1% CNE into CF films (1 and 2%) increased the antioxidant activity. The protective effects of the films with and without CNE on erythrocytes were very strong (36–72% hemolysis inhibition). These results suggest there are potential applications for CF-CNE films as active packaging for the preservation of food products.     

A microcosm system to evaluate the toxicity of the triazine herbicide simazine on aquatic macrophytes

This study evaluates the effects of the triazine herbicide simazine in an outdoor pond microcosm test system that contained two submerged rooted species (Myriophyllum spicatum and Elodea canadensis) and two emergent rooted species (Persicaria amphibia and Glyceria maxima) over a period of 84 days. Simazine was applied to the microcosms at nominal concentrations of 0.05, 0.5 and 5 mg/L. General biological endpoints and physiological endpoints were used to evaluate herbicide toxicity on macrophytes and the algae developing naturally in the system.Concentration-related responses of macrophytes and algae were obtained for the endpoints selected, resulting in a no observed ecologically adverse effect concentration (NOEAEC) at simazine concentrations of 0.05 mg active ingredient/L after 84 days. E. canadensis was the most negatively affected species based on length increase, which was consistently a very sensitive parameter for all macrophytes. The experimental design presented might constitute a suitable alternative to conventional laboratory single-species testing.     

Variability of ozone concentration in a montane environment,northern Italy

To evaluate the spatial variability of ozone concentrations, two studies were undertaken in the montane environment of Trentino region, northern Italy, in 2007. In the first study, a 225 km² area was considered. Here, a randomized design was used to evaluate the variability of ozone concentration at 1 and 225 km² scale. Measurements were carried out by passive samplers between May and June 2007. In a second study, the whole 6207 km² area of Trentino was considered. The area is covered by five grid cells of the European Monitoring and Evaluation Programme (EMEP). A systematic 15 × 15 km grid was used to allocate 15 passive samplers over the entire province, resulting into 1–4 samplers for each of the 5 EMEP grid cells (2500 km² each) overlapping the study area. Measurements were carried out between June and September 2007. Accuracy of passive samplers was checked by direct comparison with conventional ozone analysers. Significant differences (P = 0.034) were found in ozone concentration among 1 × 1 km quadrates within the 225 km² study area, while variability within the 1 × 1 km grid cells (coefficient of variation, CV′ = 0.12) slightly exceed the measurement error (CV′ = 0.08). At larger scales (225, 2500 and 6207 km²), ozone concentration shows much higher variability (CV′ from 0.18 to 0.28, with peak values at 0.40). Reported differences lead to very different AOT40 estimates even within the same EMEP grid cell. These findings suggest that 1 × 1 km resolution seems appropriate for ozone concentration modelling. On the other hand, significant sub-grid variation may exist at the resolution adopted by the EMEP model. Coupled with the likely variability of other important meteorological, soil and vegetation variables, our findings suggest that ozone risk assessment for vegetation based on large-scale modelled AOT40 and flux needs to be considered with great caution. The evidence reported in this paper asks for more detailed national-scale modelling, and the development of methods to incorporate local scale variations into large-scale models.     

Preferential retention of POPs on the northern aspect of mountains

Soils are the main reservoirs of POPs in mountain ecosystems, but the great variability of the concentrations, also at small scale, leaves some uncertainties in the evaluation of environmental burdens and exposure. The role of the aspect of the mountain side and the seasonal variation in the contamination levels was analysed by means of several soil samples taken from central Italian Alps. A greater contamination content was present in northern soils with a mean ratio between the north vs. south normalised concentration of around a factor of 2 (North-South Enrichment Factor). Experimental factors agreed with theoretical calculations based on temperature-specific calculated K_sa values. From May to November consistent differences in normalised concentrations up to 5-fold were observed. A dynamic picture of the POP contamination in high altitudinal soils is derived from the data in this work, with spring-summer half-lives between 60 and 120 days for most of the compounds.     

Visible injury, crown condition, and growth responses of selected Italian forests in relation to ozone exposure

The impact of ozone on forest ecosystems in Italy is monitored within the CONECOFOR programme. Ozone levels are measured in 30 plots using passive samplers. Response parameters used are: crown condition (transparency), BAI (basal area increment), and visible symptoms on spontaneous vegetation. Levels of AOT40 are above the concentration-based critical level of 5 ppmh in all sites, but the evidence of impact on forest vegetation remains limited. Ozone is a predictor of crown transparency residuals in beech sites over two consecutive years, but the variance explained amounts to less than 10%. The relation between BAI reduction and ozone is even less certain. Transparency and BAI are more readily explainable in terms of ecological conditions of the site and climate fluctuations. The interpretation of visible symptoms is doubtful, and is conditioned by the prevailing ecological factors in the areas.     

Corrosion on cultural heritage buildings in Italy: A role for ozone?

Because of climatic reasons and of reduced concentrations of SO₂, ground-level ozone (O₃) is one of the main air pollutants in Southern Europe. Ozone levels are very high both in rural and urban locations. In the cities, O₃ can affect human health and materials. Regarding materials, most relevant is the exposure to pollutants of cultural heritage buildings. In particular, monuments registered on UNESCO's list of the world heritage require special monitoring. In Italy 34% and 97% of the territory is exposed to corrosion risk higher than the tolerable level for limestone and copper, respectively. The tolerable corrosion level for limestone and copper was also exceeded in the central area of Milan. In this area the tolerable O₃ concentration for copper was calculated. These concentrations (ranging between 30 and 40 μg/m³) cannot be exceeded at unchanged concentration of other pollutants to maintain corrosion levels below the tolerable ones.     

