Coupled reservoir-geomechanical analysis of CO2 injection and ground deformations at In Salah,Algeria

In Salah Gas Project in Algeria has been injecting 0.5–1 million tonnes CO₂ per year over the past 5 years into a water-filled strata at a depth of about 1800–1900 m. Unlike most CO₂ storage sites, the permeability of the storage formation is relatively low and comparatively thin with a thickness of about 20 m. To ensure adequate CO₂ flow-rates across the low-permeability sand-face, the In Salah Gas Project decided to use long-reach (about 1–1.5 km) horizontal injection wells. In an ongoing research project we use field data and coupled reservoir-geomechanical numerical modeling to assess the effectiveness of this approach and to investigate monitoring techniques to evaluate the performance of a CO₂ injection operation in relatively low-permeability formations. Among the field data used are ground surface deformations evaluated from recently acquired satellite-based inferrometry (InSAR). The InSAR data shows a surface uplift on the order of 5 mm per year above active CO₂ injection wells and the uplift pattern extends several km from the injection wells. In this paper we use the observed surface uplift to constrain our coupled reservoir-geomechanical model and conduct sensitivity studies to investigate potential causes and mechanisms of the observed uplift. The results of our analysis indicate that most of the observed uplift magnitude can be explained by pressure-induced, poro-elastic expansion of the 20-m-thick injection zone, but there could also be a significant contribution from pressure-induced deformations within a 100-m-thick zone of shaly sands immediately above the injection zone.     

Finished leather waste chromium acid extraction and anaerobic biodegradation of the products

Due to the amounts of chromium in the leachate resulting from leather leaching tests, chromium sulfate tanned leather wastes are very often considered hazardous wastes. To overcome this problem, one option could be recovering the chromium and, consequently, lowering its content in the leather scrap. With this objective, chromium leather scrap was leached with sulfuric acid solutions at low temperature also aiming at maximizing chromium removal with minimum attack of the leather matrix. The effects of leather scrap dimension, sulfuric acid and sodium sulfate concentration in the solutions, as well as extraction time and temperature on chromium recovery were studied, and, additionally, organic matrix degradation was evaluated. The best conditions found for chromium recovery were leather scrap conditioning using 25 mL of concentrated H₂SO₄/L solution at 293 or 313 K during 3 or 6 days. Under such conditions, 30–60 ± 5% of chromium was recovered and as low as 3–6 ± 1% of the leather total organic carbon (TOC) was dissolved. Using such treatment, the leather scrap area and volume are reduced and the residue is a more brittle material showing enhanced anaerobic biodegradability. Although good recovery results were achieved, due to the fact that the amount of chromium in eluate exceeded the threshold value this waste was still hazardous. Thus, it needs to be methodically washed in order to remove all the chromium de-linked from collagen.     

The Importance of Natural Processes in Understanding Ecosystem Change: A Case Study of Limed Lakes

In order to determine what effects human activities have on natural processes, it is important to thoroughly understand those processes. Unfortunately, we know little about what natural processes are operating, and even less about how they have functioned historically. This paper discusses the importance of natural processes in affecting surface water acidification and the necessity for developing quantitative estimates of natural, as well as anthropogenic, contributions to the acidification of surface waters. A review of the literature and the analysis of chemistry data from six limed lakes in New York and Massachusetts have identified a number of possible processes that may play important roles in acidifying surface waters. At present, these processes are poorly understood and require further research. Once we have such knowledge, we will be able to clearly see the effects of human activities on natural processes and modify those activities in ways that will mitigate negative impact in a predictable manner.     

