The Fate of Vanadium in an Urban Air Shed: The Lower Delaware River Valley

Vanadium compounds are toxic pollutants which require engineering control in the design stage. In the lower Delaware River Valley, the main sources are presently the combustion of vanadium rich fuel oils and the catalytic processing of high vanadium crudes. These and other Industrial emissions, result in atmospheric vanadium concentrations which have varied from 0.133 μg/m³ to 0.557 μg/m³ between 1958 and 1969. Compounds of vanadium, principally with oxygen and sulfur, are considered. The dominance of oxygen compounds over sulfur compounds as derived from equilibrium data, and the tendency of vanadium oxides to move toward vanadium’s maximum valence of +5, indicate the prevalence of V₂0₅ as the emission compound.     

Biological Effects of Carbon Monoxide vs. Whole Emissions from Engine with Catalyst

The introduction of oxidizing catalytic converters in the exhaust system of automobiles has been found to be effective in reducing carbon monoxide, total hydrocarbons, and some other components of tailpipe emissions. The utilization of these converters, however, has also caused further oxidation of sulfur compounds producing an increased amount of sulfur trioxide (SO₃) which yields sulfuric acid and sulfates.¹ Studies on the biological effects of these sulfur compounds are in progress in our laboratory and preliminary findings are reported separately. This paper compares the biological effects of exposure to whole emissions from engines with and without converter and exposure to carbon monoxide alone.     

Some Heavy-Metal Pollutants in the Air of Naples

ABSTRACT

In this paper, assumptions regarding future land use as a key uncertainty is considered and its impact on risk analysis for contaminated sites is assessed. Risks are assessed for two land use scenarios (current-use industrial and future-use residential) using probabilistic models that incorporate uncertainty and variability in the exposure parameters. Residual risks are calculated for both industrial and residential cleanup standards. A Superfund site in northern California is considered.

In general, for the unremediated case, the future-use residential scenarios produce larger risks (1 to 3 orders of magnitude) than current- (continued) use industrial scenarios. For the Superfund site studied, the residual risks calculated for the remedy selected was not sufficiently protective of future-use residents in that it did not meet .S. Environmental Protection Agency (EPA) risk goals, but was protective of current-use workers, even though the cleanup criteria were based on residential use. Alternative risk management practices, such as deed restrictions, can be used in such cases.     

Evaluation of Selected Gaseous Halocarbons for Use in source Test Performance Audits

A repository of 38 gaseous organic compounds in compressed gas cylinders has been established by EPA. This repository was established to provide standards for source test performance audits, that is, quantitative quality assurance tests. Among these compounds are ten halogenated organic species, which are the focus of this paper.

Stability studies of all ten compounds have been performed to determine the feasibility of using them as performance audit standards. Results indicate that all of the halocarbons tested are adequately stable to be used as reliable audit standards.

Subsequent to completion of stability studies, four of the ten halocarbons were used in source test performance audits. Results are available at this time for two of the four compounds; the results show agreement within 10% of the concentrations previously established by Research Triangle Institute.     

Atmospheric Deposition and Ionic Input in Adirondack Forests

Major mechanisms for input of ions to forest ecosystems in the central Adirondack Mountains of New York State were studied. Precipitation and throughfall in adjacent northern hardwood and lake margin coniferous forests were continuously sampled from May 2, 1979 to May 7, 1980. Important mechanisms for transport of ions from atmosphere to forest floor were identified using regression analyses and the assumption that deciduous and coniferous forests capture particulates and aerosols with differing efficiencies. Sodium was delivered in precipitation and dry-fall and interacted little with the forest canopies. Hydrogen, potassium, and magnesium were also deposited primarily by bulk precipitation but hydrogen was retained by foliage while additional quantities of potassium and magnesium were leached from tree canopies. Impaction of suspended particulates and/or aerosols on forest vegetation was an important source of additional sulfate and nitrate, and these ions contributed to the leaching of calcium from foliage.     

