Cyanide generation during preservation of chlorinated wastewater effluent samples for total cyanide analysis.

Dechlorinating agents and pH adjustment are often used to preserve wastewater samples for cyanide analysis. The effects of four approved preservation protocols on the results of the total cyanide analysis of effluents from four water reclamation plants were examined. The results differed widely, and a clear pattern emerged. Immediate analysis without pH adjustment generally gave total cyanide concentrations below the reporting limit of 5 microg/L, irrespective of the dechlorinating agents used. When the pH was adjusted to > or =12, a slight increase in the measured total cyanide concentration was observed when thiosulfate was used to dechlorinate the samples, and a significant increase (>10 microg/L) was observed when arsenite was used as the dechlorinating agent. These results provide evidence that approved preservation protocols may give rise to cyanide formation in chlorinated wastewater effluent matrices.     

Evaluation of the use of diffusive air samplers for determining temporal and spatial variation of volatile organic compounds in the ambient air of urban communities

The Houston-Galveston metropolitan area has a relatively high density of point and mobile sources of air toxics, and determining and understanding the relationship between emissions and ambient air concentrations of air toxics is important for evaluating potential impacts on public health and formulating effective regulatory policies to control this impact, both in this region and elsewhere. However, conventional ambient air monitoring approaches are limited with regard to expense, siting limitations, and representative sampling necessary for adequate exposure assessment. The overall goal of this multiphase study is to evaluate the use of simple passive air samplers to determine temporal and spatial variability of the ambient air concentrations of selected volatile organic compounds (VOCs) in urban areas. Phase 1 of this study, reported here, was a field evaluation of 3M organic vapor monitors (OVMs) involving limited comparisons with commonly used active sampling methods, an assessment of sampler precision, a determination of optimal sampling duration, and an investigation of the utility of a simple modification of the commercial sampler. The results indicated that a sampling duration of 72 hr exhibited generally low bias relative to automated continuous gas chromatography measurements, good overall precision, and an acceptable number of measurements above detection limits. The modified sampler showed good correlation with the commercial sampler, with higher sampling rates, although lower than expected.     

Mercury deposition/accumulation rates in the vicinity of a lead smelter as recorded by a peat deposit

Mercury (Hg) concentration profiles and historical accumulation rates were determined in three ²¹⁰Pb-dated cores from a peat deposit in the vicinity of a lead (Pb) smelter at Příbram, Czech Republic. The Hg concentrations in peat samples ranged from 66 to 701 μg kg⁻¹. Cumulative Hg inventories from each core (for the past 150 yr) varied by a factor of 1.4 (13.6–18.5 mg Hg m⁻²), indicating variations of net Hg accumulation rate within the peat deposit. Historical changes in vegetation cover (leading to variable interception by trees) are probably responsible for this variation in space and time. The uncorrected Hg accumulation rates peaked between the 1960s and 1980s (up to 226 μg m⁻² yr⁻¹). Recent findings show that Hg records from peat tend to overestimate historical levels of Hg deposition. Therefore we used the mass loss compensation factor (MLCF) to normalize Hg accumulation rates. These corrected Hg accumulation rates were significantly lower (maximum 129 μg m⁻² yr⁻¹) and better corresponded to changes in historical smelter emissions, which were highest in the 1960s. The agreement between the corrected Hg accumulation rates in the uppermost peat sections (2–38 μg m⁻² yr⁻¹) and biomonitoring of atmospheric deposition by mosses in several recent years (4.7–34.4 μg m⁻² yr⁻¹) shows the usefulness of MLCF application on Hg accumulation in peat archives. However, the MLCF correction was unsuitable for Pb. The recent Pb deposition rates obtained by an independent biomonitoring study using mosses (0.5–127 mg m⁻² yr⁻¹) were better correlated with net Pb accumulation rates recorded in peat (7–145 mg m⁻² yr⁻¹) than with corrected rates obtained by the MLCF approach (1–28 mg m⁻² yr⁻¹).     

