Cross-reactivity of anti-Salmonella egg-yolk antibodies to Salmonella serovars

The cross-reactivity of egg yolk antibodies specific to antigens of Salmonella Enteritidis and Salmonella Typhimurium to killed bacterial cells of common Salmonella serovars were tested using an indirect Enzyme Linked Immunosorbent Assay (ELISA). Egg yolk antibodies were produced against purified fimbriae, flagella and lipopolysaccharide (LPS) of S. Enteritidis strain ATCC13076 and flagella, LPS and outer membrane proteins (OMP) of S. Typhimurium strain ATCC13311. For immunological specificity of egg yolk antibodies against killed bacterial cells, we found that the titers of the anti-S. Enteritidis egg yolk antibodies were higher than those of the anti-S. Typhimurium antibodies. In the evaluation of cross-reactivity of these egg yolk antibodies to various Salmonella serovars, we observed that the anti-S. Enteritidis antibodies exhibited more specific affinity than those of the anti-S. Typhimurium antibodies. All S. Enteritidis strains reacted specifically with the anti-S. Enteritidis fimbrial and flagellar egg yolk antibody whereas anti-S. Enteritidis LPS and anti-S. Typhimurium LPS, OMP and flagellar antibodies displayed non-specific reactivity to all Salmonella serovars used in this study. This finding suggests that it may be possible to design a anti-fimbrial egg yolk antibody of S. Enteritidis as a diagnostic tool and a cocktail of OMP and LPS antigens of S. Enteritidis and S. Typhimurium could be used for administering broad spectrum passive immunity to protect against the colonization of pathogenic Salmonella strains in food animals.     

Consequences of nitrate leaching following stem-only harvesting of Swedish forests are dependent on spatial scale

Short-term increases in soil solution nitrate (NO₃⁻) concentration are often observed after forest harvest, even in N-limited systems. We model NO₃⁻ leaching below the rooting zone as a function of site productivity. Using national forest inventories and published estimates of N attenuation in rivers and the riparian zone, we estimate effects of stem-only harvesting on NO₃⁻ leaching to groundwater, surface waters and the marine environment. Stem-only harvesting is a minor contributor to NO₃⁻ pollution of Swedish waters. Effects in surface waters are rapidly diluted downstream, but can be locally important for shallow well-waters as well as for the total amount of N reaching the sea. Harvesting adds approximately 8 Gg NO₃-N to soil waters in Sweden, with local concentrations up to 7 mg NO₃-N l⁻¹. Of that, ∼3.3 Gg reaches the marine environment. This is ∼3% of the overall Swedish N load to the Baltic.     

Variation in biogenic volatile organic compound emission pattern of Fagus sylvatica L. due to aphid infection

Volatile organic compounds (VOCs) have been the focus of interest to understand atmospheric processes and their consequences in formation of ozone or aerosol particles; therefore, VOCs contribute to climate change. In this study, biogenic VOCs (BVOCs) emitted from Fagus sylvatica L. trees were measured in a dynamic enclosure system. In total 18 compounds were identified: 11 monoterpenes (MT), an oxygenated MT, a homoterpene (C₁₄H₁₈), 3 sesquiterpenes (SQT), isoprene and methyl salicylate. The frequency distribution of the compounds was tested to determine a relation with the presence of the aphid Phyllaphis fagi L. It was found that linalool, (E)-β-ocimene, α-farnesene and a homoterpene identified as (E)-4,8-dimethyl-1,3,7-nonatriene (DMNT), were present in significantly more samples when infection was present on the trees. The observed emission spectrum from F. sylvatica L. shifted from MT to linalool, α-farnesene, (E)-β-ocimene and DMNT due to the aphid infection. Sabinene was quantitatively the most prevalent compound in both, non-infected and infected samples. In the presence of aphids α-farnesene and linalool became the second and third most important BVOC emitted. According to our investigation, the emission fingerprint is expected to be more complex than commonly presumed.     

Equilibration time scales of organic aerosol inside thermodenuders: Evaporation kinetics versus thermodynamics

The interpretation of thermodenuder (TD) data often relies on the assumption that thermodynamic equilibrium is reached inside the instrument. We modeled the evaporation of three organic aerosol types (adipic acid, α-pinene SOA and aged OA) inside a thermodenuder with a mass transfer model, and calculated equilibration time scales for these systems at realistic conditions. The equilibrium times varied from less than a second to several hours, decreasing with increasing aerosol concentrations, decreasing particle sizes, decreasing volatilities and increasing mass accommodation coefficients. The results indicate that generally TDs measure particle evaporation rates rather than equilibria, and time-dependent modeling of the evaporation is usually needed to interpret the data. Measurements at varying residence times and temperatures, on the other hand, are desirable to investigate the equilibration of the studied aerosol and decouple the kinetic effects from the effects caused by the thermodynamic properties of the aerosol. Organic aerosol is likely to be further from equilibrium under typical field conditions compared with laboratory data. When determining the aerosol properties from TD data, assuming incorrectly equilibrium results in under-prediction of the vaporization enthalpy of the evaporating species. Similar under-estimation is predicted if multicomponent aerosols are approximated with single-component properties.     

