太湖重金属和营养盐污染特征分析

对太湖各湖区采样点沉积物的重金属Zn、Cu、Mn、Cr、Pb及营养盐Fe-P、TP含量进行分析.结果表明,太湖重金属含量高于地壳中的背景值,Cr和Pb富集程度高于其他金属.几乎所有采样点的沉积剖面的Pb含量自底部向表层迅速增加,表明1950年以来太湖流域含Pb等污染物的工业废水大量排放.竺山湾的重金属及营养盐的污染程度...     

Regulated emission characteristics of in-use LNG and diesel semi-trailer towing vehicles under real driving conditions using PEMS

On-road driving emissions of six liquefied natural gas(LNG) and diesel semi-trailer towing vehicles(STTVs) which met China Emission Standard IV and V were tested using Portable Emission Measurement System(PEMS) in northern China.Emission characteristics of these vehicles under real driving conditions were analyzed and proved that on-road emissions of heavy-duty vehicles(HDVs) were underestimated in the past.There were large differences among LNG and diesel vehicles, which also existed between China V vehicles and China IV vehicles.Emission factors showed the highest level under real driving conditions, which probably be caused by frequent acceleration, deceleration, and start-stop.NOx emission factors ranged from 2.855 to 20.939 g/km based on distance-traveled and 6.719–90.557 g/kg based on fuel consumption during whole tests, which were much higher than previous researches on chassis dynamometer.It was inferred from tests that the fuel consumption rate of the test vehicles had a strong correlation with NOx emission, and the exhaust temperature also affected the efficiency of Selected Catalytic Reduction(SCR) aftertreatment system, thus changing the NOx emission greatly.THC emission factors of LNG vehicles were 2.012–10.636 g/km, which were much higher than that of diesel vehicles(0.029–0.185 g/km).Unburned CH_4 may be an important reason for this phenomenon.Further on-road emission tests, especially CH_4 emission test should be carried out in subsequent research.In addition, the Particulate Number(PN) emission factors of diesel vehicles were at a very high level during whole tests, and Diesel Particulate Filter(DPF)should be installed to reduce PN emission.     

蚯蚓与污水土地处理试验研究

本研究将蚯蚓－－土壤床作为污水处理的一种试验装置。试验对蚯蚓的耐水能力，蚯蚓负荷、污水浓度以及渗滤速度等因素对污水处理效果的影响了初步研究，结果表明：采用合理的间歇运行引养殖污水土地处理是可行的，系统的去除率随渗滤速度的增加而降低；蚯蚓的存在能提高土壤对氮的吸附能力，提高污水处理脱氧效果。     

我国典型钢铁行业主要工艺环节排放颗粒物源成分谱特征

鉴于我国钢铁行业排放颗粒物源成分谱数量不足,有待更新的现状,致力于服务精细化颗粒物源解析的需求,采用稀释通道系统对武汉市某钢铁公司的3个主要工艺环节(烧结、炼钢、炼铁)排放源进行了采样.构建了3类PM_(2.5)源成分谱及3类PM_(10)成分谱,对源谱主要化学组分特征进行了研究,并与国内其他区域已有的钢铁行业源谱研究进行了对比.结果表明:(1)烧结工艺源成分谱中,SO_4~(2-)、Al和NH_4~+等含量高,PM_(2.5)源谱中质量分数依次为22. 2%、4. 5%和3. 5%,PM_(10)源谱中依次为36. 0%、5. 2%和2. 7%,炼铁工艺Fe元素含量最高,在PM_(2.5)源谱和PM_(10)源谱中分别达到28. 3%和24. 5%,炼钢工艺源谱Ca、Fe元素等为主要组分;(2)元素组分中,烧结工艺S元素含量最高,地壳元素在PM_(10)源谱中含量更高,炼铁工艺Pb、Cr等重金属含量偏高,炼钢工艺Cr富集;(3)源谱之间分歧系数的计算显示,同类工艺粗细粒径源谱相似性偏高,烧结工艺与其他两类工艺源谱之间差异性较高,炼钢工艺与炼铁工艺差异性较低.同国内其他区域研究源谱相比,发现Fe、Si和Ca等为钢铁行业排放颗粒物中标识性组分,而碳组分和SO_4~(2-)等组分特征随生产方式、除污设备等不同表现出不同特征.     

电化学原位产生H2O2的影响因素分析及数学建模

以Pt为阳极,石墨碳棒为阴极,Na2SO4为支持电解质,实验探讨了电化学原位产生H2O2的规律.通过正交试验,确定阴极溶液初始pH值、电流密度CD、通氧流量Q和支持电解质浓度CNa2SO4等主要参数对H2O2产生量的影响,并提出最佳参数组合:pH=2.00,CD=1.02mA·cm-2,Q=0.4L·min-1,CNa2SO4=0.1 mol·L-1,极间距D=6cm.采用二次多项式逐步回归和BP神经元网络2种方法,建立了这些参数对于H2O2产生量的预测模型,并对模型进行检验.结果表明,2种方法在一定参数条件下都可预测阴极区溶液中H2O2浓度,BP神经元网络法预测的准确度好于二次多项式逐步回归方法,且更适合于在线控制.     

