Organic pollution and salt intrusion in Cai Nuoc District, Ca Mau Province, Vietnam.

In Ca Mau, Vietnam, farmers converted from rice to shrimp farming, while ignoring the degradation of the aquatic environment. We assessed the seasonal variations in organic pollution of the surface water and salt intrusion in one district and assessed the difference in chemical characteristics of the surface water of shrimp ponds and canals. Several variables reflecting salinity and organic pollution were measured in the wet and dry season. The results show that in the dry season salinity increased to 37.36-42.73 g l(-1) and COD and suspended solids increased to a maximum of 268.7 mg l(-1) and 1312.0 mg l(-1), respectively. In the wet season salinity values of 8.16 to 10.60 g l(-1) were recorded, indicating that salinity could no longer be washed out completely in this season. It is concluded that salinity and suspended solids in the aquatic environment in the Cai Nuoc district are increased by shrimp monoculture, whereas organic pollution is contributed by human population pressure.     

Self-build packed-bed bioreactor for rapid and effective BOD estimation

This work demonstrated a simple, low-cost, rapid, and effective biochemical oxygen demand (BOD) estimation system based on a packed-bed bioreactor that can be easily self-built on-site at a particular wastewater treatment plant for continuous monitoring of the influent and effluent. The use of natural microbial consortium that were collected from the target wastewater and immobilized on a cheap porous carrier simply by adhesion resulted in an acceptable accuracy of over 95%. The newly developed semi-continuous operating mode with peak-type signals was shown to be able to continuously estimate BOD at a high flow rate to overcome the flow dependence of the oxygen electrode, limit clogging issues, enhance the response time, and lower the limit of detection. The resulting packed-bed bioreactors could work continuously for 22 h with a coefficient of variance (CoV) of only 1.8% or for 13 h a day for several days with a maximum CoV of 1.4% and their response was observed to be stable over 80 consecutive measurements. They exhibited stable responses at a wide pH range of 6.5–8.5, which is also the recommended range for aerobic wastewater treatment, emphasizing the greater ease of use of natural microorganisms for BOD estimation.

     

Quantile relationship between globalization,financial development,economic growth,and carbon emissions: evidence from Vietnam

Environmental Science and Pollution Research - Environmental quality and economic activity have a strong relationship. Carbon emissions remain one of the world’s most dangerous environmental...     

The forest frontier in the Global South: Climate change policies and the promise of development and equity

Halting forest loss and achieving sustainable development in an equitable manner require state, non-state actors, and entire societies in the Global North and South to tackle deeply established patterns of inequality and power relations embedded in forest frontiers. Forest and climate governance in the Global South can provide an avenue for the transformational change needed—yet, does it? We analyse the politics and power in four cases of mitigation, adaptation, and development arenas. We use a political economy lens to explore the transformations taking place when climate policy meets specific forest frontiers in the Global South, where international, national and local institutions, interests, ideas, and information are at play. We argue that lasting and equitable outcomes will require a strong discursive shift within dominant institutions and among policy actors to redress policies that place responsibilities and burdens on local people in the Global South, while benefits from deforestation and maladaptation are taken elsewhere. What is missing is a shared transformational objective and priority to keep forests standing among all those involved from afar in the major forest frontiers in the tropics.Supplementary InformationThe online version contains supplementary material available at 10.1007/s13280-021-01602-1.     

Insights of healthcare waste management practices in Vietnam

Environmental Science and Pollution Research - Nowadays, together with the economic development, public health activities have gained substantial attention with increasing number of hospitals...     

Linearized and nonlinearized modellings for comparative uptake assessment of metal-organic framework-derived nanocomposite towards sulfonamide antibiotics

Environmental Science and Pollution Research - The emergent occurrence of sulfonamide species involving sulfadiazine (SDZ) and sulfamethazine (SMZ) in aquatic systems can cause a wide range of...     

Selective catalytic oxidation of ammonia over copper-cerium composite catalyst

This work considers the oxidation of ammonia (NH3) by selective catalytic oxidation (SCO) over a copper (Cu)-cerium (Ce) composite catalyst at temperatures between 150 and 400 degrees C. A Cu-Ce composite catalyst was prepared by coprecipitation of copper nitrate and cerium nitrate at various molar concentrations. This study also considers how the concentration of influent NH3 (500-1000 ppm), the space velocity (72,000-110,000 hr(-1)), the relative humidity (12-18%) and the concentration of oxygen (4-20%) affect the operational stability and the capacity for removing NH3. The effects of the O2 and NH3 content of the carrier gas on the catalyst's reaction rate also are considered. The experimental results show that the extent of conversion of NH3 by SCO in the presence of the Cu-Ce composite catalyst was a function of the molar ratio. The NH3 was removed by oxidation in the absence of Cu-Ce composite catalyst, and approximately 99.2% NH3 reduction was achieved during catalytic oxidation over the Cu-Ce (6:4, molar/molar) catalyst at 400 degrees C with an O2 content of 4%. Moreover, the effect of the initial concentration and reaction temperature on the removal of NH3 in the gaseous phase was also monitored at a gas hourly space velocity of less than 92,000 hr(-1).     

