好氧硝化颗粒污泥膜生物反应器性能和膜污染研究

实验研究了好氧硝化颗粒污泥膜生物反应器AGMBR的处理性能,并将其与活性污泥膜生物反应器ASMBR进行对比,考察了颗粒污泥在减缓膜污染中所起的作用.好氧硝化颗粒污泥膜生物反应器AGMBR连续稳定运行102 d,系统具有良好的去除有机物和同时硝化反硝化能力,在进水COD和NH+4-N浓度分别为500和200 mg/L时,COD、NH+4-N和TN的去除率分别稳定在86%、94%和45%以上.颗粒污泥有效减缓了膜污染,延长了膜清洗的周期,AGMBR中的膜污染以膜孔堵塞为主,占总阻力的64.81%;滤饼层的阻力为2.1×1012m-1,远小于ASMBR中的16.07×10"m-1;膜清洗周期是相同条件下ASMBR的2.43倍以上;而且AGMBR内不断有新颗粒生成,维持了AGMBR系统性能和运行的稳定.     

聚硅酸锌铝的制备及其性能研究

以硅酸钠、硫酸锌、硫酸铝为原料,通过共聚法制备了无机高分子絮凝剂聚硅酸锌铝（PSZAS）,研究了Na₂SiO₃的摩尔浓度、活化时间、Al/Si、Zn/Si 配比及絮凝剂的投加量对絮凝效果的影响,用X-射线衍射（XRD）和电子扫描电镜（SEM）对该絮凝剂的结构及形貌进行了表征。结果表明：当硅酸钠的浓度为0.4 mol/L,硅酸活化时间为2 h,Si∶Al∶Zn=1∶1∶1.5,絮凝剂投加量为20 mL/L废水时,絮凝剂的电中和能力和吸附架桥能力最强,絮凝剂对含H-酸染料模拟废水的絮凝效果最好。     

曙光油田节能减排现状调查及对策研究

曙光采油厂随着超稠油的不断开发,生产能耗也随之增加,通过开展节能减排及节能挖潜工作,全厂能耗增长状态得到了良好的控制,能耗总量由2005年的58.21×10~4t标煤下降到2008年的47.75×10~4t标煤;原油(气)液生产单位综合能耗为52.02 kg标煤/t,同期对比减少0.38 kg标煤/t;生产系统运行效率不断提高。文章详细介绍了曙光油田从机采系统、热注系统、集输系统等方面推广应用节能新技术、新产品,达到其投资和运行费用最少,经济性较好,对油田减排挖潜进行了探讨。     

混凝法深度处理印染废水中试研究

采用"高效混凝沉淀-过滤"深度处理工艺处理印染废水二级生化出水,并将混凝沉淀污泥回流.实验结果表明,混凝剂聚合氯化铝加入量为160 mg/L时,COD去除率平均可达34.6%,TP去除率平均达到87.9%,平均出水TP为0.3 mg/L.气相色谱-质谱分析和元素分析结果表明混凝沉淀工艺对有机物和TP的去除效果良好.     

Rapidly eliminating pathogenic microorganisms in large air space using spraying *OH radicals

A new method for rapidly eliminating pathogenic microorganisms in large air space using spraying *OH radicals is presented in this paper With a physical method of strong electric-field discharge, large numbers of *OH radicals were produced by the oxygen activated particles of O2+, O(1D), O(3P), etc., and the introducing reagent HO2-. The gram-positive bacteria Bacillus subtilis, the gram-negative bacteria Serratia marcescens, and Bacillus spores were used for the eliminating experiments. Results show that the different microorganisms were rapidly killed by *OH radicals with a concentration of 0.8 mg/L and spraying density of 21 microL/m2 within 4 sec. Cell morphological changes were also observed under microscope. The cells of B. subtilis and Bacillus spores in their cellular wall, cellular membrane, or cell protoplasm were greatly destroyed when being exposed to a killing dosage of *OH radicals.     

