长江宜昌江段几种鱼类体中六六六、滴滴涕的残留水平

利用毛细管电子捕获气相色谱法测定了长江宜昌江段采集的几种鱼样组织内六六六(HCHs)、滴滴涕(DDTs)的残留量.结果表明,在鱼体肌肉、脂肪和肝脏这三种组织中,HCHs、DDTs主要蓄积在鱼体肝脏,其次是脂肪组织,肌肉组织中残留量较低.鱼体肌肉组织中HCHs残留量低于0.5 ng/g,肝脏中的HCHs是其脂肪组织的2倍,最高为27.6 ng/g,主要为悛睭CH所贡献,猹睭CH和洫睭CH未检出.DDTs在鱼体肌肉、脂肪和肝脏组织中的残留量分别为0.4～14.8、12.5～147、33.4～286 ng/g.鱼体组织中DDTs主要以p,p′-DDE的形式存在,p,p′-DDE残留量占∑DDTs的70%左右.与国内外不同水域的鱼体中HCHs、DDTs残留量相比较,长江宜昌江段鱼体肌肉中HCHs和DDTs残留水平较低.     

Separation of fine binary mixtures under vibration in a gas-solid fluidized bed with dense medium.

The coke-slag mixture discharged from water-air generators not only causes a serious environmental problem, but also is a potential resource. In order to obtain a high economic return, separation of fine binary mixtures in a vibrating fluidized bed with dense media was experimentally investigated. The effects of volume ratio (mono-component volume to dense medium volume or binary mixture volume to dense medium volume), the fluidization velocity and vibration parameters on separation efficiency are discussed. The experimental results show that vibration can prevent the coalescence and growth of bubbles and improve fluidization properties of particles and the stability of bed density. The major factors associated with separating efficiency are discussed. Based on the experiments, the ratio of the volume of particles to bed volume and the vibration conditions are also reported. It was found that the separation efficiency for a fine coke-slag mixture was greater than 70% and close to 80% under optimal conditions.     

Ultrafine particle emission characteristics of diesel engine by on-board and test bench measurement

This study investigated the emission characteristics of ultrafine particles based on test bench and on-board measurements. The bench test results showed the ultrafine particle number concentration of the diesel engine to be in the range of (0.56-8.35) × 10⁸ cm^-3. The on-board measurement results illustrated that the ultrafine particles were strongly correlated with changes in real-world driving cycles. The particle number concentration was down to 2.0 × 10⁶ cm^-3 and 2.7 × 10⁷ cm^-3 under decelerating and idling operations and as high as 5.0 × 10⁸ cm^-3 under accelerating operation. It was also indicated that the particle number measured by the two methods increased with the growth of engine load at each engine speed in both cases. The particle number presented a "U" shaped distribution with changing speed at high engine load conditions, which implies that the particle number will reach its lowest level at medium engine speeds. The particle sizes of both measurements showed single mode distributions. The peak of particle size was located at about 50-80 nm in the accumulation mode particle range. Nucleation mode particles will significantly increase at low engine load operations like idling and decelerating caused by the high concentration of unburned organic compounds.     

长白山温带森林挥发性有机物的排放通量

2010年夏季,在长白山温带森林开展了挥发性有机物(VOC)排放通量以及气象参数、PAR的综合测量.VOC排放通量采用松弛涡度积累(RelaxedEddyAccumulation)技术在森林冠层上进行测量.初步发现长白山阔叶林主要排放α-蒎烯、β-蒎烯、莰烯、香桧烯、月桂烯、蒈烯、柠檬烯、罗勒烯、松油烯、繖花烃、萜品油烯、三环烯等.研究表明,长白山阔叶混交林VOC排放有明显的日变化——早晚较低和中午前后较高.2010年夏季,单萜烯总排放通量的平均值为0.242mg·m·h-2-1,其变化范围为0.005～1.668mg·m·h-2-1;各成分排放通量的平均值(和最大值)分别为α-蒎烯0.072(0.234)、莰烯0.028(0.356)、月桂烯0.027(0.433)、蒈烯0.023(0.173)、柠檬烯0.037(0.197)、罗勒烯0.016(0.168)、萜品油烯0.053(0.320)、繖花烃0.067(0.755)mg·m·h-2-1.研究还发现VOC排放通量与气温之间存在一定的联系.     

广州市不同功能区大气二噁英含量和分布特征研究

应用气相色谱-高分辨率质谱仪(GC-HRMS)对广州市秋冬季6个区域环境空气样品中的17种2,3,7,8-氯代二英含量进行了检测.结果表明,广州市各观测区域大气中二英毒性当量浓度范围为0.151～2.230pg.m-3,均值为0.418pg.m-3.各观测区域空气中二英毒性当量浓度分布存在一定的差异,本研究的背景区、居民住宅区和商业区二英毒性当量浓度较低且水平相近,分别为(0.294±0.099)、(0.305±0.115)、(0.308±0.102)pg.m-3.交通枢纽区、郊区和工业区二英毒性当量浓度相对较高,分别为(0.342±0.049)、(0.423±0.113)和(0.838±0.704)pg·m-3.广州市不同功能区二英毒性当量浓度呈现背景区<住宅区<商业区<交通枢纽区<郊区<工业区的分布特点.与2004年相比,广州市城区二英毒性当量浓度有所下降,郊区毒性当量浓度有所上升.     

