A comparison of X-ray fluorescence and wet chemical analysis of air filter samples from a scrap lead smelting operation

Personal and area air samples were taken at a scrap lead smelter operation in a bullet manufacturing facility. Samples were taken using the 37-mm styrene-acrylonitrile closed-face filter cassette (CFC, the current US standard device for lead sampling), the 37-mm GSP or "cone" sampler, the 25-mm Institute of Occupational Medicine (IOM) inhalable sampler, and the 25-mm Button sampler (developed at the University of Cincinnati). Polyvinylchloride filters were used for sampling. The filters were pre- and post-weighed, and analyzed for lead content using a field-portable X-ray fluorescence (XRF) analyzer. The filters were then extracted with dilute nitric acid in an ultrasonic extraction bath and the solutions were analyzed by inductively coupled plasma optical emission spectroscopy. The 25-mm filters were analyzed using a single XRF reading, while three readings on different parts of the filter were taken from the 37-mm filters. The single reading from the 25-mm filters was adjusted for the nominal area of the filter to obtain the mass loading, while the three readings from the 37-mm filters were inserted into two different algorithms for calculating the mass loadings, and the algorithms were compared. The IOM sampler was designed for material collected in the body of the sampler to be part of the collected sample as well as that on the filter. Therefore, the IOM sampler cassettes were rinsed separately to determine if wall-loss corrections were necessary. All four samplers gave very good correlations between the two analytical methods above the limit of detection of the XRF procedure. The limit of detection for the 25-mm filters (5 microg) was lower than for the 37-mm filters (10 microg). The percentage of XRF results that were within 25% of the corresponding ICP results was evaluated. In addition, the bias from linear regression was estimated. Linear regression for the Button sampler and the IOM sampler using single readings and the GSP using all tested techniques for total filter loading gave acceptable XRF readings at loadings equivalent to sampling at the OSHA 8-hour Action Level and Permissible Exposure Limit. However, the CFC only had acceptable results when the center reading corrected for filter area was used, which was surprising, and may be a result of a limited data set. In addition to linear regression, simple estimation of bias indicated reasonable agreements between XRF and ICP results for single XRF readings on the Button sampler filters, (82% of the individual results within criterion), and on the IOM sampler filters (77% or 61%--see text), and on the GSP sampler filters using the OSHA algorithm (78%). As a result of this pilot project, all three samplers were considered suitable for inclusion in further field research studies.     

Bioindicator organisms: Heavy metal pollution evaluation in the Ionian Sea (Mediterranean Sea—Italy)

Trace metal concentrations of mercury, cadmium, lead and chromium in Patella caerulea, and Mullus barbatus were investigated to provide information on pollution of Ionian Sea, since these metals have the highest toxic potential. High chromium levels (0.47–0.97 g g^–1 ww) were registered in limpet samples collected from two station near the Gulf of Taranto, while elevated concentration of mercury (0.31–1.50 g g^–1 ww) were found in mullet specimens from Sicily. The metal concentrations recorded at the clean stations may be considered as useful background levels to which to refer for comparison within the Mediterranean area. On the contrary, the high levels of chromium and mercury found respectively in the areas near the Gulf of Taranto and at Capo Passero being of concern in terms of environmental health need frequent monitoring.     

Environmental quality control and environmental games

Conclusion  In this paper we have considered a specific environmental game emphasizing both control-prevention efforts and the propensity to pollute by a firm which adopts a given pollution abatement technology. A random payoff game was constructed and solved under a risk neutral assumption and quadratic utilities for both the firm and the environmental controller. The game thus defined, provides a wide range of interpretations and potential approaches for selecting a control-inspection policies to prevent environmental risks. There are of course many facets to this problem, which could be considered and have not been considered in sufficient depth. For example, more complex control mechanisms and liabilities, the effects of insurance and risk sharing, the application of cooperative efforts and subvention of pollution abatement investments (through tax incentives and their like), etc. have not been considered [5,7]. These are topics for further research. The basic presumption of this paper is that it is very difficult to fully enforce pollution prevention by firms, as a result, some controls are needed to ensure that firms be controlled so that appropriate efforts are carried.     

The collection of PM10 for toxicological investigation: comparisons between different collecting devices

A positive correlation has been established between increased levels of airborne particulate pollution and adverse health effects, the toxicological mechanisms of which are poorly understood. For toxicologists to unambiguously determine thesemechanisms, truly representative samples of ambient PM₁₀ are required. This presents problems, as PM₁₀ collecting equipment commonly employed, such as the Tapered Element Oscillating Microbalance (TEOM®), heat the inflow toexclude moisture or use fibrous filters, resulting in a PM₁₀sample that may have undergone significant chemical change on thefilter surface or is contaminated by filter fibres. Other systems(i.e. Negretti and Partisol) can successfully collect PM₁₀ without chemical alteration or filter contamination. Comparativecollections from Port Talbot, S. Wales suggest that TEOMs and Negretti/Partisol systems collect different PM₁₀'s; the principle difference arising from the TEOM's heating chamber, which precipitates water-soluble ions and volatilises some organic components. This results in both the mass and compositionof the PM₁₀'s being altered. Particle size distributionsfor Negretti and Partisol collections highlighted differences mainly attributed to different flow rates. The results of thiswork demonstrate that simple correlations between PM₁₀ massand adverse health effects are problematic. Furthermore, elucidation of the complex fractionation and chemical changes indifferent collectors is necessary.     

