Interinstrument comparison of remote-sensing devices and a new method for calculating on-road nitrogen oxides emissions and validation of vehicle-specific power

Emissions of nitrogen oxides (NOx) by vehicles in real driving environments are only partially understood. This has been brought to the attention of the world with recent revelations of the cheating of the type of approval tests exposed in the dieselgate scandal. Remote-sensing devices offer investigators an opportunity to directly measure in situ real driving emissions of tens of thousands of vehicles. Remote-sensing NO₂ measurements are not as widely available as would be desirable. The aim of this study is to improve the ability of investigators to estimate the NO₂ emissions and to improve the confidence of the total NOx results calculated from standard remote-sensing device (RSD) measurements. The accuracy of the RSD speed and acceleration module was also validated using state-of-the-art onboard global positioning system (GPS) tracking. Two RSDs used in roadside vehicle emissions surveys were tested side by side under off-carriageway conditions away from transient pollution sources to ascertain the consistency of their measurements. The speed correlation was consistent across the range of measurements at 95% confidence and the acceleration correlation was consistent at 95% confidence intervals for all but the most extreme acceleration cases. VSP was consistent at 95% confidence across all measurements except for those at VSP ≥ 15 kW t^?1, which show a small underestimate. The controlled distribution gas nitric oxide measurements follow a normal distribution with 2σ equal to 18.9% of the mean, compared to 15% observed during factory calibration indicative of additional error introduced into the system. Systematic errors of +84 ppm were observed but within the tolerance of the control gas. Interinstrument correlation was performed, with the relationship between the FEAT and the RSD4600 being linear with a gradient of 0.93 and an R² of 0.85, indicating good correlation. A new method to calculate NOx emissions using fractional NO₂ combined with NO measurements made by the RSD4600 was constructed, validated, and shown to be more accurate than previous methods.

Implications: Synchronized remote-sensing measurements of NO were taken using two different remote-sensing devices in an off-road study. It was found that the measurements taken by both instruments were well correlated. Fractional NO₂ measurements from a prior study, measurable on only one device, were used to create new NO_x emission factors for the device that could not be measured by the second device. These estimates were validated against direct measurement of total NO_x emission factors and shown to be an improvement on previous methodologies. Validation of vehicle-specific power was performed with good correlation observed.     

The use of XAD-resins for the detection of mutagenic activity in water: I. Studies with surface water

A study of the effects of different XAD-resins, bed volume, flow rate, pH and type of eluent on the extraction of organic mutagens from surface water is presented. XAD-4/8 is as effective as XAD-2 in concentrating organic mutagens from surface water and dimethylsulfoxide (DMSO) is as efficient as acetone in eluting the adsorbed organic mutagens. The latter allows direct testing up to 0.5 ml of DMSO concentrate in the Ames test. Variation of the pH of the water after passing the XAD-4/8, followed by readsorption, shows that the majority of the mutagenic activity due to dissolved organics is adsorbed at neutral pH. Only a minor fraction is readsorbed at pH 3. Further a XAD-4/8 concentrate and a similar concentrate prepared by freeze drying gives similar mutagenic activity. This indicates that many of the organic mutagens are recovered in the XAD-4/8 concentrate.It is concluded that adsorption on XAD-4/8, followed by direct testing of the DMSO eluates in the Ames test, presents a rapid and relatively simple way to detect low concentrations of organic mutagens in surface water. The general suitability of the method is shown for different types of surface water.     

Seasonal changes in an intertidal community affected by sewage pollution

Seasonal changes in structure of a rocky intertidal community affected by sewage pollution at Quequén (Argentina) were studied over a period of 2 years. Most species showed a decrease in cover values in the polluted area. On the other hand, a small proportion of organisms favoured by organic enrichment predominated around the outfall during the period of study. Community structure was not significantly altered by frosts or windstorms. Desiccation is identified as the main physical stress. A combination of late spring high temperatures with extreme midday low-tides caused by northerly winds was responsible for heavy losses in dominant algae. Major seasonal changes in community structure were primarily due to variations in area covered by the chlorophyte Ulva lactuca, and crusts of blue-green algae and diatoms in the vicinity of the outfall. Highest diversity values were attained during either late winter or spring, due to increased abundances of several seasonal algae. Abundance of the dominant organism, the bivalve Brachidontes rodriguezi, remained stable, showing only slight, non-seasonal, changes. Since the absence of B. rodriguezi is an indication of heavy pollution, temporal stability of this species suggests that the intensity of sewage discharges did not vary over the period of study.     

The response of Lemna trisulca L. to cadmium

Lemna trisulca was grown, using aseptic culture techniques in a filter-sterilized medium, a portion of which was replaced regularly during experiments. L. trisulca responded to the addition of 0.64 microM Cd with a reduction in multiplication rate (MR) 2 +/- 1 days after exposure. The internal Cd content reached 1000 +/- 140 microg Cd/g (dry wt) within 2 days exposure to 0.64 microM Cd. The final yield was reduced by an average of c.8% for each day of exposure to 0.64 microM Cd in a 14 day experiment. This implies that an equilibration period should be used for short-term bioassay tests before the effect of a toxicant is determined. Pretreating L. trisulca with 0.08 or 0.32 microM Cd for 6 weeks had no significant effect on MR or Cd uptake when plants were subsequently exposed to a range of Cd concentrations or grown in a control medium. This suggests that L. trisulca does not become acclimated to elevated Cd concentrations. The MR of L. trisulca fluctuated over a period of almost 600 days and the doubling time ranged from 1.6 to 2.4 days. This produced more than a fivefold difference in final yield in experiments of 14 days duration. The reduction in MR in response to 0.32 microM Cd during this same 600 days period averaged 24% with a coefficient of variation of 38%, and varied with the MR of control cultures. Fluctuations in the intrinsic growth rate and the effect of a toxicant on L. trisulca could potentially confound the assessment of toxicity and must be carefully considered when designing test protocols for aquatic plants.