Impairment of symbiont photosynthesis increases host cell proliferation in the epidermis of the sea anemone Aiptasia pallida

Corals exposed to environmental stresses need to engage appropriate physiological strategies to survive. Here, we examined tissue modifications following algal dysfunction. Aiptasia pallida was exposed during 1 week to 3-(3,4-dichlorophenyl)-1,1-dimethylurea (DCMU), the herbicide called diuron. DCMU treatment produced a drastic loss in photosynthetic efficiency and a subsequent diminution of algae density over the following days. Cell proliferation evaluated by measuring the number of cells labeled with a thymidine analogue (EdU) revealed a significant increase in EdU+ cells in the epidermis after 1 week of DCMU incubation and in the gastrodermis at 4 weeks. TUNEL histology showed that the extent of cell death was, however, similar in the epidermis of control and treated specimens. In addition, we noticed a significant effect of DCMU treatment on the density of epidermal mucocytes after 1, 2 and 4 weeks. These results show that inhibition of Symbiodinium photosynthesis in the absence of any known direct effect of DCMU on host cells can induce an increase in epidermal host cell proliferation in both the epidermis and the gastrodermis. While new host gastrodermal cells are likely to promote tissue regeneration in order to recruit new algae, the new host epidermal cells may contribute to tissue adaptation following a decrease in energy income. Some of these new epidermal cells, such as mucocytes, may contribute to an eventual increase in the host heterotrophic ability until restoration of algal autotrophic contribution.     

Summaries

Summaries

Summaries     

Performance of firefighters' protective clothing after heat exposure.

Heat and mechanical protection properties of 6 fabric combinations commonly used in firefighters' protective clothing were assessed before and after different heat treatment. It was shown that after heat exposure, the values obtained were generally lower than in the original state. The mechanical properties of the materials were more affected by heat than by heat protective properties. In 2 cases, degradation started before a visible change in the material could be observed, which might be potentially dangerous for the end user who will not realize the alteration of the material.     

Detection of fungal development in closed spaces through the determination of specific chemical targets

In addition to the biodegradation problems encountered in buildings, exposure of their occupants to moulds is responsible for numerous diseases: infections (invasive nosocomial aspergillosis), immediate or delayed allergies, food-borne infections and different types of irritation. In this context, the aim of our work has been to determine specific chemical tracers for fungal development on construction materials. More generally, by detecting a specific chemical fingerprint of fungal development, our objective was to propose a microbiological alert system which could control systems and/or procedures for the microbiological treatment of indoor areas.

We therefore characterized the chemical emissions from six types of construction material contaminated artificially by moulds. Chemical fingerprints were established for 19 compounds arising specifically from fungal metabolism: 2-ethylhexanoic acid methyl ester, 1-octen-3-ol, 3-heptanol, 3-methyl-1-butanol, 2-methyl-1-butanol, 1,3-octadiene, 2-(5H)-furanone, 2-heptene, -pinene, 2-methylisoborneol, 4-heptanone, 2-methylfuran, 3-methylfuran, dimethyldisulfide, methoxybenzene, a terpenoid and three sesquiterpenes.

Determining the origin of these compounds and their specific links with a growth substrate or fungal species made it possible to judge the pertinence of choosing these compounds as tracers.

Thus the detecting specific volatile organic compounds emitted as from the second day of fungal growth demonstrated that this approach had the advantage of detecting fungal development both reliably and rapidly before any visible signs of contamination could be detected.     

Natural variability in soil and runoff from small headwater catchments at Storgama, Norway

To provide baseline data for climate manipulation experiments in 11 small (30-268 m2) headwater catchments at Storgama, Telemark County, Southern Norway, we assessed the natural variability in site characteristics and runoff quality. Annual average concentrations in runoff at the sites have coefficients of variation between 26-61%, with the smallest values for total organic carbon (TOC) and carbon to nitrogen (C/N) ratios and the largest for inorganic nitrogen (N). The catchments have between two and five times higher concentrations of inorganic N, TOC, and total phosphorus than the larger (0.6 km2) Storgama watershed nearby. Concentrations of TOC and TON in runoff tend to increase with soil C and N content and with the volume of soil in the catchment. For nitrate (NO3) and ammonium in runoff, the reverse is true. In wet years the proportion of bare rock is a major predictor for the annual average NO3 concentration in runoff.     