Clay-sewage sludge co-pyrolysis. A TG-MS and Py-GC study on potential advantages afforded by the presence of clay in the pyrolysis of wastewater sewage sludge

Wastewater sewage sludge was co-pyrolyzed with a well characterized clay sample, in order to evaluate possible advantages in the thermal disposal process of solid waste. Characterization of the co-pyrolysis process was carried out both by thermogravimetric-mass spectrometric (TG-MS) analysis, and by reactor tests, using a lab-scale batch reactor equipped with a gas chromatograph for analysis of the evolved gas phase (Py-GC).Due to the presence of clay, two main effects were observed in the instrumental characterization of the process. Firstly, the clay surface catalyzed the pyrolysis reaction of the sludge, and secondly, the release of water from the clay, at temperatures of approx. 450-500 °C, enhanced gasification of part of carbon residue of the organic component of sludge following pyrolysis.Moreover, the solid residue remaining after pyrolysis process, composed of the inorganic component of sludge blended with clay, is characterized by good features for possible disposal by vitrification, yielding a vitreous matrix that immobilizes the hazardous heavy metals present in the sludge.     

Preliminary evaluation of insecticide resistance in a strain of Musca domestica (Diptera: Muscidae) from an intensive chicken farm of Northern Italy

The house fly, Musca domestica L., a relevant sanitary pest, is mainly controlled by insecticides. However, an inappropriate use of chemicals may induce resistance, treatment efficacy decline and environmental damages. We evaluated toxicity of some organophosphates, pyrethroids, spinosad and neonicotinoids by topical applications on adults of a M. domestica strain (OcRo) collected from an intensive chicken farm in Northern Italy, in comparison to a susceptible strain (s-DBF). The OcRo strain exhibited higher levels of resistance (RR??) to four pesticides in comparison to s-DBF. Spinosad and imidacloprid had very low RR??, thus were still efficient in OcRo control. We also tested resistance to pesticides in OcRo after topical applications of synergistic compounds. Hydrolases were involved in phosphorganic detoxification and cytochrome P450 monoxygenases in that of pyrethroids. These results indicate that OcRo strain is now multiresistant to organophosphates and pyrethroids, and this should be considered for an environmentally safe pest management.     

Insecticidal activity and fungitoxicity of plant extracts and components of horseradish (Armoracia rusticana) and garlic (Allium sativum)

To avoid environmental pollution and health problems caused by the use of traditional synthetic pesticides, there is a trend to search for naturally occurring toxicants from plants. Among the compounds discussed for anti-fungal and insecticidal activity, the natural extracts from garlic and horseradish have attracted considerable attention. The objective of this study is to determine the insecticidal and anti-fungal activity of Armoracia rusticana and Allium sativum L. extracts against larvae of Aedes albopictus (Skuse) and some pathogenic fungi. For the insecticidal test, horseradish and garlic extracts were prepared from fresh plants (cultivated in Emilia Romagna region) in a solution of ethanol 80 % and the two different solutions were used at different concentrations (for the determination of the lethal dose) against the fourth instar mosquito's larvae. The fungicidal test was carried out by the agar plates technique using garlic and horseradish extracts in a 10 % ethanol solution against the following organisms: Sclerotium rolfsii Sacc., Trichoderma longibrachiatum, Botrytis cinerea Pers., Fusarium oxysporum Schlecht. and Fusarium culmorum (Wm. G. Sm.) Sacc. The first results demonstrated that the horseradish ethanol extracts present only a fungistatic activity against Sclerotium rolfsii Sacc., Fusarium oxysporum Schlecht. and F. culmorum (Wm.G. Sm) Sacc. while garlic extracts at the same concentration provided a good fungicidal activity above all against Botrytis cinerea Pers. and S. rolfsii. A. rusticana and A. sativum preparations showed also an interesting and significant insecticidal activity against larvae of A. albopictus, even if horseradish presented a higher efficacy (LC?? value of 2.34 g/L), approximately two times higher than garlic one (LC?? value of 4.48 g/L).     

Biologic impact on the coastal belt of the province of Venice (Italy,Northern Adriatic Sea): preliminary analysis for the characterization of the bathing water profile

Background, aim and scope  

This paper presents a preliminary study of the water profile with reference to microbiological parameters, required by Directive 2006/07/EC (European Community 2006) concerning the management of bathing water quality, in the coastal belt of the Province of Venice (Italy, Northern Adriatic Sea). A historical database has been implemented with monitoring data for the period 2000–2006 (data on rivers, bathing and marine coastal waters and on the characterization of Wastewater Treatment Plant (WWTP) discharges) from the institutional activity of Veneto Regional Environmental Prevention and Protection Agency (ARPAV). An integrated areal analysis for the microbiological investigation of homogeneous stretches along the coast of the Province of Venice was performed for a preliminary characterization of the bathing water profile considering water quality status and existing pressure sources.