Indoor and outdoor formaldehyde concentrations in homes in residential areas in Greater Cairo

Indoor and outdoor measurements of formaldehyde were conducted at seven flats located in residential areas in Greater Cairo, during spring and summer seasons 1999. The mean daytime formaldehyde concentrations in kitchens, bedrooms and living rooms were 89, 100 and 100 ppb, respectively, in the seven flats. Significant positive correlations were found between the concentrations of formaldehyde found in these three rooms. On the other hand, no significant differences were found between the mean formaldehyde concentrations in these three rooms. The maximum mean concentration of formaldehyde (147 ppb) was recorded in a new flat, while the minimum concentration (43 ppb) was observed in an old flat. The maximum hourly and daytime concentrations were 350 and 225 ppb, respectively. Air temperature, relative humidity and the age of the flat are factors affecting the emission and concentration of formaldehyde. The maximum indoor and outdoor formaldehyde concentrations were recorded during the summer season. During the spring, 38% of the samples indicated that the concentration of formaldehyde in the seven flats exceeded 0.1 ppm, the American Society of Heating, Refrigerating, and Air Conditioning Engineers' (ASHRAE) standard; in the summer, this figure increased to 53%.     

Performance evaluation of a sorbent tube sampling method using short path thermal desorption for volatile organic compounds

Air sampling, using sorbents, thermal desorption and gas chromatography, is a versatile method for identifying and quantifying trace levels of volatile organic compounds (VOCs). Thermal desorption can provide high sensitivity, appropropriate choices of sorbents and method parameters can accommodate a wide range of compounds and high humidity, and automated short-path systems can minimize artifacts, losses and carry-over effects. This study evaluates the performance of a short-path thermal desorption method for 77 VOCs using laboratory and field tests and a dual sorbent system (Tenax GR, Carbosieve SIII). Laboratory tests showed that the method requirements for ambient air sampling were easily achieved for most compounds, e.g., using the average and standard deviation across target compounds, blank emissions were < or = 0.3 ng per sorbent tube for all target compounds except benzene, toluene and phenol; the method detection limit was 0.05 +/- 0.08 ppb, reproducibility was 12 +/- 6%, linearity, as the relative standard deviation of relative response factors, was 16 +/- 9%, desorption efficiency was 99 +/- 28%, samples stored for 1-6 weeks had recoveries of 87 +/- 9%, and high humidity samples had recoveries of 102 +/- 12%. Due to sorbent, column and detector characteristics, performance was somewhat poorer for phenol groups, ketones, and nitrogen containing compounds. The laboratory results were confirmed in an analysis of replicate samples collected in two field studies that sampled ambient air along roadways and indoor air in a large office building. Replicates collected under field conditions demonstrated good agreement except for very low concentrations or large (> 41 volume) samples of high humidity air. Overall, the method provides excellent performance and satisfactory throughput for many applications.     

Temporal variation in a coral reef community at Pattaya Bay,Gulf of Thailand

Changes in the fringing coral reef community of a small island (Ko Nok) at Pattaya Bay, Gulf of Thailand, were examined at the beginning and at the end of a 3-year period using 7m×7m permanent quadrats for benthic organisms, and visual census along 100m transects for fish. The coral community was dominated by Porites lutea in terms of colony number and areal cover throughout the period. Variations in the community structure parameters on opposite sides of the island indicated increasing dissimilarity with time. Little variation in live coral cover was noted, but colony number and species diversity declined on both sides. The abundance of edible fish species dropped while that of non-edible species increased over the 3-year period, indicating selective removal of the former category through fishing. Impacts from both human and natural influences are implicated in these changes.     

Organochlorine and mercury residues in Swainson's and ferruginous hawk eggs collected in North and South Dakota, 1974–79

Residues of organochlorine pesticides, polychlorinated biphenyls (PCBs), and mercury were measured in eggs of Swainson's hawks (Buteo swainsoni) and ferruginous hawks (B. regalis) collected in North and South Dakota during 1974–79. DDE was the most common compound detected in the eggs, but residues were below levels known to have adverse effects on reproduction. Other organochlorine compounds and mercury were found at low levels. Eggs of ferruginous hawks tended to contain more compounds with higher residues than eggs of Swainson's hawks.     