Leaching of wood ash products aimed for spreading in forest floors--influence of method and L/S ratio

Use of biofuels in the form of logging residues is increasing in the European countries. This intensive forestry, where entire trees are removed from the felling sites, may contribute to a negative nutrient balance in the forest soil. Recycling of ash from the combustion of clean wood fuel, sometimes in combination with limestone or additives/binders, back into the forest soil could maintain the soil nutrient reservoir intact. Before spreading ash, it is important to determine its contents and, particularly, its decomposition pattern using reliable laboratory leaching tests. In this study, mineralogy and the leaching of Na, Ca, K, Mg, Mn, Al, Cu, Fe, P, and Zn from wood ash pellets and granules, produced both from green liquor sludge and fly ash, are examined by XRD and by subjecting these substances to three different laboratory leaching tests: upflow percolation (CEN/TS 14405), batch leaching (SS-EN12457), and a new Swedish leaching test using a magnetic stirrer. Mineral phases such as quartz, ettringite, calcite, gehlenite, and aphtitalite were identified in the ash granules and in the ash/green liquor sludge granules, by means of XRD. Six additional minerals were detected in the granules of ash only, and another six in the ash/green liquor sludge granules. At L/S 2, the batch leaching test resulted in the highest amounts of elements leached and the upflow percolation test the lowest. At L/S 10, both the batch leaching test and the upflow percolation test resulted in high amounts of elements leached. The batch leaching test at L/S 10 complies quite well with the percolation test and could be suitable for ash/green liquor sludge granule evaluation in daily practice. The magnetic stirrer test seems to underestimate the release potential of elements from granules. The batch test is simple to perform, and has the ability to dissolve 70-80% of the elements with the highest mobility from the materials under study.     

Towards a SOLAP-based public participation GIS

In this paper, we describe how spatial on-line analytical processing (SOLAP), a specific category of business intelligence technology especially adapted to geospatial data, can help to improve the technological side of public participation GIS applications. Based on two simulated cases of realistic scenarios of a public audience, this paper aims at demonstrating the relevance of this SOLAP technology to support and improve the interactive access and analysis of multi-scale, multi-epoch geospatial information (and indirectly public involvement) for an environmental management PPGIS application.     

Effects of water content on reactive transport of 85Sr in Chernobyl sand columns

It is known that under unsaturated conditions, the transport of solutes can deviate from ideal advective-dispersive behaviour even for macroscopically homogeneous porous materials. Causes may include physical non-equilibrium, sorption kinetics, non-linear sorption, and the irregular distribution of sorption sites. We have performed laboratory experiments designed to identify the processes responsible for the non-ideality of radioactive Sr transport observed under unsaturated flow conditions in an Aeolian sandy deposit from the Chernobyl exclusion zone. Miscible displacement experiments were carried out at various water contents and corresponding flow rates in a laboratory model system. Results of our experiments have shown that breakthrough curves of a conservative tracer exhibit a higher degree of asymmetry when the water content decreases than at saturated water content and same Darcy velocity. It is possible that velocity variations caused by heterogeneities at the macroscopic scale are responsible for this situation. Another explanation is that molecular diffusion drives the solute mass transfer between mobile and immobile water regions, but the surface of contact between these water regions is small. At very low concentrations, representative of a radioactive Sr contamination of the pore water, sorption and physical disequilibrium dominate the radioactive Sr transport under unsaturated flow conditions. A sorption reaction is described by a cation exchange mechanism calibrated under fully saturated conditions. The sorption capacity, as well as the exchange coefficients are not affected by desaturation. The number of accessible exchange sites was calculated on the basis that the solid remained in contact with water and that the fraction of solid phase in contact with mobile water is numerically equal to the proportion of mobile water to total water content. That means that for this type of sandy soil, the nature of mineral phases is the same in advective and non-advective domains. So sorption reaction parameters can be estimated from more easily conducted saturated experiments, but hydrodynamic behaviour must be characterized by conservative tracer experiments under unsaturated flow conditions.     

Insights into low fish mercury bioaccumulation in a mercury-contaminated reservoir, Guizhou, China

We examined Hg biogeochemistry in Baihua Reservoir, a system affected by industrial wastewater containing mercury (Hg). As expected, we found high levels of total Hg (THg, 664-7421 ng g(-1)) and monomethylmercury (MMHg, 3-21 ng g(-1)) in the surface sediments (0-10 cm). In the water column, both THg and MMHg showed strong vertical variations with higher concentrations in the anoxic layer (>4m) than in the oxic layer (0-4 m), which was most pronounced for the dissolved MMHg (p < 0.001). However, mercury levels in biota samples (mostly cyprinid fish) were one order of magnitude lower than common regulatory values (i.e. 0.3-0.5 mg kg(-1)) for human consumption. We identified three main reasons to explain the low fish Hg bioaccumulation: disconnection of the aquatic food web from the high MMHg zone, simple food web structures, and biodilution effect at the base of the food chain in this eutrophic reservoir.