Environmental Impact Assessment of Polylactide(PLA)/Chicken Feathers Biocomposite Materials

The aim of this study is to analyse the environmental impacts (EIs) of the process of preparation of new biocomposite materials obtained from polylactide (PLA) and chicken feathers (CFs). Two CFs stabilization methods and different percentages of CFs have been studied. The EIs of these new composites were compared to the impact of virgin PLA. Cradle-to-gate life cycle inventories were assessed for 0–35% v/v of CFs in a CFs/PLA biocomposite. Two CFs stabilization processes, autoclave and surfactant, were tested and compared with the aim to prioritize one of them from the environmental point of view. A composite plate of 184?×?184?×?2.2 mm³ was defined as the functional unit. Autoclave stabilization process exhibited lower environmental impact compared with surfactant stabilization process mainly due to both the lower requirements of electricity and water and the reduced pollution loads of the generated wastewater. Thus, the autoclave process was selected as the standard method when comparing the EIs of the proposed CFs/PLA biocomposites. In this sense, the addition of CFs to PLA matrix proportionally reduces all the EIs compared to pure PLA due to the replacement of PLA with CFs. This behaviour can be explained because the PLA production accounts for the 99% of the impact of the biocomposite. Consequently, CFs conveniently stabilized might be an alternative raw material to prepare CFs/PLA biocomposites with less environmental impact compared to pure PLA.     

Baked Foams Based on Cassava Starch Coated with Polyvinyl Alcohol with a Higher Degree of Hydrolysis

The aims of this work were to produce trays based on cassava starch, coated with polyvinyl alcohol (PVA) with a higher degree of hydrolysis (98%), and to study the effects of the coating on the mechanical and water sorption properties of the trays. Two types of PVA were tested: SELVOL? 325 (degree of polymerization?=?1000–1500) and SELVOL? 107 (degree of polymerization?=?350–650). A decrease in the water absorption capacity of 50% was observed when the coated samples were compared with the control sample after 30 min of immersion in water. It was observed in both coated samples a reduction of the initial rate of water adsorption sorption and a decrease in hydrophilicity compared with the control sample. Tensile strength and elongation were increased with application of the coatings. The use of the two types of PVA resulted in materials with similar mechanical and water sorption properties.     

Effect of Cross-Linking Waste Protein with Diepoxides on its Biodegradation under Anaerobic Conditions

Biodegradability testing was performed in an aqueous environment under anaerobic conditions after inoculation with digested sludge from municipal wastewater treatment plant. In cross-linking with 1,2:3,4-diepoxybutane in limits 0.8–9.1% weight, biodegradability degree decreased from 76.8 to 62.2%; when 1,2:7,8 diepoxyoctane in quantities 1.1–13.2% weight was used, biodegradability degree dropped more prominently – from 72.3 to 22.8%. There is obviously a direct connection between growing cross-link degree (assessed by so-called fixation index) and decreasing readiness to biodegradation, apparently owing to build-up of a network forming an obstacle to access of micro-organisms and enzymes.     

Methodology for quantification of waste generated in Spanish railway construction works

In the last years, the European Union (EU) has been focused on the reduction of construction and demolition (C&D) waste. Specifically, in 2006, Spain generated roughly 47million tons of C&D waste, of which only 13.6% was recycled. This situation has lead to the drawing up of many regulations on C&D waste during the past years forcing EU countries to include new measures for waste prevention and recycling. Among these measures, the mandatory obligation to quantify the C&D waste expected to be originated during a construction project is mandated. However, limited data is available on civil engineering projects. Therefore, the aim of this research study is to improve C&D waste management in railway projects, by developing a model for C&D waste quantification. For this purpose, we develop two equations which estimate in advance the amount, both in weight and volume, of the C&D waste likely to be generated in railway construction projects, including the category of C&D waste generated for the entire project.     

Correlation analysis between sulphate content and leaching of sulphates in recycled aggregates from construction and demolition wastes

In some recycled aggregates applications, such as component of new concrete or roads, the total content of soluble sulphates should be measured and controlled. Restrictions are usually motivated by the resistance or stability of the new structure, and in most cases, structural concerns can be remedied by the use of techniques such as sulphur-resistant cements. However, environmental risk assessment from recycling and reuse construction products is often forgotten. The purpose of this study is to analyse the content of soluble sulphate on eleven recycled aggregates and six samples prepared in laboratory by the addition of different gypsum percentages. As points of reference, two natural aggregates were tested. An analysis of the content of the leachable amount of heavy metals regulated by European regulation was included. As a result, the correlation between solubility and leachability data allow suggest a limiting gypsum amount of 4.4% on recycled aggregates. This limit satisfies EU Landfill Directive criteria, which is currently used as reference by public Spanish Government for recycled aggregates in construction works.     

Effect of aeration rate and moisture content on the emissions of selected VOCs during municipal solid waste composting

The influence of the industrial control composting conditions (aeration 0.005–0.300?L_air?kg^?1 and moisture 40–70?%) of municipal solid waste on the composition of the selected compound emitted (limonene, β-pinene, 2-butanone, undecane, phenol, toluene, dimethyl sulfide, dimethyl disulfide) was studied. The highest emissions of volatile organic compounds (VOCs) were observed in the early stages of the processes. At the end of the process, low concentrations of the emitted compounds were found. Aeration rate had a strong effect on emissions. High aeration rate (0.300?L_air?kg^?1?min^?1) caused normally high emissions of all selected compounds whereas low aeration rates (0.05?L_air?kg^?1?min^?1) could cause anaerobiosis problems and generation of organic sulphur compounds. We observed that the effect of the moisture upon the emitted concentrations varied depending on the studied compound.     

