工业烟气净化系统的风量平衡调节及数值模拟应用研究

为了对某钢铁集团烧结机尾气净化系统的风量平衡进行调节,提出了利用Fluent仿真软件对通风管道内部流场进行数值模拟,在主管和部分支管上设置节流管、调节管径的改进措施。风量模拟结果表明,通风管道的原风量存在严重的不平衡性,吸尘点的风量不平衡率高达75.0%,在部分管道增加节流管可以有效调整管道的风量不平衡性,调整后吸尘点风量的不平衡率为18.8%;对于压力损失较大、风量偏小的管道,可通过管径调节使其风量基本达到设计要求;Fluent仿真软件的风量模拟值与现场实测值有较高的吻合性,数值模拟方法可以为工业烟气净化系统的改造提供参考依据。不仅能够为前期工程设计提供帮助,大大节省工程调试费用,缩短工期,并有助于风量不平衡管道的调节和改造。     

碳源投加方式对SBR工艺脱氮速率的影响

为了提高生物反应器的脱氮效率,研究采用SBR处理模拟生活污水,利用醋酸钠作为碳源,考察碳源投加方式对脱氮速率的影响。结果表明,当温度为10~15℃,进水COD为330~550 mg/L时,采用不同的碳源投加方式,COD去除率均高于95%。进水一次投加2.4 g碳源,COD平均反应速率为5.3 mg/(g·h),平均反硝化速率为0.28 mg/(g·h)。进水、反应器运行3 h时分别投加1.2 g碳源,COD平均反应速率为6.89 mg/(g·h),平均反硝化速率为0.37 mg/(g·h)。进水、反应6 h时分别投加1.2 g碳源,COD平均反应速率为6.50 mg/(g·h),平均反硝化速率为0.52 mg/(g·h)。进水投加1.2 g碳源、反应器运行3 h和6 h时分别投加0.6 g醋酸钠碳源,COD平均反应速率为6.2 mg/(g·h),平均反硝化速率为0.39 mg/(g·h)。分次投加碳源能够提高COD反应速率和TN去除率,同时保持较高的硝化反硝化速率。     

荧光染色法测定活性污泥中的活性生物量

活性污泥中活性微生物量是表征污染物去除能力的重要指标。探索了荧光染色法直接检测活性细菌的原理和测定方法,结果表明,大肠杆菌、唾液链球菌和铜绿假单胞杆菌的活菌细胞浓度与荧光光强的线性相关度都超过0.95;在惰性颗粒物浓度为20 mg/L到60 mg/L的范围内,其对荧光光强的影响可通过线性关系修正;搅拌速度为1 000 r/min且搅拌10 min时前处理效果最好。     

Cyanide generation during preservation of chlorinated wastewater effluent samples for total cyanide analysis.

Dechlorinating agents and pH adjustment are often used to preserve wastewater samples for cyanide analysis. The effects of four approved preservation protocols on the results of the total cyanide analysis of effluents from four water reclamation plants were examined. The results differed widely, and a clear pattern emerged. Immediate analysis without pH adjustment generally gave total cyanide concentrations below the reporting limit of 5 microg/L, irrespective of the dechlorinating agents used. When the pH was adjusted to > or =12, a slight increase in the measured total cyanide concentration was observed when thiosulfate was used to dechlorinate the samples, and a significant increase (>10 microg/L) was observed when arsenite was used as the dechlorinating agent. These results provide evidence that approved preservation protocols may give rise to cyanide formation in chlorinated wastewater effluent matrices.     

Real-world in-use activity, fuel use, and emissions for nonroad construction vehicles: a case study for excavators

A study design was developed and demonstrated for deployment of a portable emission measurement system (PEMS) for excavators. Excavators are among the most commonly used vehicles in construction activities. The PEMS measured nitric oxide, carbon monoxide, hydrocarbons, carbon dioxide, and opacity-based particulate matter. Data collection, screening, processing, and analysis protocols were developed to assure data quality and to quantify variability in vehicle fuel consumption and emissions rates. The development of data collection procedures was based on securing the PEMS while avoiding disruption to normal vehicle operations. As a result of quality assurance, approximately 90% of the attempted measurements resulted in valid data. On the basis of field data collected for three excavators, an average of 50% of the total nitric oxide emissions was associated with 29% of the time of operation, during which the average engine speed and manifold absolute pressure were significantly higher than corresponding averages for all data. Mass per time emission rates during non-idle modes (i.e., moving and using bucket) were on average 7 times greater than for the idle mode. Differences in normalized average rates were influenced more by intercycle differences than intervehicle differences. This study demonstrates the importance of accounting for intercycle variability in real-world in-use emissions to develop more accurate emission inventories. The data collection and analysis methodology demonstrated here is recommended for application to more vehicles to better characterize real-world vehicle activity, fuel use, and emissions for nonroad construction equipment.     