The characteristics of size distribution of suspended particulates in the air for sulphates and selected metals in different areas and seasons

The characteristics of the distribution of particles by size were investigated for sulphates and selected metals (Pb, Fe, Mn, and Cu) in the air in two urban and an industrial area during the winter and summer periods using an Andersen cascade impactor.In the case of metals, but not sulphates, the character of the area affected the value of mass median diameter. Lowest values were obtained in a sparsely populated urban area, whereas in a densely populated urban area and in the industrial area the values were higher.In the industrial area a high correlation coefficient was found between sulphate and manganese, and between sulphate and lead, as well as a high value of the equivalent Mn²⁺/SO _inf4 ^sup2- ratio for the total sample. It may therefore be assumed that in the industrial area manganese produces a catalytic effect on SO₂ conversion to sulphate. Among the investigated metals lead stands out as a dominant cation which binds to the sulphate ion in the industrial and densely populated areas.     

An evaluation of in situ microcosms for validating aquatic fate and transport models

The fates of two compounds, 2,4 Dichlorophenoxy Acetic Acid Butoxyethyl Ester (2,4-DBEE) and 1,4 Dichlorobenzene (1,4-DCB), were examined in in situ microcosms placed in a pond and compared with the fates in the pond itself. Results also were compared with predictions of an aquatic fate and transport model (EXAMS). Decay rates of 2,4-DBEE were not significantly different among the microcosms, pond and model predictions. The decay rate of 1,4-DCB in the microcosms was significantly lower than the rate for the pond, and lower than the rate predicted by the model. The low volatility of 1,4-DCB in the microcosms is attributed primarily to lack of water surface turbulence in the microcosms.     

Second derivative spectroscopy for the determination of volatilized ammonia from urea-amended soil

A second derivative spectrometer custom fitted with a 1 m stainless steel White cell and maintained at 105°C is used to make real-time measurements of volatilized NH₃ from urea-amended soil. Comparison of the technique to impinger data shows a 5–16% discrepancy between the two techniques; however, other experiments presented suggests that this is not real. Sulfur dioxide and nitrous oxide interferences are discussed, though they were not found to be present in this study. Instrument response time is shown to be fast if 67% of the total response is achieved in less than 5 min. Fast response is achieved for ammonia if wall-adsorption effects are minimal and if ammonia mass flow is maintained at 0.2 μg min^-1.     

Indicators of ecosystem health at the species level and the example of selenium effects on fish

Chemical monitoring of aquatic ecosystems describes the chemical exposures of aquatic biota and measures the success of pollution control. However, meeting water quality criteria cannot assure that aquatic biota are protected from the effects of unexpected chemicals, mixtures and interactions between toxicity and environmental stressors.Biological monitoring is an obvious solution since aquatic biota integrate spatial and temporal variations in exposure to many simultaneous stressors. Top predators, typical of specific ecosystems (e.g. lake trout in cold water oligotrophic lakes) indicate whether environmental criteria have been met. The presence of naturally reproducing, self-sustaining and productive stocks of edible fish demonstrates a high quality environment. If these conditions are not met, there is a clear sign of environmental degradation. Specific changes in population structure and performance may also diagnose which life stage is affected and the nature of the stressor.Unfortunately, environmental managers cannot rely solely on populations, communities or ecosystems to indicate chmical effects. The lag between identifying a problem and finding a cause may destroy the resource that we wish to protect, particularly where chemicals are persistent.A solution to this dilemma is the measurement of primary or secondary responses of individual organisms to chemical exposure. Since toxicity at any level of organization must start with a reaction between a chemical and a biological substrate, these responses are the most sensitive and earliest sign of chemical exposure and effect.Application of this idea requires research on molecular mechanisms of chemical toxicity in aquatic biota and adaptation of existing mammalian diagnostic tools. Since relevance of biochemical responses to populations and ecosystems is not obvious, there is a need to study the links between chemical exposure and responses of individuals, populations and ecosystems.The recognition of chemical problems and cause-effect relationships requires the integration of chemical and biological monitoring, using the principles of epidemiology to test the strength of relationships and to identify specific research needs. The contamination of a reservoir with selenium and impacts on fish populations provide an excellent example of this approach.