水泥炉窑SNCR及SCR烟气脱硝技术比较

通过分析水泥炉窑氮氧化物(NOx)生成机理、脱除技术以及国内外水泥炉窑脱硝现状并结合我国具体情况,探讨适合我国的水泥炉窑切实可行脱硝技术,为"十二五"期间我国水泥炉窑开展烟气脱硝整治工作提供技术性方向。     

Biological sulfate removal from acrylic fiber manufacturing wastewater using a two-stage UASB reactor

A two-stage UASB reactor was employed to remove sulfate from acrylic fiber manufacturing wastewater. Mesophilic operation (35±0.5℃) was performed with hydraulic retention time (HRT) varied between 28 and 40 hr. Mixed liquor suspended solids (MLSS) in the reactor was maintained about 8000 mg/L. The results indicated that sulfate removal was enhanced with increasing the ratio of COD/SO₄^2-. At low COD/SO₄^2-, the growth of the sulfate-reducing bacteria (SRB) was carbon-limited. The optimal sulfate removal efficiencies were 75% when the HRT was no less than 38 hr. Sulfidogenesis mainly happened in the sulfate-reducing stage, while methanogenesis in the methane-producing stage. Microbes in sulfate-reducing stage performed granulation better than that in methane-producing stage. Higher extracellular polymeric substances (EPS) content in sulfate-reducing stage helped to adhere and connect the flocculent sludge particles together. SRB accounted for about 31% both in sulfate-reducing stage and methane-producing stage at COD/SO₄^2- ratio of 0.5, while it dropped dramatically from 34% in sulfate-reducing stage to 10% in methane-producing stage corresponding to the COD/SO₄^2- ratio of 4.7. SRB and MPA were predominant in sulfate-reducing stage and methane-producing stage respectively.     

地下空间在节能减排中的应用及展望

在能源短缺和环境污染的双重压力下,我国出台多项措施加大节能减排力度。总结概括了地下空间的几种类型,认为盐岩洞穴、废弃矿洞、废弃油井、枯竭油气层等地下空间经过技术改造,可以埋存CO2、固体垃圾、废弃核原料,储存油气,地热利用等,能创造可观的社会价值和环境保护效益,可作为节能减排的一种有效措施。以山东地区为例,调研分析了山东多处地下空间利用现状,给出了地下空间的三种发展方向。     

碳纳米管径向尺寸对碳纳米管自支撑膜孔隙结构及通量的影响

为了探索碳纳米材料膜在水处理中应用的可能性,本实验选取4种径向尺寸的碳纳米管(Carbon Nanotubes, CNTs),采用压力辅助过滤技术制备CNTs自支撑膜.通过对CNTs自支撑膜的平均孔径、孔径分布及截留分子量(Molecular weight Cut-Off,MWCO)等进行分析,研究了CNTs径向尺寸变化对CNTs自支撑膜孔隙结构的影响.结果表明,CNTs的径向尺寸越小,制备得到的CNTs自支撑膜越趋向于形成小孔径的膜孔,且孔径分布更加均匀,孔隙面积比越高,膜的MWCO越小.单壁碳纳米管(Single-walled carbon nanotube, SWNT)与多壁碳纳米管(Multi-walled carbon nanotube, MWNT)相比,前者更容易形成膜平均孔径更小且孔径分布更均匀的CNTs自支撑膜.膜通量测定结果表明,研究制备的CNTs自支撑膜的通量属于低压膜范围,通量在230～347 L·m~(-2)·h~(-1)·bar~(-1)之间.其中,虽然由径向尺寸较小的CNTs所制备的CNTs自支撑膜的平均孔径更小,但由于其具有更高的孔隙面积比和更小的膜厚度,其纯水通量相对高于由大径向尺寸CNTs制备的CNTs自支撑膜.     

太原市夏季大气VOCs污染特征及臭氧生成潜势

2018年8月采集太原市大气样品,分析太原市夏季大气VOCs的污染特征,并利用最大增量反应活性系数法（MIR系数法）估算了VOCs的臭氧生成潜势（OFP）.结果表明,太原市夏季大气VOCs浓度为17.36~89.60μg/m³,其中烷烃占比58.01%、芳香烃占比20.06%、烯烃占比16.52%、炔烃占比5.40%.大气VOCs浓度变化表现为明显的早晚双高峰特征,且以早高峰影响为主.OFP分析显示,烷烃、烯烃、芳香烃、炔烃分别占总OFP的19.16%、47.74%、31.75%、1.35%,C₃~C₅类烯烃是活性较高的物种,对O₃生成贡献较大.