Combustion and inorganic bromine emission of waste printed circuit boards in a high temperature furnace

High temperature combustion experiments of waste printed circuit boards (PCBs) were conducted using a lab-scale system featuring a continuously-fed drop tube furnace. Combustion efficiency and the occurrence of inorganic bromine (HBr and Br₂) were systematically studied by monitoring the main combustion products continuously. The influence of furnace temperature (T) was studied from 800 to 1400 °C, the excess air factor (EAF) was varied from 1.2 to 1.9 and the residence time in the high temperature zone (RT_HT) was set at 0.25, 0.5, or 0.75 s.Combustion efficiency depends on temperature, EAF and RT_HT; temperature has the most significant effect. Conversion of organic bromine from flame retardants into HBr and Br₂ depends on temperature and EAF. Temperature has crucial influence over the ratio of HBr to Br₂, whereas oxygen partial pressure plays a minor role. The two forms of inorganic bromine seem substantially to reach thermodynamic equilibrium within 0.25 s. High temperature is required to improve the combustion performance: at 1200 °C or higher, an EAF of 1.3 or more, and a RT_HT exceeding 0.75 s, combustion is quite complete, the CO concentration in flue gas and remained carbon in ash are sufficiently low, and organobrominated compounds are successfully decomposed (more than 99.9%).According to these results, incineration of waste PCBs without preliminary separation and without additives would perform very well under certain conditions; the potential precursors for brominated dioxins formation could be destroyed efficiently. Increasing temperature could decrease the volume percentage ratio of Br₂/HBr in flue gas greatly.     

基于常规环境试验装备的HALT技术应用研究

目的 探索军用装备极限边界条件考核试验方法.方法 引入HALT技术,在前期装备试验各类故障案例统计的基础上,选择装备上应用普遍和故障发生较频繁的继电器为研究对象,探索应用常规环境试验设备,设计HALT试验,研究继电器极限边界条件下可靠性考核的技术和方法.结果 在进行低温–30℃和高温70℃步进应力以及在–70～120℃...     

间歇式活性污泥法处理制革废水

介绍了间歇式活性污泥法 (SBR法 )处理制革废水的工程概况及工程调试和试运转情况 ,认为SBR法的特殊运行工序是适合处理制革废水的。     

大型环保设施建设中的政府民间合作融资模式

对基础设施和公共工程建设中常用的10种政府民间合作融资模式进行分析,并探讨其在环保设施建设中的具体运用。     

Distribution and hydrodynamic model of the Keumdong oil spill in Kwangyang Bay, Korea

Oil concentrations in the seawater, seabed sediments, and shoreline sediments were measured from the samples collected 165 days after the Keumdong oil spill accident, which had occurred in Kwangyang Bay of the South Sea, Korea in September 1993. Distribution patterns of the concentrations in the seabed and shoreline sediments have allowed us to hindcast the transport and fate of the spilled oil. Overall, the patterns agree better with the southward (seaward) surface water circulation than with the northward (landward) bottom water circulation over the region. Rapid, initial dispersal of the spilled oil to the south and its subsequent grounding onto the intertidal seabed sediments, as well as onto the shorelines, appear to have made ineffective the subsurface oil transport by the bottom current.     

9种硝基苯对鱼肝微粒体EROD活性的影响

混合功能氧化酶系(mixed function oxidase,MFO)中的敏感指标,7-乙氧基-异吩唑酮-脱乙基酶(7-ethoxyresorufin-O-deethylase,EROD)已作为生物标志物,应用于生态毒理学研究领域.笔者以苯并(a)芘作为阳性对照,采用鲤鱼肝脏体外直接染毒测定EROD的方法,分析了9种硝基苯对EROD活性的诱导影响.      

电解氧化法预处理垃圾渗滤液

采用连续式电解槽对垃圾渗滤液进行预处理研究.考察不同的电流密度、进水pH值、Cl-质量浓度等对电解效果的影响,从而确定了最佳操作条件.在最佳条件下,比较研究电解装置对3种不同来源的垃圾渗滤液各项指标的去除效果.结果表明,连续式电解法对中等COD质量浓度的垃圾渗滤液(COD质量浓度为2 000～10 000 mg/L)有较好的处理效果,可有效去除废水中的COD,氨氮和重金属,且对难降解的污染物(如苯胺、苯酚等)有良好的去除作用.该法提高了水质的可生化性,强化了后续生化处理,为中试及工业化工程设计应用提供了参考.      

用铬渣作水泥矿化剂

介绍了铬渣作水泥矿化剂的原理和生产控制条件,通过经济和环境效益分析证明,铬渣作水泥矿化剂确实是一种处理和利用铬渣的好方法。     

绿色分离技术-超临界流体萃取的应用

介绍了超临界流体的性质及萃取过程,主要介绍了超临界流体萃取技术在医药、食品、环保及分析领域方面的应用。     

ClO_2对活性艳红K—2G和分散蓝2BLN染料的脱色研究

本论文主要利用自制高纯二氧化氯对两种常用且结构具有代表性的活性艳红K— 2G和分散蓝 2BLN料染 ,进行氧化脱色研究 ,作了温度 ,pH值 ,二氧化氯用量等条件试验 ,并用实际印染废水进行了实验 ,取得了良好的效果。在室温时 ,t =5min～ 7min ,pH值偏碱性条件下 ,单一染料溶液及混合染料溶液的脱色率均达到 90 %以上 ,实际印染废水的脱色也在 90 %左右。pH值、温度和ClO2 用量等多种因素对脱色率均有一定的影响 :pH值越高 ,染料脱色率越高。ClO2 用量存在一最佳值 ,与活性艳红K— 2G及分散蓝 2BLN染料的最佳摩尔比分别为 4 0及 2 0左右。ClO2 耗量随染料起始浓度的增大而增加 (脱色率相同时 )