An Assessment of the Emissions Inventory Processing Systems EMS-2001 and SMOKE in Grid-Based Air Quality Models

Abstract

In the United States, emission processing models such as Emissions Modeling System-2001 (EMS-2001), Emissions Preprocessor System-Version 2.5 (EPS2.5), and the Sparse Matrix Operator Kernel Emissions (SMOKE) model are currently being used to generate gridded, hourly, speciated emission inputs for urban and regional-scale photochemical models from aggregated pollutant inventories. In this study, two models, EMS-2001 and SMOKE, were applied with their default internal data sets to process a common inventory database for a high ozone (O₃) episode over the eastern United States using the Carbon Bond IV (CB4) chemical speciation mechanism. A comparison of the emissions processed by these systems shows differences in all three of the major processing steps performed by the two models (i.e., in temporal allocation, spatial allocation, and chemical speciation). Results from a simulation with a photochemical model using these two sets of emissions indicate differences on the order of ±20 ppb in the predicted 1-hr daily maximum O₃ concentrations. It is therefore critical to develop and implement more common and synchronized temporal, spatial, and speciation cross-reference systems such that the processes within each emissions model converge toward reasonably similar results. This would also help to increase confidence in the validity of photochemical grid model results by reducing one aspect of modeling uncertainty.     

Absorption and Reaction Kinetics of Amines and Ammonia Solutions with Carbon Dioxide in Flue Gas

Abstract

The removal system for the absorption of CO₂ with amines and NH₃ is an advanced air pollution control device to reduce greenhouse gas emissions. Absorption of CO₂ by amines and NH₃ solutions was performed in this study to derive the reaction kinetics. The absorption of CO₂ as encountered in flue gases into aqueous solutions of monoethanolamine (MEA), diethanolamine (DEA), and NH₃ was carried out using a stirred vessel with a plane gas-liquid interface at 50 °C. Various operating parameters were tested to determine the effect of these variables on the absorption kinetics of the reactants in both gas and liquid phases and the effect of competitions between various reactants on the mass-transfer rate.

The observed absorption rate increases with increasing gas-liquid concentration, solvent concentration, temperature, and gas flow rate, but changes with the O₂ concentration and pH value. The absorption efficiency of MEA is better than that of NH₃ and DEA, but the absorption capacity of NH₃ is the best. The active energies of the MEA and NH₃ with CO₂ are 33.19 and 40.09 kJ/mol, respectively.     

张家界溶洞旅游资源价值评价与开发研究

溶洞是重要的旅游资源,开发得当可获得良好经济效益,否则便会造成不可逆的资源破坏。以张家界溶洞资源为研究对象,在对溶洞资源基本情况进行调查的基础上,对溶洞的景观价值进行定量评价,并提出溶洞开发措施,为张家界市溶洞旅游的可持续开发利用提供理论依据。     

德国环境设备责任制度初探

德国《民法典》确定了一般环境侵权的规则——行为责任,再以《环境责任法》确立了特殊的环境侵权的规则——设备责任。设备侵权是危险责任的一种,其构成要件有两个:设备运营对环境产生不良影响进而导致损害;人身、财产受侵害。设备责任的承担不要求设备运营人的过错。设备责任归责采用因果关系推定原则。     

高加速应力试验装置技术参数的测量

气锤驱动的高加速应力试验装置,能产生温度和非高斯随机振动应力,其中振动应力是由多个气锤作六自由度运动产生的。一般用来进行高温步进、低温步进、快速温度变化、振动、快速温变和振动复合试验。目前国家标准和校准规程中均无关于该试验装置的技术参数的校准方法。本文结合试验装置的技术特点,提出了几个关于温度和振动技术参数的测量方法,如:温度偏差、温度波动度、温度均匀度、温度过冲量、温度变化速率、均方根加速度、横向振动比、功率谱密度等。     

