长江中下游燕山期火山岩地质特征及其与成矿的关系

笔者根据长江中下游基底构造特征、火山岩时空分布及其相互关系,对该区火山岩盆地进行了重新认定,划分出三个受北东-北北东向和近东西向两组岩石圈断裂控制的断陷火山盆地.在此基础上,依据火山活动特点及其与壳断裂的关系又将其划分为若干个亚盆地.本文系统论述了各盆地的火山岩演化、岩石组合及其地球化学特征;对内生金属矿床与火山岩的关系作了探讨,认为成岩物质主要来源于上地幔,成矿作用是火山活动的一部分,成矿物质主要来源于岩浆.     

味精生产的污染排放分析与治理研究

以东北地区某味精生产厂为例,对味精生产从水体、大气、固废三个方面进行了污染分析。通过对污水处理和大气污染治理的系统控制以及对固体废弃物的综合利用研究,结果表明,味精生产中污染排放能够达到国家的相关标准。     

跨流域调水社会评价的定量化探讨--以改善氟病区生活饮用水为例

本文建立一个用跨流域调水来改善氟病区生活饮用水水质所带来的环境经济效益的评价和估算的经济数学方法.从而揭示水作为一种资源用于改善自然环境,提高人民健康水平,可创造经济价值,带来社会效益.     

中空纤维膜器处理含铀(VI)废水的研究

在中空纤维膜器中研究了二（2－乙基己基）磷酸（HDEHP＿煤油膜萃取含铀（Ⅵ）废水。实验表明，HDEHP－煤油膜萃取铀（Ⅵ）的萃取率随萃取时间的增加而增加；当水相pH大于2时，水相酸度对速率影响较小，当水相pH小于2时，随着水相pH的提高，速率明显上升；提高水相流速可提高膜萃取率；当有机相HDEHP浓度小于0.01mol/L时，随着HDEHP浓度的提高萃取率上升，当大于0.01mol/L后，其浓度改变对萃取率影响不大。温度和有机相流速对膜萃取率影响较小。     

超临界水氧化的技术研究进展

超临界水氧化是利用有机物与超临界反应来破坏有机物结构的一种新型氧化技术.本文介绍了超临界水的特性和超临界水氧化的原理与工艺装置,综述了这一高新技术在对酚、甲胺磷、DDT、硝基苯等有毒有机污染物的处理方面的最新研究成果,且对影响处理效果的各因素(温度、压力、氧化剂浓度、停留时间、有机物初始浓度、pH值)以及催化剂的研究进行了概括,并对这一新型氧化技术的发展前景作了展望.     

优势工程菌在H/O工艺中处理制药废水的研究

采用水解 (H)—好氧 (O)生化工艺研究了优势复合工程菌对抗生素工业废水有机质的降解能力并进行了处理条件试验研究。探讨了预处理、生化温度、pH值、水力停留时间、进水有机物浓度等因素对生化处理工艺的影响。试验结果表明 ,在选定的条件下 ,水解单元COD的降解率达 71 9%。好氧单元COD的降解率达 62 9% ,总去除率达 98 5%。达到国家规定的制药行业排放标准 ,出水的COD平均浓度低于 30 0mg/L。     

超塑胀形唯象力学研究综述

此文对超塑胀形唯象力学研究作了较全面系统的回顾,对各文献的研究作了相应的分类和逐一地评述,进而指出了超塑胀形唯象力学研究在理论和应用上存在的主要问题,为今后的相关研究指明了方向。     

沈阳市区大气飘尘中有机物含量的分布规律

利用粉尘采样器采集沈阳市区十五个点的大气ＰＭ１０，用四氯化碳进行萃取，在１７３０型ＦＴ－ＩＲ光谱仪上进行红外定量，制得沈阳市区大气ＰＭ１０及其有机物含量分布图，找出规律，查出污染源。     

A spectral power analysis of driving behavior changes during the transition from nondistraction to distraction

Objective: This article investigated and compared frequency domain and time domain characteristics of drivers' behaviors before and after the start of distracted driving.

Method: Data from an existing naturalistic driving study were used. Fast Fourier transform (FFT) was applied for the frequency domain analysis to explore drivers' behavior pattern changes between nondistracted (prestarting of visual–manual task) and distracted (poststarting of visual–manual task) driving periods. Average relative spectral power in a low frequency range (0–0.5 Hz) and the standard deviation in a 10-s time window of vehicle control variables (i.e., lane offset, yaw rate, and acceleration) were calculated and further compared. Sensitivity analyses were also applied to examine the reliability of the time and frequency domain analyses.

Results: Results of the mixed model analyses from the time and frequency domain analyses all showed significant degradation in lateral control performance after engaging in visual–manual tasks while driving. Results of the sensitivity analyses suggested that the frequency domain analysis was less sensitive to the frequency bandwidth, whereas the time domain analysis was more sensitive to the time intervals selected for variation calculations. Different time interval selections can result in significantly different standard deviation values, whereas average spectral power analysis on yaw rate in both low and high frequency bandwidths showed consistent results, that higher variation values were observed during distracted driving when compared to nondistracted driving.

Conclusions: This study suggests that driver state detection needs to consider the behavior changes during the prestarting periods, instead of only focusing on periods with physical presence of distraction, such as cell phone use. Lateral control measures can be a better indicator of distraction detection than longitudinal controls. In addition, frequency domain analyses proved to be a more robust and consistent method in assessing driving performance compared to time domain analyses.     

Comparative study on pyrolysis of bamboo in microwave pyrolysis-reforming reaction by binary compound impregnation and chemical liquid deposition modified HZSM-5

The deactivation of catalyst is a significant reason for its limited application during the catalytic fast pyrolysis (CFP) process. To reduce the coke formation, binary compound impregnation (BCI) and chemical liquid deposition (CLD) were used to modify HZSM-5 catalysts. At the same time, the self-designed microwave reactor separated the pyrolysis of bamboo and catalytic upgrading of primary vapor, which made the catalytic effect more thorough. Experimental results indicated that CLD used TiO₂ deposition to cover external acid sites, while BCI by phosphorus-nickel could cover and partly destroy superficial acid sites through two different ways. Within the scope of the loaded amount studied, the yield of aromatic hydrocarbons in the oil phase increased at first and then decreased, while the coke formation reduced continuously. BTX (benzene, toluene and xylene), the most valuable product in bio-oil, drastically increased by 39.1% and 22.6% respectively over the CLD and BCI modified catalysts. Considering the catalytic performance as well as cost, CLD over HZSM-5 has more advantages in the CFP process to upgrade bio-oil.