Acid generation upon thermal concentration of natural water: The critical water content and the effects of ionic composition

Thermal evaporation of a variety of simulated pore waters from the region of Yucca Mountain, Nevada, produced acidic liquids and gases during the final stages of evaporation. Several simulated pore waters were prepared and then thermally distilled in order to collect and analyze fractions of the evolved vapor. In some cases, distillates collected towards the end of the distillation were highly acidic; in other cases the pH of the distillate remained comparatively unchanged during the course of the distillation. The results suggest that the pH values of the later fractions are determined by the initial composition of the water. Acid production stems from the hydrolysis of magnesium ions, especially at near dryness. Near the end of the distillation, magnesium nitrate and magnesium chloride begin to lose water of hydration, greatly accelerating their thermal decomposition to form acid. Acid formation is promoted further when precipitated calcium carbonate is removed. Specifically, calcium chloride-rich pore waters containing moderate (10–20 ppm) levels of magnesium and nitrate and low levels of bicarbonate produced mixtures of nitric and hydrochloric acid, resulting in a precipitous drop in pH to values of 1 or lower after about 95% of the original volume was distilled. Waters with either low or moderate magnesium content coupled with high levels of bicarbonate produced slightly basic fractions (pH 7–9). If calcium was present in excess of bicarbonate, waters containing moderate levels of magnesium produced acid even in the presence of bicarbonate, due to the precipitation of calcium carbonate. Other salts such as halite and anhydrite promote the segregation of acidic vapors from residual basic solids. The concomitant release of wet acid gas has implications for the integrity of the alloys under consideration for containers at the Yucca Mountain nuclear waste repository. Condensed acid gases at very low pH, especially mixtures of nitric and hydrochloric acid, are capable of corroding even alloys, such as nickel-based Alloy 22, which are considered to be corrosion-resistant under milder conditions.     

Field Evaluation of DRAINMOD 5.1 Under a Cold Climate: Simulation of Daily Midspan Water Table Depths and Drain Outflows1

Abstract: The hydrologic performance of DRAINMOD 5.1 was assessed for the southern Quebec region considering freezing/thawing conditions. A tile drained agricultural field in the Pike River watershed was instrumented to measure tile drainage volumes. The model was calibrated using water table depth and subsurface flow data over a two‐year period, while another two‐year dataset served to validate the model. DRAINMOD 5.1 accurately simulated the timing and magnitude of subsurface drainage events. The model also simulated the pattern of water table fluctuations with a good degree of accuracy. The R² between the observed and simulated daily WTD for calibration was >0.78, and that for validation was 0.93. The corresponding coefficients of efficiency (E) were >0.74 and 0.31. The R² and E values for calibration/validation of subsurface flow were 0.73/0.48 and 0.72/0.40, respectively. DRAINMOD simulated monthly subsurface flow quite accurately (E > 0.82 and R² > 0.84). The model precisely simulated daily/monthly drain flow over the entire year, including the winter months. Thus DRAINMOD 5.1 performed well in simulating the hydrology of a cold region.     

Incorporating organizational factors into probabilistic risk assessment of complex socio-technical systems: Principles and theoretical foundations

The current generation of Probabilistic Risk Analysis (PRA), particularly those for technical systems, does not include an explicit representation of the possible impacts of organization and management on the safety performance of equipment and personnel. There are a number of technical challenges in developing a predictive model of organizational safety performance. There is a need for a widely accepted and theoretically sound set of principles on which models of organizational influences could be developed and validated. As a result of a multidisciplinary effort, this paper explores the feasibility of developing such principles and proposes a set of principles for organizational safety risk analysis. Then, as a realization of the proposed modeling principles, a safety risk framework, named Socio-Technical Risk Analysis (SoTeRiA), is developed. SoTeRiA formally integrates the technical system risk models with the social (safety culture and safety climate) and structural (safety practices) aspects of safety prediction models, and provides a theoretical basis for the integration. A systematic view of safety culture and safety climate leaves an important gap in modeling complex system safety risk, and SoTeRiA, describing the relationship between these two concepts, bridges this gap. The framework explicitly recognizes the relationship among constructs at multiple levels of analysis, and extends the PRA framework to include the effects of organizational factors in a more comprehensive and defensible way.     