Measurements of fractionated gaseous mercury concentrations over northwestern and central Europe, 1995-99

Although it makes up only a few per cent. of total gaseous mercury (TGM) in the atmosphere, the fraction of oxidised (divalent) mercury plays a major role in the biogeochemical cycle of mercury due to its high affinity for water and surfaces. Quantitative knowledge of this fraction present in mixing ratios in the parts-per-10(15) (ppq) range is currently very scarce. This work is based on approximately 220 data for divalent gaseous mercury (DGM) collected during 1995-99 in ambient air. Over the course of the measurements, the sampling and analytical methods were modified and improved. This is described here in detail and includes transition from wet leaching and reduction procedures to thermo-reductive desorption, the use of annular as well as tubular denuders and adoption of an automated sampling system. The concentration of DGM exhibited a strong seasonal behaviour in contrast to atomic gaseous mercury, with low values in winter and maximum values in summer. The DGM/TGM ratios were frequently found to be below the detection limit (< or = 1%) and in the range 1-5%. A trend of diurnal DGM patterns was observed and implies photolytically induced sources. Scavenging of DGM during rain events was also noticed.     

Air pollution exposure monitoring and estimation. Part VI. Ambient exposure of adults in an industrialised region

This paper presents methodology and results of a dynamic individual air pollution exposure model (DINEX) that calculates the hourly exposure for each adult in a panel study. Each of over 260 participants, through the use of a diary, provided information used in the model to calculate his/her personal, individualised exposure. The participants filled out the diary daily, hour by hour, over two, two month periods. The exposure assessment model coupled the diary information and results of an indoor/outdoor measurement program, with the results of dispersion modelling on an hourly basis for an industrial area in Norway. The estimated air pollution concentrations from the dispersion model, based on continuous meteorological measurements, were calibrated with air pollutant concentrations measured continuously.     

Evaluation of two adsorbents for diffusive sampling and thermal desorption-gas chromatographic analysis of monoterpenes in air

Tube type samplers with two different adsorbents, Chromosorb 106 and Tenax TA, were evaluated by laboratory experiments and field tests for simultaneous diffusive sampling of alpha-pinene, beta-pinene and delta 3-carene and subsequent thermal desorption-gas chromatographic analysis. No statistically significant effects of exposure time, concentrations of monoterpenes or relative humidity were found for samplers with Chromosorb 106 when running a factorial design, with the exception of the adsorption of delta 3-carene, for which some weak effects were noted. Samplers with Tenax TA were affected by the sampling time as well as the concentration for all terpenes, with a strong interaction effect between these two factors. The terpenes showed good storage stability on both adsorbents. No effect of back-diffusion was noted when using Chromosorb 106, while Tenax TA showed some back-diffusion effects. The uptake rates, in ml min-1, for the terpenes on Chromosorb 106 were 0.36 for alpha-pinene, 0.36 for beta-pinene and 0.40 for delta 3-carene. The corresponding average values on Tenax TA were 0.30 for alpha-pinene, 0.32 for beta-pinene and 0.38 for delta 3-carene. The field validation proved that diffusive sampling on Chromosorb 106 agreed well with pumped sampling on charcoal for stationary samples, while the personal samples indicated a discrepancy of 25% between Chromosorb 106 and charcoal samples. Tenax TA generally gave lower results than Chromosorb 106 in all field samples. Samplers packed with Chromosorb 106 could be used to monitor terpene levels in workplaces such as sawmills. The major advantages with this method are the sampling procedure, which is simple to perform compared to other techniques, the easily automated analysis procedure and the possibility to reuse the samplers.     

Integrating disciplinary research into an interdisciplinary framework: A case study in sustainability research

The complexity of today’s research problems increasingly demands that scientists move beyond the confines of their own discipline. In this special issue, the basics of a transdisciplinary framework are established and problems analyzed in a specific discipline are successfully integrated in this transdisciplinary network. The intent has been to go beyond only statements about the importance of enabling early stage researchers to work across disciplinary boundaries, and to show that important discoveries are being made at the intersection of disciplines. Embedding various research projects in a more global framework can meet the demands of an interdisciplinary or transdisciplinary approach (especially for early stage researchers) and contribute significantly to sustainable research.     

A study on the orbit of air temperature movement

In this paper, we describe an air temperature movement by mapping its time series to the polar coordinates: the value of the time series is plotted on the radial coordinate and the time on the angular coordinate. In this way, both the yearly and daily air temperature movements from five different locations of China are used to demonstrate that, in an intuitionistic view, air temperature movement is neither random nor chaotic, but has its own orbit. We then propose an elliptic orbit model for the air temperature movement. Our proposed model provides quite good results when it is applied to the evaluation of yearly air temperature movements in eight locations in various parts of the world, and the evaluation of daily air temperature movements in five locations in Hunan Province of China on December 17, 2005. Results show that our approach provides a concise and helpful model for air temperature analysis.     

Study of heat exposure in the work environment in Jeddah

The present work was conducted to define the magnitude of the problem of heat exposure in Jeddah and the role of both the climatic and the industrial factors on the total heat load. Indoor heat exposure was studied in an industrial complex of 5 plants for cables' manufacturing. Outdoor heat exposure was studied in shaded and unshaded operations in Jeddah Islamic Port (JIP). The heat exposure parameters, including air temperature (Ta), wet bulb temperature (Tw), and globe temperature (Tg), as well as the wet bulb globe temperature (WBGT) heat stress index, the relative humidity and the air velocity, were assessed at representative locations. Results of the study indicated that: