考虑儿童运动特性的小学教学楼楼梯间人员疏散研究

为研究小学教学楼楼梯间人员运动行为以及影响人员疏散的因素,开展人员疏散实验并构建疏散模拟场景。基于疏散实验研究不同实验场景的出口流量和人员运动速度,通过疏散仿真模拟,分析不同人员运动速度、人员数量及疏散策略对疏散的影响。结果表明:排队下楼的人员运动速度比紧急疏散人员低22.7%,自由上楼人员运动速度比排队上楼人员高8%;人员总疏散时间随人员运动速度的增加而降低,但总疏散时间随速度增加而降低的幅度变小;加入分层疏散策略会增加人群疏散总时间,但整个疏散过程人员分布均匀,在建筑瓶颈不易产生人员过度拥挤现象,因而在疏散过程中应适当采用分层疏散策略。     

Effect of pipes in heat pump system on electric vehicle energy saving

ABSTRACT

Refrigerant pressure drop and temperature change in pipes are normally ignored in the thermodynamic analysis of traditional vehicle air conditioning system, this will result in serious errors. In this Paper, pressure drop and temperature difference are simulated in different pipes of electric vehicle (EV) heat pump system to analysis the effects of pipes in the actual EV heat pump system. The results indicate that the greater the mass flow, the faster pressure drop increases, the temperature difference decreases. Pressure drop of saturated liquid refrigerant is smaller than that of saturated gas refrigerant at the same saturation pressure and mass flow rate. The higher the refrigerant pressure (no phase change), the slower pressure drop decreases, the faster the temperature difference decreases. Pressure drop decreases with the increment of bending angle of the pipe. For EV heat pump system, suitable valves and less branches are helpful for energy saving of the system. Shortening the pipe between compressor and condenser can reduce temperature change obviously. Pressure drop per unit length in the pipe between evaporator and compressor is large especially in heating mode because of lower refrigerant density. It even reaches to over 100 times of that in the pipe between condenser and throttle valve in heating mode and has negative effects on the performance of the system. If the evaporator is closer to the compressor and the number of branches is less, then pressure drop will decrease a lot, which will be advantageous for energy saving of the heat pump system.     

典型有机磷酸酯阻燃剂分析方法研究进展

有机磷酸酯(OPEs)是一类重要的有机磷阻燃剂,近些年逐渐取代了溴代阻燃剂,广泛应用于各行各业,也因此导致在多种环境介质中有较高的暴露量和潜在风险。已有研究表明,OPEs具有一定的毒理效应,对人体及其他生物均有潜在危害。本文综述了近年来国内外OPEs的检测技术,详述了不同环境介质OPEs的前处理方法。结果表明,目前固相萃取(SPE)和固相微萃取(SPME)仍是水样前处理的主要方法;对于固体样品,加速溶剂萃取/加压液相萃取(ASE/PLE)和微波辅助萃取(MAE)应用较多;虽然大气样品仍以固体吸附剂方式为主,但已向在线一体化方向发展;而生物样品的前处理方法多与水样和固体样品方法相似;但是对于复杂环境介质中OPEs样品的前处理较为困难,方法有待改善;气相色谱-质谱联用(GC-MS)和气相色谱-氮磷检测器(GC-NPD)对弱极性和易挥发的OPEs分析效果好,而强极性和难挥发的OPEs多用液相色谱-质谱联用(LCMS);气相色谱-质谱串联(GC-MS/MS)、液相色谱-质谱串联(LC-MS/MS)和高效液相色谱-质谱串联(UPLC-MS/MS)等对多种复杂的环境介质中的OPEs均有较好的检测分析效果,但并未普及。最后,对OPEs分析测试方法的发展趋势提出了展望。     

天津市地表水体与沉积物中7种高关注酚类化合物的污染特征与生态风险分析

为探究地表水体与沉积物中酚类化合物的污染分布特征和生态风险,选择天津市3个水源地与6条主要河流,采集了26个地表水样与6个沉积物样品,利用固相萃取与超声萃取、高效液相色谱-串联质谱法(HPLC-MS/MS)测定了水样及沉积物中1-萘酚(1-naphthol)、壬基酚(nonylphenol, NP)、双酚A(bisphenol A, BPA)、2-苯基苯酚(biphenyl-2-ol)、3,4-二氯酚(3,4-dichlorophenol)、四溴双酚A(tetrabromobisphenol A, TBBPA)和对叔丁基苯酚(p-tert-butylphenol, PTBP)等7种高关注酚类化合物的浓度水平,并应用物种敏感性分布(species sensitivity distribution, SSD)法和熵值法(ecological risk quotient, RQ)评估7种酚类化合物水环境和沉积物的生态风险。结果表明,地表水样中7种酚类化合物均全部检出;其中壬基酚的检出浓度最高,其次为四溴双酚A、对叔丁基苯酚、1-萘酚、2-苯基苯酚、3,4-二氯酚和双酚A。沉积物中酚类化合物的污染分布规律与水样相似,除双酚A外的目标物全部检出。其中,壬基酚浓度比其他物质浓度高2个数量级。风险评估结果显示,壬基酚对水环境与沉积物存在不可接受的风险;而四溴双酚A、对叔丁基苯酚、1-萘酚、2-苯基苯酚、3,4-二氯酚和双酚A则对环境具有较低风险或者存在一定的风险。     

Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.     

Metabolic uncoupler, 3,3′,4′,5-tetrachlorosalicylanilide addition for sludge reduction and fouling control in a gravity-driven membrane bioreactor

• Effects of metabolic uncoupler TCS on the performances of GDMBR were evaluated. • Sludge EPS reduced and transformed into dissolved SMP when TCS was added. • Appropriate TCS increased the permeability and reduced cake layer fouling. • High dosage aggravated fouling due to compact cake layer with low bio-activity. The gravity-driven membrane bioreactor (MBR)system is promising for decentralized sewage treatment because of its low energy consumption and maintenance requirements. However, the growing sludge not only increases membrane fouling, but also augments operational complexities (sludge discharge). We added the metabolic uncoupler 3,3′,4′,5-tetrachlorosalicylanilide (TCS) to the system to deal with the mentioned issues. Based on the results, TCS addition effectively decreased sludge ATP and sludge yield (reduced by 50%). Extracellular polymeric substances (EPS; proteins and polysaccharides) decreased with the addition of TCS and were transformed into dissolved soluble microbial products (SMPs) in the bulk solution, leading to the break of sludge flocs into small fragments. Permeability was increased by more than two times, reaching 60–70 L/m²/h bar when 10–30 mg/L TCS were added, because of the reduced suspended sludge and the formation of a thin cake layer with low EPS levels. Resistance analyses confirmed that appropriate dosages of TCS primarily decreased the cake layer and hydraulically reversible resistances. Permeability decreased at high dosage (50 mg/L) due to the release of excess sludge fragments and SMP into the supernatant, with a thin but more compact fouling layer with low bioactivity developing on the membrane surface, causing higher cake layer and pore blocking resistances. Our study provides a fundamental understanding of how a metabolic uncoupler affects the sludge and bio-fouling layers at different dosages, with practical relevance for in situ sludge reduction and membrane fouling alleviation in MBR systems.     

Photosynthesis and related metabolic mechanism of promoted rice (Oryza sativa L.) growth by TiO2 nanoparticles

• The rice growth was promoted by nano-TiO₂ of 0.1–100 mg/L. • Nano-TiO₂ enhanced the energy storage in photosynthesis. • Nano-TiO₂ reduced energy consumption in carbohydrate metabolism and TCA cycle. Titanium dioxide nanoparticle (nano-TiO₂), as an excellent UV absorbent and photo-catalyst, has been widely applied in modern industry, thus inevitably discharged into environment. We proposed that nano-TiO₂ in soil can promote crop yield through photosynthetic and metabolic disturbance, therefore, we investigated the effects of nano-TiO₂ exposure on related physiologic-biochemical properties of rice (Oryza sativa L.). Results showed that rice biomass was increased >30% at every applied dosage (0.1–100 mg/L) of nano-TiO₂. The actual photosynthetic rate (Y(II)) significantly increased by 10.0% and 17.2% in the treatments of 10 and 100 mg/L respectively, indicating an increased energy production from photosynthesis. Besides, non-photochemical quenching (Y(NPQ)) significantly decreased by 19.8%–26.0% of the control in all treatments respectively, representing a decline in heat dissipation. Detailed metabolism fingerprinting further revealed that a fortified transformation of monosaccharides (D-fructose, D-galactose, and D-talose) to disaccharides (D-cellobiose, and D-lactose) was accompanied with a weakened citric acid cycle, confirming the decrease of energy consumption in metabolism. All these results elucidated that nano-TiO₂ promoted rice growth through the upregulation of energy storage in photosynthesis and the downregulation of energy consumption in metabolism. This study provides a mechanistic understanding of the stress-response hormesis of rice after exposure to nano-TiO₂, and provides worthy information on the potential application and risk of nanomaterials in agricultural production.     

Monitoring land cover change detection with NOAA-AVHRR and MODIS remotely sensed data in the North and West of Africa from 1982 to 2015

Environmental Science and Pollution Research - Mapping land cover changes (LCC) cover three decades over North and West Africa regions provides critical insights for the climate research that...