Atrazine sorption and fate in a Ultisol from humid tropical Brazil

This study combined laboratory based microcosm systems as well as field experiments to evaluate the mobility of atrazine on a Ultisol under humid tropical conditions in Brazil. Results from sorption experiments fit to the Freundlich isotherm model [K(f) 0.99 mg kg(-1)/(mg l(-1))(1/n)], and indicate a low sorption capacity for atrazine in this soil and consequently large potential for movement by leaching and runoff. Microcosm systems using (14)C-atrazine to trace the fate of the applied herbicide, showed that 0.33% of the atrazine was volatilized, 0.25% mineralized and 6.89% was recorded in the leachate. After 60 d in the microcosms, 75% of the (14)C remained in the upper 5 cm soil layer indicating atrazine or its metabolites remained close to the soil surface. In field experiments, after 60 d, only 5% of the atrazine applied was recovered in the upper soil layers. In the field experiments atrazine was detected at a depth of 50 cm indicating leaching. Simulating tropical rain in field experiments resulted in 2.1% loss of atrazine in runoff of which 0.5% was adsorbed onto transported soil particles and 1.6% was in solution. Atrazine runoff was greatest two days after herbicide application and decreased 10 fold after 15 d. The use of atrazine on Ultisols, in the humid tropics, constitutes a threat to water quality, causing surface water and ground water pollution.     

Reusing fly ash in glass fibre reinforced cement: a new generation of high-quality GRC composites

New composite materials based on an alkali-resistant glass-fibre reinforced cement (AR-GRC) system are being developed by using fly ash (FA) produced at coal thermoelectric power plants, and fluid catalytic cracking catalyst residue (FC3R) from the petrol industry as cement replacement materials. These wastes are reactive from the pozzolanic viewpoint, and modify the nature and the microstructure of the cement matrix when a part of the Portland cement is replaced in the formulation of GRC. Several microstructural and mechanical aspects are being studied for AR-GRC systems. The behaviour of composites exposed to ageing shows that the pozzolanic activity of the ground FA added in high amounts and its mixture with the FC3R increase the flexural strength and no evidences of strength decay are observed. Additionally, the fibres due to the high alkalinity of the cementing matrix can be deteriorated. Fibres in the control (only Portland cement) and FC3R containing composites were attacked, whereas composites with FA and their mixture with FC3R show that the fibres have not been attacked, due to the pozzolanic activity of replacing materials that reduce the calcium hydroxide content in the cementing matrix.     

Assessing dimethoate contamination in temperate and tropical climates: potential use of biomarkers in bioassays with two chironomid species

This study was conducted to investigate the potential use of biomarkers in bioassays with chironomids to assess contamination by pesticides in temperate and tropical climates. Two species of midge were studied, the widespread Chironomus riparius and the tropical Kiefferulus calligaster (Kieffer, 1911). Preliminary studies included investigations of the effects of temperature on larval development and the influence of larval age on normal variability of cholinesterase (ChE) and glutathione S-transferase (GST) activities and protein content. In the second phase, the influence of two abiotic factors particularly important in tropical conditions (temperature and oxygen concentration) and of the organophosphorous (OP) insecticide dimethoate on biochemical and conventional endpoints was investigated. Results showed that K. calligaster is morphologically and physiologically similar to C. riparius and for both, the time of larval development decreases with the increase of temperature. Moreover, 3rd and 4th instars appeared to be the most suitable for biomarkers determinations. ChE activity seems to be valuable biomarker regarding temperature and dissolved oxygen (DO) variations, while some caution should be taken when using GST as an environmental biomarker, since it shows some dependence of these parameters. C. riparius was more sensitive to dimethoate than K. calligaster suggesting that the use of bioassays with the former species in tropical conditions may overestimate the toxicity of OP pesticides to autochthonous species. When testing sub-lethal effects of dimethoate to C. riparius, ChE activity showed to be a very sensitive parameter detecting significant effects at the lowest concentration that caused emergence delay of larvae, suggesting that it is an ecologically relevant parameter.     

