Decomposition of trichloroethylene and 2,4-dichlorophenol by ozonation in several organic solvents

The effects of chemical characteristics of organic solvents on the decomposition rate constants of undissociative trichloroethylene (TCE) and dissociative 2,4-dichlorophenol (2,4-DCP) by ozonation were studied. The TCE and 2,4-DCP decomposition by ozonation in organic solvents followed to the first-order reaction kinetics with respect to TCE or 2,4-DCP concentration. The orders of the rate constants among organic solvents for undissociative TCE and dissociative 2,4-DCP were different indicating that the ozonation rates for undissociative and dissociative compounds were dependent on the chemical property of organic solvent. The decomposition of undissociative TCE by ozonation was a simple electrophilic reaction, which was dependent on acceptor number (AN) of the solvent. On the other hand, the decomposition of dissociative 2,4-DCP was dependent on by the dissociation of the compounds and would be dependent on donor number (DN) of the solvent. Finally, TCE in acetic acid was transformed to chlorinated intermediates and chloride ion and then these intermediates were continuously oxidized to chlorine gas.     

Comparison of chorionic villus sampling and amniocentesis: Current status of prenatal diagnosis in Japan

Data were tabulated and compared for cases involving prenatal diagnostic procedures performed in the 8 years between January 1985 and December 1992. Of a total of 2781 pregnancies, 2546 cases (91·5 per cent) were diagnosed by amniocentesis, and 235 (8·5 per cent) by chorionic villus sampling (CVS). These findings reflect the fact that amniocentesis has taken deep root as the prenatal diagnostic procedure widely acknowledged by society, whereas even the existence of CVS has yet to be generally recognized. Analysis of our clinical and laboratory results and complication rates, however, suggests that CVS is a safe and accurate alternative to amniocentesis which should and can be positively presented to all patients who are candidates for prenatal diagnosis.     

Feasibility study of the separation of chlorinated films from plastic packaging wastes

This study describes the possible separation of chlorinated plastic films (PVC and PVDC) from other heavy plastic packaging waste (PPW) by selective twist formation and gravity separation. Twists formation was mechanically induced in chlorinated plastic films, whereas twist formation did not occur in PS and PET films. After twist formation, all the films had the apparent density of less than 1.0 g/cm³ and floated in water even though the true density was more than 1.0 g/cm³. However, the apparent density of the PS and the PET films increased with agitation to more than 1.0 g/cm³, whereas that of chlorinated plastic films was kept less than 1.0 g/cm³. The main reason would be the air being held inside the chlorinated plastic films which was difficult to be removed by agitation. Simple gravity separation after twist formation was applied for artificial film with 10 wt.% of the chlorinated films and real PPW films with 9 wt.% of the chlorinated films. About 76 wt.% of the artificial PPW films and 75 wt.% of real PPW films after the removal of PP and PE were recovered as settling fraction with 4.7 wt.% and 3.0 wt.% of chlorinated plastic films, respectively. These results indicate that simple gravity separation process after twist formation can be used to reduce the chlorinated plastic concentration from mixed heavy PPW films.     

Environmental risk assessment and concentration trend of atmospheric volatile organic compounds in Hyogo Prefecture, Japan

Purpose  

The purpose of this study was to evaluate the influences of volatile organic compounds (VOCs) emissions on hazardousness and photochemical reactivity and to propose efficient VOCs abatement strategies.     

Surface ozonation of polyvinyl chloride for its separation from waste plastic mixture by froth floatation

Selective surface modification of polyvinyl chloride (PVC) by ozonation was evaluated to facilitate the separation of PVC from other heavy plastics with almost the same density as PVC, especially polyethylene terephthalate (PET), by the froth flotation process. The optimum froth flotation conditions were investigated, and it was found that at 40°C, 90% of PVC and PET plastics floated. The bubble size became larger and the area covered with bubbles on the plastic surface was reduced with increasing temperature. Optimum PVC separation was achieved with the flotation solution at 40°C and mixing at 180–200 rpm, even for sheet samples 10 mm in size. Combined treatment by ozonation and froth flotation is a simple, effective, and inexpensive method for PVC separation from waste plastics.     

