介质特性对DBD降解苯的影响

为了提高介质阻挡放电(dielectric barrier discharge,DBD)等离子体的处理效率,研究了内外介质组成分别为:(1)石英 石英;(2)陶瓷 石英;(3)陶瓷 陶瓷这3种情况下苯的降解情况.试验结果表明,在处理低浓度含苯废气时,陶瓷 陶瓷效果最好;陶瓷(内管) 石英(外管)在处理高浓度含苯废气时显示出优势.通过对气相产物和固相结焦产物的分析验证了DBD能有效降解苯,降解产物不会带来新的污染.进一步分析了实验条件和介质材料的变化对DBD降解苯的影响机理.     

Particulate matter pollution in Kunshan High-Tech zone: Source apportionment with trace elements, plume evolution and its monitoring

Particulate matter(PM) in the Kunshan High-Tech zone is studied during a three-month campaign. PM and trace elements are measured by the online pollution monitoring, forecastwarning and source term retrieval system AS3. Hourly measured concentrations of PM_(10), PM_(2.5) and 16 trace elements in the PM_(2.5) section(Ca, Pb, Cu, Cl, V, Cr, Fe, Ti, Mn, Ni, Zn, Ga, As, Se, Sr, Ba)are focused. Source apportionment of trace elements by Positive Matrix Factorization modeling indicates that there are five major sources, including dust, industrial processing, traffic,combustion, and sea salt with contribution rate of 23.68%, 21.66%, 14.30%, 22.03%, and 6.89%,respectively. Prediction of plume dispersion from concrete plant and traffic emissions shows that PM_(10) pollution of concrete plant is three orders of magnitude more than that of the traffic. The influence range can extend to more than 3 km in 1 hr. Because the footprint of the industrial plumes is constantly moving according to the local meteorological conditions, the fixed monitoring sites scattered in a few hundred meters haven't captured the heaviest pollution plume at the local scale of a few km~2. As a more intensive monitoring network is not operationally possible, the use of online modeling gives accurate and quantitative information of plume location, which increases the spatial pollution monitoring capacity and improves the understanding of measurement data. These results indicate that the development of the AS3 system, which combines monitoring equipment and air pollution modeling systems, is beneficial to the real-time pollution monitoring in the industrial zone.     

Observation and analysis of atmospheric volatile organic compounds in a typical petrochemical area in Yangtze River Delta, China

Volatile organic compounds (VOCs) are a kind of important precursors for ozone photochemical formation. In this study, VOCs were measured from November 5th, 2013 to January 6th, 2014 at the Second Jinshan Industrial Area, Shanghai, China. The results showed that the measured VOCs were dominated by alkanes (41.8%), followed by aromatics (20.1%), alkenes (17.9%), and halo-hydrocarbons (12.5%). The daily trend of the VOC concentration showed a bimodal feature due to the rush-hour traffic in the morning and at nightfall. Based on the VOC concentration, a receptor model of Positive Matrix Factorization (PMF) coupled with the information related to VOC sources was applied to identify the major VOC emissions. The result showed five major VOC sources: solvent use and industrial processes were responsible for about 30% of the ambient VOCs, followed by rubber chemical industrial emissions (23%), refinery and petrochemical industrial emissions (21%), fuel evaporations (13%) and vehicular emissions (13%). The contribution of generalized industrial emissions was about 74% and significantly higher than that made by vehicle exhaust. Using a propylene-equivalent method, alkenes displayed the highest concentration, followed by aromatics and alkanes. Based on a maximum incremental reactivity (MIR) method, the average hourly ozone formation potential (OFP) of VOCs is 220.49?ppbv. The most significant source for ozone chemical formation was identified to be rubber chemical industrial emissions, following one by vehicular emission. The data shown herein may provide useful information to develop effective VOC pollution control strategies in industrialized area.     

基于恢复效度的三峡升船机驱动系统失效危害性TOPSIS评估

三峡升船机驱动系统故障模式的危害性直接关系到升船机的安全运行。为判定故障模式危害度等级,根据运行情况,结合同类型升船机,选取了驱动系统的5类故障模式;引入恢复效度的概念,运用德尔菲法对恢复效度、发生频度、严酷度和可探测度进行等级划分并利用AHP法确定各评估指标的权重;最后通过TOPSIS方法建立了数学模型,对三峡升船机驱动系统故障模式的危害性进行了分析、排序和验证。结果表明:恢复效度与故障危害性关联最为密切,齿轮和齿条故障对升船机的危害性最大,其次分别是减速器、同步轴系统、小齿轮托架以及万向轴等。此方法为有针对性的制定相关弥补措施和对策提供了依据,也为三峡升船机其他关键机构失效危害性分析提供了参考。     