Chemical compositions and sources of atmospheric PM10 in heating, non-heating and sand periods at a coal-based city in northeastern China

Mass concentrations and chemical components (18 elements, 9 ions, organic carbon [OC] and elemental carbon [EC]) in atmospheric PM(10) were measured at five sites in Fushun during heating, non-heating and sand periods in 2006-2007. PM(10) mass concentrations varied from 62.0 to 226.3 μg m(-3), with 21% of the total samples' mass concentrations exceeding the Chinese national secondary standard value of 150 μg m(-3), mainly concentrated in heating and sand periods. Crustal elements, trace elements, water-soluble ions, OC and EC represented 20-47%, 2-9%, 13-34%, 15-34% and 13-25% of the particulate matter mass concentrations, respectively. OC and crustal elements exhibited the highest mass percentages, at 27-34% and 30-47% during heating and sand period. Local agricultural residuals burning may contribute to EC and ion concentrations, as shown by ion temporal variation and OC and EC correlation analysis. Heavy metals (Cr, Ni, Zn, Cu and Mn) from coal combustion and industrial processes should be paid attention to in heating and sand periods. The anion/cation ratios exhibited their highest values for the background site with the influence of stationary sources on its upper wind direction during the sand period. Secondary organic carbon were 1.6-21.7, 1.5-23.0, 0.4-17.0, 0.2-33.0 and 0.2-21.1 μg m(-3), accounting for 20-77%, 44-88%, 4-77%, 8-69% and 4-73% of OC for the five sampling sites ZQ, DZ, XH, WH and SK, respectively. From the temporal and spatial variation analysis of major species, coal combustion, agricultural residual burning and industrial emission including dust re-suspended from raw material storage piles were important sources for atmospheric PM(10) in Fushun at heating, non-heating and sand periods, respectively. It was confirmed by principal component analysis that coal combustion, vehicle emission, industrial activities, soil dust, cement and construction dust and biomass burning were the main sources for PM(10) in this coal-based city.     

Speciation of heavy metals in biosolids of wastewater treatment plants at Mysore,Karnataka, India

Urban wastewater treatment leads to the generation of large quantities of biosolids. Accumulation of biosolids is a problem of environmental relevance due to the existence of heavy metals in the biosolids. Determination of total metal in biosolid provides information relating pollution levels. Determination of their mobilization capacity and behaviour in the environment is an important task. An experimental approach commonly used for studying the mobility, transport and bioavailability of metal in biosolids is the use of selective sequential extraction procedure. In the present study an attempt has been made to study the heavy metal properties in biosolid samples collected from urban wastewater treatment plants located at Mysore, Karnataka. Few heavy metals selected for the present study are cadmium, chromium, copper, iron, nickel and zinc. The concentration of these metals in biosolids and their partition in different fractions are studied. The speciation of metals based on the sequential extraction scheme was carried out. The concentration of heavy metals is lower than that established by European legislation. The residual fraction has the maximum percentage of heavy metals whereas, only a small fraction of heavy metals (Fe, Zn and Cd) are extracted in the most soluble fractions, exchangeable and carbonate fractions.     

Spatial and seasonal distribution of nitrogen in marsh soils of a typical floodplain wetland in Northeast China