Enhancement of biodegradation of oil adsorbed on fine soils in a bioslurry reactor

Techniques for enhancing the biodegradation of oil-contaminated fine soils in a slurry-phase bioreactor were investigated. Using a model system consisting of kaolin particles containing adsorbed n-dodecane as a diesel fuel surrogate, we investigated how increasing the temperature and adding a surfactant and various hydrophobic support media affected the biodegradation rate of n-dodecane. Increasing the temperature from 25 to 35 degrees C decreased the time required for complete degradation of n-dodecane by 30%, from 110h to 80h. Addition of the surfactant polyethylene glycol p-1,1,3,3-tetramethylbutylphenyl ether decreased the degradation time to less than 48h at 35 degrees C, although a high concentration of the surfactant (3000mgl(-1)) was required. We suspect that the surfactant increased the degradation rate by solubilizing the n-dodecane into the solution phase in which the microorganisms were suspended. We tested five types of organic polymers as support media for the microorganisms and found that the biodegradation time could be reduced by approximately 50% with a support medium made from polyurethane; in the presence of this medium, only 36h was required for complete decomposition at 35 degrees C. The reduction in the degradation time was probably due to transfer of the n-dodecane from the soil to the support medium, which improved contact between the n-dodecane and the microorganisms. The polyurethane support medium bearing the microorganisms was stable and could be reused.     

Release of phosphorus from lake sediments

The relationship between the content of various forms of phosphorus in lakesediments and the amount of phosphorus released under aerobic and anaerobic conditions was studied. Total phosphorus content in the sediment of Lake Kasumigaura was highest at the 0–5 cm surface layer and decreased with depth. The constant value below 15 cm was consistent with the decrease of iron-bound phosphorus conent (FeP). The amount of phosphorus released from the sediments was proportional to the decrease of FeP under both aerobic and anaerobic conditions. Under anaerobic conditions, 90% of the FeP initially held in the sediments was released in 55 days. Using dialysis apparatus, maximum growth yield of algae was shown to be linearly dependent on the amount of phosphorus released under aerobic conditions.     

Reduction–melting combined with a Na2CO3 flux recycling process for lead recovery from cathode ray tube funnel glass

With large quantity of flux (Na₂CO₃), lead can be recovered from the funnel glass of waste cathode-ray tubes via reduction–melting at 1000 °C. To reduce flux cost, a technique to recover added flux from the generated oxide phase is also important in order to recycle the flux recovered from the reduction–melting process. In this study, the phase separation of sodium and the crystallization of water-soluble sodium silicates were induced after the reduction–melting process to enhance the leachability of sodium in the oxide phase and to extract the sodium from the phase for the recovery of Na₂CO₃ as flux. A reductive atmosphere promoted the phase separation and crystallization, and the leachability of sodium from the oxide phase was enhanced. The optimum temperature and treatment time for increasing the leachability were 700 °C and 2 h, respectively. After treatment, more than 90% of the sodium in the oxide phase was extracted in water. NaHCO₃ can be recovered by carbonization of the solution containing sodium ions using carbon dioxide gas, decomposed to Na₂CO₃ at 50 °C and recycled for use in the reduction–melting process.     

Adsorption capacity of powdered activated carbon for 3,5-dichlorophenol in activated sludge

The objectives of this study were to evaluate the performance of powdered activated carbon treatment (PACT) process based on the adsorption capacity of powdered activated carbon (PAC) in activated sludge and the effect of dissolved organic substances in activated sludge on the adsorption capacity of PAC. The DCP adsorption capacity of three PACs originated from different raw materials (coal, soft coal and sawdust) in activated sludge were 29%, 34% and 17% of that of new PAC, respectively. The performance of PACT process for shock loading of 3,5-dichlorophenol (3,5-DCP) was different among PACs in spite of the same adsorption capacity in new PAC. The performance of PACT process for removal of DCP is dependent not on the adsorption capacity of new PAC but on the adsorption capacity of PAC in the aeration tank. Dissolved organic matter (DOM) with molecular weight smaller than 50kDa did not affect the adsorption capacity of PAC for 3,5-DCP in the activated sludge reactor. DOM with molecular weight larger than 50kDa and biofilm developed on the surface of PAC seemed to be responsible for the decreased adsorption capacity of PAC for the DCP.