Indoor Ozone Exposures

Indoor and outdoor ozone concentrations were measured from late May through October at three office buildings with very different ventilation rates. The indoor values closely tracked the outdoor values, and, depending on the ventilation rate, were 20 to 80 percent of those outdoors. The Indoor/outdoor data are adequately described with a mass balance model. The model can also be coupled with reported air exchange rates to estimate indoor/outdoor ratios for other structures. The results from this and previous studies indicate that Indoor concentrations are frequently a significant fraction of outdoor values. These observations, and the fact that most people spend greater than 90 percent of their time indoors, indicate that indoor ozone exposure (concentration × time) is greater than outdoor exposure for many people. Relatively Inexpensive strategies exist to reduce indoor ozone levels, and these could be implemented to reduce the public’s total ozone exposure.     

Polymers as Solid Waste in Municipal Landfills

Abstract

Synthetic polymers reach municipal landfills as components of products such as waste household paints, packaging films, storage containers, carpet fibers, and absorbent sanitary products. Some polymers in consumer products that reach landfills are designed to photodegrade or biodegrade. This article examines the significance of degradable polymers in management of solid waste in municipal landfills. Most landfills are not designed to photodegrade or biodegrade solid waste. Landfill disposal of stable polymers such as polyacrylics and polyethylenes is not associated with significant polymer degradation or mobility. Stability to photodegradation and biodegradation is an advantage when municipal landfills are used for disposal of polymer products as solid waste. Use of landfill disposal can be a responsible means to manage polymer waste and can be part of an overall waste management plan which includes source reduction, recycling, reuse, composting, and waste-to-energy incineration.     

Rotary Kiln Incineration of Dichloromethane and Xylene: A Comparison of Incinerability Characteristics Under Various Operating Conditions

Comparisons are made, for the first time, between the combustion characteristics of dichloromethane and xylene in an industrial rotary kiln incinerator. The comparisons are made under different operating conditions, including variable kiln rotation rate and operation both with and without turbulence air. Continuous gas composition and temperature measurements and batch gas composition measurements were obtained from two vertical locations hear the exit region of the rotary kiln. The measurements show that there is significant vertical stratification at the exit of the kiln. Addition of turbulence air enhanced combustion conditions throughout the kiln during xylene processing. During dichloromethane processing, however, the addition of turbulence air had minimal effect and only promoted greater bulk mixing; chlorinated compounds transported from the lower kiln during operation with turbulence air were not efficiently processed in the upper kiln. Evolution of test liquids from the bed was not constant but rather was characterized by intermittent peaks. The field-scale data of this work suggest that the evolution rate of the test liquid was increased as kiln rotation rate increased. Many of the differences between xylene and dichloromethane processing during these experiments are explained by a simple stoichiometric analysis.     

Exposure of Chronic Obstructive Pulmonary Disease Patients to Particulate Matter: Relationships between Personal and Ambient Air Concentrations

ABSTRACT

Most time-series studies of particulate air pollution and acute health outcomes assess exposure of the study population using fixed-site outdoor measurements. To address the issue of exposure misclassification, we evaluate the relationship between ambient particle concentrations and personal exposures of a population expected to be at risk of particle health effects.

Sampling was conducted within the Vancouver metropolitan area during April-September 1998. Sixteen subjects (non-smoking, ages 54-86) with physician-diagnosed chronic obstructive pulmonary disease (COPD) wore personal PM_{2 5} monitors for seven 24-hr periods, randomly spaced approximately 1.5 weeks apart. Time-activity logs and dwelling characteristics data were also obtained for each subject. Daily 24-hr ambient PM₁₀ and PM_2.5 concentrations were measured at five fixed sites spaced throughout the study region. SO₄ ^2-, which is found almost exclusively in the fine particle fraction and which does not have major indoor sources, was measured in all PM_{2 5} samples as an indicator of accumulation mode particu-late matter of ambient origin.