Design,measurement and evaluation of photovoltaic pumping system for rural areas in Oman

In the present paper, the optimum design of a PV system used to operate a water pumping system was determined for Oman. The system design focused on the environmental conditions of Sohar city. The implementation and measurement of the designed system are presented to prove the effectiveness of the proposed system. The results show that the system can provide the required power at peak hours, leading to a substantial reduction in the sizing of the PV system. Consequently, the investment capital costs 2400 USD, and the cost of energy is equal to 0.309 USD/kWh. Furthermore, the results indicate that the system annual yield factor is 2024.66 kWh/kWp and that the capacity factor is 23.05 %, which is encouraging since the latter is typically 21 %. The system capital cost and the cost of energy are worth comparing to a diesel generator. A comparison is made between the proposed system and several others in the literature. The comparison indicated that the system cost of energy is promising.     

Proposing of new building scheme and composite towards global warming mitigation for Malaysia

The building sector has been regarded as a potential sector where there is large capacity to reduce the climate change effect. This study has proposed solutions to mitigate environmental impacts and achieve low CO₂ emission from residential sector. Therefore, full life cycle assessment (LCA) has been run to assess the CO₂ emission and its effect on the atmosphere and climate change. Based on the result, timber scheme is the best choice due to releasing less CO₂ emissions to the atmosphere. However, house builders in Malaysia have almost completely neglected timber as a building material, with timber use as building components reduced to 5%. In this study, LCA Software was used to assess CO₂ emissions from different wall construction. The alternative building scheme has been made by reinforce steel stud, wooden beam and timber wall (S8) to improve the scheme deficiency while releasing less CO₂ emissions compared to other schemes. Therefore, S8 has a decreased CO₂ effect by 85% less than precast concrete frame and 90% less than brick over their lifetime. (S8) increased the load bearing compared to conventional timber beam. Thus, new scheme S8 could be replaced by current scheme and promote more adjustable scheme for Malaysian housing.     

Proximate composition and mineral contents in the body wall of two species of sea cucumber from Oman Sea

The proximate composition and mineral contents of Stichopus horrens and Holothuria arenicola from Chabahar Bay were analyzed and investigated. During the present study, we aimed to demonstrate the nutritive value. The approximate percent composition of moisture, protein, fat, and ash were 92.8, 3.47, 0.4, and 3.33% in S. horrens and 93, 4.4, 0.6, and 2% in H. arenicola, respectively. Atomic absorption spectrophotometry of the ashes indicated the body wall of two species of sea cucumbers contained higher amounts of both macro minerals (92.5 mg/100 g Mg in S. horrens and 115 mg/100 g Mg in H. arenicola; 106.25 mg/100 g Ca in S. horrens and 83.25 mg/100 g Ca in H. arenicola) and trace elements (521.781 mg/100 g Fe in S. horrens; 60.354 mg/100 g Fe in H. arenicola, and 0.096 mg/100 g Zn in S. horrens; 0.04 mg/100 g Zn in H. arenicola). For both species, there were high content of protein and essential mineral. Also, they have low content of fat in the body wall of two species in the experiment.     

Model and algorithm for bi-fuel vehicle routing problem to reduce GHG emissions

Because of the harmful effects of greenhouse gas (GHG) emitted by petroleum-based fuels, the adoption of alternative green fuels such as biodiesel and compressed natural gas (CNG) is an inevitable trend in the transportation sector. However, the transition to alternative fuel vehicle (AFV) fleets is not easy and, particularly at the beginning of the transition period, drivers may be forced to travel long distances to reach alternative fueling stations (AFSs). In this paper, the utilization of bi-fuel vehicles is proposed as an operational approach. We present a mathematical model to address vehicle routing problem (VRP) with bi-fuel vehicles and show that the utilization of bi-fuel vehicles can lead to a significant reduction in GHG emissions. Moreover, a simulated annealing algorithm is adopted to solve large instances of this problem. The performance of the proposed algorithm is evaluated on some random instances.     

