Biotreatability and kinetics of UASB reactor to mixtures of chlorophenol pollutants

In most natural ecosystems heterotrophic microorganisms encountercomplex mixtures of carbon sources, each of which is present at aconcentration of few micrograms per litre. This study examined the biotreatability and kinetics of an upflow anaerobic sludge blanket (UASB) reactor to complex mixtures of chlorophenols encountered in environmental conditions using on-line and off-line experimental studies. Results indicate that (1) steady-state concentration was quite lower (98.3 mg L^-1) with complex mixture of chlorophenols than steady-state concentration achieved when only 2.4 dichlorophenol (124 mg L^-1) was studied alone on the same reactor; (2) that toxiceffects of chlorophenols increase with increasing concentrationsof toxicant. (Onset of the inhibitory effect occurred at a lowerconcentration in multi-substrate than in single substrate utilization); (3) addition of alternative utilizable substrate can mitigate toxic effects and enhance degradation; (4) the relative concentration of substrate was critical in determiningutilization patterns. HPLC analysis of off-line experimental samples resulted in a steady-state treatment efficiency of68% for COD, 36% for 2-hlorophenol, 40.5% for 4-chlorophenol, 70.7% for 2,4-dichlorophenol, 53.2% for 2,4,6-trichlorophenol and 42% for pentachlorophenol in presence of glucose. Kinetic constant in terms of V _max and K _s were determined. K _s for the five chlorophenols ranged between 0.016 and 0.117 kg m^-3 day^-1 while V _max ranged between 0.056 and 0.244 kg m^-3 day^-1.     

Measurements of Ozone Concentrations in Zagreb

Ozone concentrations were measured in Zagreb at four sites from May 1999 to April 2001 in order to categorize the air quality with respect to ozone. In the summer of 2000, the ozone measurements were also extended to four sites in the suburbs of Zagreb. Methods of active and passive sampling with nitrite ion as a reagent were used. In the northern part of the town ozone was analyzed by an automatic device. Automatic device measurements in the years 1999 and 2000 showed that hourly averages of ozone concentrations did not exceed the Croatian recommended value of the 98th percentile (180 g m^–3). Over the two-year period, 24-h averages occasionally exceed 110 g m^–3 in city center and in the northern part of the town. Regardless of these isolated examples, ozone was well within acceptable concentrations. Ozone concentrations measured in summer 2000 were higher in the suburbs of Zagreb than in the city. The 98th percentile values higher than 110 g m^–3 were recorded at three sites.     

Evaluation of interference to conventional and real-time PCR for detection and quantification of fungi in dust

Advances in polymerase chain reaction (PCR) have permitted accurate, rapid and quantitative identification of microorganisms in pure cultures regardless of viability or culturability. In this study, a simple sample processing method was investigated for rapid identification and quantification of fungal spores from dust samples using both conventional and real-time PCR. The proposed method was evaluated for susceptibility to interference from environmental dust samples. Stachybotrys chartarum and Aspergillus fumigatus were used as test organisms. The sensitivity of detection in pure culture was 0.1 spore DNA equivalents per PCR reaction corresponding to 20 spores ml(-1) in the sample. However, 1 spore DNA equivalent per PCR reaction corresponding to 200 spores ml(-1) in the sample was the lowest amount of spores tested without interference in dust samples spiked with spores of either fungal species. The extent of inhibition was calculated using conventional and real-time PCR reactions containing fungal spores, specific primers, specific probes (for real-time PCR) and various amounts of dust. The results indicate that the extent of inhibition by dust on PCR varies with the type and amount of dust, and number of spores. No interference in the analysis of spiked samples was detected from 0.2 mg ml(-1) of four real-life dust samples at p-value >0.05 using 2 x 10(4) spores for conventional PCR and 2 x 10(5) spores for real-time PCR. However, samples containing >0.2 mg ml(-1) real-life dust compromised the PCR assay. These results suggest the potential usefulness of a simple sample processing method in conjunction with PCR for monitoring the fungal content of aerosols collected from indoor environments.     

