Comparison of the energetic performance of a binary cycle and a flash evaporation binary cycle,using low-enthalpy geothermal energy

In this article, the comparison of the energetic performance of a binary cycle and a modified binary cycle with flash evaporation is presented, both using a low-enthalpy geothermal resource. The comparative analysis is based on two main discourses: the first one evaluates a conventional binary cycle (CBC) with isopentane as working fluid in order to validate and compare the generated data with those reported in similar studies; the second one uses the same input parameters for both cycles, obtaining the cases in which the modified binary cycle is the most viable choice to use. In addition to the above, several aspects are considered when selecting the most suitable working fluid, and the use of water as working fluid is introduced. When the temperature of the geothermal resource is below 140 °C, and the ambient temperature is 25 °C, the flash evaporation binary cycle, using water as working fluid, shows an improved performance compared to a CBC, with a theoretical output over 1000 kWe. This may encourage new areas of opportunity for power generation, not only with low- and medium-enthalpy geothermal energy, but also with other renewable energy sources such as solar.     

PM source apportionment and trace metallic aerosol affinities during atmospheric pollution episodes: a case study from Puertollano, Spain

Source apportionment study was performed, applying principal component analysis to the results of 221 chemical analyses of PM10 and PM2.5 samples collected daily from the industrial (but low traffic) Spanish town of Puertollano over a 14-month period during 2004-2005. Results reveal compositional variations attributable to different mixtures of natural and anthropogenic materials, mainly soil and rock dust (crustal), marine salt (only in PM10), petrochemical refinery emissions, and particles attributed to the combustion of local coal, which is unusually rich in Pb and Sb. During the study period there were 34 pollution episodes when PM10 exceeded 50 tg m(-3), mostly due to winter air temperature inversions, regional atmospheric stagnation, or African dust incursions (North African, NAF days: usually in summer). Whereas the crustal component during NAF episodes averaged 52% with a PM2.5/PM10 ratio of 0.54, this dropped to 29% and a PM2.5/PM10 of 0.67 during non-NAF days when anthropogenic materials predominated. Abnormally enhanced concentrations of pathfinder metallic trace elements provide additional evidence for source apportionment: thus aerosols with raised levels of Pb and Sb are associated with local coal combustion, Ni and V can be linked to petrochemical PM emissions, and Ti, Mn, Rb, and Ce are particularly characteristic of crustal dust incursions.     

Fractionation of eleven elements by chemical bonding from airborne particulate matter collected in an industrial city in Argentina

A four-step chemical sequential extraction procedure was used to evaluate the distribution of Al, As, Cr, Cu, Fe, Mn, Ni, Pb, Ti, V and Zn in airborne particulate matter collected on glass fibre filters using a high-volume sampler. Two sets of samples were collected in 2001 (winter and summer campaigns) in representative zones of an industrial city of Argentina. The leaching scheme was applied to PM-10 particles and consisted in extracting the elements in four fractions, namely soluble and exchangeable elements; carbonates, oxides and reducible elements; bound to organic matter and sulfidic metals; and residual elements. Metals and metalloids at microg g(-1) level were determined in each fraction by inductively coupled plasma optical emission spectrometry (ICP OES). Analyte concentration varied from 14 microg g(-1) (equivalent to 1.0 ng m(-3)) for As to 11.8 mg g(-1) (equivalent to 2,089 ng m(-3)) for Al. Seven elements, namely Al, Cr, Fe, Mn, Pb, Ti and Zn showed similar distributions in both seasons while As was distributed in a significantly different manner in each season. The results exhibited low As contents in the first and second fractions that could be associated with routine coal combustion and a high content in the third and fourth fractions of the summer samples that could be linked to the use of pesticides. Aluminium, As, Cu, Mn, Ni, Ti, V and Zn were found in different percentages in the more bioavailable aqueous fraction with As, Mn, V and Zn exhibiting solubilities greater than 1% while Cr and Pb being insoluble. The content of Al, Cr, Cu, Fe, Ni, Pb, and Zn in the residual fraction was, in average, higher than 50%. A comparative assessment of the use of the underlying information available from fractionation studies compared to that obtained from total element content was done for Fe and Mn. It showed that the results obtained using chemical sequential extraction procedures allowed further discrimination of the potential air pollution sources.     

The effect of management systems and ecosystem types on bark regeneration in Himatanthus drasticus (Apocynaceae): recommendations for sustainable harvesting

Bark and exudates are widely commercialized non-timber forest products. However, the ecological impacts of the harvesting of these products have seldom been studied. The aim of this study is to investigate the relationship of tree resilience to harvesting intensity in Himatanthus drasticus, a tree that is highly exploited in the Brazilian savanna (Cerrado) for its medicinal latex. Although the traded product is the latex, the traditional harvesting systems involve the removal of the bark of the trees to allow exploitation. A 3-year experiment was conducted in two different Cerrado ecosystems (open savanna and savanna woodland). Trees were debarked at four debarking intensities to simulate the effects of traditional management systems. Measurements of bark growth were taken every 6 months, and quantitative and qualitative indexes of bark regeneration were obtained. The mortality of the debarked trees was low and could not be related to the intensity of harvesting. No signs of attack by fungi or insects were recorded. Compared with other species exploited for bark, H. drasticus is very resilient to harvesting; however, bark regeneration is relatively slow. In both analyzed ecosystems, the regeneration indexes showed higher values in the controls than in the treatments, indicating that 3 years is not sufficient for total recovery of the rhytidome. Bark regeneration occurred primarily by sheet growth and was more rapid in open savanna than in savanna woodland. No differences in the rate of bark recovery were found among management treatments. Based on the results, sustainable harvesting guidelines are suggested for the species.     

