压裂废水粘度对二氧化锰臭氧催化氧化处理特性的影响

通过FT-IR和GC-MS检测分析,表明了压裂废水中有机物主要以苯环结构为主的芳香类化合物和其他杂环化合物,苯环及杂环上的主要官能团包括酮、酯、羧酸、醛、酚、氨基等。同时,压裂废水中的粘度为常规水粘度的2~3倍。针对压裂废水高粘度和高COD污染水质特征,实验研究了压裂废水二氧化锰臭氧催化氧化处理特性以及粘度对处理效果的影响,研究结果表明,在粘度较高(2.2×10^-3Pa·s)压裂废水中,投加的化学药剂很难扩散,羟基自由基·OH的利用效率较低,处理效果较差。通过投加过硫酸钾(5 g/L)降粘后,可在很大程度上提高二氧化锰臭氧催化氧化的处理效果。通过对压裂废水中有机物分子量分布、FT-IR分析以及GC-MS分析可知,二氧化锰臭氧催化氧化处理压裂废水是通过激发羟基自由基,破坏水中有机物极性和有机物化学构造,将复杂长链有机物转变为简单有机物,其出水COD可达到国家污水综合排放标准中的二级排放标准。     

A comparative study of metal pollution and potential eco-risk in the sediment of Chaohu Lake (China) based on total concentration and chemical speciation

Total and extractable concentrations of Cu, Pb, and Zn were determined in surface sediments of west Chaohu Lake (China) by HCl-HNO₃-HF-HClO₄ digestion and an optimized BCR sequential extraction procedure, respectively. The metal pollution was evaluated by the enrichment factor approach, and the potential eco-risk was evaluated by the sediment quality guideline (SQG) and risk assessment code (RAC) assessments. The results indicated that both total and extractable metal concentrations were highly variable and were affected by sediment properties, even though the sediments were predominantly composed of <63-μm particles (>89 %). Enrichment factors of the metals based on the total and extractable concentrations all showed higher values in the northern lake area and decreasing values towards the south. This distribution indicated an input of anthropogenic metals via the Nanfei River. Anthropogenic Cu, Pb, and Zn in surface sediments showed comparable values for each metal based on the total and extractable concentrations, suggesting that anthropogenic Cu, Pb, and Zn resided predominantly in the extractable fractions. Sediment Cu had low eco-risk, and Pb and Zn had medium eco-risk by the SQG assessment, whereas the eco-risk rankings of Cu, Pb, and Zn were medium, low, and low–high, respectively, by the RAC assessment. Referencing to the labile (dilute acid soluble) metal concentrations, we deduced that the eco-risk of Cu may be largely overestimated by the RAC assessment, and the eco-risk of Pb may be largely overestimated by the SQG assessment. Overall, sediments Cu and Pb may pose low eco-risk, and Zn may pose low–high eco-risk.     

Biosorption of lead(II) in aqueous solution by spent mushroom Tricholoma lobayense

The biosorption of lead(II) ions in both simulated and real wastewater by spent mushroom Tricholoma lobayense, was studied in this work. The results show a biomass with a high potential for removing lead ions from wastewater. The optimum pH for the adsorption is 4, and the adsorption process is fast. The best sorbent mass of the biomaterial is 5 g/L with an initial lead(II) concentration of 1 mmol/L. The process follows the Langmuir isotherm model, and the biosorption capacity of lead ions reaches to 210 mg/g, which is higher than many biosorbents previously studied. The mechanism of biosorption may be mainly attributed to ion exchange. The FT-IR study identifies the functional groups responsible for this process. A scanning electron microscope showed a significant change of the sorbent surface after the biosorption process. The energy dispersive elemental analysis also confirmed the adsorption of lead(II) ions.     

LiFePO_4非均相Fenton法处理亚甲基蓝染料的研究

采用水热法制备出LiFePO4催化剂,通过电子显微镜（SEM）、X射线衍射（XRD）和傅立叶红外光谱（FTIR）对其进行表征,并将其作为非均相Fenton催化剂处理亚甲基蓝（MB）染料溶液。实验结果表明,在催化剂用量为4 g/L,H2O2浓度为0.04 mol/L,pH值为3,温度为50℃,反应时间为60 min的条件下,浓度为500 mg/L的亚甲基蓝脱色率达99%。根据实验结果,讨论了LiFePO4作为非均相Fenton催化剂对亚甲基蓝的降解机理。     

Comparison of the cytotoxic responses of Escherichia coli (E. coli) AMC 198 to different fullerene suspensions (nC60)

Fullerenes are set to be produced on an industrial scale in anticipation of their wide applications. This calls for research on their environmental and health impacts. This study investigates and compares the cell toxicity of different aqueous fullerene aggregates. Popular C₆₀ dispersal methods were used to prepare four types of nC₆₀ aggregates. These aggregates were tested against the indicator species Escherichia coli (E. coli) AMC 198. With aggregates of around 150 nm in diameter, the THF/nC₆₀ suspension was very toxic and gave rise to a half maximal effective concentration (EC₅₀) of 0.54 mg L⁻¹ in E. coli. By contrast, the Tol/nC₆₀ suspension exhibited a cytoprotective role while the Aqu-N₂/nC₆₀ and Aqu-O₂/nC₆₀ suspensions enhanced the metabolism of E. coli. Although some toxicants, such as THF and THF-peroxide, were introduced into the THF/nC₆₀ suspension during the dispersion, the toxicity of nC₆₀ itself cannot be neglected.     

