Performance assessment of NAPL remediation in heterogeneous alluvium

Over the last few years, more than 40 partitioning interwell tracer tests (PITTs) have been conducted at many different sites to measure nonaqueous phase liquid (NAPL) saturations in the subsurface. While the main goal of these PITTs was to estimate the NAPL volume in the subsurface, some were specifically conducted to assess the performance of remedial actions involving NAPL removal. In this paper, we present a quantitative approach to assess the performance of remedial actions to recover NAPL that can be used to assess any NAPL removal technology. It combines the use of PITTs (to estimate the NAPL volume in the swept pore volume between injection and extraction wells of a test area) with the use of several cores to determine the vertical NAPL distribution in the subsurface. We illustrate the effectiveness of such an approach by assessing the performance of a surfactant/foam flood conducted at Hill Air Force Base, UT, to remove a TCE-rich NAPL from alluvium with permeability contrasts as high as one order of magnitude. In addition, we compare the NAPL volumes determined by the PITTs with volumes estimated through geostatistical interpolation of aquifer sediment core data collected with a vertical frequency of 5-10 cm and a lateral borehole spacing of 0.15 m. We demonstrate the use of several innovations including the explicit estimation of not only the errors associated with NAPL volumes and saturations derived from PITTs but also the heterogeneity of the aquifer sediments based upon permeability estimates. Most importantly, we demonstrate the reliability of the     

Toxicity of methyl tert-butyl ether to marine organisms: ambient water quality criteria calculation

In response to increasing concerns over the detection of methyl tert-butyl ether (MTBE) in groundwater and surface water and its potential effects in aquatic ecosystems, industry and the United States Environmental Protection Agency (USEPA) began to collaborate in 1997 to develop aquatic toxicity databases sufficient to derive ambient water quality criteria for MTBE consistent with USEPA requirements. Acute toxicity data for seven marine species, chronic toxicity data for an invertebrate, and plant toxicity data were developed to complete the saltwater database. The species tested were Cyprinodon variegatus, Gasterosteus aculeatus, Callinectes sapidus, Mytilus galloprovincialis, Palaemonetes pugio, Rhepoxynius abronius, Americamysis bahia, and Skeletonema costatum. The toxicity tests were conducted in accordance with USEPA and American Society for Testing and Materials testing procedures and Good Laboratory Practice guidelines. Data developed from this study were consistent with existing data and showed that MTBE has low acute and chronic toxicity to the marine species tested. Based upon measured MTBE concentrations, acute effects were found to range from 166 mg MTBE/l for the grass shrimp to 1950 mg MTBE/l for marine mussel. The no-observed effect concentration for the reproduction and growth of mysids was 26 mg MTBE/l during the life cycle test. The toxicity of MTBE to saltwater organisms is comparable to its toxicity to the freshwater species tested. Reported MTBE concentrations in coastal waters are several orders of magnitude lower than concentrations observed to cause effects in marine organisms.     

Lead removal from synthetic leachate matrices by a novel ion-exchange material

This paper discusses the application of a novel polyacrylate-based ion-exchange material for the removal of Pb ions from water. Preliminary testing includes the establishment of the operating pH range, capacity information, and the effect of Ca2+ and anions in the matrix. Batch testing with powder indicates slightly different optimal operational conditions from those used for column testing. The ion-exchanger is excellent for removing Pb from aqueous solutions.     

Overview and assessment of techniques to measure ammonia emissions from animal houses: the case of the Netherlands

In order to comply with the ammonia (NH(3)) emission reduction assigned to the Netherlands development of new measures are needed, which should be supported by fast and accurate measurements to arrive at new estimates of the NH(3) emission from each agricultural source. This paper gives an overview of the current methods used in the Netherlands to measure NH(3) emissions from animal houses, and provides alternative methods for some particular situations. For mechanically ventilated animal houses, passive flux samplers placed in the ventilation shafts of the animal house are presented as alternative to measure a larger number of animal houses (replicates) with the same housing system at a low price. For naturally ventilated animal houses, when mixing in the animal house is not good enough to allow measurements within the animal house (internal tracer gas ratio method), two measurement methods are discussed: the Gaussian plume dispersion model, which is usually not suitable for agricultural situations, and the flux frame method, which is not always applicable because of distortion of the flow around the building. Finally, for animal houses with outside yards for the animals, there are at this moment no methods available to measure the NH(3) emissions from these complex situations, although quick box methods (for the outside yards) and a combination of a backward Lagrangian stochastic model with open-path concentration measurements with a tunable diode laser (TDL), look promising.     

Passive air sampling theory for semivolatile organic compounds

The mathematical modelling underlying passive air sampling theory can be based on mass transfer coefficients or rate constants. Generally, these models have not been inter-related. Starting with basic models, the exchange of chemicals between the gaseous phase and the sampler is developed using mass transfer coefficients and rate constants. Importantly, the inter-relationships between the approaches are demonstrated by relating uptake rate constants and loss rate constants to mass transfer coefficients when either sampler-side or air-side resistance is dominating chemical exchange. The influence of sampler area and sampler volume on chemical exchange is discussed in general terms and as they relate to frequently used parameters such as sampling rates and time to equilibrium. Where air-side or sampler-side resistance dominates, an increase in the surface area of the sampler will increase sampling rates. Sampling rates are not related to the sampler/air partition coefficient (K(SV)) when air-side resistance dominates and increase with K(SV) when sampler-side resistance dominates.     

