浓盐水处理技术研究进展

海水淡化技术是解决中国水资源危机的一种具有根本性的举措之一.然而随着海水淡化产业规模的增大,其产生的浓盐水的排放成了本身面临解决的问题之一.本文阐述了浓盐水的特性及其对环境的各种危害性,并对浓盐水直接排放问题进行了详细分析.介绍了国内外近年来主要处理浓盐水的方法-真空膜蒸馏浓缩技术、正渗透技术、喷雾蒸发技术、冷冻法浓缩技术.对各种处理技术的原理和特点进行了详细综述,并对其研究进展进行了归纳总结.最后对各项处理技术的应用前景提出了展望.     

智能化系统在自燃温度测试中的设计和应用

为降低液体自燃温度测试过程中的操作危险,准确判定自燃现象发生及温度,减少繁琐的手工操作,参照ASTME659—78（2005）、GB/T21791-2008及GB／T21860-2008标准,设计了一套智能自燃温度测试系统。采用操作微机软件控制炉体升降温、自动进样泵进样、温度采集、自燃现象拍摄、尾气抽滤等过程,实现自燃温度测试从开始进样到吹扫尾气全流程的自动化;利用设计系统测试乙醇、丙酮等5种常见物质的自燃温度,测试结果与文献值的相对标准偏差不超过2．0％。结果表明所设计系统操作方便快捷、安全实用、结果准确。     

气相色谱法测定废水中6种挥发性脂肪酸含量

挥发性脂肪酸(VFA)是厌氧消化过程的重要中间产物,在反应器运行中,出水VFA用作重要的控制指标。通过色谱条件探索将各种脂肪酸分离,同时研究了水样酸碱度,吸附等对测定的影响,进一步优化了废水中挥发性脂肪酸的测定。方法的检出限在0.99~1.77 mg/L,回收率在90.9%~102.7%之间,相对标准差(n=5)在1.3%~3.8%之间。     

地球化学定量预测法在武夷成矿带铜资源潜力评价中的应用

利用地球化学定量预测理论方法技术,建立了武夷成矿带紫金山铜金矿等7个典型矿床的地质-地球化学找矿模型,圈定了54处AB级预测区,并利用地球化学定量预测法分别估算了每类预测区的铜资源量,为科学评估武夷成矿带的铜矿资源潜力和该成矿带地质矿产勘察工作部署提供地球化学依据。     

基于生产工艺的水泥工业项目竣工环保验收监测重点分析研究

基于水泥工业的生产工艺特点,说明新型干法生产时代,水泥生产的主要产污环节及特征污染物,并分析其对生态环境的影响和危害,表明该行业属高能耗、高污染的产能过剩行业.根据建设项目竣工环境保护验收规范要求和工作实践经验,结合生产工艺、特征污染物和污染物总量控制等要求,从废水监测、废气监测、噪声监测等方面阐明水泥行业项目竣工环保验收的侧重点和注意事项,并指出污染防治设施、总量控制等几方面应重点关注的问题.     

污染影响型土壤环境影响评价过程中预测和评价方法

随着国民经济的持续发展,建设项目开发过程中可能造成土壤本身或与之相关的环境要素之间在物质、能量转移循环过程中受到不同程度的影响。以《环境影响评价技术导则土壤环境》(HJ 964-2018)为依据,对污染型土壤环境进行环境影响评价,为建设项目土壤环境保护提供科学依据。     

Transformation of hazardous lead into aluminosilicate ceramics: structure evolution and lead leaching

This study investigated crystallization mechanisms for the formation of lead aluminosilicate by sintering lead stabilization with kaolin-based precursors. PbAl2Si2O8 was found to be the only stable lead aluminosilicate in low-PbO system and demonstrates its highly intrinsic resistance to acid attack in leaching test. A three-stage PbAl2Si2O8 formation mechanism was supported by the results of the changing temperature in the system. Amorphization of sintered products was observed in both PbO/kaolinite and PbO/mullite systems at 600–700°C. When the temperature was increased to 750–900°C, the crystallochemical formation of lead aluminosilicates (i.e., Pb4Al4Si3O16, Pb6Al6Si2O21, and PbAl2Si2O8) was observed. Pb4Al4Si3O16 and Pb6Al6Si2O21 were found to be the intermediate phases at 700–900°C. Finally, PbAl2Si2O8 was found to be the only crystallite phase to host Pb at above 950°C. A maximum of 80% and 96.7% Pb can be incorporated into PbAl2Si2O8 in PbO/kaolinite and PbO/mullite systems, respectively, but the final products exhibited different microstructures. To reduce environmental hazard of lead, this strategy demonstrated a preferred mechanism of immobilizing lead into PbAl2Si2O8 structure via kaolin-based precursors.     

The dynamic changes of arsenic biotransformation and bioaccumulation in muscle of freshwater food fish crucian carp during chronic dietborne exposure

Dietary uptake is the major way that inorganic arsenic (iAs) enters into benthic fish; however, the metabolic process of dietborne iAs in fish muscle following chronic exposure remains unclear. This was a 40-day study on chronic dietborne iAs [arsenite (AsIII) and arsenate (AsV)] exposure in the benthic freshwater food fish, the crucian carp (Carassius auratus), which determined the temporal profiles of iAs metabolism and toxicokinetics during exposure. We found that an adaptive response occurred in the fish body after iAs dietary exposure, which was associated with decreased As accumulation and increased As transformation into a non-toxic As form (arsenobetaine). The bioavailability of dietary AsIII was lower than that of AsV, probably because AsIII has a lower ability to pass through fish tissues. Dietary AsV exhibited a high potential for transformation into AsIII species, which then accumulated in fish muscle. The largely produced AsIII considered more toxic at the earlier stage of AsV exposure should attract sufficient attention to human exposure assessment. Therefore, the pristine As species and exposure duration had significant effects on As bioaccumulation and biotransformation in fish. The behavior determined for dietborne arsenic in food fish is crucial for not only arsenic ecotoxicology but also food safety.     

脱除SO2活性炭的再生方法

分别用溶剂和气体对脱除SO2后失活的活性炭进行了再生。在固定床反应器上考察了再生后活性炭的脱硫性能。实验结果表明：用溶剂再生时,质量分数为60％的HNO3溶液的再生效果最好,活性炭的再生率达到80％以上。用气体再生时,400℃左右时的再生效果最好,活性炭的再生率达到70％以上。再生后活性炭的比表面积和pH是衡量活性炭再生效果的重要参数。在实际脱硫生产中,用H2O对失活活性炭进行反复洗涤再生,是一种经济、实用的方法,活性炭的再生率达60％以上。