Changes in hematological and serum biochemical values in jundiá Rhamdia quelen due to sub-lethal toxicity of cypermethrin

Jundiá (Rhamdia quelen, Quoy and Gaimard), a South American teleostean fish, was exposed to sub-lethal concentrations of cypermethrin (30% and 45% of the 48-h LC(50) value of 0.265 ppm) for 2, 4 or 8 days. Serum biochemical and hematological values and behavioral changes were studied. The 30% LC(50), 0.08 ppm, produced significant increases in Mg(2+), P, K(+), creatinine, urea, glucose, cholesterol, aspartate aminotransferase and alkaline phosphatase levels, and reduction in total proteins and triglycerides in serum. The 45% LC(50), 0.12 ppm, produced significant increase in Na(+), Mg(2+), P, K(+), creatinine, urea, glucose, cholesterol, and alkaline phosphatase, and reduction in triglycerides and alanine aminotransferase levels in serum. At this concentration, the fish showed behavior changes such as hyper-excitability, asphyxia, and widening of mouth and operculum. The hematological values remained normal, except for hemoglobin concentrations and the mean corpuscular hemoglobin concentration, which increased with exposure to 0.08 ppm and 0.12 ppm cypermethrin. Results of the present work show that biochemical analysis of serum can be useful to detect incipient cypermethrin intoxication of the shoal.     

Modelling of PCDD/F release from MSW bio-drying

In the present work, an experimentation was carried out to study the behaviour of PCDD/F during the process of municipal solid waste (MSW) bio-drying. This process belongs to the biological mechanical treatment (BMT) options and is aimed to the dewatering of MSW thanks to the biological exothermal reactions (thermal drying, on the contrary, needs an external heat source as methane). The result is a decrease of waste weight and an increase of lower heating value (as the energy content refers to a lower amount of waste). Of course, the overall energy availability does not increase, but the characteristics of bio-drying are interesting as a way for refuse derived fuel generation: glass, metals and inert removals are easier after bio-drying. The literature of the sector shows only few data on PCDD/F emission to air from BMT. Anyway, in the present work an original theory has been put forward in order to explain the enrichment of PCDD/F in the air exiting the biological processes. The role of the initial PCDD/F concentration in the ambient air entering the plant is obviously taken into account. The results of the developed experimentation and the following elaborations point out that PCDD/F could be freed from the volatile solids consumed during the process. The different amount of PCDD/F in the waste and the different consumption of volatile solids depending on the biological process can explain the different PCDD/F emission factors available in the literature.     

Kinetic and adsorption study of acid dye removal using activated carbon

The adsorption of three acid dyes, Acid Red 97, Acid Orange 61 and Acid Brown 425 onto activated carbon was studied for the removal of acid dyes from aqueous solutions at room temperature (25 degrees C). The adsorption of each dye with respect to contact time was then measured to provide information about the adsorption characteristics of activated carbon. The rates of adsorption were found to conform to the pseudo-second-order kinetics with a good correlation. The experimental isotherms obtained, except for Acid Orange 61 studied in mixture, were of the S-type in terms of the classification of Giles and co-workers. The best fit of the adsorption isotherm data was obtained using the Freundlich model. When a comparative study was made of the results obtained with single and mixed dyes, it can be seen that some of them affect others and modify their behavior in the adsorption process. The results indicate that activated carbon could be employed for the removal of dyes from wastewater.     

Gas chromatographic methods for monitoring of wastewater chlorophenol degradation in anaerobic reactors

Wastewater samples from an anaerobic reactor were extracted with hexane and derivatized with diazomethane (method 1) and with acetic anidride (method 2). Gas chromatography with electron-capture detection (ECD) was employed for separating the parent compound and intermediates trichlorophenols (TCP) and dichlorophenols (DCP) which originated from the penta chlorophenol (PCP) degradation process. The relations between concentrations of PCP, TCP and DCP areas were linear in the range of concentrations of 0.2 to 8 mg/L and 0.025 mg/L to 5 mg/L for methods 1 and 2, respectively. The repeatability of the extraction methods was satisfactory, with variation coefficients lower than 11%. For method 1, at the fortification level of 0.2 mg/L, recovery of PCP, TCP, and DCP was 112%, 74% and 45%, respectively. For method 2, the corresponding recovery values at the fortification level of 0.1 mg/L were 91%, 93% and 103%, respectively. Storage of the frozen samples did not alter their PCP determination properties. The chromatographic methods adapted for chlorophenol determination in wastewater were suitable with relatively simple manipulation techniques. The obtained results were reproducible and allowed identification of intermediates formed during the PCP degradation process.     