Dissolved oxygen and dietary phosphorus modulate utilization and effluent partitioning of phosphorus in rainbow trout (Oncorhynchus mykiss) aquaculture

Phosphorus (P) is the limiting nutrient in freshwater primary production, and excessive levels cause premature eutrophication. P levels in aquaculture effluents are now tightly regulated. Increasing our understanding of waste P partitioning into soluble, particulate, and settleable fractions is important in the management of effluent P. When water supply is limited, dissolved oxygen concentration (DO) decreases below the optimum levels. Therefore, we studied effects of DO (6 and 10mg/L) and dietary P (0.7 and 1.0% P) on rainbow trout growth, P utilization, and effluent P partitioning. Biomass increased by 40% after 3 weeks. DO at 10mg/L significantly increased fish growth and feed efficiency, and increased the amount of P in the soluble fraction of the effluent. Soluble effluent P was greater in fish fed 1.0% P. DO increases fish growth and modulates P partitioning in aquaculture effluent.     

The impact of pumped water from a de-watered Magnesian limestone quarry on an adjacent wetland: Thrislington, County Durham, UK

Although quarrying is often cited as a potential threat to wetland systems, there is a lack of relevant, quantitative case studies in the literature. The impact of pumped groundwater discharged from a quarry into a wetland area was assessed relative to reference conditions in an adjacent fen wetland that receives only natural runoff. Analysis of vegetation patterns at the quarry wetland site, using Detrended Correspondence Analysis and the species indicator values of Ellenberg, revealed a clear disparity between community transitions in the quarry wetland and the reference site. Limited establishment of moisture-sensitive taxa, the preferential proliferation of robust wetland species and an overall shift towards lower species diversity in the quarry wetland were explicable primarily by the physico-chemical environment created by quarry dewatering. This encompassed high pH (up to 12.8), sediment-rich effluent creating a nutrient-poor substrate with poor moisture retention in the quarry wetland, and large fluctuations in water levels.     

Partitioning of polychlorinated biphenyls in octanol/water, triolein/water, and membrane/water systems

The use of the octanol/water partition constant (Kow) as a surrogate parameter for lipid/water partitioning of persistent organic pollutants (POPs) was reassessed by comparing the measured Kow of 12 selected polychlorinated biphenyl congeners (PCBs) with partition constants in triolein/water (Ktw) and membrane/water (Kmw) systems. Kow and Ktw were measured by the slow-stirring method. Kmw was measured by an adaptation of the slow-stirring method using suspensions of phosphatidylcholine and phosphatidylserine liposomes. Partitioning of POPs to octanol, triolein, and liposomes is similar but not equal. The log-log correlation for Kow and Ktw is excellent (r2 = 0.982) and that for Kow and Kmw is somewhat weaker (r2 = 0.856). Ktw values are greater than Kow by a factor of 1.6. Kmw of some PCB congeners exceed both Kow and Ktw by an order of magnitude. The differences are attributed to different PCB activity coefficients in the different lipid phases. The results imply that Kow can be used as a reasonable conservative estimate of lipid/water partitioning. But the observed differences between Kow and Kmw also indicate that using Kow to predict accumulation of POPs, particularly highly hydrophobic ones, in the polar lipids of organisms will underestimate their concentrations at equilibrium.     

Screening of organic halogens and identification of chlorinated benzoic acids in carbonaceous meteorites

The occurrence of halogenated organic compounds measured as a sum parameter and the evidence of chlorinated benzoic acids in four carbonaceous meteorites (Cold Bokkeveld, Murray, Murchison and Orgueil) from four independent fall events is reported. After AOX (Adsorbable organic halogen) and EOX (Extractable organic halogen) screening to quantify organically bound halogens, chlorinated organic compounds were analyzed by gas chromatography. AOX concentrations varying from 124 to 209 microg Cl/g d.w. were observed in carbonaceous meteorites. Ion chromatographic analysis of the distribution of organically bound halogens performed on the Cold Bokkeveld meteorite revealed that chlorinated and brominated organic compounds were extractable, up to 70%, whereas only trace amounts of organofluorines could be extracted. Chlorinated benzoic acids have been identified in carbonaceous meteorite extracts. Their presence and concentrations raise the question concerning the origin of halogenated, especially chlorinated, organic compounds in primitive planetary matter.     

The recovery of ammonia and hydrogen sulfide from ground-level area sources using dynamic isolation flux chambers: bench-scale studies

Controlled bench-scale laboratory experiments were conducted to evaluate the recovery of ammonia (NH3) and hydrogen sulfide (H2S) from dynamic isolation flux chambers. H2S (80-4000 ppb) and NH3 (5000-40,000 ppb) samples were diffused through the flux chamber to simulate ground level area source emissions while measuring the inlet and outlet flux chamber concentrations simultaneously. Results showed that the recovery of H2S during a 30-min sampling time was almost complete for concentrations >2000 ppb. At the lowest concentration of 80 ppb, 92.55% of the H2S could be recovered during the given sampling period. NH3 emissions exhibited similar behavior between concentrations of 5000-40,000 ppb. Within the 30-min sampling period, 92.62% of the 5000-ppb NH3 sample could be recovered. Complete recovery was achieved for concentrations >40,000 ppb. Predictive equations were developed for gas adsorption. From these equations, the maximum difference between chamber inlet and outlet concentrations of NH3 or H2S was predicted to be 7.5% at the lowest concentration used for either gas. In the calculation of emission factors for NH3 and H2S, no adsorption correction factor is recommended for concentrations >37,500 ppb and 2100 ppb for NH3 and H2S, respectively. The reported differences in outlet and inlet concentration above these ranges are outside the fullscale sensitivity of the gas sensing equipment. The use of 46-90 m of Teflon tubing with the flux chambers has apparently no effect on gas adsorption, because recovery was completed almost instantaneously at the beginning of the tests.