Evaluation of airborne lead in the welding working environment

Manual and automatic welding machines (which use leaded alloys) are considered to be important sources of the emission of lead fumes into the general air of the working environment. Three workplaces at a television factory were selected for the present study, to determine the control class of the working unit. The concentrations of conventional measurements ("A" sampling points) were lower than the administrative control level (statutory standard of lead, 150 microg m(-3)), whereas the maximum concentration of 264.1 microg m(-3) ("B" sampling point) was higher at one working unit than the administrative control level. However, the control classes varied between class III (bad) and class I (good).     

Performance evaluation of a sorbent tube sampling method using short path thermal desorption for volatile organic compounds

Air sampling, using sorbents, thermal desorption and gas chromatography, is a versatile method for identifying and quantifying trace levels of volatile organic compounds (VOCs). Thermal desorption can provide high sensitivity, appropropriate choices of sorbents and method parameters can accommodate a wide range of compounds and high humidity, and automated short-path systems can minimize artifacts, losses and carry-over effects. This study evaluates the performance of a short-path thermal desorption method for 77 VOCs using laboratory and field tests and a dual sorbent system (Tenax GR, Carbosieve SIII). Laboratory tests showed that the method requirements for ambient air sampling were easily achieved for most compounds, e.g., using the average and standard deviation across target compounds, blank emissions were < or = 0.3 ng per sorbent tube for all target compounds except benzene, toluene and phenol; the method detection limit was 0.05 +/- 0.08 ppb, reproducibility was 12 +/- 6%, linearity, as the relative standard deviation of relative response factors, was 16 +/- 9%, desorption efficiency was 99 +/- 28%, samples stored for 1-6 weeks had recoveries of 87 +/- 9%, and high humidity samples had recoveries of 102 +/- 12%. Due to sorbent, column and detector characteristics, performance was somewhat poorer for phenol groups, ketones, and nitrogen containing compounds. The laboratory results were confirmed in an analysis of replicate samples collected in two field studies that sampled ambient air along roadways and indoor air in a large office building. Replicates collected under field conditions demonstrated good agreement except for very low concentrations or large (> 41 volume) samples of high humidity air. Overall, the method provides excellent performance and satisfactory throughput for many applications.     

Temporal variation in a coral reef community at Pattaya Bay,Gulf of Thailand

Changes in the fringing coral reef community of a small island (Ko Nok) at Pattaya Bay, Gulf of Thailand, were examined at the beginning and at the end of a 3-year period using 7m×7m permanent quadrats for benthic organisms, and visual census along 100m transects for fish. The coral community was dominated by Porites lutea in terms of colony number and areal cover throughout the period. Variations in the community structure parameters on opposite sides of the island indicated increasing dissimilarity with time. Little variation in live coral cover was noted, but colony number and species diversity declined on both sides. The abundance of edible fish species dropped while that of non-edible species increased over the 3-year period, indicating selective removal of the former category through fishing. Impacts from both human and natural influences are implicated in these changes.     

Organochlorine and mercury residues in Swainson's and ferruginous hawk eggs collected in North and South Dakota, 1974–79

Residues of organochlorine pesticides, polychlorinated biphenyls (PCBs), and mercury were measured in eggs of Swainson's hawks (Buteo swainsoni) and ferruginous hawks (B. regalis) collected in North and South Dakota during 1974–79. DDE was the most common compound detected in the eggs, but residues were below levels known to have adverse effects on reproduction. Other organochlorine compounds and mercury were found at low levels. Eggs of ferruginous hawks tended to contain more compounds with higher residues than eggs of Swainson's hawks.     

The characteristics of size distribution of suspended particulates in the air for sulphates and selected metals in different areas and seasons

The characteristics of the distribution of particles by size were investigated for sulphates and selected metals (Pb, Fe, Mn, and Cu) in the air in two urban and an industrial area during the winter and summer periods using an Andersen cascade impactor.In the case of metals, but not sulphates, the character of the area affected the value of mass median diameter. Lowest values were obtained in a sparsely populated urban area, whereas in a densely populated urban area and in the industrial area the values were higher.In the industrial area a high correlation coefficient was found between sulphate and manganese, and between sulphate and lead, as well as a high value of the equivalent Mn²⁺/SO _inf4 ^sup2- ratio for the total sample. It may therefore be assumed that in the industrial area manganese produces a catalytic effect on SO₂ conversion to sulphate. Among the investigated metals lead stands out as a dominant cation which binds to the sulphate ion in the industrial and densely populated areas.     

An evaluation of in situ microcosms for validating aquatic fate and transport models

The fates of two compounds, 2,4 Dichlorophenoxy Acetic Acid Butoxyethyl Ester (2,4-DBEE) and 1,4 Dichlorobenzene (1,4-DCB), were examined in in situ microcosms placed in a pond and compared with the fates in the pond itself. Results also were compared with predictions of an aquatic fate and transport model (EXAMS). Decay rates of 2,4-DBEE were not significantly different among the microcosms, pond and model predictions. The decay rate of 1,4-DCB in the microcosms was significantly lower than the rate for the pond, and lower than the rate predicted by the model. The low volatility of 1,4-DCB in the microcosms is attributed primarily to lack of water surface turbulence in the microcosms.     

Population monitoring for genetic damage induced by environmental physical and chemical agents

The short-term tests performed in vitro on different systems, from phage to human cells, or in vivo, on laboratory animals, allow only a qualitative estimate of the action of mutagenic agents, and the extrapolation of such experimental results to man may encounter many difficulties.Direct biomonitoring of populations exposed to chemicals could represent a more realistic approach for an evaluation of the hazards to man. Certain methods are still under development. Nevertheless, other ones can already by used routinely, e.g. the cytogenetic observations on peripheral blood lymphocytes and the Ames test for mutagenic substances in urine, and can provide useful suggestions how to set threshold limits for chemical substances encountered in the working environment.     

Changes in levels of organochlorines in woodcock wings from 1971 to 1975

Wings from woodcock (Philohela minor) were first monitored for organochlorine pesticides and polychlorinated biphenyls (PCBs) in the eastern U.S. in 1971. Regional differences in these compounds were clearly demonstrated and baseline residue levels were obtained for later comparisons. An expanded sampling of wings in 1972 revealed that residues in wings of adult woodcock may differ significantly from those in immatures, and that residues of several important agricultural insecticides and PCBs had declined significantly. More extensive sampling was undertaken in 1975 to determine if changes in residue levels had taken place in the intervening years. PCBs, mirex, and heptachlor epoxide increased significantly between 1972 and 1975 in adult woodcock wings. In immature woodcock wings mirex, dieldrin, and PCBs increased significantly between 1972 and 1975, but DDT residues decreased significantly.     

Second derivative spectroscopy for the determination of volatilized ammonia from urea-amended soil

A second derivative spectrometer custom fitted with a 1 m stainless steel White cell and maintained at 105°C is used to make real-time measurements of volatilized NH₃ from urea-amended soil. Comparison of the technique to impinger data shows a 5–16% discrepancy between the two techniques; however, other experiments presented suggests that this is not real. Sulfur dioxide and nitrous oxide interferences are discussed, though they were not found to be present in this study. Instrument response time is shown to be fast if 67% of the total response is achieved in less than 5 min. Fast response is achieved for ammonia if wall-adsorption effects are minimal and if ammonia mass flow is maintained at 0.2 μg min^-1.