Combustion and inorganic bromine emission of waste printed circuit boards in a high temperature furnace

High temperature combustion experiments of waste printed circuit boards (PCBs) were conducted using a lab-scale system featuring a continuously-fed drop tube furnace. Combustion efficiency and the occurrence of inorganic bromine (HBr and Br₂) were systematically studied by monitoring the main combustion products continuously. The influence of furnace temperature (T) was studied from 800 to 1400 °C, the excess air factor (EAF) was varied from 1.2 to 1.9 and the residence time in the high temperature zone (RT_HT) was set at 0.25, 0.5, or 0.75 s.Combustion efficiency depends on temperature, EAF and RT_HT; temperature has the most significant effect. Conversion of organic bromine from flame retardants into HBr and Br₂ depends on temperature and EAF. Temperature has crucial influence over the ratio of HBr to Br₂, whereas oxygen partial pressure plays a minor role. The two forms of inorganic bromine seem substantially to reach thermodynamic equilibrium within 0.25 s. High temperature is required to improve the combustion performance: at 1200 °C or higher, an EAF of 1.3 or more, and a RT_HT exceeding 0.75 s, combustion is quite complete, the CO concentration in flue gas and remained carbon in ash are sufficiently low, and organobrominated compounds are successfully decomposed (more than 99.9%).According to these results, incineration of waste PCBs without preliminary separation and without additives would perform very well under certain conditions; the potential precursors for brominated dioxins formation could be destroyed efficiently. Increasing temperature could decrease the volume percentage ratio of Br₂/HBr in flue gas greatly.     

Thermal conversion of municipal solid waste via hydrothermal carbonization: comparison of carbonization products to products from current waste management techniques

Hydrothermal carbonization (HTC) is a novel thermal conversion process that may be a viable means for managing solid waste streams while minimizing greenhouse gas production and producing residual material with intrinsic value. HTC is a wet, relatively low temperature (180-350 °C) thermal conversion process that has been shown to convert biomass to a carbonaceous residue referred to as hydrochar. Results from batch experiments indicate HTC of representative waste materials is feasible, and results in the majority of carbon (45-75% of the initially present carbon) remaining within the hydrochar. Gas production during the batch experiments suggests that longer reaction periods may be desirable to maximize the production of energy-favorable products. If using the hydrochar for applications in which the carbon will remain stored, results suggest that the gaseous products from HTC result in fewer g CO(2)-equivalent emissions than the gases associated with landfilling, composting, and incineration. When considering the use of hydrochar as a solid fuel, more energy can be derived from the hydrochar than from the gases resulting from waste degradation during landfilling and anaerobic digestion, and from incineration of food waste. Carbon emissions resulting from the use of the hydrochar as a fuel source are smaller than those associated with incineration, suggesting HTC may serve as an environmentally beneficial alternative to incineration. The type and extent of environmental benefits derived from HTC will be dependent on hydrochar use/the purpose for HTC (e.g., energy generation or carbon storage).     

大型垃圾填埋场垃圾稳定化研究

本文对大型垃圾填埋场内不同填埋时间垃圾四个组分 (总糖、有机质、生物可降解物和粗纤维 )含量进行了分析 ,并对各指标随填埋时间的变化趋势进行了讨论。结果表明 :在试验场封场后不久 ,垃圾取样均匀性不能保证 ,各指标随时间变化波动很大 ;封场 71 8d后 ,各指标随时间变化呈现一定的规律性 ,垃圾的生物可降解物含量变化能较好地反映垃圾的降解规律。     

论环境监测综合信息系统的建设规划

根据对各级环保机械综合信息技术应用的调研,提出环境监测综合信息系统设计原则及技术路线。     

毛毯印染废水处理技术研究

本文采用投菌水解(酸化)--接触氯化法处理毛毯印染废水.试验表明该工艺流程简单,处理效果好,出水水质稳定.当进水CODc在480～750mg/L范围变化时,出水CODDc稳定在100mg/L以下.其中,水解池对色度有较好的去除效果,同时可提高后续接触氧化池的处理效率;而CODc的去除则主要在接触氧化池进行.     

故障树可视化分析系统

论述了自行研制设计的可视化故障树分析系统的功能及程序结构与设计原理。该系统由故障树生成、故障树分析计算、文件输出和系统管理 4个模块组成 ,可使故障树生成与分析变得非常直观而简便 ,只需用鼠标在屏幕上绘制出故障树图 ,系统就能自动识别并进行定性与定量分析。     

焦化废水专用混凝剂对污染物的去除效果与规律

通过烧杯搅拌实验得出了焦化废水专用混凝剂对废水中的 COD_Cr、色度、F^-和总 CN^- 等主要污染物的去除情况随投加量和混凝 pH值变化的规律 ,给出了最佳投加量、最佳混凝 pH范围等操作参数 ,并通过现场混凝模拟实验考察了混凝处理效果对废水水质波动的承受能力 .结果表明 ,在最佳有效投加量 300 mg/L和混凝 pH值为 6.0～ 6.5的操作条件下 ,专用混凝剂对各污染物都有良好的去除效果 ,且受进水水质波动的影响很小 .     

估算多氯联苯在鱼体内生物富集因子的分子连接性指数模型

根据 40个 PCB在鱼体内生物富集因子 ( BCF)的实测数据建立了分子连接性指数估算模型 .模型可决系数 0 .91 1 ,平均误差 0 .1 95个对数单位 .通过比较发现 ,对于单一类别化合物分子连接性指数模型比片段常数模型更精确 ,对分子整体结构特征的描述效率更高 ,但片段常数模型具有物理意义明确、变量选择及模型调整灵活的优点 .     

唐山市农业区地下水垂向剖面中硝态氮污染的研究

当今农业地区灌溉施肥引起氮素对地下水的污染已成为人们普遍关注的环境问题.本文结合唐山市农业区的生产实际,应用LEACHN数学模型,对唐山市农业地区灌溉施肥条件下氮素在土壤中的迁移转化进行了模拟计算.所建立的地下水垂向剖面的二维水量水质模型,对典型剖面中地下水的硝态氮污染进行了模拟和分析.计算结果表明,唐山农业区灌溉施肥引起根区以下硝态氮渗漏损失可造成浅层地下水的污染.     

纳米二氧化硅对秀丽线虫的毒性作用研究

为探讨二氧化硅纳米颗粒(SiNP)的毒性作用.以微米SiO2和空白做对照,将尺寸为20和60 nm的SiNP分别以0.2,1.0和5.0 g·L-13个浓度对模式生物秀丽隐杆线虫进行染毒.通过第一代和第二代线虫体长、身体弯曲频率、头部摆动频率以及第一代线虫后代数目、世代时间等发育、运动和生殖的相关评价指标,对SiNP毒...