Leaching of mecoprop and dichlorprop in calcareous soil. Effect of the exogen organic matter addition in this process

Abstract

Leaching studies of mecorprop (R,S)‐2‐(4‐chloro‐2‐methylphenoxy)propanoic acid, and dichlorprop, (R,S)‐2‐(4‐chloro‐2,4‐dichlorophenoxy) propanoic acid, under saturated conditions were conducted in unamended and amended soil columns. The purpose of the study was to investigate the leaching of these herbicides in three type of soils and the exogen organic matter effect on this process. The leaching patterns could be related to variation in the soil texture and diffusion processes of the herbicides into micropores within the walls of conducting pore. The leaching rate in the amended soil columns decreased with the addition of organic matter. The breakthrough curves (BTC) of these herbicides in the leachates of the amended soil columns were wider and more diffused than the BTC obtained for the corresponding unamended soil. The theoretical BTC overestimated the pore volume required for the displacement of these pesticides from the soil column. This may be due to the differences in the adsorption process between the bacth and soil columns methods     

Experimental Characterization of Atmospheric Diffusion in Complex Terrain with Land-Sea Interactions

The body of information presented in this paper is directed to scientists working in atmospheric dispersion research and model development. Two years of field measurements in the coastal area of Bilbao in northern Spain show that the diffusion behavior in this complex terrain can be classified into several well defined patterns, which correspond to certain meteorological conditions. The approach taken has been the systematic use of SO₂ remote sensors (COSPEC) and ground level monitors in moving platforms which are used to follow and document the flow of the air mass. Results to date show that complex reentry cycles can occur and that synoptically different flows may be indistinguishable by wind sensors at ground level (affected by channeling), and yet result in totally different observed pollution levels by a fixed monitoring network (affected by topographical effects). These results are being used to parameterize the cause-effect relationships and guide the modeling efforts in this area of complex terrain.     

An Evaluation of the Semi-VOST Method for Determining Emissions from Hazardous Waste Incinerators

The Semi-Volatile Organic Sampling Train method was investigated to determine its reliability and to determine the bias and precision of the method when used to determine emissions from hazardous waste incinerators. Experiments showed that the matrix and sampling variables usually involved in sampling emissions from a hazardous waste incinerator had no significant effect on the recovery of 11 different organic compounds. Significant losses of the sampled compounds can occur during sample preparation. The degree of loss appears to be directly related to the compounds, vapor pressure. These losses can be corrected for by adding deuterated surrogates to the sample and analyzing the surrogates along with the native compounds.

The bias determination was based on dynamic spiking of the sampling train with five deuterated organic compounds selected from Appendix VIII of the Resource Conservation and Recovery Act regulations. The results show biases of from -1 ± 8 percent to -18 ± 27 percent for chlorinated and nonchlorinated compounds. Pyridine, a water-soluble compound, showed a larger bias of-29 ± 13 percent. Particular attention to the recovery of water soluble compounds is necessary to minimize bias in their determinations. Further work is needed to determine the reliability of laboratory-determined retention volumes that are used to determine sampling conditions.     

The Mutagenic Activity of Particulate Organic Matter Collected with a Dilution Sampler at Coal-Fired Power Plants

The Deep Creek Lake Study of 1983 provided an opportunity to obtain emission samples from coal-fired power plants with a dilution sampler for mutagenicity testing. Stack and ambient samples of particulate matter were collected with a dilution sampler at three coal-fired power plants in West Virginia. Samples were sequentially extracted with cyclohexane (CX), dichloromethane (DCM) and acetone (ACE) and tested for mutagenicity in the Ames Salmonella/microsome assay using TA98 (-S9). For the stack samples, the CX, DCM and ACE fractions constituted 1.0, 0.7 and 98.1 percent of the total extractable organic material (EOM), respectively, compared to 28.5, 7.4 and 64.1 percent for the ambient samples. In contrast, the mutagenic activity of the organic fractions was concentrated in the CX and DCM fractions.

The cyclohexane- and dichloromethane-soluble fractions of the stack samples from all locations exhibited mutagenicity when tested in the plate incorporation assay. No significant response was observed with the acetone fraction. When tested with Kado's modification of the preincubation assay, the acetone-soluble fraction did exhibit mutagenic activity comparable to that of the other fractions when expressed in units of revertants per milligram of particular matter. Chemical analyses of one of the acetone-soluble fractions indicated that half of the mass was sulfuric acid while the remainder consisted of C, H and O. More than 30 peaks were detected in the high pressure liquid chromatogram of this fraction.

Although little mutagenic activity was detected in the polar ACE fraction of the diluted stack emissions samples with this single bioassay, in view of the large mass of this fraction, further investigation of the chemical composition and genotoxic activity of this fraction would be prudent.     

Hazardous Waste Minimization: Part IV Waste Reduction in the Metal Finishing Industry

The metal finishing industry uses over 40 production processes to produce a wide range of metal products. Waste streams generated include wastewater, waste oils, spent solvents, and spent process solutions. Currently a wide variety of techniques which minimize waste are available. Cost-effective methods to reduce electroplating wastewater contamination include water conservation and drag-out reduction, recovery and management. Ways to cost-effectively reduce the generation of spent metal-working fluids include establishing a fluid management program and installing a fluid recovery system. However, before any techniques are selected, a waste reduction survey should first be conducted.     

Stationary Combustion NOX Control A Summary of the 1989 Symposium

This paper summarizes information and results presented at the 1989 Symposium on Stationary Combustion NOX Control, held March 6-9, 1989 in San Francisco. Cosponsored by the Electric Power Research Institute (EPRI) and the U.S. Environmental Protection Agency, (EPA) the symposium was the fifth in a biennial series.     

Comparison of the Annular Denuder System and the Transition Flow Reactor for Measurements of Selected Dry Deposition Species

An intensive field study was conducted in Research Triangle Park, North Carolina in the fall of 1986. Ambient concentrations of the following constituents were obtained: nitric acid, nitrous acid, nitrogen dioxide, sulfur dioxide, ammonia, hydrogen ion, and particulate nitrate, sulfate, and ammonium. Results collected using the annular denuder system (ADS) and the transition flow reactor (TFR) are presented and compared.

Both types of samplers had operational detection limits on daily (22-hour) samples that were generally below 1 μg m_-3 suggesting that both samplers can provide sensitive measurements for most of the constituents of interest. Both the ADS and TFR show reasonable (>25 percent) within-sampler precision for most of the measured species concentrations, except TFR fine particulate nitrate measurements where results were frequently negative (The TFR fine particulate nitrate measurement is calculated using subtraction of positive numbers).

Comparison of ADS and TFR daily results showed good agreement for total particulate sulfate, the sum of total (coarse plus fine) particulate and gaseous nitrate, and ammonia. As a result of different inlet particle collection efficiencies, the ADS fine particulate sulfate exceeded the TFR (5 percent). In the absence of a filter to collect volatilized particulate ammonium in the ADS, the sum of total particulate and gaseous ammonium in the TFR exceeded that in the ADS. Of potentially more importance, ADS measurements of SO₂ and H⁺ exceeded those of the TFR, while TFR measurements of HNO₃ exceeded those of the ADS. Results of this study suggest that the TFR may provide biased measurements of SO₂, H⁺, HNO₃, and Fine NO₃ ^- that cannot be corrected without modifications to the fundamental design of the sampling system.