Pool of Dust Particles over the Asian Continent: Balloon-borne Optical Particle Counter and Ground-based Lidar Measurements at Dunhuang, China

Measurements of aerosols were made in 2001 and 2002 at Dunhuang (40 degrees 00'N, 94 degrees 30'E), China to understand the nature of atmospheric particles over the desert areas in the Asian continent. Balloon-borne measurements with an optical particle counter suggested that particle size and concentration had noticeable peaks in super micron size range not only in the boundary mixing layer but also in the free troposphere. Super-micron particle concentration largely decreased in the mid tropopause (from 5 to 10 km; above sea level, a.s.l.). Lidar measurements made during August 2002 at Dunhuang suggested the possibility that mixing of dust particles occurred from near the ground to about 6 km even under calm weather conditions, and a large depolarization ratio of particulate matter was found in the aerosol layer. The top of the aerosol layer was found at heights of nearly 6 km (a.s.l.). It is strongly suggested that nonspherical dust particles (Kosa particles) frequently diffused in the free atmosphere over the Taklamakan desert through small-scale turbulences and are possible sources of dust particles of weak Kosa events that have been identified in the free troposphere not only in spring but also in summer over Japanese archipelago. Electron microscopic experiments of the particles collected in the free troposphere confirmed that coarse and nonspherical particles observed by the mineral particle were major components of coarse mode (diameter larger than 1 microm) below about 5 km over Dunhuang, China.     

Total versus inhalable sampler comparison study for the determination of asphalt fume exposures within the road paving industry

Exposure to asphalt fumes has a threshold limit value (TLV of 0.5 mg m(-3) (benzene extractable inhalable particulate) as recommended by the American Conference of Governmental Industrial Hygienists (ACGIH). This reflects a recent change (2000) whereby two variables are different from the previous recommendation. First is a 10-fold reduction in quantity from 5 mg m(-3) to 0.5 mg m(-3). Secondly, the new TLV specifies the "inhalable" fraction as compared to what is presumed to be total particulate. To assess the impact of these changes, this study compares the differences between measurements of paving asphalt fume exposure in the field using an "inhalable" instrument versus the historically used 'total' sampler. Particle size is also examined to assist in the understanding of the aerodynamic collection differences as related to asphalt fumes and confounders. Results show that when exposures are limited to asphalt fumes, a 1:1 relationship exists between samplers, showing no statistically significant differences in benzene soluble matter (BSM). This means that for the asphalt fume ACGIH TLV, the 'total' 37-mm sampler is an equivalent method to the "inhalable" method, referred to as IOM (Institute of Occupational Medicine), and should be acceptable for use against the TLV. However, the study found that when confounders (dust or old asphalt millings) are present in the workplace, there can be significant differences between the two samplers' reported exposure. The ratio of IOM/Total was 1.37 for milling asphalt sites, 1.41 for asphalt paving over granular base, and 1.02 for asphalt over asphalt pavements.     

Monitoring of Phenol in Wastewater Bioremediation by HPLC

Bioremediation emphasizes the detoxification and destruction of toxic substances by microorganisms. Wastewater obtained from an industrial concern was solvent extracted with methyl alcohol and dichloromethane and analysed by GC/MS. Besides phenol, a large variety of organic compounds were detected. Under controlled laboratory conditions, the wastewater was innoculated with a mixed culture of microorganisms specially selected for their abilities to degrade phenol. Samples were collected at regular intervals from the stirred tank bioreactor and analysed for phenol by reverse phase HPLC with a C18 column. Results shows that from an initial phenol concentration of 987 ppm, slightly more than 50% was destroyed within 163 hours. The dry weight of the microorganisms and the plate count (CFU/ml) shows a steady increase from 0.5238 gms to 0.5355 gms and from 1.1E+9 to 1.94E+13 respectively over the same period. This suggested that the phenol was consumed by the microorganisms as the sole carbon source.     

The Influence of pH on Mobility of Heavy Metals from Municipal Solid Waste Incinerator Fly Ash

Incineration has become one of the principal methods for municipal solid waste disposal particularly in all large cities throughout the world. Currently, the municipal solid waste incinerator fly ashes (MSWIF) are disposed of by landfill. The metal speciation of cadmium (Cd), chromium (Cr), copper (Cu), lead (Pb), and zinc (Zn) in MSWIF after been extracted with water at different pH values were examined using a sequential extraction procedure. The extraction sequence was as follows: (1) Exchangeable (NaOAc, pH 8.2), (2) Bound to Carbonates (NaOAc, pH 5.0), (3) Bound to metal oxides (HONH3Cl), (4) Bound to organic matters (HNO3, H2O2), and (5) Residual (HNO3, HCl, H2O2, HF, 1:3:1:3). The heavy metal contents in the extraction solutions were determined by inductively coupled plasma atomic emission spectrometry. The heavy metal concentrations in the different fractions obtained by sequential extraction show distinct distribution trends. The extractable fraction ranges from 25.5 to 88% of the total element content. With the pH of the extractant fall below the neutral and acidic ranges, the concentrations of heavy metals rise substantially due to the released of metals bound to carbonate fraction.     

Utility of dynamics as indicators of stress in population models

The relationships between the dynamics of environmentally and chemically stressed populations and indicators of the effects of the stressor are explored in a model framework. The physiologically structured population, represented by a system of McKendrick–von Foerster hyperbolic partial differential equations, includes the dynamics of numerous individuals distinguished by ecotype. Chemical uptake of nonpolar narcotics is modeled by first order kinetics. Classical methodologies, frequency analysis and phase space reconstruction, are explored in a search for indicators of magnitude of stress. When these techniques proved generally unsuccessful for the objective of indicator selection in our model setting, summary statistics, as related to bifurcation diagrams, were constructed and appear more useful as indicators. It is concluded that physiological structures generally lead to more feasible measurable indicators of magnitude of stress than do specifics of population dynamics.     

Fractionation of heavy metals and phosphorus in suspended sediments of the Yamuna river,India

The Yamuna river is the largest tributary of the Ganges river system. It originates in the Himalayas and flows through a varied geological terrain encompassing a large basin area. Metals Fe, Mn, Pb, Zn, Cu in different chemical fractions of suspended sediments such as exchangeable, carbonates, Fe–Mn oxides, organics and residual fractions were studied. Phosphorus associated with different chemical forms are discussed. The metals are mostly associated with residual fractions in the sediments followed by organics, Fe–Mn oxides, exhangeable and carbonates. Intensive use of chemical fertilizers and pesticides in agriculture in the basin affects the high inorganic phosphorus content in sediments.     

Genetic population structure of the recently introduced Asian clam,Potamocorbula amurensis,in San Francisco Bay

The genetic population structure of the recently introduced Asian clam, Potamocorbula amurensis, in San Francisco Bay was described using starch gel electrophoresis at eight presumptive loci. Specimens were taken from five environmentally distinct sites located throughout the bay. The population maintains a high degree of genetic variation, with a mean heterozygosity of 0.295, a mean polymorphism of 0.75, and an average of 3.70 alleles per locus. The population is genetically homogeneous, as evidenced from genetic distance values and F-statistics. However, heterogeneity of populations was indicated from a contingency chi-square test. Significant deviations from Hardy-Weinberg equilibrium and heterozygote deficiencies were found at the Lap-1 locus for all populations and at the Lap-2 locus for a single population. High levels of variability could represent a universal characteristic of invading species, the levels of variability in the source population(s), and/or the dynamics of the introduction. Lack of differentiation between subpopulations may be due to the immaturity of the San Francisco Bay population, the general purpose phenotype genetic strategy of the species, high rates of gene flow in the population, and/or the selective neutrality of the loci investigated.