石油污染土壤修复技术的进展

综述了石油污染土壤修复技术的发展现状及存在的瓶颈,分析了石油污染对油-水-土界面性质、土-水关系和土壤渗透性等水理性质的影响.对石油污染土壤再利用于工程建设进行了探讨,并总结了石油污染土壤主要的力学性质变化,为石油污染土壤修复技术的工程实践和机理研究提供参考.     

双极不对称预荷电静电增强过滤除尘技术的应用

双极不对称预荷电静电增强过滤除尘技术 ,是国家“九五”科技攻关课题所取得的成果之一 ,该技术采用双极不对称荷电增强方式 ,将普通静电增强效果与粉尘凝并机能有机地结合在一起 ,既提高了过滤除尘器的收尘效率 ,尤其是呼吸性粉尘的效率 ,同时又极大地改善了滤料粉尘层的结构 ,可显著地降低过滤阻力增值 ,节约运行能耗。笔者研究的该技术应用于焊接车间的焊接烟尘的治理上 ,取得了良好的效果。现场测试表明 ,该技术对焊接烟尘的滤除效率提高了 3% ,尤其对微细粉尘效果显著 ,2 μm粉尘穿透率相对下降了 4 7%。采用超细滑石粉高粉尘负荷测试结果表明 ,过滤阻力增值降低达 30 % ,清灰效果明显改善     

新型絮凝剂室内评价试验

通过对比国外的有机絮凝剂和无机絮凝剂复配使用情况,对钻井污水用新型絮凝剂一有机一无机复合絮凝剂ＷＢＹ进行了评价,结果证明该絮凝剂能经济、高效地处理钻井污水。     

提供生物稳定饮用水的最佳工艺

研究由预处理、常规处理和深度处理组合而成的 7种不同工艺对饮用水源水中可生物同化有机碳 ( AOC)的去除效果 .试验表明 :生物陶粒预处理对 AOC具有较高的去除率 ,达到 45%左右 ,如果在它之前先经过预臭氧化 ,生物处理的去除率可增大到 58.4% ;常规处理对 AOC的去除非常有限 ,去除率平均在 2 0 %左右 ;新活性炭单元因其吸附作用对 AOC的去除效果稳定在30 %左右 ,如和臭氧氧化连用 ,去除效果能提高到 50 %以上 ;包括了常规处理、生物预处理、预臭氧和臭氧活性炭的组合工艺对AOC的去除效果最好 ,达到 86% .因此臭氧氧化、生物炭和生物处理是提高饮用水生物稳定性的重要手段 ,并以本试验结果为依据提出了对于不同的水源水所采用的最佳工艺 .     

燃煤手烧锅炉除尘器的研究与开发

介绍了一种集多种湿法除尘技术之长于一体的新型组合式除尘装置,该装置不仅能有效地消除手烧锅炉燃烧时产生的烟尘,而且实现了除尘水的内循环,消除了其他湿式除尘器所带来的水的二次污染问题。     

散射光下铁(Ⅲ)-丙酮酸盐配合物还原铬(Ⅵ)的研究

研究了在散射光下铁（Ⅲ）-丙酮酸盐配合物对铬（Ⅵ）的光还原反应;考察了溶液pH、铁（Ⅲ）、丙酮酸钠、铬（Ⅵ）浓度对反应的影响;分析了铬（Ⅵ）光还原反应的动力学。实验结果表明：铁（Ⅲ）-丙酮酸盐配合物体系能在较弱的散射光下还原铬（Ⅵ）。在铬（Ⅵ）浓度为19．2μmol／L、铁（Ⅲ）浓度为10．0μmol／L、丙酮酸钠浓度为240μmol／L、pH为3．0、光照240min的条件下,铬（Ⅵ）的还原率达到99．7％。从表观动力学方程的反应级数看,铁（Ⅲ）的级数（0．83）最高,铁（Ⅲ）浓度是影响铬（Ⅵ）光还原反廊速率的主要因素．铁（Ⅱ）是铬（Ⅵ）光还原的主要还原剂。     

Thermogravimetric analysis and kinetic study on pyrolysis of representative medical waste composition

To obtain detailed information on the pyrolysis characteristics, a thermogravimetric study on the pyrolysis of 14 typical medical waste compositions was carried out in thermogravimetric analysis (TGA) equipment using dynamic techniques in a stream of N(2). An index representing pyrolysis reactivity of waste was presented. Kinetic parameters were obtained by Coats-Redfern method and used to model the TG curve. The results showed that: (a) Plastic, protein, cellulosic material, synthetic fibre, and rubber entered pyrolysis process in succession. (b) There was one decomposition stage in the pyrolysis of one-off medical glove, operating glove, cellulosic waste, absorbable catgut suture and adhesive plaster, while other components had two obvious weight loss stages. (c) The obtained apparent activation energy for second stage pyrolysis was comparably higher than that for first stage. (d) Each stage was controlled by only one kinetic mechanism, in which kinetic parameters were constant. (e) The degradation kinetics of medical waste may be affected by special physical and chemical treatment in the product manufacturing process. (f) Among 13 waste samples, the pyrolysis index of cellulosic matter was the highest, which indicated cellulosic matter had strong pyrolysis reactivity. (g) With increasing heating rate, TG curve and DTG peak shifted to high temperatures and main reaction interval of the sample became longer.     

Geotechnical and leaching properties of flowable fill incorporating waste foundry sand

Waste foundry sand (WFS) can be converted into flowable fill for geotechnical applications. In this study, WFS samples were obtained from 17 independent metal casting facilities with different casting processes, thus representing a good range of WFS properties. The laboratory studies include physical, geotechnical and leaching properties of flowable fills consisting of WFS, cement, and fly ash mixed to different water contents. The main properties measured include WFS physical properties (density, particle gradation, grain shape, and fine content), WFS flowable fill geotechnical properties (unconfined compressive strength, hydraulic conductivity, setting time, and bleeding), and the fill's leaching properties (heavy metals and organics in the bleed water and the leachate extracted from hardened WFS flowable fills). The test results indicate that in terms of the physical properties, most of the data fall within narrow ranges, although data from the copper/aluminum-based WFS samples might fall beyond the ranges. Geotechnical properties of WFS flowable fills in both fresh and hardened phases were verified conforming to the features of specified flowable fills. Material leaching analyses indicate that the toxicity of WFS flowable fills is below regulated criteria. A mix formulation range originated from this study is proposed for the design of WFS made flowable fill.     

三种偶氮染料降解历程在紫外-可见光谱上的表现

本文对基本结构相似的三种偶氮染料橙黄Ⅱ、活性艳红Ｘ－３Ｂ和活性黑Ｋ－ＢＲ水溶液在铁粉还原－光氧化两步法处理中的紫外－可见光谱图作对比分析,依据其结构与特征吸收的关系,初步推测还原铁粉－光氧化法降解染料的历程。     

油气钻井作业对地下水污染治理研究＊

分析了钻井作业对地下水污染的特点、污染途径,针对性地提出了钻井作业对地下水污染的预防措施,以及污染物处理技术,其中氧化还原技术、气体抽取技术、环境生物技术主要用于有机物污染治理,SRB技术、废弃钻井液固化技术、钻井液转换为水泥浆(MTC)的固井技术可用于处理废弃钻井液。钻井引起的污染治理应以"预防为主,防治结合",切实推行清洁生产和HSE管理。