利用人工湿地系统深度处理城市污水尾水

利用垂直复合流模拟人工湿地系统对城市污水厂尾水进行深度处理实验研究,植物床选用美人蕉、菖蒲、茭草、芋头和象草混合栽种,采用石英砂为主体填料。实验研究表明:人工湿地系统在停留时间为24h,水力负荷为0.4m3(m2·d)的运行条件处理效果较佳,在此条件下连续稳定运行10个月,处理后的尾水主要指标达到(GBT189212002)标准。     

河流环境持久性有机污染物归宿的动态逸度模型

运用逸度方法构建了依赖于温度的、模拟持久性有机污染物(POPs)在河流环境中长期变化的动态归宿模型,其中逸度容量、污染物的转化速率、传递系数等模型参数的计算与温度有关.为了检验模型的合理性,以辽河下游为研究区域,对水体和沉积物中的γ-HCH进行了模拟计算.结果表明:逸度容量的变化与温度负相关,速率系数则相反.在模拟温度范围内(273～298K),-γHCH在空气、水和沉积物中的逸度容量分别减少了8.4%、89.7%和89.7%,转化速率系数分别增加了0.69、22.0和4.5倍;气-水界面的挥发和水-沉积物界面的扩散速率系数分别增加了7.9和1.6倍.模型计算值与实测值吻合较好,最大偏差为5.6倍,表明该模型用于残留POPs的长期预测是可行的.     

电增强活性炭纤维吸附有机污染物的动力学研究

研究了在电极化条件下,几种具有代表性污染物质在活性炭纤维上的电吸附动力学特性.结果表明,各种污染物的电吸附动力学比较好地符合Lagergren一级吸附动力学,其平衡吸附量在电极化下的增加量各不相同.在400mV的极化电位下,苯酚钠的吸附量从开路时的0.008 3mmol·g^-1增加到0.18 mmol·g^-1,增加了17倍;而对硝基苯酚的吸附量从开路时的2.93mmol·g^-1降到2.65 mmol·g^-1.在-400mV的极化电位下,苯胺的吸附量从开路时的3.60 mmol·g^-1增加到3.88 mmol·g^-1;而十二烷基苯磺酸钠的吸附量从开路时的2.20 mmol·g^-1降到1.59 mmol·g^-1.说明不同取代基的苯衍生物,电吸附改变量不相同,供电子基团的单取代苯,正极化都能明显增强其吸附量;但是吸电子基团的单取代,正负极化对吸附量的影响都很小;供体-共轭桥键-受体型结构的苯衍生物,正负极化都使其吸附减弱但吸附速率加快.静电作用在离子型污染物的电吸附中表现明显.     

钢渣预处理含铬废水及其废渣与铬渣的固化

用钢渣对含铬废水进行预处理,探讨了钢渣粒度、用量、废水pH值和添加硫酸亚铁还原剂的影响.结果表明,经硫酸亚铁还原处理后再用钢渣处理比单纯用钢渣处理的效果明显提高,采用钢渣/总铬质量比为40的100目钢渣处理经硫酸亚铁还原后的含铬废水,总铬和Cr6 去除率分别达79%和84%,采用钢渣柱进行的两级淋滤实验进一步表明该方法可作为工业上含铬废水处理的预处理段.处理后的废钢渣同工业铬渣一起进行水泥固化,标准养护20 d后固化体表面Cr6 浸出率、破碎至5 mm粒径以下和酸雨淋溶下的浸出液Cr6 浓度均符合安全标准,可作为普通建材或进行填埋处置.     

活塞风影响下地铁火灾烟气运动规律的数值模拟研究

地铁车站及地铁列车为人流密集的公众聚集场所,一旦发生火灾事故伤亡损失往往非常惨重,因此深入开展地铁火灾安全的研究有助于地铁安全管理工作。在合理分析地铁站台和列车火灾荷载的基础上,采用数值模拟方法对活塞风情况下地铁区间隧道火灾问题进行了模拟计算和分析,研究了在活塞风影响下的烟气蔓延规律和温度分布情况,其结果有助于提高地铁车站的运营的安全管理和发生火灾后的疏散指挥能力。     

气候变化主要因子对马铃薯生物量积累及产量和品质的影响

利用新型开顶式气室(OTC)开展CO2浓度升高和大气增温试验,分别为模拟增温2.0℃,模拟增温2.0℃且CO2浓度增加到650μmol·mol-1,对照CO2浓度约410μmol·mol-1,对马铃薯叶片、叶柄和茎等地上生物量、根和块茎等地下生物量积累过程及其特征参数的协同影响研究,分析气候变化对马铃薯产量形成和品质的...     

