混凝法深度处理印染废水中试研究

采用"高效混凝沉淀-过滤"深度处理工艺处理印染废水二级生化出水,并将混凝沉淀污泥回流.实验结果表明,混凝剂聚合氯化铝加入量为160 mg/L时,COD去除率平均可达34.6%,TP去除率平均达到87.9%,平均出水TP为0.3 mg/L.气相色谱-质谱分析和元素分析结果表明混凝沉淀工艺对有机物和TP的去除效果良好.     

利用含铬废水和含铅废水制备铬黄

利用净化后的含铬废水和含铅废水制备铬黄.采用沉淀法对废水进行净化预处理,最佳工艺条件:100mL含铬废水中加入20 g Na_2CO_3,及10 mL H_2O_2,用NaOH调节含铬废水pH为10.00;用NaOH调节含铅废水pH为2.65.将净化后的10 mL含铬废水和25 mL含铅废水混合,在55-60℃条件下反应10 min,合成的铬黄达到GB/T 3184-2008<铬酸铅颜料和钼铬酸铅颜料>的质量标准.经重金属吸附剂处理Pb~(2+)后铬黄合成滤液中的Cr~(6+)和Pb~(2+)质量浓度均达到GB8978-1996<污水综合排放标准>的指标.     

Ru/γ-Al_2O_3和Ru/AC催化剂的制备及其对氨氧化反应的催化性能

分别以γ-Al_2O_3和活性炭(AC)为载体,采用浸渍法制备了Ru质量分数均为2.0%的Ru/γ-Al_2O_3和Ru/AC催化剂,并用X射线衍射仪和透射电子显微镜等方法对催化剂结构进行了表征.实验结果表明:Ru/AC中Ru沉积在AC表面,分散度较低;而Ru/γ-Al_2O_3中Ru进入到γ-Al_2O_3内部,形成了一种高度分散体系.Ru/γ-Al_2O_3对氨的催化活性高于Ru/AC,氨在Ru/γ-Al_2O_3和Ru/AC上的起活温度分别为200 ℃和266 ℃,T_(90)(氨去除率达90%时的反应温度)分别为267℃和320 ℃.随混合气体空速增大,Ru/γ-Al_2O_3催化剂的T_(90)逐渐升高,气体空速分别为3 600,4 800,5 400 h~(-1)时,T_(90)分别为235,266,303 ℃.随反应前混合气体中氨质量分数增加,氨的去除率降低.     

pH敏感性β-环糊精微球的制备及其吸附性能

采用反相微悬浮乳液聚合技术制备了β-环糊精(β-CD)微球,用丁二酸酐对β-CD微球进行化学改性,制备了pH敏感性β-CD(pH-β-CD)微球.通过傅里叶红外光谱仪和扫描电子显微镜对微球的结构、粒径和形貌进行了表征.探讨了亚甲基蓝模拟染料废水pH、吸附时间和微球加入量对亚甲基蓝吸附性能的影响.实验结果表明,在亚甲基蓝模拟染料废水pH为10.0、吸附时间为90 min的条件下,当pH-β-CD微球加入量为50 mg时,pH-β-CD微球吸附量为16.1 mg/g;当pH-β-CD微球加入量为250 mg时,pH-β-CD微球对亚甲基蓝的脱色率达96.2%.     

Study on Biodegradable Starch/OMMT Nanocomposites for Packaging Applications

The thermoplastic starch (TPS) and nanocomposite(TPS/OMMT) was prepared with 15% carbamide, 15% ethanolamine and different contents of organic activated montmorillonite (OMMT) by twin-screw extruder with a 130 °C barrel temperature. Fourier transforms infrared spectroscopy and wide angle X-ray diffraction shown that the alkylamine in dodecyl benzyl dimethyl ammonium bromide could react with MMT via cation exchange reaction. After treated, the d(001)space distance of MMT increased from 1.5 to 1.7 nm. Scanning electron microscope revealed that the lower contents of OMMT could disperse well in the matrixes of TPS. The carbamide, ethanolamine and the OMMT could destroy the crystallization behavior of starch, but only the OMMT restrained this behavior for long-term storing. Mechanical properties investigation indicated that the tensile strength and modulus of TPS/OMMT nanocomposites were better than those of TPS, while the elongation at break was descended with the increasing of OMMT contents. When the content of OMMT was 4%, the tensile strength and modulus of TPS was improved from 4.2 and 42 MPa to 6.0 and 76 MPa, respectively.     

