清浊分流条件下的混凝-臭氧处理棉针织印染清废水

根据污染源头控制和废水回用的要求,对典型棉针织染整厂的不同生产过程废水排水水质特征进行了统计分析,提出了较实用的废水源头清浊分流方案。在此基础上重点研究了混凝-臭氧组合工艺对清废水处理效果,确定了最优的工艺条件。结果表明,清废水主要为洗水,占废水总量的25%～30%;混凝-臭氧组合工艺的最优工艺条件为：pH为6～9,PAC投加量为48 mg/L,PAM投加量为1.0 mg/L,臭氧接触时间为12 min（臭氧浓度为14.5 mg/L）,这时,清废水COD、色度去除率分别为71%和98%,实践证明,出水水质完全能够满足染整生产。     

TiO2/Ti及其改性处理聚乙二醇模拟废水

采用溶胶-凝胶法制备TiO2/Ti负载体系,并以聚乙二醇2000（PEG-2000）为模拟废水对其光催化性能进行研究。实验表明,TiO2/Ti的最佳负载条件为镀膜层数8层、pH值为3、焙烧温度700℃、焙烧时间2 h,掺杂Fe3＋、Ag＋、La3＋、Pt4＋4种金属离子均可有效提高TiO2/Ti对PEG-2000模拟废水的处理效果,在Ag＋掺杂量为0.3%、焙烧温度800℃时,2.5h反应后的COD去除率达到了79.5%。XRD分析表明,金属离子的加入抑制了TiO2由锐钛矿相向金红石相转化。GC-MS分析表明,PEG-2000的光催化是大分子分解为小分子然后被矿化的过程。     

改性膨胀石墨对含铅废水吸附特性

采用微波法在1 000 W下微波膨胀60 s制备了膨胀石墨,以乙醇为分散剂,采用超声沉淀法制备了纳米氢氧化镁,同时将纳米氢氧化镁负载到膨胀石墨孔隙中,制备出一种新型吸附剂,并采用静态吸附的方法研究了该吸附剂对铅离子的吸附效果,实验证明当改性膨胀石墨的用量为0.035 g,铅溶液的pH=4,铅溶液初始浓度为300 mg/L,吸附温度为25℃时,该吸附剂对铅离子的去除率能达到48%,吸附容量能达到105 mg/g左右。同时该吸附反应能够较好地符合Lang-muir吸附等温式以及二级动力学模型。     

进水水质成分改变引发的污泥粘性膨胀及控制

在研究强化SBR工艺除污性能时,由于可溶性淀粉投加导致进水水质成分发生改变,污泥沉降性能在短时间内迅速恶化,污泥出现大量的粘液。镜检发现,大量指状菌胶团异常增殖且丝状菌的数量也逐渐减少。实验结果表明,系统膨胀属于污泥粘性膨胀。停止可溶性淀粉和提高主反应池的DO浓度,污泥粘性膨胀并未得到恢复,但污泥粘液逐渐消失。粘液消失后,通过模拟前期进水水质成分和缩短泥龄,污泥粘性膨胀得以控制,污泥沉降性能在短时间内恢复。实验还研究了污泥粘性膨胀对污染物去除性能的影响。     

抗压实验法厌氧颗粒污泥机械强度的测定及影响因素分析

通过首先对厌氧颗粒污泥样品进行筛分,然后测定其机械强度,解决了实际操作过程中现有抗压实验法出现的精确度与重现性较差的问题。通过对不同来源厌氧颗粒污泥样品机械强度的测定、对比分析发现,厌氧颗粒污泥的机械强度大小与反应器的规模、反应器所采用水力负荷存在一定的正相关性,且与其主要金属元素（Ca、Fe和Mg）含量的大小存在着密切的关系。     

Oxidation of polycyclic aromatic hydrocarbons by horseradish peroxidase in water containing an organic cosolvent