Characterization of real-world activity, fuel use, and emissions for selected motor graders fueled with petroleum diesel and B20 biodiesel

Motor graders are a common type of nonroad vehicle used in many road construction and maintenance applications. In-use activity, fuel use, and emissions were measured for six selected motor graders using a portable emission measurement system. Each motor grader was tested with petroleum diesel and B20 biodiesel. Duty cycles were quantified in terms of the empirical cumulative distribution function of manifold absolute pressure (MAP), which is an indicator of engine load. The motor graders were operated under normal duty cycles for road maintenance and repair at various locations in Wake and Nash Counties in North Carolina. Approximately 3 hr of quality-assured, second-by-second data were obtained during each test. An empirical modal-based model of vehicle fuel use and emissions was developed, based on stratifying the data with respect to ranges of normalized MAP, to enable comparisons between duty cycles, motor graders, and fuels. Time-based emission factors were found to increase monotonically with MAP. Fuel-based emission factors were mainly sensitive to differences between idle and non-idle engine operation. Cycle average emission factors were estimated for road "resurfacing," "roading," and "shouldering" activities. On average, the use of B20 instead of petroleum diesel leads to a negligible decrease of 1.6% in nitric oxide emission rate, and decreases of 19-22% in emission rates of carbon monoxide, hydrocarbons, and particulate matter. Emission rates decrease significantly when comparing newer engine tier vehicles to older ones. Significant reductions in tailpipe emissions accrue especially from the use of B20 and adoption of newer vehicles.     

人工湿地中一株高效低温菌的分离鉴定与去除特性研究

为了寻找在低温条件下能够净化城市污水的微生物,取南四湖人工湿地的底泥,对其中的微生物进行驯化后,从中分离出在低温条件下生长速率及代谢速率都较高的6株菌.根据这6株菌对模拟废水的去除效果从中筛选出去除效率最高的菌株E,其对模拟废水中COD、总磷、氨氮的去除率分别为62.92％、56.42％、50.63％.经形态特征、生理生化特性及16S rDNA序列分析鉴定,该菌株为黄假单胞菌(Pseudomonas flava),命名为Pseudomonas tiava WD-3.研究表明,菌株E最适温度、pH和盐度分别为16℃、6.0 ～8.0、1％,最佳碳源和氮源分别为蔗糖、蛋白胨.在最适生长条件下的去除试验表明,菌株E对模拟污水COD、总磷、氨氮的去除效果有明显的提高,分别是最初试验值的1.20、1.25、1.02倍,且去除性能稳定.因此,该菌株在湿地对城市污水的生物治理中具有良好的应用前景和很大的发展空间.     

过氧化氢氧化法处理低浓度含氰废水的研究

实验采用过氧化氢氧化法处理低浓度含氰废水,考察了过氧化氢浓度、反应时间以及反应pH值对于总氰化物去除率的影响。结果表明:上述研究参数均存在最佳值。在本实验研究范围内,总氰化物初始浓度为3.7 mg/L,过氧化氢浓度为0.96g/L,反应pH值为9,反应时间为2.5 h的条件下,总氰化物去除率达91.2%。实验室小试对比实验表明,过氧化氢和次氯酸钠均能有效处理低浓度含氰废水,但过氧化氢氧化法的药剂成本费比次氯酸钠氧化法的药剂成本费低。     

硒对汞在稀有鲫体内积累动力学影响

通过增加饲料中亚硒酸钠的含量，研究了硒对氯化汞在稀有鲫体内积累动力学的影响，探讨了硒对汞富集的影响机制，并给出了两种硒浓度下汞的积累方程。结果表明，饲料中０．２ｍｇ／ｋｇ的硒对鱼体汞富集无明显影响，２．０ｍｇ／ｋｇ的硒使鱼体汞富集增加。并且高硒饲料降低了鱼对汞的排除常数，使鱼体总汞的稳态含量增大。     

The impact of different voltage application modes on biodegradation of chloramphenicol and shift of microbial community structure

● Presented coupled system enhanced biodegradation of antibiotic chloramphenicol. ● HRT and electrical stimulation modes were key influencing factors. ● Electrical stimulation had little effect on the chloramphenicol metabolic pathway. ● Microbial community structure varied with the voltage application mode. Exoelectrogenic biofilms have received considerable attention for their ability to enhance electron transfer between contaminants and electrodes in bioelectrochemical systems. In this study, we constructed anaerobic-aerobic-coupled upflow bioelectrochemical reactors (AO-UBERs) with different voltage application modes, voltages and hydraulic retention times (HRTs). In addition, we evaluated their capacity to remove chloramphenicol (CAP). AO-UBER can effectively mineralize CAP and its metabolites through electrical stimulation when an appropriate voltage is applied. The CAP removal efficiencies were ~81.1%±6.1% (intermittent voltage application mode) and 75.2%±4.6% (continuous voltage application mode) under 0.5 V supply voltage, which were ~21.5% and 15.6% greater than those in the control system without voltage applied, respectively. The removal efficiency is mainly attributed to the anaerobic chamber. High-throughput sequencing combined with catabolic pathway analysis indicated that electrical stimulation selectively enriched Megasphaera, Janthinobacterium, Pseudomonas, Emticicia, Zoogloea, Cloacibacterium and Cetobacterium, which are capable of denitrification, dechlorination and benzene ring cleavage, respectively. This study shows that under the intermittent voltage application mode, AO-UBERs are highly promising for treating antibiotic-contaminated wastewater.