Horizontal and profile distributions of nitrogen in marsh soils in different seasons were studied in a typical site within the Erbaifangzi wetland in Northeast China. Results showed that there was higher spatial heterogeneity for nitrate nitrogen (NO₃^--_{3}^{-}-N) and ammonium nitrogen (NH₄⁺_{4}^{+}–N), as well as available nitrogen (AN), in surface soils in July compared to that in September. Relative to July, the mean nitrogen contents in surface soils were slightly higher in September; however, in November, soils contained significantly lower NO₃^--_{3}^{-}-N and NH₄⁺_{4}^{+}–N, higher AN, organic nitrogen (Org-N), and total nitrogen (TN). Except for mineral nitrogen, no significant differences were observed between Org-N and TN contents in September and November. Nitrogen contents generally declined exponentially with depth along soil profiles in three sampling dates (July, September, and November), except for a significant accumulation peak of NO₃^--_{3}^{-}-N at the 20–30 cm depth in September. However, NH₄⁺_{4}^{+}–N contents showed a vertical alternation of “increasing and decreasing” in both July and September, while nearly kept constant with depth in November. The depth ranking of nitrogen showed the shallowest distribution for AN, followed by Org-N and TN, while deeper distributions for NO₃^--_{3}^{-}-N and NH₄⁺_{4}^{+}–N. TN, Org-N, and AN were significantly correlated with soil organic matter and total phosphorus. Soil pH values were significantly correlated with TN and AN contents in surface soils. Clay contents showed significant correlations with nitrogen contents except for NO₃^--_{3}^{-}-N in surface soils and NH₄⁺_{4}^{+}–N in profile soils. However, soil moisture was not significantly correlated with nitrogen contents among all soil samples.     

Disturbance of Dabao highway construction on plant species and soil nutrients in Longitudinal Range Gorge Region (LRGR) of Southwestern China

The disturbance of highway construction upon surrounding vulnerable ecosystems is a common threat in the Longitudinal Range Gorge Region of southwestern China. We evaluated the disturbance of highway on plant species richness and diversity and soil nutrients from adjacent to the highway to 300 m upslope and 100 m downslope in forests and grasslands by setting 12 belt transects in forests and grasslands (six belt transects and six control belt transects, respectively). The results showed that there were some significant variances in belt transects with respective control belt transects for species richness and diversity in both forests and grasslands. Species richness and diversity of trees were lower within a 50-m distance from the highway and more noticeable on the downslope portion. Species richness and diversity of shrubs and herbs appeared higher near highway edge. Both species richness and diversity of herbs were similar in forests. In addition, exotic species, such as Eupatorium adenophorum, were further from the road and more widely dispersed in grasslands. Soil nutrients except total potassium (TK) were lower in the downslope area adjacent to highway edge and showed a significant increase with increasing distance from the highway in both forests and grasslands. This indicates that grasslands acted as microhabitats for exotic species and are more easily to be invaded than forests, especially if disturbed. Once destroyed, plant species and soil nutrients will require a significant amount of time to be restored to control levels. This work illustrates that the effects extend considerably to distances upslope and downslope from the construction site. Given that these changes occurred relatively quickly, the study suggests that the environmental "footprint" grows far beyond the road and adjacent zone of disruption.     

Integrated emergy,energy and economic evaluation of rice and vegetable production systems in alluvial paddy fields: Implications for agricultural policy in China

China is the largest rice producing and consuming country in the world, but rice production has given way to the production of vegetables during the past twenty years. The government has been trying to stop this land-use conversion and increase the area in rice-vegetable rotation. Important questions that must be answered to determine what strategy is best for society are, “What is the reason behind this conversion?”; “Which system is more productive and which is more sustainable?”; and “How can economic policy be used to adjust the pattern of farmland use to attain sustainable development?” To answer these questions, a combined evaluation of these agricultural production systems was done using emergy, energy and economic methods. An economic analysis clearly showed that the reason for this conversion was simply that the economic output/input ratio and the benefit density of the vegetable production system were greater than that of rice. However, both energy and emergy evaluations showed that long-term rice was the best choice for sustainable development, followed by rotation systems. The current price of rice is lower than the em-value of rice produced from the long-term rice system, but higher than that of rice produced from the rotation system. Scenario analysis showed that if the government increases the price of rice to the em-value of rice produced from the long-term rice system, US$0.4/kg, and takes the value of soil organic matter into account, the economic output/input ratios of both the rice and rotation systems will be higher than that of the vegetable system. The three methods, energy, emergy and economics, are different but complementary, each revealing a different aspect of the same system. Their combined use shows not only the reasons behind a system’s current state or condition, but also the way to adjust these systems to move toward more sustainable states.