Assessment of trace metal concentration in feathers of seabird (Larus dominicanus) sampled in the Florianópolis, SC, Brazilian coast

Cd, Co, Cr, Cu, Mn, Ni, Zn, and Pb were measured in feather samples of adult, subadult, and juvenile of Larus dominicanus, sampled in the Florianólis, SC, in the south of Brazil in December 2005, by flame atomic absorption spectrophotometry. The average of the distribution of Cd concentration in adult feathers (0.072 μg g^???1) was significantly different than that found in juvenile feathers (0.021 μg g^???1). Cu concentration averages were not significantly different between adults (13.30 μg g^???1), subadults (9.67 μg g^???1), and juveniles (13.76 μg g^???1). For adults and juveniles there was significant difference in feather concentrations for Cd, Co, Cr, Ni, and Pb. The distribution of Mn concentration averages in feathers differs between adults (11.36 μg g^???1) and juveniles (1.184 μg g^???1). Ni concentration averages of adults (5.92 μg g^???1) were significantly higher than those of juveniles (2.23 μg g^???1). For Pb, concentration averages were significantly higher in adults (7.53 μg g^???1) than in juveniles (1.47 μg g^???1). The concentration of Co and Cr in juvenile and subadults are statistically different when compared with the adults. In the present study, levels of Cd, Co, Cr, Mn, Ni, Zn, and Pb increased with age. The concentrations of essential trace elements in L. dominicanus were generally comparable to values reported in other studies. With non-essential metals (Cd, Pb, and Ni), in our study, L. dominicanus had lower values than those reported for their northern Atlantic counterparts.     

Erosivity, surface runoff, and soil erosion estimation using GIS-coupled runoff–erosion model in the Mamuaba catchment, Brazil

This study evaluates erosivity, surface runoff generation, and soil erosion rates for Mamuaba catchment, sub-catchment of Gramame River basin (Brazil) by using the ArcView Soil and Water Assessment Tool (AvSWAT) model. Calibration and validation of the model was performed on monthly basis, and it could simulate surface runoff and soil erosion to a good level of accuracy. Daily rainfall data between 1969 and 1989 from six rain gauges were used, and the monthly rainfall erosivity of each station was computed for all the studied years. In order to evaluate the calibration and validation of the model, monthly runoff data between January 1978 and April 1982 from one runoff gauge were used as well. The estimated soil loss rates were also realistic when compared to what can be observed in the field and to results from previous studies around of catchment. The long-term average soil loss was estimated at 9.4 t ha^?1 year^?1; most of the area of the catchment (60 %) was predicted to suffer from a low- to moderate-erosion risk (<6 t ha^?1 year^?1) and, in 20 % of the catchment, the soil erosion was estimated to exceed >?12 t ha^?1 year^?1. Expectedly, estimated soil loss was significantly correlated with measured rainfall and simulated surface runoff. Based on the estimated soil loss rates, the catchment was divided into four priority categories (low, moderate, high and very high) for conservation intervention. The study demonstrates that the AvSWAT model provides a useful tool for soil erosion assessment from catchments and facilitates the planning for a sustainable land management in northeastern Brazil.     

Potentially toxic elements (PTEs) in soils from the surroundings of the Trans-Amazonian Highway,Brazil

The Trans-Amazonian Highway (TAH) is located in the northern region of Brazil, comprising a border region where agricultural, mining, and logging activities are the main activities responsible for fostering economic development, in addition to large hydroelectric plants. Such activities lead to environmental contamination by potentially toxic elements (PTEs). Environmental monitoring is only possible through the determination of element contents under natural conditions. Many extraction methods have been proposed to determine PTEs’ bioavailability in the soil; however, there is no consensus about which extractor is most suitable. In this study, we determined the contents of PTEs in soils in the surroundings of TAH after mineral extraction with diethylenetriaminepentaacetic acid-triethanolamine (DTPA-TEA), Mehlich I, and Mehlich III solutions. Soil samples were collected in areas of natural vegetation in the vicinity of TAH in the state of Pará, Brazil. Chemical attributes and particle size were determined, besides concentrations of Fe, Al, Mn, and Ti by sulfuric acid digestion, Si after alkaline solution attack, and poorly crystalline Fe, Al, and “free” Fe oxides. Mehlich III solution extracted greater contents from Fe, Al, and Pb as compared to Mehlich I and DTPA-TEA and similar contents from Cd, Mn, Zn, and Cu. Significant correlations were found between concentrations of PTEs and the contents of Fe and Mn oxides as well as organic carbon and soil cation exchange capacity. Contents of Cu, Mn, Fe, and Zn by the three methods were positively correlated.