Evaluation of landfill leachate treatment by advanced oxidative process by Fenton’s reagent combined with membrane separation system

A high content of refractory organic matter, ammonia and toxic compounds is characteristic of landfill leachate. Advanced oxidative processes (AOPs) are an attractive alternative for landfill leachate treatment. However, when applied as a unique process treatment, they do not provide a complete solution for the effluent treatment. Combining AOP with a membrane separation process (MSP) presents a number of benefits and provides an adequate solution for this problem. With this in mind, the present work aims to evaluate, using a bench scale, leachate treatability through AOP by Fenton’s reagent (AOP/Fenton) combined with microfiltration (MF) and nanofiltration (NF). A high efficient removal of COD (63%), true color (76%) and humic substances (50%) was observed during AOP/Fenton under optimized conditions (1.7 g H₂O₂/g COD_{raw leachate}; FeSO₄·7H₂O:H₂O₂ = 1:5.3; pH = 3.8; reaction conditions = 115 rpm/28 min). According to the evaluated parameters, MSP presented an efficient complementary treatment, in which the integrity of the stages was sufficient for reaching regulatory levels in the effluent (Deliberação Normativa Conjunta COPAM/CERH-MG N^o. 1, May 5, 2008).     

Effect of water washing on the thermal behavior of rice straw

Rice straw can be used as a renewable fuel for heat and power generation. It is a viable mean of replacing fossil fuels and preventing pollution caused by open burning, especially in the areas where this residual biomass is generated. Nevertheless, the thermal conversion of rice straw can cause some operating problems such as slag formation, which negatively affects thermal conversion systems. So, the main objective of this research is studying the combustion behavior of rice straw samples collected from various regions by applying thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC). In addition, the thermal behavior of ashes from rice straw was also analyzed in order to detect their melting points, and ash sintering was detected at different temperatures within the range between 550 and 1000 °C. Since washing rice straw with water could reduce the content of undesirable inorganic compounds related to the ash fusibility, samples of washed rice straw were analyzed under combustion conditions to investigate its differences regarding the thermal behavior of rice straw. The results showed that rice straw washing led to a significant improvement in its thermal behavior, since it reduced the ash contents and sintering formation.     

Valorisation of used cooking oil sludge by codigestion with swine manure

The addition of lipid wastes to the digestion of swine manure was studied as a means of increasing biogas production. Lipid waste was obtained from a biodiesel plant where used cooking oil is the feedstock. Digestion of this co-substrate was proposed as a way of valorising residual streams from the process of biodiesel production and to integrate the digestion process into the biorefinery concept.Batch digestion tests were performed at different co-digesting proportions obtaining as a result an increase in biogas production with the increase in the amount of co-substrate added to the mixture. Semi-continuous digestion was studied at a 7% (w/w) mass fraction of total solids. Co-digestion was successful at a hydraulic retention time (HRT) of 50 d but a decrease to 30 d resulted in a decrease in specific gas production and accumulation of volatile and long chain fatty acids. The CH₄ yield obtained was 326 ± 46 l/kg VS_feed at an HRT of 50 d, while this value was reduced to 274 ± 43 l/kg VS_feed when evaluated at an HRT of 30 d. However these values were higher than the one obtained under batch conditions (266 ± 40 l/kg VS_feed), thus indicating the need of acclimation to the co-substrate. Despite of operating at low organic loading rate (OLR), measurements from respirometry assays of digestate samples (at an HRT of 50 d) suggested that the effluent could not be directly applied to the soil as fertiliser and might have a negative effect over soil or crops.     

Effects of induced paralysis on hemocytes and tissues of the giant lions-paw scallop by paralyzing shellfish poison

In general, bivalves are not affected by exposure to toxic dinoflagellates that produce paralyzing shellfish poisons (PSP). After injection with PSP extracted from the Gymnodinium catenatum, Nodipecten subnodosus is paralyzed, indicating that PSP provokes effects similar to what is observed in vertebrates, including paralysis and metabolic stress. To investigate the processes involved in poisoning by PSP, lions-paw scallops were injected with gonyautoxin (GTX) 2/3 epimers in the adductor muscle. Mild doses provoked adductor muscle contractions and paralysis, mantle retraction, and incapacity of shell closure, but scallops gradually recovered in a clear, dose-time recovery pattern. With high doses of GTX 2/3, scallops were permanently paralyzed, and hemocytes in hemolymph were reduced. Surprisingly, under these conditions, scallops continued normal feeding and did not show any microscopic defect in intestine or gills, but hemocytes infiltrated the adductor muscle and abnormal vitellogenesis and mantle melanization occurred. Paralysis stress was accompanied by negative scallop responses, based on visible effects, generation of nitric oxide, lipid peroxidation, and changes in antioxidant and hydrolytic enzymes in hemocytes and tissues. These data can be used to understand potential side effects of PSP in bivalves.