Microwave irradiation and citric acid assisted seed germination and phytoextraction of nickel (Ni) by <Emphasis Type="Italic">Brassica napus</Emphasis> L.: morpho-physiological and biochemical alterations under Ni stress

The complex bio-geochemistry of soil allows pollutant to persist for a longer period of time which further decreased the fertility and natural composition of land. Nickel, an inorganic pollutant, coming from a wide range of industrial and manufacturing units possesses serious threat to soil degradation and crop productivity around the world. The present study was carried to evaluate the combined role of microwave irradiation (MR) and citric acid (CA) on the phytoextraction potential of Brassica napus L. under Ni stress. An initial seed germination test was conducted to select effective time scale of MR exposure. Highest seed germination was observed at exposure of 2.45 GHz frequency for 30 s. Healthy seeds of B. napus L. genotype Faisal Canola (RBN-03060) treated with MR at 2.45 GHz for 30 s were sown in plastic pots filled with 5 kg of soil. Nickel and CA applied exogenously in solution form with different combinations to both MR-treated and untreated B. napus plants. The MR-treated plants showed higher growth, biomass, photosynthetic pigments (Chl a, b, total, and carotenoids) and activities of antioxidant enzymes (SOD, POD, APX, CAT) as compared to untreated plants who showed higher reactive oxygen species (MDA, H₂O₂) and electrolyte leakage. Increasing Ni concentration significantly decreased the physiological and biochemical attributes of B. napus both in MR-treated and untreated plants. The addition of CA alleviated Ni-induced toxic effects in both MR-treated and untreated plants by improving antioxidant defense system. The degree of Ni stress mitigation was higher in MR-treated plants. The Ni concentration was higher in root, stem, and leaves of MR-treated plants under CA application as compared to untreated plants. The present study concluded that seeds treated with MR before sowing showed higher accumulation and concentration of Ni from soil, and this phenomenon boosted with the application of CA.     

Morphological,physiological and biochemical responses of two Australian biotypes of Parthenium hysterophorus to different soil moisture regimes

Parthenium weed is a problematic invasive species in several countries around the world. Although it is considered to be a highly invasive species within Australia, not all biotypes of parthenium weed exhibit the same ability in regard to aggressive colonization and distribution. Differences among biotypes, particularly in regard to environmental ranges as a possible basis for this variation, have not always been elucidated. To determine whether drought tolerance could be a factor in biotype demographics, we quantified the biological responses of two Australian parthenium weed biotypes known to differ in invasive ability Clermont (“high”) and Toogoolawah (“low”) to 100, 75 and 50% of soil water holding capacity (WHC). The Clermont biotype had greater vegetative growth, seed production and chlorophyll content than Toogoolawah, across all moisture levels. Net photosynthesis, stomatal conductance, internal CO₂ concentration, seed production per plant, 1000 seed weight and subsequent germination percentage were also higher for Clermont than for Toogoolawah and were maximum at 75% WHC. Clermont plants also had higher total soluble sugar, phenolics and free proline content than Toogoolawah, and a significant increase in the levels of all of these biochemicals was observed at 50% WHC. In conclusion, Clermont grew and reproduced better than Toogoolawah across all moisture regimes consistent of enhanced invasive ability of this biotype. Overall, the ability of parthenium weed to maintain good growth, physiology and seed production under moisture stress may enable it to colonize a wide range of Australian environments.

     

Phyto-management of Cr-contaminated soils by sunflower hybrids: physiological and biochemical response and metal extractability under Cr stress

Environmental Science and Pollution Research - Chromium (Cr) is a biologically non-essential, carcinogenic and toxic heavy metal. The cultivation of Cr-tolerant genotypes seems the most favorable...