Impact of injection system design on ISCO performance with permanganate--mathematical modeling results

In situ chemical oxidation (ISCO) using permanganate (MnO(4)(-)) can be a very effective technique for remediation of soil and groundwater contaminated with chlorinated solvents. However, many ISCO projects are less effective than desired because of poor delivery of the chemical reagents to the treatment zone. In this work, the numerical model RT3D was modified and applied to evaluate the effect of aquifer characteristics and injection system design on contact and treatment efficiency. MnO(4)(-) consumption was simulated assuming the natural oxidant demand (NOD) is composed of a fraction that reacts instantaneously and a fraction that slowly reacts following a 2nd order relationship where NOD consumption rate increases with increasing MnO(4)(-) concentration. MnO(4)(-) consumption by the contaminant was simulated as an instantaneous reaction. Simulation results indicate that the mass of permanganate and volume of water injected has the greatest impact on aquifer contact efficiency and contaminant treatment efficiency. Several small injection events are not expected to increase contact efficiency compared to a single large injection event, and can increase the amount of un-reacted MnO(4)(-) released down-gradient. High groundwater flow velocities can increase the fraction of aquifer contacted. Initial contaminant concentration and contaminant retardation factor have only a minor impact on volume contact efficiency. Aquifer heterogeneity can have both positive and negative impacts on remediation system performance, depending on the injection system design.     

Genetic engineering of cyanobacteria to enhance biohydrogen production from sunlight and water

To mitigate global warming caused by burning fossil fuels, a renewable energy source available in large quantity is urgently required. We are proposing large-scale photobiological H(2) production by mariculture-raised cyanobacteria where the microbes capture part of the huge amount of solar energy received on earth's surface and use water as the source of electrons to reduce protons. The H(2) production system is based on photosynthetic and nitrogenase activities of cyanobacteria, using uptake hydrogenase mutants that can accumulate H(2) for extended periods even in the presence of evolved O(2). This review summarizes our efforts to improve the rate of photobiological H(2) production through genetic engineering. The challenges yet to be overcome to further increase the conversion efficiency of solar energy to H(2) also are discussed.     

PCE dissolution and simultaneous dechlorination by nanoscale zero-valent iron particles in a DNAPL source zone

While the capability of nanoscale zero-valent iron (NZVI) to dechlorinate organic compounds in aqueous solutions has been demonstrated, the ability of NZVI to remove dense non-aqueous phase liquid (DNAPL) from source zones under flow-through conditions similar to a field scale application has not yet been thoroughly investigated. To gain insight on simultaneous DNAPL dissolution and NZVI-mediated dechlorination reactions after direct placement of NZVI into a DNAPL source zone, a combined experimental and modeling study was performed. First, a DNAPL tetrachloroethene (PCE) source zone with emplaced NZVI was built inside a small custom-made flow cell and the effluent PCE and dechlorination byproducts were monitored over time. Second, a model for rate-limited DNAPL dissolution and NZVI-mediated dechlorination of PCE to its three main reaction byproducts with a possibility for partitioning of these byproducts back into the DNAPL was formulated. The coupled processes occurring in the flow cell were simulated and analyzed using a detailed three-dimensional numerical model. It was found that subsurface emplacement of NZVI did not markedly accelerate DNAPL dissolution or the DNAPL mass-depletion rate, when NZVI at a particle concentration of 10g/L was directly emplaced in the DNAPL source zone. To react with NZVI the DNAPL PCE must first dissolve into the groundwater and the rate of dissolution controls the longevity of the DNAPL source. The modeling study further indicated that faster reacting particles would decrease aqueous contaminant concentrations but there is a limit to how much the mass removal rate can be increased by increasing the dechlorination reaction rate. To ensure reduction of aqueous contaminant concentrations, remediation of DNAPL contaminants with NZVI should include emplacement in a capture zone down-gradient of the DNAPL source.     

