Gas and Particle Emissions from Automobile Tires in Laboratory and Field Studies

This paper is directed to air pollution scientists interested in special mobile emission sources. The purpose was to determine the contribution which automobile tires make to air pollution. The gaseous hydrocarbon and sulfur compounds emitted in laboratory tests were identified. Although these hydrocarbons can participate in smog reactions, their mass emission rate is less than 0.1 % of the current exhaust hydrocarbon emission rate. Hydrocarbons from tires are not measurable near a freeway. The particulate emitted from tires ranges in size from 0.01 μm to more than 30 μm, with the larger particles dominating the total mass. Measurements along a California freeway showed that most of the tire debris had settled within 5 m of the pavement edge. Airborne rubber concentrations were less than 0.5 μg/m³, or less than 5% of the total tire wear. These field measurements confirm the indoor emission pattern and verify that tire wear products are not a significant air pollution problem.     

Dry FGD at United Power Association’s Stanton Station

The United Power Association’s dry FGD system at Stanton, North Dakota was the first utility-operated lime spray dryer to be put into service in the United States. At 60 MW in size, it utilizes a single spray dryer vessel with three rotary atomizers and a ten-compartment fabric filter. It is currently operating at better than expected efficiency and Is meeting state and federal air quality requirements. Start-up and operation have shown that certain areas of design and operating conditions are critical to reliable operation. Flue gas, slurry, and water distribution and mixing must be carefully controlled if reliable, long term operation is to be achieved. Likewise, water chemistry Is Important in the reagent preparation equipment. Start-up of the system was accomplished In a step-wise fashion to bring the baghouse on line first, followed by the spray dryer. The spray dryer was operated at gradually lower outlet temperatures until design conditions were met. Measures taken since start-up to ensure reliable operation, and operation over an eighteen month period are discussed. Both particulate and SO₂ emission performance are evaluated.     

A Pilot Indoor-Outdoor Study of Organic Particulate Matter and Particulate Mutagenicity

Abstract

Many large metropolitan areas experience elevated concentrations of ground-level ozone pollution during the summertime “smog season”. Local environmental or health agencies often need to make daily air pollution forecasts for public advisories and for input into decisions regarding abatement measures and air quality management. Such forecasts are usually based on statistical relationships between weather conditions and ambient air pollution concentrations. Multivariate linear regression models have been widely used for this purpose, and well-specified regressions can provide reasonable results. However, pollution-weather relationships are typically complex and nonlinear—especially for ozone—properties that might be better captured by neural networks. This study investigates the potential for using neural networks to forecast ozone pollution, as compared to traditional regression models. Multiple regression models and neural networks are examined for a range of cities under different climate and ozone regimes, enabling a comparative study of the two approaches. Model comparison statistics indicate that neural network techniques are somewhat (but not dramatically) better than regression models for daily ozone prediction, and that all types of models are sensitive to different weather-ozone regimes and the role of persistence in aiding predictions.     

Particulate,Carbon Monoxide,and Acid Emission Factors for Residential Wood Burning Stoves

Emissions from residential wood burning stoves are of Increasing concern in many areas. This concern is due to the magnitude of the emissions and the toxic and chemical characteristics of the pollutants. Recent testing of standard and new technology woodstoves has provided data for developing a family of particulate and carbon monoxide emission factor curves. This testing has also provided data illustrating the acidity of woodstove emissions. The particulate and carbon monoxide curves relate the actual stove emissions to the stove size and operating parameters of burn rate, fuel loading, and fuel moisture. Curves relating stove types to the acidity of emissions have also been constructed.

Test data show actual emissions vary from 3 to 50 grams per kilogram for particles and from 50 to 300 grams per kilogram for carbon monoxide. Since woodstove emissions are the largest single category of particulate emissions in many areas, it Is essential that these emissions be quantified specifically for geographic regions, allowing meaningful impact analysis modeling to be accomplished. Emission factors for particles and carbon monoxide are presented from several stove sizes and burn rates.

The acidic nature of woodstove emissions has been clearly demonstrated. Tests indicate woodstove flue gas condensate solutions to be predominantly in the 2.8 to 4.2 pH range. Condensate solutions from conventional woodstoves exhibited the characteristic buffering capacity of carboxylic acids when titrations were performed with a strong base. The environmental impact of buffered acidic woodstove emissions is not currently well understood; however, it is possible with the data presented here to make semi-quantitative estimates of acid emissions from particulate and carbon monoxide emission factors and wood use inventories.     

Rotary Kiln Incineration III. An Indepth Study—Kiln Exit/Afterburner/Stack Train and Kiln Exit Pattern Factor Measurements During Liquid CCl4 Processing

Temperature and stable species concentration data are presented from various locations within a full-scale rotary kiln incinerator firing natural gas/carbon tetrachloride/air. The data are being collected as part of a cooperative program involving university, industry and government participation. The overall goal of the program is to develop a more sophisticated understanding of and a predictive capability for rotary kiln and afterburner performance as influenced by basic design and operational parameters. Non-uniformities in stable species and temperature exist for this particular kiln, at the kiln exit, under certain operating conditions. Flow perturbations from within the kiln were found to persist into the afterburner, but not into the stack. High destruction and removal efficiencies (DRE’s) were achieved under the operating conditions of these tests through adequate secondary combustion processing.     

Rotary Kiln Incineration IV. An Indepth Study— Kiln Exit,Transition and Afterburner Sampling During Liquid CCl4 Processing

Detailed temperature and stable species concentration data are presented from the kiln exit, transition section and afterburner of a full-scale incinerator facility firing natural gas/carbon tetrachloride/air. The data are collected as part of a cooperative program involving university, industry and government participation. The overall goal of the program is to develop an understanding and predictive capability for rotary kiln and afterburner performance as influenced by basic design and operational parameters. The data demonstrate that nonuniformities in stable species and temperature exist, under certain operating conditions, at the kiln exit in the vertical direction only. Measurements from the transition section indicate that non-uniformities may exist within this region under certain operating conditions. Flow perturbations from within the kiln can persist into the afterburner, although the degree of nonuniformity is substantially reduced compared to either the kiln or transition sections. High destruction and removal efficiencies were achieved under all operating conditions of these tests through a combination of kiln and secondary combustion processing.     

Indoor/Outdoor Measurements of Volatile Organic Compounds in the Kanawha Valley of West Virginia

The Kanawha Valley region of West Virginia which is comprised of Charleston and surrounding communities Is the center of a heavily industrialized area known for its chemical manufacturing. As part of a larger study designed to investigate the Impact of the chemical industry on human exposures to volatile organic compounds (VOC), a study of the relationship between indoor and outdoor concentrations was conducted. Thirty-five homes were selected for monitoring from among volunteers; approximately ten in each of three distinct population-industry centers and four outside the Valley to act as controls. Monitoring was performed using passive, badge samplers with a three-week monitoring period. Two separate questionnaires were administered: one for characterization of the residence; and one to characterize source use during monitoring. Participants were also asked to keep a record of their activities with respect to in-home, outdoors and other Indoor environments. Analysis of the samplers was performed by solvent extraction followed by gas chromatography using a flame-ionization detector. Results suggest that indoor VOC concentrations are higher than outdoor concentrations. Additionally, certain ventilation-related parameters were identified that afforded some predictive power for indoor concentrations. No statistically significant differences between regions were identified.