天津地区大气污染状况和气溶胶硫酸盐的研究

我们于1980—1981年对天津市大气污染物浓度做了同步监测,对天津市大气污染状况,二氧化硫转化为硫酸盐的过程及其对大气能见度的影响做了研究。以超C_i几率和的方法处理数据,研究结果表明,大气污染以早晨最严重,傍晚次之,中午较轻:冬季比夏季污染严重。各种污染物中以硫酸盐对大气能见度的影响最大,总颗粒物次之。当大气相对湿度大于70%时,对大气能见度的影响比较突出。颗粒物中的苯溶物对大气能见度有一定的影响。城市中相对湿度高时硫酸盐浓度大,可能是产生冬季烟雾事件的原因。下风方向的硫酸根浓度与二氧化硫浓度的比值和硫酸根含硫浓度与大气总硫浓度的比值均比上风方向相应的数值高,说明城市燃煤烟气是硫酸盐的来源。城市中硫酸根浓度与二氧化硫浓度的相关系数为0.77,硫酸根与颗粒物浓度的相关系数为0.95。在形成硫酸根的过程中二氧化硫浓度和颗粒物可能有贡献。以一维有源简化模式估算二氧化硫转化为硫酸根的速率常数,约为2.3±1.1%/hr,冬季约1.5%/hr。二氧化硫的迁移距离约为17—340km。     

焦作煤矿区浅层地下水污染成因及特征研究

研究了焦作煤矿区的浅层地下水污染动态，分析了焦作市的地下水污染状况，找出了地下水污染的四条途径，讨论了浅层孔隙地下水污染的主要原因是矿坑排水形成水位降落漏斗、污水灌溉及河渠渗流等，研究了地下水污染的空间分布特征和规律。     

废旧塑料浮选分离中气泡黏附行为的影响

塑料浮选作为一种基于表面活性剂的废旧塑料分选技术,是解决废旧塑料环境污染的有效方法. 为深入考察塑料浮选过程中气泡的黏附行为及影响因素,运用高速摄影技术结合气泡黏附时间模型,对比分析纯水中气泡与亲/疏水材料的黏附效果,重点比较不同溶液〔纯水、鼠李糖脂和SDS(十二烷基硫酸钠)溶液〕中气泡与疏水材料的黏附时间变化,并探讨其影响机制. 结果表明:气泡在纯水中只与疏水材料发生黏附,表面活性剂及其浓度对气泡与疏水材料的黏附时间影响显著. 在c(鼠李糖脂)和c(SDS)(二者均为0.03 mmol/L)均较低的溶液中,气泡与疏水材料的黏附时间由纯水中的158 ms分别降至120和140 ms,而二者较高(10.00 mmol/L)时黏附时间分别增至1 134和338 ms. 基于黏附时间模型分析表明,黏附时间是气泡尺寸、接触角、溶液黏度及表面张力等参数的函数,通过控制这些参数可以调控气泡在目标塑料表面的黏附时间,实现浮选效率的优化.      

高效液相色谱法测定水中的六种邻苯二甲酸酯研究

建立了高效液相色谱法测定水中六种邻苯二甲酸酯(邻苯二甲酸二甲酯、邻笨二甲酸二乙酯、邻苯二甲酸二丁酯、邻苯二甲酸二(2-乙基己基)酯、邻苯二甲酸二辛酯、邻苯二甲酸丁基苄酯)的检测方法.对水样中邻苯二甲酸酯的萃取条件和高效液相色谱分析条件进行优化,采用正己烷二次萃取,浓缩定容后分析,以乙腈-水为流动相梯度洗脱,紫外检测波长226 nm,16 min可将六种邻苯二甲酸酯分离出.方法的检出限为0.13μg/L ～0.37 μg/L,加标回收率为78.6％～118.5％,相对标准偏差为0.82％～2.17％,是一种理想的测定水中六种邻苯二甲酸酯的方法.     

Influences and mechanisms of nanofullerene on the horizontal transfer of plasmid-encoded antibiotic resistance genes between E. coli strains

• Sub-inhibitory levels of nC₆₀ promote conjugative transfer of ARGs. • nC₆₀ can induce ROS generation, oxidative stress and SOS response. • nC₆₀ can increase cell membrane permeability and alter gene expression. • Results provide evidence of nC₆₀ promoting antibiotic resistance dissemination. The spread and development of antibiotic resistance globally have led to severe public health problems. It has been shown that some non-antibiotic substances can also promote the diffusion and spread of antibiotic resistance genes (ARGs). Nanofullerene (nC₆₀) is a type of nanomaterial widely used around the world, and some studies have discovered both the biological toxicity and environmental toxicity of nC₆₀. In this study, cellular and molecular biology techniques were employed to investigate the influences of nC₆₀ at sub-minimum inhibitory concentrations (sub-MICs) on the conjugation of ARGs between the E. coli strains. Compared with the control group, nC₆₀ significantly increased the conjugation rates of ARGs by 1.32‒10.82 folds within the concentration range of 7.03‒1800 mg/L. This study further explored the mechanism of this phenomenon, finding that sub-MICs of nC₆₀ could induce the production of reactive oxygen species (ROS), trigger SOS-response and oxidative stress, affect the expression of outer membrane proteins (OMPs) genes, increase membrane permeability, and thus promote the occurrence of conjugation. This research enriches our understanding of the environmental toxicity of nC₆₀, raises our risk awareness toward nC₆₀, and may promote the more rational employment of nC₆₀ materials.