Thermodynamic analysis of the energy recovery from the aerobic bioconversion of solid urban waste organic fraction

Waste management is of the utmost importance for many countries and especially for highly developed ones due to its implications on society. In particular, proper treatment before disposal of the solid urban waste organic fraction is one of the main issues that is addressed in waste management. In fact, the organic fraction is particularly reactive and if disposed in sanitary landfills without previous adequate treatment, a large amount of dangerous and polluting gaseous, liquid and solid substances can be produced. Some waste treatment processes can also present an opportunity to produce other by-products like energy, recycled materials and other products with both economic and environmental benefits. In this paper, the aerobic treatment of the organic fraction of solid urban waste, performed in a biocell plant with the possibility of recovering heat for civil or industrial needs, was examined from the thermodynamic point of view. A theoretical model was proposed both for the biological process of the organic fraction, as well as for the heat recovery system. The most significant results are represented and discussed.     

Determination of granule size distribution in a UASB reactor

Granular sludge is the key factor for an efficient operation of an upflow anaerobic sludge blanket (UASB) reactor. In order to monitor the granularity of anaerobic sludge, the determination of the granule size distribution is of vital importance. For this reason, several techniques have been proposed; however, they are either tedious, imprecise or expensive and hardly applicable in full-scale treatment plants. There was then the need for a simple and low-cost technique. This technique involves the determination of the settling velocities of a sludge sample and of extrapolating the corresponding diameters using a mathematical algorithm. In the proposed algorithm, the granules density was calculated, the flow regime was examined and finally the granule size distribution was obtained. Two very important correlations were suggested by the experimental results. The granule density and diameter were strongly correlated with the VSS/TSS ratio.     

A mixed integer linear programming model for optimisation of organics management in an integrated solid waste system

In this paper, the authors propose a mixed integer linear programming model for designing an Integrated Solid Waste Management System (ISWMS) to meet specific economic goals. The model refers to a set of municipalities, known as ‘local basin’, which have to share a common waste management system. At the municipal level the model allows for an identification of the optimal collection service option; at the local basin level, the model provides the optimal waste flow appropriate to the collection service option of each municipality. The model has been applied to a full-scale case study of an area located in southeast Italy. A scenario analysis was carried out to investigate alternative municipal solid waste management options, which fundamentally differ in the organic flow mass rate to be either collected and composted or landfilled. Findings show that an increase in the cost of landfilling determines the optimal collection scenario and the configuration plants tend to recover higher rates of organics in separate collection and thus higher refuse derived fuel productions. The results obtained validate the application of the model in both the strategic planning and operational phases, by supporting public administrators at both municipality and local basin level in decision making and evaluation of technical and economic performances of ISWMSs.     

Minimization of the environmental impact of chrome tanning: a new process with high chrome exhaustion

In all tanning technology operations wastes are generated. These reach the environment as residual waters, solid and liquid waste as well as atmospheric emissions and odours.

This study tests an alternative method to the traditional tanning method at an industrial level. The new method is based on tanning without float and by significantly increasing the temperature at the end of the tanning process. The properties of the leathers obtained using the two methods have been compared and the results indicate that those leathers have similar physical, chemical, and organoleptic properties. However, the differences existing from the environmental point of view are significant. It is not necessary to use clean water for this tanning. Moreover, there is a 75% reduction of the residual float, a 91% reduction of the chrome discharged, and a 94% reduction of the chlorides discharged. A financial assessment was carried out to demonstrate that the newly proposed system is 32% more economic than the traditional one.     

Fate of cadmium in Elodea canadensis

Elodea canadensis is a submersed macrophytes, widely distributed in stormwater treatment ponds and able to remove heavy metals from water. This study examines the Cd uptake, translocation, and efflux patterns in Elodea. Several experiments were set up in a climate chamber. To study the root and shoot Cd uptake, living and dead roots and shoots were treated with (109)Cd in one- and two-compartment systems. Furthermore, to examine Cd translocation and distribution, either roots or shoots were treated with (109)Cd. Finally, the efflux of Cd from roots and shoots, respectively, to the external solution was studied after loading whole plants with (109)Cd. Results from the two compartment studies show that Cd is accumulated via direct uptake by both roots and shoots of Elodea. The Cd accumulation proved not to be metabolically dependent in Elodea, and the apoplastic uptake in particular was decreased by Cd pretreatment. In one week, up to 23% of the root uptake was translocated to the shoots, while about 2% of the Cd accumulated by shoots was translocated to the roots. Thus, slight dispersion of Cd is possible, while metal immobilization will not be directly mediated via the Elodea plant. The efflux experiment proved that both shoots of dead plants and roots of living plants had a faster efflux than did shoots of living plants. This information is relevant for an understanding of the fate of Cd in stormwater treatment ponds with Elodea.     