Modification of Fe–Mn mixed oxide COS removal sorbent by rare-earth oxides addition

In order to develop highly active sorbent for COS removal, Fe–Mn mixed oxides doped with CeO₂, La₂O₃ or Sm₂O₃ were studied. The effects of these promoters on the structural properties of Fe–Mn oxides were investigated by XRD, BET, TPR and TEM techniques. XRD results revealed that the degree of crystallinity of Fe–Mn oxide phase decreased due to the addition of rare-earth oxides. Doping with CeO₂, La₂O₃ or Sm₂O₃ led to an increase in BET surface area of the sample. TPR studies showed that the reactivity of the reduction of doped samples increased in the temperature range of 300–450 °C. In addition, the desulfurization test was performed at 325 °C with a gas hourly space velocity of 1000 h⁻¹. It was found that the addition of 3% La₂O₃ greatly improved the absorption sulfur capacity of the sorbent, while the sorbent doped 3% CeO₂ achieved a sufficiently high purifying degree before breakthrough.     

Removal of Cr(VI) from simulative contaminated groundwater by iron metal

The Cr(VI) removal from simulative contaminated groundwater using zero-valent iron (Fe⁰) filings, Fe⁰ powder and nanoscale Fe⁰ in batch experimental mode was studied. Cr(VI) is a primary pollutant of some soils and groundwater. Zero-valent iron, an important natural reductant, could transform Cr(VI) to Cr(III) which is much less toxic and immobile. The Cr(VI) removal percentage was 87% at a metal to solution ratio of 6 g l⁻¹ for commercial iron powder (200 mesh) in 120 min, and 100% Cr(VI) was removed when the metal to solution ratio was 10 g l⁻¹. The results demonstrates that the Cr(VI) removal percentage was affected apparently by pH, the amount of Fe powder and the reaction temperature. The Cr(VI) removal percentage with nanoscale Fe⁰ was much higher than those with Fe⁰ filings or Fe⁰ powder at the same reaction time. Electrochemical analysis of the reaction process led to the conclusion that the Cr(VI) trended to form Cr(III) hydroxide under the reaction conditions. The kinetics analysis showed that Cr(VI) reduction by Fe⁰ could be described as a pseudo-first-order kinetics model.     

Land desertification monitoring and assessment in Yulin of Northwest China using remote sensing and geographic information systems (GIS)

The objective of this study is to develop techniques for assessing and analysing land desertification in Yulin of Northwest China, as a typical monitoring region through the use of remotely sensed data and geographic information systems (GIS). The methodology included the use of Landsat TM data from 1987, 1996 and 2006, supplemented by aerial photos in 1960, topographic maps, field work and use of other existing data. From this, land cover, the Normalised Difference Vegetation Index (NDVI), farmland, woodland and grassland maps at 1:100,000 were prepared for land desertification monitoring in the area. In the study, all data was entered into a GIS using ILWIS software to perform land desertification monitoring. The results indicate that land desertification in the area has been developing rapidly during the past 40 years. Although land desertification has to some extent been controlled in the area by planting grasses and trees, the issue of land desertification is still serious. The study also demonstrates an example of why the integration of remote sensing with GIS is critical for the monitoring of environmental changes in arid and semi-arid regions, e.g. in land desertification monitoring in the Yulin pilot area. However, land desertification monitoring using remote sensing and GIS still needs to be continued and also refined for the purpose of long-term monitoring and the management of fragile ecosystems in the area.     

紫外分光光度法在水中阴离子表面活性剂标准样品研制中的应用

研究了阴离子表面活性剂水溶液的紫外吸收特性,并将研究结果用于阴离子表面活性剂水质标样的稳定性,均匀性和定值工作,简化了操作手续,获得了准确的分析结果。     

关于推行清洁生产有关问题的探讨

阐述了清洁生产是可持续局长战略思想的具体体现,是实现可持续发展战略的必由之路。并提出了推行清洁生产的一些建议和设想。