Brain myelination in rats treated with ionizing radiation in utero

Abstract

Effects of ionizing radiation on brain myelination and some physical development parameters were studied in laboratory rats (Fisher F‐344 inbred strain). Rats were treated with three different doses of radiation (150 rad, 15 rad, and 6.8 rad) delivered on the 20th day of prenatal life. Exposure to 150 rad reduced body, brain, ovary, kidney, heart and spleen weights. Prenatal exposure to 150 rad of radiation reduced the cerebral cortex weight by 22 percent at 30 days of age, and 20 percent at 52 days of age which caused a reduction in cerebral cortex myelin content by 20 and 23 percent at the ages of 30 and 52 days respectively. This dose did not affect the myelin content of the cerebellum or the brain stem, or the myelin concentration (mg myelin/g brain tissue) of the cerebral cortex, cerebellum, and the brain stem. The cerebral cortex weight of the 15 rad treated rats was reduced at the age of 30 days. Exposure to 15 rad, and 6.8 rad did not affect either the myelin content or the myelin concentration of these brain areas.     

Photochemical Reactivities of Paraffinic Hydrocarbon-Nitrogen Oxide Mixtures Upon Addition of Propylene or Toluene

Effects associated with photochemical air pollution were measured during irradiation of n-butane-nitrogen oxide or n-butane-ethane-nitrogen oxide mixtures, with small amounts of propylene or toluene added. The effects measured including nitrogen dioxide and oxidant dosages, yields of formaldehyde and peroxy-acetyl nitrate, and eye irritation response. The results obtained clearly show that beneficial effects result from selective changes in hydrocarbon composition as well as from reduction of total hydrocarbon concenfration. Exclusion of olefins and alkylbenzenes was highly effective in reducing oxidant dosage, formaldehyde and peroxyacetyl nitrate concentrations, and eye irritation response. The only penalty was a modest increase in nitrogen dioxide dosage. A large reduction in nitrogen oxide concentration reduced nitrogen dioxide dosage and eye irritation response, but with the penalty of a large increase in oxidant dosage. The desirability of preferentially reducing olefins and alkylbenzenes rather than paraffinic hydrocarbons, acetylene, and benzene is strongly supported by this study. Research and development efforts should be directed toward preferential hydrocarbon control by mechanical or catalytic control     

Isoprene emissions and climate

Biogenic volatile organic compounds (BVOCs) play an important role in atmospheric chemistry and the carbon cycle. Isoprene is quantitatively the most important of the non-methane BVOCs (NMBVOCs), with an annual emission of about 400–600 TgC; about 90% of this is emitted by terrestrial plants. Incorporating a mechanistic treatment of isoprene emissions within land-surface schemes has recently become a focus for the modelling community, the aim being to quantify the potential magnitude of associated climate feedbacks. However, these efforts are hampered by major uncertainties about why plants emit isoprene and the relative importance of different environmental controls on isoprene emission. The availability and reliability of observations of isoprene fluxes from different types of vegetation is limited, and this also imposes constraints on model development. Nevertheless, progress is being made towards the development of mechanistic models of isoprene emission which, in conjunction with atmospheric chemistry models, will ultimately allow improved quantification of the feedbacks between the terrestrial biosphere and climate under past and future climate states.     

The Role of Disaggregation of Asset Values in Flood Loss Estimation: A Comparison of Different Modeling Approaches at the Mulde River,Germany

In loss estimation there is a spatial mismatch of hazard data that are commonly modeled on an explicit raster level and exposure data that are often available only for aggregated administrative units. Usually disaggregation methods that use ancillary information to distribute lumped exposure data in a finer spatial resolution help to bridge this gap. However, the actual influence of different mapping techniques and ancillary data on the final loss estimation has not been analyzed yet. In this paper three methods are applied to disaggregate residential building assets using two kinds of land use/land cover (LULC) data. The resulting disaggregated assets are validated and compared using census data of the residential building number on the community and constituency level. In addition, the disaggregated assets are taken to estimate residential building losses due to the flood in August 2002 in 21 municipalities on the River Mulde in Saxony, Germany. Losses are calculated with the help of four loss models. In general, disaggregation helps to decrease the error variance within the loss estimation. It must, however, be stated that the application of sophisticated disaggregation methods does not lead to significant improvements compared to the straightforward binary method. Therefore more effort should instead be put into the provision of high-resolution LULC data. Finally, the remaining uncertainties in loss estimation are high and demand further improvements in all modeling aspects.