A study on the orbit of air temperature movement

In this paper, we describe an air temperature movement by mapping its time series to the polar coordinates: the value of the time series is plotted on the radial coordinate and the time on the angular coordinate. In this way, both the yearly and daily air temperature movements from five different locations of China are used to demonstrate that, in an intuitionistic view, air temperature movement is neither random nor chaotic, but has its own orbit. We then propose an elliptic orbit model for the air temperature movement. Our proposed model provides quite good results when it is applied to the evaluation of yearly air temperature movements in eight locations in various parts of the world, and the evaluation of daily air temperature movements in five locations in Hunan Province of China on December 17, 2005. Results show that our approach provides a concise and helpful model for air temperature analysis.     

Survey of the occurrence of residues of methyl tertiary butyl ether (MTBE) in Dutch drinking water sources and drinking water

An indicative survey has been carried out in The Netherlands investigating the presence of methyl tertiary butyl ether (MTBE) in drinking water and the corresponding sources. In total, 71 different sites used for the preparation of drinking water in The Netherlands were sampled in two successive seasons in 2001 involving the analysis of 156 samples. (ground water (n = 88), surface water (n = 17), bank filtrate water (n = 6) and drinking water (n = 45)). To combine high sample throughput with high selectivity and sensitivity, off-line purge and trap for sampling and gas chromatography mass spectrometry equipped with an automated thermal desorption sampler (TDS-GC-MS) was selected as the preferred analytical methodology. The developed procedure enabled the analysis of at least 40 samples per day and provided a limit of quantification of 2 ng l(-1). In the first period 63 samples of raw water were analyzed. Concentrations ranged between < 10 ng l(-1) and 420 ng l(-1) with a median concentration below 10 ng l(-1). The second period was focused at the re-sampling of positive locations (MTBE > 10 ng l(-1)) and a few additional drinking water utilities of which both the raw and drinking water of the utilities were analyzed. The median concentration of MTBE in the selected set of drinking water samples was 20 ng l(-1) (n = 45). At one location MTBE was found at a level of 2900 ng l(-1) caused by point source contamination of the ground water (11 900 ng l(-1)). Special attention has been paid to the quality of the results by analyzing all samples in duplicate and the analysis of control samples during each series of analyses.     

Sequential extractions of selenium soils from Stewart Lake: total selenium and speciation measurements with ICP-MS detection

Different techniques have been employed in order to evaluate the most efficient procedure for the extraction of selenium from soil as required for speciation. Selenium contaminated sediments from Stewart Lake Wetland, California were used. A strong acid mineralization of the samples gives quantitative total selenium, which is then used to estimate recoveries for the milder extraction methods. The different extraction methodologies involve the sequential use of water, buffer (phosphate, pH 7) and either acid solution (e.g. HNO3 or HCl) or basic solutions (e.g. ammonium acetate, NaOH or TMAH). Pyrophosphate extraction was also evaluated and showed that selenium was not associated with humic acids. The extractants were subsequently analyzed by size exclusion chromatography (SEC) with UV (254 and 400 nm) and on-line ICP-MS detection; anion exchange chromatography, and ion-pair reversed phase chromatography with ICP-MS detection. For sequential extractions the extraction efficiencies showed that the basic extractions were more efficient than the acidic. The difference between the acidic and the basic extraction efficiency is carried to the sulfite extraction, suggesting that whatever is not extracted by the acid is subsequently extracted by the sulfite. The species identified with the different chromatographies were selenate, selenite, elemental selenium and some organic selenium.     

Assessing land use impacts on flood processes in complex terrain by using GIS and modeling approach

A distributed hydrologic modeling and GIS approach is applied for the assessment of land use impact in the Steinsel sub-basin, Alzette, Grand-Duchy of Luxembourg. The assessment focuses on the runoff contributions from different land use classes and the potential impact of land use changes on runoff generation. The results show that the direct runoff from urban areas is dominant for a flood event compared with runoff from other land use areas in this catchment, and tends to increase for small floods and for the dry season floods, whereas the interflow from forested, pasture and agricultural field areas contributes to the recession flow. Significant variations in flood volume, peak discharge, time to the peak, etc., are found from the model simulation based on the three hypothetical land use change scenarios.     

Application of a checklist for quality assistance in environmental modelling to an energy model

Large, complex energy models present considerable challenges to develop and test. Uncertainty assessments of such models provide only partial guidance on the quality of the results. We have developed a model quality assistance checklist to aid in this purpose. The model checklist provides diagnostic output in the form of a set of pitfalls for the model application. The checklist is applied here to an energy model for the problem of assessing energy use and greenhouse gas emissions. Use of the checklist suggests that results on this issue are contingent on a number of assumptions that are highly value-laden. When these assumptions are held fixed, the model is deemed capable of producing moderately robust results of relevance to climate policy over the longer term. Checklist responses also indicate that a number of details critical to policy choices or outcomes on this issue are not captured in the model, and model results should therefore be supplemented with alternative analyses.     