Toxic effects of deltamethrin and λ-cyhalothrin on Xenopus laevis tadpoles

This study evaluates the toxic effects of deltamethrin and λ-cyhalothrin on Xenopus laevis tadpoles after 168 h of exposure. The LC(50) of deltamethrin and λ-cyhalothrin at 168 h was calculated as the μg of active ingredient per liter (μg AI/L). According to these values, the LC(50) was 6.26 and 3.94 μg AI/L for deltamethrin and λ-cyhalothrin, respectively. Several enzymes were studied for early signs of intoxication following exposure to the pesticides for 24 h. Glutathione-S-transferase,carboxylesterase, and lactate dehydrogenase were inhibited by λ-cyhalothrin, and both pesticides inhibited acid phosphatase and aspartate aminotransferase. In contrast, acetylcholinesterase was activated by deltamethrin. The results suggest that X. laevis is sensitive to the pyrethroids that were tested, and the enzyme responses suggest that they are potential biomarkers for evaluating the toxic effect of pyrethroids on amphibians in environmental conditions.     

Optimization of photo-Fenton process parameters on carbofuran degradation using central composite design

Carbofuran, one of the most toxic and biorefractory carbamate compounds, is widely used in insecticides in Taiwan (9-18% of total insecticides production per year). In the present study, a central composite design experiment was used to study the effect of photo-Fenton treatment on carbofuran solution and to optimize the process variables such as carbofuran concentration (1-100 mg L(-1)), H(2)O(2) dosage rate (0.25-6 mg L(-1) min(-1)) and Fe(3+) dosage (1-50 mg L(-1)), which influenced the efficiency of carbofuran degradation and mineralization. The results indicated that all the variables investigated in this study had significant roles in the degradation and mineralization of carbofuran in solution. The carbofuran degradation and mineralization efficiencies were increased with increase in H(2)O(2) dosage rate and Fe(3+) dosage, and with decrease in carbofuran concentration. Furthermore, optimum values of both H(2)O(2) dosage rate and Fe(3+) dosage were found to shift to higher values as carbofuran concentration increased. Based on the model obtained in this study, optimum H(2)O(2) dosage rate and Fe(3+) dosage were found to be 4 mg L(-1) min(-1) and 20 mg L(-1), respectively, for 51 mg L(-1) of carbofuran concentration. Under these conditions, carbofuran was completely removed within 30 min and coupled with 78% mineralization at the end of experiment.     

Comparison of methods for evaluation of activity of photocatalytic films

Objective

This work aims to investigate the correlation between the photocatalytic activity determined by methylene blue bleaching (DIN 52980), stearic acid degradation, and degradation of acetone in gas phase.

Method

The photocatalytic TiO₂ coatings included in this investigation ranged from thin commercially available coatings (Activ^TM and BioClean^TM) and ready to use suspensions (Nano-X PK1245) to lab-produced PVD and sol?Cgel coatings. XRD analysis of the photocatalytic coatings showed that all the coatings consisted of nanocrystalline anatase, although the thickness and porosity varied considerably.

Results

The study showed that the reproducibility of the activity measurements was good. However, more importantly, the investigation showed that there is a good correlation between the activities determined by the different methods even though the characteristics of the photocatalytic coatings and the organic probe molecules varied considerably.

Conclusion

The overall findings of this work suggest that there is a good correlation between the investigated methods. These results are promising for the future work concerning standardization of methods for determination of the activity of photocatalytic films.     

Climate Change and Population Growth in Timor Leste: Implications for Food Security

The climate in Timor Leste (East Timor) is predicted to become about 1.5 °C warmer and about 10 % wetter on average by 2050. By the same year, the population is expected to triple from 1 to 2.5–3 million. This article maps the predicted changes in temperature and rainfall and reviews the implications of climate change and population growth on agricultural systems. Improved cultivars of maize, rice, cassava, sweet potato and peanuts with high yield performance have been introduced, but these will need to be augmented in the future with better adapted cultivars and new crops, such as food and fodder legumes and new management practices. The requirements for fertilizers to boost yields and terracing and/or contour hedgerows to prevent soil erosion of steeply sloping terrain are discussed. Contour hedges can also be used for fodder for improved animal production to provide protein to reduce malnutrition.     