Aerosol speciation and mass prediction from toluene oxidation under high NOx conditions

A kinetically based gas-particle partitioning box model is used to highlight the importance of parameter representation in the prediction of secondary organic aerosol (SOA) formation following the photo-oxidation of toluene. The model is initialized using experimental data from York University's indoor smog chamber and provides a prediction of the total aerosol yield and speciation. A series of model sensitivity experiments were performed to study the aerosol speciation and mass prediction under high NO_x conditions (VOC/NO_x = 0.2). Sensitivity experiments indicate vapour pressure estimation to be a large area of weakness in predicting aerosol mass, creating an average total error range of 70 μg m^?3 (range of 5–145 μg m^?3), using two different estimation methods. Aerosol speciation proved relatively insensitive to changes in vapour pressure. One species, 3-methyl-6-nitro-catechol, dominated the aerosol phase regardless of the vapour pressure parameterization used and comprised 73–88% of the aerosol by mass. The dominance is associated with the large concentration of 3-methyl-6-nitro-catechol in the gas-phase. The high NO_x initial conditions of this study suggests that the predominance of 3-methyl-6-nitro-catechol likely results from the cresol-forming branch in the Master Chemical Mechanism taking a significant role in secondary organic aerosol formation under high NO_x conditions. Further research into the yields and speciation leading to this reaction product is recommended.     

Evaluation of airborne particulate matter and metals data in personal,indoor and outdoor environments using ED-XRF and ICP-MS and co-located duplicate samples

Factors and sources affecting measurement uncertainty associated with monitoring metals in airborne particulate matter (PM) were investigated as part of the Windsor, Ontario Exposure Assessment Study (WOEAS). The assessment was made using co-located duplicate samples and a comparison of two analytical approaches: ED-XRF and ICP-MS. Sampling variability was estimated using relative percent difference (RPD) of co-located duplicate samples. The comparison of ICP-MS and ED-XRF results yields very good correlations (R² ≥ 0.7) for elements present at concentrations that pass both ICP-MS and ED-XRF detection limits (e.g. Fe, Mn, Zn, Pb and Cu). PM concentration ranges (median, sample number) of 24-h indoor PM₁₀ and personal PM₁₀ filters, and outdoor PM_2.5 filters were determined to be 2.2–40.7 (11.0, n = 48) μg m^?3, 8.0–48.3 (11.9, n = 48) μg m^?3, and 17.1–42.3 (21.6, n = 18) μg m^?3, respectively. The gravimetric analytical results reveal that the variations in PM mass measurements for same-day sampling are insignificant compared to temporal or spatial variations: 92%, 100% and 96% of indoor, outdoor and personal duplicate samples, respectively, pass the quality criteria (RPD ≤ 20%). Uncertainties associated with ED-XRF elemental measurements of S, Ca, Mn, Fe and Zn for 24-h filter samples are low: 78%–100% of the duplicate samples passed the quality criteria. In the case of 24-h filter samples using ICP-MS, more elements passed the quality criteria due to the lower detection limits. These were: Li, Na, K, Ca, Si, Al, V, Fe, Mn, Co, Cu, Mo, Ag, Zn, Pb, As, Mg, Sb, Sn, Sr, Th, Ti, Tl, and U. Low air concentrations of metals (near or below instrumental detection limits) and/or inadvertent introduction of metal contamination are the main causes for excluding elements based on the pass/fail criteria. Uncertainty associated with elemental measurements must be assessed on an element-by-element basis.     

Impact of the Knudsen number and mass-transfer expression on multi-phase kinetic modeling