Polycyclic aromatic hydrocarbons (PAHs) are environmental contaminants that are toxic, mutagenic, and carcinogenic. We investigated the horseradish peroxidase (HRP)-catalyzed oxidation of PAHs in water containing N,N-dimethylformamide. Four PAHs (anthracene, phenanthrene, pyrene, and fluoranthene) were investigated using single-PAH and mixed-PAH systems. The results provide useful information regarding the preferential oxidation of anthracene over other PAHs regardless of the reaction time, enzyme dosage, and hydrogen peroxide concentration. The removal of PAHs was found to be very strongly correlated with the ionization potential (IP), and much greater PAH oxidation was observed at a lower IP. The oxidation of anthracene was specifically pH- and temperature-dependent, with the optimal pH and temperature being 8.0 and 40 °C, respectively. The redox mediators 1-hydroxybenzotriazole and veratryl alcohol promoted the transformation of anthracene by HRP; 9,10-anthraquinone was the main product detected from the anthracene oxidation system. The results of this study not only provide a better understanding of the oxidation of PAHs by utilizing a plant biocatalyst, but also provide a theoretical basis for establishing the HRP-catalyzed treatment of PAH-contaminated wastewater.     

污泥淤砂分离器再分离底流污泥

研究了污泥淤砂分离器对分离原污泥所得的底流污泥进行再分离时,分离分流污泥的性质。实验结果表明,原污泥MLVSS/MLSS为0.372,1次分离后得到的底流污泥MLVSS/MLSS为0.222,2次分离后得到的底流污泥MLVSS/MLSS为0.126,表明通过底流污泥再分离,能够进一步降低底流污泥中生物有机质的含量,提高底流污泥中无机淤砂的含量。同时,原污泥CST为2.85(s·L)/g SS,1次分离后得到的底流污泥CST为0.98(s·L)/g SS,2次分离后得到的底流污泥CST为0.12(s·L)/g SS,表明底流污泥再分离进一步提高了底流污泥的脱水性能,最终得到的底流污泥脱水性能良好。     

Recycling and pollution control of the End of Life Vehicles in China

The quantity of vehicles has increased rapidly in recent years in China; however, the recycling of End of Life Vehicles (ELV) faces several problems and barriers including the collection difficulty and the environmental pollution caused by improper dismantling. In this paper, based on analysis of the basic situation regarding management and recycling of ELV in China, the ELV flow was introduced, and the potential ELV quantity was estimated. The current management regulations and policies were summarized, and dismantling and pollution control technologies for ELV recycling were introduced, too. It was suggested that with the rapid growth of ELV quantities, more regulations will be enacted, and the recycling network will be more effective; the dismantling technology and pollution control measures will be upgraded, and the recycling and remanufacturing industries will be more combined. The government should pay more attention to improve the management and supervision of, and encourage the development of, high level enterprises.     

物化-生物组合工艺处理TNT红水

采用酸析+微电解+混凝沉淀+减压蒸馏+固定化微生物滤池+活性焦吸附组合工艺处理兵器八○五厂(襄樊分部)的TNT红水,出水中的硝基化合物浓度多小于0.8 mg/L,且多次未检出;COD最高值为76 mg/L,平均值为51.6 mg/L;色度为20°;苯胺浓度全部小于1 mg/L,达到了中试方案提出的要求,出水水质指标符合《兵器工业水污染物排放标准火炸药》(GB14470.1-2002)的要求.中试期间设备没有发生堵塞、燃烧等事故,减压蒸馏装置正常稳定运行,证实了减压蒸馏法处理TNT红水的安全可靠性.     

铁炭微电解法降解TAIC废水

TAIC（三烯丙基异氰脲酸酯）作为过氧化物交联或自由基反应交联的助交联剂被广泛应用。由于TAIC性质稳定难于生物降解,采用铁炭微电解法处理TAIC生产废水,并考察了铁炭比、进水pH值、反应时间对处理效果的影响,以及TAIC降解机理和反应动力学过程。结果表明,影响微电解工艺的因素主次关系为：pH>Fe/C质量比>反应时间;在最佳条件进水pH值为5,铁炭质量比为2：1,反应时间为135 min时,COD的去除率达到46%以上,TAIC的去除率达到48%以上。TAIC去除机理研究表明,微电解对TAIC废水的作用主要通过·H的还原和铁离子的絮凝作用,其中·H的还原作用是TAIC降解的主要原因。反应动力学分析表明,铁炭微电解法处理TAIC的降解过程基本符合二级反应动力学规律,通过建立模型并拟合出了TAIC降解的二级反应动力学方程。