Emission of heavy metals from animal carcass incinerators in Taiwan

The metal emissions from three incinerators burning different feedstock in Taiwan were characterized in this study. It was found that the Incinerators A and B, treating pig carcasses and animal (including pigs) carcasses, respectively, had much higher metal concentrations in stack flue gases than Incinerator C that combusted medical wastes. However, Incinerator A obtained relative lower metal contents in fly ash and bottom ash than the other two incinerators, mainly because the former used a much lower feedstock rate (although burning at a lower temperature) than the latter. For all the incinerators, (1) Fe, Ni, Pb, and Zn were dominant in both the fly ash and bottom ash while most of the Cd and Pb (more volatile) were present in the fly ash; (2) Fe emission factor was the highest and Zn/Pb/Ni/Cr emission factors were greater than those of Mn/Cd/Cu; (3) the Cu emission factors in bottom ash were relatively higher in comparison with those in fly ash; and (4) indicatory metals were the same (Fe, Zn, Pb, and Cu). The metal emission factors obtained from the livestock incinerators were much higher than those reported from MSW incinerators. Likewise, crematories that burn human cadavers must create similar pollution issues since metal supplements are part of human's normal diets. This causes an environmental concern and this work has important ramifications both in technical and regulatory decisions.     

Field enhancements of packed-bed performance for low-concentration acidic and basic-waste gases from semiconductor manufacturing process

Low-concentration acidic and basic-waste gas pollutants contribute significantly in the total emission of a facility. Previous results show that the control of high volumetric flow rate (approximately 500 m3/min), low-concentration acidic (< 1 ppm by vol) and basic (< 3 ppm by vol) gases from semiconductor process vent, by conventional wet scrubbing technique is a challenging task. This work was targeted to enhance the performance of packed beds for high-volumetric flow rate, low-concentration acidic (HF, HCl), and basic (NH3)-waste gases from the semiconductor manufacturing process. The methodology used to meet the goal was the application of fine-water mist over the inlet stream before entering to the packed bed and use of the surfactant with mist/packed-bed liquid in low concentration. An experimental study was carried out in two acid-packed beds to optimize the operating conditions, such as pH of the liquid, circulating liquid flow rate, blow-down cycle, and so forth. The relationship among liquid pH, liquid ionic concentration, and the removal efficiency of the packed bed for the pollutants has been discussed considering chemical equilibrium, two-film theory, and Henry's law. For the potential utilization of scrubbing water, the dependency of the efficiency on blow-down cycle was studied, and a mechanism is suggested. The proposed water-mist surfactant system was installed in two acid-packed beds, and performance of the packed beds was compared. The background efficiencies of the acid-packed beds for HF, HCl, and NH3 were found max to be (n = 11) 53, 40, and 27%, whereas after installation of the system, they increased significantly and became 76 +/- 13% (n = 10), 76 +/- 8% (n = 7), and 78 +/- 7% (n = 7), respectively, for inlet concentrations of HF and HCl < 1 ppm and NH3 < 14 ppm. The mechanism by which the surfactants operate to enhance the removal in scrubbing process is suggested considering the hydrodynamic effect and the interfacial effect with the charge-generating characteristic of surfactants on water surface, when dissolved into water. The results show that a proposed rectification system can effectively reduce the emission rates below the regulatory level (0.6 kg/hr) at the present conditions of the facility.     

Source location and characterization of volatile organic compound emissions at a petrochemical plant in Kaohsiung, Taiwan

This paper elucidated a novel approach to locating volatile organic compound (VOC) emission sources and characterizing their VOCs by database and contour plotting. The target of this survey was a petrochemical plant in Linyan, Kaohsiung County, Taiwan. Samples were taken with canisters from 25 sites inside this plant, twice per season, and analyzed by gas chromatography-mass spectrometry. The survey covered 1 whole year. By consolidated into a database, the data could be readily retrieved, statistically analyzed, and clearly presented in both table and graph forms. It followed from the cross-analysis of the database that the abundant types of VOCs were alkanes, alkenes/dienes, and aromatics, all of which accounted for 99% of total VOCs. By contour plotting, the emission sources for alkanes, aromatics, and alkenes/ dienes were successfully located. Through statistical analysis, the database could provide the range and 90% confidence interval of each species from each emission source. Both alkanes and alkene/dienes came from tank farm and naphtha cracking units and were mainly composed of C3-C5 members. Regarding aromatics, benzene, toluene, and xylenes were the primary species; they were emitted from tank farm, aromatic units, and xylene units.