Different compensatory mechanisms in two metal-accumulating aquatic macrophytes exposed to acute cadmium stress in outdoor artificial lakes

Mechanisms underlying cadmium (Cd) detoxification were compared in two aquatic macrophytes commonly used in phytoremediation, namely Pistia stratiotes L. and Eichhornia crassipes (Mart.) Solms. To simulate Cd pollution in the open environment, plants growing in outdoor artificial lakes were exposed for 21d to either 25 or 100microM Cd, in two consecutive years. Toxicity symptoms were absent or mild in both species. Metal accumulation was much higher in the roots of P. stratiotes, whereas in E. crassipes a comparatively higher fraction was translocated to the leaves. In both species, Cd was neither included in phenolic polymers or Ca-oxalate crystals, nor altered the levels of Cd-complexing organic acids. Glutathione levels were constitutively remarkably higher and much more responsive to Cd exposure in P. stratiotes than in E. crassipes. Abundant phytochelatin synthesis occurred only in P. stratiotes, both in roots and in leaves. In E. crassipes, on the other side, the constitutive levels of some antioxidant enzymes and ascorbate were higher and more responsive to Cd than in P. stratiotes. Thus, in these two aquatic plants grown in the open, different detoxification mechanisms might come into play to counterbalance Cd acute stress.     

Possible effects of persistent organochlorinated pollutants cocktail on thyroid hormone levels and pituitary-thyroid interrelations

In polluted district of Michalovce in East Slovakia (POLL) and two districts with background pollution (BCGR) 2046 adults (834 males and 1212 females aged 20-75 years) were examined. Serum levels of thyrotropin (TSH), free thyroxine (FT4), total triiodothyronine (TT3) and antithyroperoxidase antibodies (TPOab) were estimated by electrochemiluminiscent assay and also these of 15 polychlorinated biphenyl congeners (PCBs), p,p'-DDE, p,p'-DDT, hexachlorobenzene (HCB) and hexachlorocyclohexane were measured by high resolution gas chromatography/mass spectrometry. In addition, also dioxins, furans, coplanar- and mono-ortho-PCBs as well as selected hydroxylated and methylsulphonated PCBs and DDE metabolites were measured by appropriate methods based on gas chromatography/mass spectrometry principle. In POLL significantly higher levels of all organochlorines were found than these in BCGR. When pooled values from both areas were stratified in terms of PCBs level and treated as continuous variables, positive association of PCBs with FT4 and TT3 was found, the latter two being also mutually associated. However, within the category of PCBs level <530 ng/glipid (n=232) the association between PCBs and both the FT4 (p<0.09) and TT3 (p<0.03) was negative and any association of these was not found within the category of PCBs level of 531-1000 ng/g (n=691). In contrast, in the category of 531-2000 ng/g (n=1307) positive association appeared between PCBs and FT4 (p<0.001) as well as TT3 (p<0.05). Highly significant association of PCBs with FT4 (p<0.001) was further found in the categories with PCBs level of 1001-101414 ng/g (n=1307) and 2001-101414 (n=1123), while significant association with TT3 was observed only in the category of 531-2000 ng/g. Such findings suggest possible threshold level in positive effect of PCBs on FT4 and TT3 level which seems to be individual and located somewhere around the PCBs level of 1000 ng/g. However, highly significant negative association of both FT4 and TT3 with TSH was found in each of above indicated PCBs categories. Considerable difference in FT4 and TT3 level between large groups of subjects with the same range of PCBs level was also found suggesting different individual susceptibility to the effects of organochlorines. Among a total of 26 cases from POLL with very low TSH level (<0.5 mU l(-1)) 13 cases showed very high level of PCBs, FT4 and TT3, thus supporting a hypothesis on a novel sporadic form of high PCBs related peripheral subclinical hyperthyroidism possibly resulting from the long-term disruption of equilibrium between bound and free thyroxine in plasma by high PCBs level followed by a striking inhibition of TSH release from the pituitary.