宝钢中厚板分公司煤干燥机除尘系统风量调整技术探究

文章针对宝钢股份中厚板分公司炼铁厂煤干燥机除尘系统吸尘点冒灰,粉尘无组织排放超标的现象进行了测试分析,数据表明主要由除尘系统风量匹配不佳、吸尘点风量不合理造成。笔者通过不断调整阀门及风机档板开摩,测试调整后的风量、除尘性能、岗位粉尘浓度等参数,确定了一个合理的系统风量,不仅可以达到环境排放及职业卫生的要求,而且充分挖掘了除尘系统潜力,达到了节能降耗、经济运行的目的,同时对类似除尘系统风量匹配不佳、扬尘等问题也形成了有效的解决方案。     

α-HCH在太湖地区环境中的长期迁移与残留的动态模拟

根据太湖地区1/4°×1/6°经纬度网格的地表特征及α-HCH施用量,建立了一个基于同精度网格系统, 包含迁移和传输2个模块的质量平衡模型. 迁移模块使用逸度方法描述α-HCH在每一个网格的多介质环境中的迁移过程,传输模块使用拉格朗日方法描述α-HCH在不同网格间的大气平流和水体径流. 模型模拟了α-HCH在研究区域开始施用至今(1952~2007年) α-HCH在5类4层土壤、气、水和底泥23个环境相中的积累、迁移和残留情况. 模拟值与实测α-HCH浓度对比验证表明两者吻合得很好. 环境温度是影响α-HCH在各环境介质中浓度的最重要因素. 模拟结果表明,在α-HCH使用时期,在土壤中的年积累趋势约为年使用量趋势的5.7%; 在停止使用后,其减少趋势为积累趋势的50%. 在α-HCH使用期间,太湖流域α-HCH的年使用量与其水-气界面沉积通量存在显著的相关性,而与土-气界面通量则无显著相关性. α-HCH停止使用后,太湖流域水-气界面通量表现为向大气的挥发,且自1985年其年挥发通量大于土-气挥发通量. 底泥是α-HCH水-气界面挥发的主要补给源. 2007年太湖流域内α-HCH大气浓度普遍高于流域外大气浓度. 整个模拟时段α-HCH的主要输出途径是流出太湖地区,且以大气平流为主;其次的减少途径是在环境介质中的降解,其中土壤降解量占绝大部分. 2007年环境中残留的α-HCH为总使用量的0.005%,以土壤残留量为主,其次是底泥.     

仓面浇筑立体空间冲突致灾过程建模与伤害评价*

为定量评价大坝浇筑过程空间冲突致灾事故后果,通过对缆机运输典型情景进行危害能量运动分解,确定在水平和竖直方向运动方式,阐述危害能量在流动路径相互转化形式;根据能量守恒定律,分析危害能量在吊罐与承灾体碰撞接触之间转移规律,将吊罐与人头部接触过程抽象为带强阻尼的弹簧振子系统,建立危害能量与碰撞冲量相等的动量方程,量化空间冲突致灾后果。结果表明:吊罐坠落危害能量极大,产生的碰撞冲击力与吊罐的运输速度、高度呈正相关,与阻力系数呈负相关,风速、载重对其影响较大。对比2种不同碰撞情景发现,机械碰撞因顶部承载力缓冲,对人头部产生伤害远小于直接碰撞,并对碰撞结果分级评价,研究结果可为大坝浇筑交叉作业空间冲突致灾风险评价提供参考。     

Sources, chemistry, impacts and regulations of complex air pollution: Preface

正Clean air is essential to people's health and that of the environment.Since the industrial revolution,however,the quality of the air that people breathe has deteriorated considerably—mainly as a result of human activities.Rising industrial and energy production,the burning of fossil fuels and the dramatic rise in traffic all contribute to air pollution in our cities which,in turn,can lead to serious health problems for instance     

基于保护的瓷窑型遗址绿化改造研究——以长沙铜官窑遗址为例

瓷窑型遗址由于其埋藏浅、需要恒温恒湿等特点,对绿化的要求与其它遗址不尽相同。基于保护为主的绿化改造是瓷窑型遗址保护的重要内容。文章以长沙铜官窑遗址为例,在分析了长沙铜官窑遗址的植被组成、绿化现状以及现有植被对遗址保护的利弊基础上,提出了基于保护为主的绿化改造总体设想、主要对策措施和技术模式,希望为中国瓷窑型遗址的绿化改造提供借鉴。     

纯氧曝气与空气曝气处理生活污水的效果比较

研究纯氧曝气与空气曝气对好氧装置处理生活污水效果以及对NH3和H2S产生量的影响。试验结果表明,与空气曝气相比,纯氧曝气的COD去除率高2.57%,NH3-N去除率高9.59%;处理7L相同体积的污水,空气曝气吹脱出的NH3是纯氧曝气的3.4倍,吹脱出的H2S平均值为12.99 ug,远大于纯氧曝气装置的0.38 ug。