Three different mass-transfer expressions are employed within the Model of Aerosol, Gas, and Interfacial Chemistry (MAGIC) to study gas-phase molecular chlorine and bromine production from NaCl and NaBr aerosols, respectively. Simulations of chamber experiments are performed in which NaCl aerosols react with gas-phase ozone in the presence of UV light, in order to identify the importance of the Knudsen number and mass-transfer expression in systems with varying contributions from gas-phase, aqueous-phase, and interfacial chemistry. In the case of NaBr aerosols, simulations are performed of both dark and photolytic conditions. A range of Knudsen numbers spanning the continuum, transition and free-molecular regimes is studied. Particle size is varied over three orders of magnitude, and particle concentration is changed to keep either (a) total aerosol volume or (b) total aerosol surface area constant. When total aerosol volume is constant, the total amount of surface area available for interfacial reaction increases linearly with Knudsen number. Consequently peak gas-phase Cl₂ and Br₂ concentrations increase by two orders of magnitude from the continuum regime to the free-molecular regime. When total aerosol surface area is constant, total aerosol volume is inversely proportional to Knudsen number, with lesser volume being available at higher Knudsen numbers. Consequently Cl^? depletion in the kinetic regime leads to most gas-phase Cl₂ being produced in the transition regime. Gas-phase Br₂ concentration trends are determined by aqueous-phase reaction mechanisms, leading to a monotonic decrease in production with Knudsen number. At all Knudsen numbers, more gas-phase bromine is produced in the photolytic case than in the dark case, the difference being significant in the transition regime. Results of this study suggest that halogen production is insensitive to the mass-transfer expression used in the simulations.     

Simulating the fine and coarse inorganic particulate matter concentrations in a polluted megacity

A three dimensional chemical transport model (PMCAMx) is applied to the Mexico City Metropolitan Area (MCMA) in order to simulate the chemical composition and mass of the major PM₁ (fine) and PM_1–10 (coarse) inorganic components and determine the effect of mineral dust on their formation. The aerosol thermodynamic model ISORROPIA-II is used to explicitly simulate the effect of Ca, Mg, and K from dust on semi-volatile partitioning and water uptake. The hybrid approach is applied to simulate the inorganic components, assuming that the smallest particles are in thermodynamic equilibrium, while describing the mass transfer to and from the larger ones. The official MCMA 2004 emissions inventory with improved dust and NaCl emissions is used. The comparison between the model predictions and measurements during a week of April of 2003 at Centro Nacional de Investigacion y Capacitacion Ambiental (CENICA) “Supersite” shows that the model reproduces reasonably well the fine mode composition and its diurnal variation. Sulfate predicted levels are relatively uniform in the area (approximately 3 μg m^?3), while ammonium nitrate peaks in Mexico City (approximately 7 μg m^?3) and its concentration rapidly decreases due to dilution and evaporation away from the urban area. In areas of high dust concentrations, the associated alkalinity is predicted to increase the concentration of nitrate, chloride and ammonium in the coarse mode by up to 2 μg m^?3 (a factor of 10), 0.4 μg m^?3, and 0.6 μg m^?3 (75%), respectively. The predicted ammonium nitrate levels inside Mexico City for this period are sensitive to the physical state (solid versus liquid) of the particles during periods with RH less than 50%.     

Critical Steps for Continuing Advancement of Satellite Rainfall Applications for Surface Hydrology in the Nile River Basin1

Gebremichael, Mekonnen, Emmanouil N. Anagnostou, and Menberu M. Bitew, 2010. Critical Steps for Continuing Advancement of Satellite Rainfall Applications for Surface Hydrology in the Nile River Basin. Journal of the American Water Resources Association (JAWRA) 46(2):361-366. DOI: 10.1111/j.1752-1688.2010.00428.x. Abstract: Given the increasingly higher resolution and data accessibility, satellite precipitation products could be useful for hydrological application in the Nile River Basin, which is characterized by lack of reasonably dense hydrological in situ sensors and lack of access to the existing dataset. However, in the absence of both extreme caution and research results for the Nile basin, the satellite rainfall (SR) products may not be used, or may even be used erroneously. We identify two steps that are critical to enhance the value of SR products for hydrological applications in the Nile basin. The first step is to establish representative validation sites in the Nile basin. The validation site will help to quantify the errors in the different kinds of SR products, which will be used to select the best products for the Nile basin, include the errors in decision making, and design strategies to minimize the errors. Using rainfall measurements collected from the unprecedented high-density rain gauge network over a small region within the Nile basin, we indicate that SR estimates could be subject to significant errors, and quantification of estimation errors by way of establishing validation sites is critically important in order to use the SR products. The second step is to identify the degree of hydrologic model complexity required to obtain more accurate hydrologic simulation results for the Nile basin when using SR products as input. The level of model complexity may depend on basin size and SR algorithm, and further research is needed to spell out this dependence for the Nile basin.     

Hume’s Knave and Nonanthropocentric Virtues

This essay offers a critical assessment of environmental virtue ethics (EVE). Finding an environmental ethical analogy with Hume’s critique of the sensible knave, I argue that EVE is limited in much the same way as morality is on the Humean view. Advocates of nonanthropocentrism will find it difficult to engage those whose virtues comport them to anthropocentrism. Nonetheless, EVE is able to ground confidence in nonanthropocentric virtues by explicating specific key virtues, thereby holding open the possibility of bridging the motivational gap between anthropocentrism and nonanthropocentrism.