一起塔式起重机冲顶事故的技术分析

某桥梁施工企业在对桥面施工时,塔式起重机空载起升发生冲顶事故,起升钢丝绳断裂,造成吊钩装置坠落砸死1人伤害事故.本文介绍了事故情况、事故勘查要点和模拟试验及相关计算方法,分析事故技术原因,提出预防事故的建议.     

出口欧盟家用烹饪电炉灶的性能法规及测试标准研究

本文对出口欧盟家用烹饪电炉灶的性能法规及测试标准进行了研究,并与国内现行标准进行了对比分析。欧盟发布的No 66/2014法规对家用烹饪电炉灶的能耗限值作出强制性要求。IEC 60350-2提供了该类产品性能测试的指导方法。深入了解相关的法规条例和标准内容,可以帮助中国企业更好的"走出去"。     

Locally enhanced electric field treatment (LEEFT) for water disinfection

• Nanowire-assisted LEEFT is applied for water disinfection with low voltages. • LEEFT inactivates bacteria by disrupting cell membrane through electroporation. • Multiple electrodes and device configurations have been developed for LEEFT. • The LEEFT is low-cost, highly efficient, and produces no DBPs. • The LEEFT can potentially be applicable for water disinfection at all scales. Water disinfection is a critical step in water and wastewater treatment. The most widely used chlorination suffers from the formation of carcinogenic disinfection by-products (DBPs) while alternative methods (e.g., UV, O₃, and membrane filtration) are limited by microbial regrowth, no residual disinfectant, and high operation cost. Here, a nanowire-enabled disinfection method, locally enhanced electric field treatment (LEEFT), is introduced with advantages of no chemical addition, no DBP formation, low energy consumption, and efficient microbial inactivation. Attributed to the lightning rod effect, the electric field near the tip area of the nanowires on the electrode is significantly enhanced to inactivate microbes, even though a small external voltage (usually<5 V) is applied. In this review, after emphasizing the significance of water disinfection, the theory of the LEEFT is explained. Subsequently, the recent development of the LEEFT technology on electrode materials and device configurations are summarized. The disinfection performance is analyzed, with respect to the operating parameters, universality against different microorganisms, electrode durability, and energy consumption. The studies on the inactivation mechanisms during the LEEFT are also reviewed. Lastly, the challenges and future research of LEEFT disinfection are discussed.     

Biogenic palladium prepared by activated sludge microbes for the hexavalent chromium catalytic reduction: Impact of relative biomass

• Pd nanoparticles could be reduced and supported by activated sludge microbes. • The effect of biomass on Pd adsorption by microbes is greater than Pd reduction. • More biomass reduces Pd particle size, which is more dispersed on the cell surface. • When the biomass/Pd add to 6, the catalytic reduction rate of Cr(VI) reaches stable. Palladium, a kind of platinum group metal, owns catalytic capacity for a variety of hydrogenations. In this study, Pd nanoparticles (PdNPs) were generated through enzymatic recovery by microbes of activated sludge at various biomass/Pd, and further used for the Cr(VI) reduction. The results show that biomass had a strong adsorption capacity for Pd(II), which was 17.25 mg Pd/g sludge. The XRD and TEM-EDX results confirmed the existence of PdNPs associated with microbes (bio-Pd). The increase of biomass had little effect on the reduction rate of Pd(II), but it could cause decreasing particle size and shifting location of Pd(0) with the better dispersion degree on the cell surface. In the Cr(VI) reduction experiments, Cr(VI) was first adsorbed on bio-Pd with hydrogen and then reduced using active hydrogen as electron donor. Biomass improved the catalytic activity of PdNPs. When the biomass/Pd (w/w) ratio increased to six or higher, Cr(VI) reduction achieved maximum rate that 50 mg/L of Cr(VI) could be rapidly reduced in one minute.