3种植物对Cd污染农田土壤的修复效果比较试验研究

通过盆栽试验研究了3种植物三叶鬼针草(Bidens pilosa L.)、紫茉莉(Mirabilis Jalapa)、中华景天(Sedum polytrich-oides)对上海地区2种质量浓度(1.2、12.0mg/kg)Cd污染农田土壤的修复效果,以探索其在上海地区Cd污染农田土壤修复中应用的可行性。结果表明:2种浓度下,三叶鬼针草对土壤Cd去除效果均最佳,1.2mg/kg处理下盆中土壤Cd质量浓度由原来的1.249 9mg/kg下降到0.861 7mg/kg,降低0.388 2mg/kg,Cd去除率为31.06%;12.0mg/kg处理下三叶鬼针草盆中土壤Cd质量浓度由原来的12.033 2mg/kg下降到10.020 6mg/kg,降低2.012 6mg/kg,Cd去除率为16.73%;紫茉莉和中华景天相比较而言,修复效果均较差。在2种浓度下,3种植物地上部分生物量排序均为三叶鬼针草>中华景天>紫茉莉。因此,建议将三叶鬼针草作为上海地区Cd污染农田土壤修复的优选植物。     

苦土和氧化镁处理氮磷废水的对比研究

分别采用苦土、纯氧化镁为沉淀剂对模拟高浓度氮磷废水(N/P=0.8)进行了脱氮除磷研究,比较了沉淀剂投加量、pH对2种沉淀剂处理氮磷废水的影响,对沉淀产物进行XRD分析,并进行了经济效益比较。结果表明,pH是影响2种沉淀剂处理氮磷废水的主要因素,随着pH的增加,脱氮除磷效果提高,在平衡pH为9～10之间时氮磷处理效果最佳,pH继续增加,由于磷酸镁沉淀的形成使得氨氮去除率降低。此外,处理相同的废水,苦土的最佳投加量要大于纯氧化镁,但是经济效益比较结果表明,以苦土为沉淀剂处理氮磷废水可大大降低处理成本。     

一体化臭氧-曝气生物滤池处理酸性玫瑰红印染模拟废水

针对含酸性玫瑰红印染废水高色度、难生物降解的特点,分别采用了一体化和分离式臭氧-曝气生物滤池(O3-BAF)工艺处理。与分离式工艺相比,一体化工艺的特点是在一个反应器内部同时实现臭氧氧化和生化的协同作用,降低了处理设施的基建和运行费用。实验结果表明,一体化工艺处理效果明显优于分离式工艺,脱色率达92%,COD去除率达60%,处理效果良好。     

UV-H_2O_2联用工艺去除水中阿特拉津的研究

采用间歇式反应器考察了UV-H2O2高级氧化技术去除水中阿特拉津的效果及其影响因素,并进行了相关的反应动力学研究。结果表明,在pH值6.9,阿特拉津初始浓度500μg/L,紫外辐照强度172μW/cm2时,H2O2投加量50mg/L,反应10min后,阿特拉津的去除率90%。UV-H2O2联用工艺对阿特拉津的降解符合一级反应动力学。H2O2在该联用工艺降解阿特拉津中具有双重作用,一方面,当H2O2投加量较小时,一级反应速率常数随H2O2投加量的增加基本呈现线性增加的趋势;另一方面,当H2O2浓度增加到一定程度(90mg/L)后,阿特拉津的降解速率随H2O2浓度的变化已不明显,而H2O2浓度为102mg/L时,则出现了抑制作用。     

接地极的土壤腐蚀

接地极是接地装置的主要组成部分,接地极埋设在土壤中,用于泄流,保障电网和电气设备的安全运行。近年来,接地极的腐蚀损坏造成的事故屡有发生,接地极的土壤腐蚀引起了普遍的重视,防止接地极腐蚀已成为一个重要的研究课题。本文介绍了目前我国电网和电气设备接地极的选材,接地极土壤腐蚀的特点,并对接地极防腐蚀方法做了简单总结。