SI-traceable certification of Cu, Cr, Cd and Pb in sediment and fly ash candidate reference materials

Many fields in environmental analytical chemistry deal with very low limits and thresholds as set by governmental legislations or transnational regulations. The need for the accuracy, comparability and traceability of analytical measurements in environmental analytical chemistry has significantly increased and total uncertainties are even asked for by accreditation bodies of environmental laboratories. This paper addresses achieving these goals to guarantee accuracy, quality control, quality assurance or validation of a method by means of certified reference materials. The assessment of analytical results in certified reference materials must be as accurate as possible and every single step has to be fully evaluated. This paper presents the SI-traceable certification of Cu, Cr, Cd and Pb contents in geological and environmentally relevant matrices (three sediments and one fly ash sample). Certification was achieved using isotope dilution (ID) ICPMS as a primary method of measurement. In order to reduce significantly the number of analytical steps and intermediate samples a multiple spiking approach was developed. The full methodology is documented and total uncertainty budgets are calculated for all certified values. A non-element specific sample digestion process was optimised. All wet chemical digestion methods examined resulted in a more or less pronounced amount of precipitate. It is demonstrated that these precipitates originate mainly from secondary formation of fluorides (essentially CaF2) and that their formation takes place after isotopic equilibration. The contribution to the total uncertainty of the final values resulting from the formation of such precipitates was in general < 0.1% for all investigated elements. Other sources of uncertainty scrutinised included the moisture content determination, procedural blank determination, cross-contamination from the different spike materials, correction for spectral interferences, instrumental background and deadtime effects, as well as the use of either certified values or IUPAC data in the IDMS equation. The average elemental content in the sediment samples was 30-130 micrograms g-1 for Pb, 0.5-3 micrograms g-1 for Cd and 50-70 micrograms g-1 for Cu. Cr was measured in one sample and was about 60 micrograms g-1. The concentrations in the fly ash sample were up to 2 orders of magnitude higher. Expanded uncertainty for the investigated elements was about 3% (coverae factor k = 2) except for Cr, (measured by high resolution ICPMS), for which the expanded uncertainty was about 7% (k = 2).     

Assessment of Metal Contamination in Doñana National Park (Spain) using Crayfish (Procamburus Clarkii)

Water quality assessment in the Aznalcollar area was attempted using multivariate methods based on heavy metal concentrations in red swamp crayfish (Procamburus clarkii). Trace levels of four heavy metals, copper (Cu), zinc (Zn), cadmium (Cd) and lead (Pb), were detected in crayfish from eleven different stations. Principal component analysis (PCA) highlighted a gradient of contamination between the sampling stations. Cluster analysis (CA) distinguished three groups of stations. Discriminant analysis also differentiated three groups. The group centroids of the first discriminant function were used to devise an index that varies according to the source of the crayfish. These standardized values are proposed for use as a water quality index. The ability of this index to successfully predict environmental quality was proved with random samples.     

Spatial properties of nutrient concentrations in the Baltic Sea

Using existing monitoring data, the present study attempts to characterize spatial patterns of surface water nutrients in the Baltic Sea. The analysis was made for two different spatial scales, differences between and within sub-basins.Non-parametric methods were chosen to reduce problems with the distributional properties of the data. By dividing the data into four seasons care was taken as to seasonality. To avoid bias due to different laboratory analysis, only data from Nordic countries were used, whose results did not apparently depart from each other. Bias due to different sampling frequency was another problem. This was reduced by using only the last observation in each season for every station and year.The results suggested differences in the nutrient concentrations between basins. The two northernmost basins (Bothnian Bay and Bothnian Sea) had lower phosphate concentrations and higher silicate concentrations compared to the rest of the Sea. Bothnian Bay and the Gulf of Finland had higher nitrate concentrations.The concentration structure within basins was studied using transects in both latitudinal and longitudinal direction. A gradient for phosphate and nitrate was found in the Gulf of Finland, with lower concentrations at the mouth. The Bothnian Sea showed lower concentrations in the middle of the basin compared to the coasts. The highest concentrations of phosphate were found close to the Finnish coast and for silicate the highest concentrations were located near the Swedish coast. It was not possible to study variation in the west-east direction within the Baltic proper, due to data shortage. For the transects in the north-south direction no differences were detected for nitrate and silicate. Phosphate gave one significant result during autumn for the transect in the eastern part of the Baltic proper.This study revealed several problems associated with the data available. Uneven sampling in space and time put severe constraints on the study. A better design of the monitoring program is suggested, where spatial properties are considered explicitly. Revision of the program in this direction is needed for reasonable calculation of total amounts and concentrations representative for a basin.     

Trisomy 7 in chorionic villi: Follow-up studies of pregnancy,normal child,and placental clonal anomalies

Cytogenetic study of chorionic villi sampled because of advanced maternal age revealed, after overnight culture, an apparently non-mosaic trisomy 7. Amniocentesis showed exclusively normal mitoses, and the pregnancy continued normally. One hundred mitoses from cord blood of the normal newborn revealed a non-mosaic 46,XX complement. No cells with a proven trisomy 7 were found in cultures from either of two biopsies of the morphologically normal placenta, but the peripheral biopsy showed in multiple cultures an abnormal clone: 47,XX, + 20,-2,-21, + t(2;21)(p13;q22). To our knowledge, this is the first case of non-mosaic trisomy 7 detected on CVS which has had follow-up studies of amniotic fluid, cord blood, and term placenta.