Histopathological effects of chronic aqueous exposure to bis(tri-n-butyltin)oxide (TBTO) to environmentally relevant concentrations reveal thymus atrophy in European flounder (Platichthys flesus)

Although the use of tributyltin in antifouling paints has been banned, this compound is still a serious pollutant of the marine environment. This paper describes a unique study in which European flounder (Platichthys flesus) were chronically (8 months) exposed to bis(tri-n-butyltin)oxide (TBTO) in the water under controlled laboratory conditions. Residue levels in selected tissues (liver, muscle) and general health status indices were measured and the effects on several organs (gills, liver, mesonephros, ovary/testis, spleen, and gastrointestinal tract) were examined histopathologically. Additionally, morphometric analysis of the thymus was performed. The major finding is that exposure of flounder to 5 μg TBTO/l over a period of 8 months, resulting in body burdens comparable to high field levels, induced significant reduction of thymus volume, possibly affecting immunocompetence of the animals. Chronic exposure of European flounder to tributyltin is therefore likely to affect the general health status of this species in heavily polluted aquatic environments.     

Occurrence and congener specific profiles of polybrominated diphenyl ethers and their hydroxylated and methoxylated derivatives in breast milk from Catalonia

The presence of polybrominated diphenyl ethers (PBDEs) from mono to hepta brominated and 11 hydroxylated (OH-) and methoxylated (MeO-) PBDEs was examined in 37 breast milk samples collected from 11 mothers living in Barcelona. An extraction method based on accelerated solvent extraction followed by gas chromatography coupled to high resolution mass spectrometry was used to inequivocally identify all target compounds at the low pg g(-1) lw level. Data obtained were examined for absolute and relative concentrations and specific PBDE, OH- and MeO-PBDE congener patterns. Sigma PBDE concentration ranged between 1,161 and 1,372,797 pg g(-1) lw and BDEs 47, 99, 100, 153 and 183 accounted for more than 80% of the total PBDEs. All tri and tetra OH- and MeO-PBDEs compounds were detected at levels between 6 and 14,984 pg g(-1)lw. The median ratio OH/PBDE and MeO-PBDEs/PBDEs was from 2.9% to 1.6%, respectively, suggesting either that PBDE metabolism to OH- and MeO- derivatives is not an important degradation route in humans or either OH- and MeO-PBDEs are rapidly excreted. No significant correlation was observed between PBDEs and OH- and MeO-PBDE, although OH- and OMe-PBDEs co-occurred in mothers' milk (R(2)=0.5349). According to the daily intake of PBDEs and OH- and MeO-PBDEs, which was between 0.47 and 363 ng d(-1) (excluding a smoking donor), potential health risks associated with these compounds are assessed.     

Biomass consumption and CO2, CO and main hydrocarbon gas emissions in an Amazonian forest clearing fire

Biomass consumption and CO₂, CO and hydrocarbon gas emissions in an Amazonian forest clearing fire are presented and discussed. The experiment was conducted in the arc of deforestation, near the city of Alta Floresta, state of Mato Grosso, Brazil. The average carbon content of dry biomass was 48% and the estimated average moisture content of fresh biomass was 42% on wet weight basis. The fresh biomass and the amount of carbon on the ground before burning were estimated as 528 t ha^?1 and 147 t ha^?1, respectively. The overall biomass consumption for the experiment was estimated as 23.9%. A series of experiment in the same region resulted in average efficiency of 40% for areas of same size and 50% for larger areas. The lower efficiency obtained in the burn reported here occurred possibly due to rain before the experiment. Excess mixing ratios were measured for CO₂, CO, CH₄, C₂–C₃ aliphatic hydrocarbons, and PM_2.5. Excess mixing ratios of CH₄ and C₂–C₃ hydrocarbons were linearly correlated with those of CO. The average emission factors of CO₂, CO, CH₄, NMHC, and PM_2.5 were 1,599, 111.3, 9.2, 5.6, and 4.8 g kg^?1 of burned dry biomass, respectively. One hectare of burned forest released about 117,000 kg of CO₂, 8100 kg of CO, 675 kg of CH₄, 407 kg of NMHC and 354 kg of PM_2.5.