Anaerobic degradation of nonylphenol in soil

This study investigated the effects of various factors on the anaerobic degradation of nonylphenol (NP) in soil. The results show that the optimal pH for NP degradation was 7.0 and that the degradation rate was enhanced when the temperature was increased. The addition of compost enhanced NP degradation. The individual addition of the electron donors lactate, acetate, and pyruvate inhibited NP degradation. The high-to-low order of NP degradation rates under three anaerobic conditions was sulfate-reducing conditions > methanogenic conditions > nitrate-reducing conditions. The results show that sulfate-reducing bacteria, methanogen, and eubacteria are involved in the anaerobic degradation of NP, with sulfate-reducing bacteria being a major component of the soil. Of the anaerobic strains isolated from the soil samples, strain AT3 expressed the best ability to biodegrade NP.     

The Distribution and Sources of Polycyclic Aromatic Hydrocarbons in Surface Sediments Along the Egyptian Mediterranean Coast

Coastal marine sediment samples were collected from 31 sampling stations along the Egyptian Mediterranean Sea coast. All sediment samples were analyzed to determine aliphatic and polycyclic aromatic hydrocarbons (PAHs) as well as total organic carbon (TOC) contents and grain size analysis. Total concentrations of 16 EPA-PAHs in the sediments were varied from 88 to 6338 ng g⁻¹ with an average value of 154 ng g⁻¹ (dry weight). However, the concentrations of total aliphatic were varied from 1.3 to 69.9 ng g⁻¹ with an average value of 15.6 ng g⁻¹ (dry weight). The highest contents of PAHs were found in the Eastern harbor (6338 ng g⁻¹), Manzala (5206 ng g⁻¹) and El-Jamil East (4895 ng g⁻¹) locations. Good correlations observed between a certain numbers of PAH concentrations allowed to identify its origin. The average total organic carbon (TOC) percent was varied from 0.91 to 4.54%. Higher concentration of total pyrolytic hydrocarbons (∑COMB) than total fossil hydrocarbons (∑PHE) declared that atmospheric fall-out is the significant source of PAHs to marine sediments of the Egyptian Mediterranean coast. The selected marked compounds, a principal component analysis (PCA) and special PAHs compound ratios (phenanthrene/anthracene vs fluoranthene/pyrene; ∑COMB/∑EPA-PAHs) suggest the pyrogenic origins, especially traffic exhausts, are the dominant sources of PAHs in most locations. Interferences of rather petrogenic and pyrolytic PAH contaminations were noticed in the harbors due to petroleum products deliveries and fuel combustion emissions from the ships staying alongside the quays.     

Biosurfactant technology for remediation of cadmium and lead contaminated soils

This research focuses on column experiments conducted to evaluate the potential of environmentally compatible rhamnolipid biosurfactant produced by Pseudomonas aeruginosa strain BS2 to remove heavy metals (Cd and Pb) from artificially contaminated soil. Results have shown that di-rhamnolipid removes not only the leachable or available fraction of Cd and Pb but also the bound metals as compared to tap water which removed the mobile fraction only. Washing of contaminated soil with tap water revealed that approximately 2.7% of Cd and 9.8% of Pb in contaminated soil was in freely available or weakly bound forms whereas washing with rhamnolipid removed 92% of Cd and 88% of Pb after 36 h of leaching. This indicated that di-rhamnolipid selectively favours mobilization of metals in the order of Cd>Pb. Biosurfactant specificity observed towards specific metal will help in preferential elution of specific contaminant using di-rhamnolipid. It was further observed that pH of the leachates collected from heavy metal contaminated soil column treated with di-rhamnolipid solution was low (6.60-6.78) as compared to that of leachates from heavy metal contaminated soil column treated with tap water (pH 6.90-7.25), which showed high dissolution of metal species from the contaminated soil and effective leaching of metals with treatment with biosurfactant. The microbial population of the contaminated soil was increased after removal of metals by biosurfactant indicating the decrease of toxicity of metals to soil microflora. This study shows that biosurfactant technology can be an effective and nondestructive method for bioremediation of cadmium and lead contaminated soil.