Photocatalytic degradation of methyl orange by a multi-layer rotating disk reactor

Introduction

Solar wastewater treatment based on photocatalytic reactions is a green process that utilizes renewable energy resources and minimizes secondary pollution. Reactor design plays an important role in promoting treatment efficiency and throughput density (based on unit volume of the reactor).

Experimental

A rotating disk reactor that significantly increases the process efficiency has been designed and evaluated for application to photocatalytic decomposition of dye pollutants in aqueous solutions. In this process, a novel multi-layer rotating disk reactor (MLRDR) was presented. Photocatalyst (TiO₂) particles are immobilized on the surfaces of disks. Within each layer of the reactor, methyl orange aqueous solution is allowed to flow from the center of the disk in a radial direction along the surface of the disk, which is rotating at high speed and is irradiated with UV lamps. The effluent is then directed to the center of another layer that lies underneath. Up to four stacked layers have been tested in this study, and the effects due to the number of the layers and volumetric flow rate on reaction conversion are investigated.

Results and discussion

The efficiency of this photocatalytic reactor exhibits complex dependence on these parameters. With selected operating conditions, conversions greater than 95% can be achieved within seconds of residence time. Design equations of the reactor have been derived based on fluid dynamics and kinetic models, and the simulation results show promising scale-up potential of the reactor.     

中国商品有机肥重金属分析

测定了来自10个地区不同生产原料的118个商品有机肥样品的重金属含量.结果表明:(1)商品有机肥样品中的Cd、Hg、Pb、Cr、As、Zn、Cu、Ni的平均值分别为0.600、0.120、7.34、84.30、9.45、202.91、91.06、11.01 mg/kg.(2)河南、湖北、上海的商品有机肥中8种重金属平均值均较高;内蒙古的商品有机肥中Cr平均值为20.32 mg/kg,广西的商品有机肥中Zn平均值为51.36mg/kg,远低于所有样品中Cr和Zn平均值.(3)以猪粪为主要生产原料的商品有机肥中重金属平均值最高.(4)Cr超过中国商品有机肥重金属限量标准、欧盟生态标志法的重金属限量标准、加拿大堆肥重金属限量标准(A级)和加拿大堆肥重金属限量标准(B级);As、Cd超过中国商品有机肥重金属限量标准、欧盟生态标志法的重金属限量标准和加拿大堆肥重金属限量标准(A级);Cu、Zn超过欧盟生态标志法的重金属限量标准和加拿大堆肥重金属限量标准(A级);Hg超过加拿大堆肥重金属限量标准(A级);Pb超过中国商品有机肥重金属限量标准;Ni均未超标.     

On airborne nano/micro-sized wear particles released from low-metallic automotive brakes

The paper addresses the wear particles released from commercially available “low-metallic” automotive brake pads subjected to brake dynamometer tests. Particle size distribution was measured in situ and the generated particles were collected. The collected fractions and the original bulk material were analyzed using several chemical and microscopic techniques. The experiments demonstrated that airborne wear particles with sizes between 10 nm and 20 μm were released into the air. The numbers of nanoparticles (<100 nm) were by three orders of magnitude larger when compared to the microparticles. A significant release of nanoparticles was measured when the average temperature of the rotor reached 300 °C, the combustion initiation temperature of organics present in brakes. In contrast to particle size distribution data, the microscopic analysis revealed the presence of nanoparticles, mostly in the form of agglomerates, in all captured fractions. The majority of elements present in the bulk material were also detected in the ultra-fine fraction of the wear particles.     

Indoor and outdoor sources of size-resolved mass concentration of particulate matter in a school gym—implications for exposure of exercising children

Introduction  

It has been noticed many times that schools are buildings with high levels of particulate matter concentrations. Several authors documented that concentrations of particulate matter in indoor school microenvironments exceed limits recommended by WHO namely when school buildings are situated near major roads with high traffic densities. In addition, exercise under conditions of high particulate concentrations may increase the adverse health effects, as the total particle deposition increases in proportion to minute ventilation, and the deposition fraction nearly doubles from rest to intense exercise.     

皂素提取头道液的典型有机物组成研究

利用紫外、红外拉曼光谱和GC/MS对传统皂素生产工艺、S-F工艺和E-S工艺头道液废水的有机物组成进行了分析。结果表明,传统工艺、S-F和E-S工艺头道液废水的有机物主要是醛类,此外,传统工艺头道液中检测到的22种有机物中,还有大量生物难降解的杂环类（12.24%）;而S-F和E-S工艺头道液中检测到的25种和31种有...