Study of PCDD/Fs distribution in fly ash,ash deposits,and bottom ash from a medical waste incinerator in China

Over the past decades in China, the number of medical waste incinerators (MWIs) has been rising rapidly, causing emissions of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). In this study, samples of fly ash, ash deposits, and bottom ash from typical MWIs were analyzed for PCDD/Fs and their distribution characteristics. Results showed international toxic equivalent (I-TEQ) values in the range of 6.9–67 ng I-TEQ/g in fly ash and ash deposits, whereas the concentration in bottom ash was extremely low (only 1.33 pg I-TEQ/g), yet the generation of PCDD/Fs was mostly de novo synthesis in fly ash and ash deposits according to the ratio of PCDFs to PCDDs; the major distribution differences of PCDD/Fs in fly ash was manifested by the content of toxic furan 2,3,7,8-TCDF, but other toxic PCDD/Fs showed similar distribution. Other findings are that 2,3,4,7,8-PeCDF had the most contribution to TEQ concentration, and that the most abundant toxic furan congener is 1,2,3,4,6,7,8-HpCDF. Correlation analysis showed that there was no significant correlation between PCDD/Fs concentration and several other physical and chemical parameters.

Implications: This paper is of interest because it presents the emission performances of PCDD/Fs in ash from medical waste incineration in China. PCDD/F contents in fly ash and ash deposits vary between 6.9 and 67.3 ng I-TEQ/g. However, the concentration in bottom ash was extremely low (only 1.33?×?10^?3 ng I-TEQ/g). The fingerprints of PCDD/Fs in fly ash are almost similar, except for 2,3,7,8-TCDF. There is no marked correlation between PCDD/Fs and other physicochemical properties.

Supplemental Materials: Supplemental materials are available for this paper. Go to the publisher's online edition of the Journal of the Air & Waste Management Association.     

锆(Ⅳ)负载交联壳聚糖吸附硫酸根的性能

以甲醛、苯甲醛为交联剂,制备交联壳聚糖树脂,再与锆(Ⅳ)离子反应制备锆负载交联壳聚糖吸附剂。采用静态吸附法考察了该吸附剂对水中硫酸根离子(SO24-)的吸附性能。实验发现,吸附时间2 h,SO24-溶液初始浓度500 mg/L,pH值3.0,溶液温度35℃为较优的吸附条件;吸附过程符合Langmuir等温吸附模型,属于优惠吸附型,吸附容量可达78.65 mg/g;吸附过程较好地符合拟二级动力学模型;锆负载前后交联壳聚糖对硫酸根的吸附量提高了约4.5倍;该吸附剂具有良好的耐酸性和再生性能。     

低浓度含砷污酸处理工艺的比较研究

比较研究了石灰中和法和石灰-铁盐法对硫化后含低浓度砷(20～50 mg/L)污酸的处理效果。结果表明,单纯采用石灰法,废水难以达标排放;而两段石灰-铁盐(氯化铁)法满足达标排放的同时,一段及二段沉淀物的浸出液中砷、镉、铜、铅和锌含量均低于危险废物鉴别标准要求(GB 5085.3-2007);其最优工艺参数为一段终了pH=2,反应时间为2 h,二段终了pH=8、Fe/As=8、反应时间为60 min、氧化剂投加量(Ca(ClO)2/As)为6∶1;正交实验结果中各参数对铁盐除砷效果影响顺序为终了pH>反应时间>Fe/As>氧化剂投加量。     

Aquatic plant debris improve phosphorus sorption into sediment under anoxic condition

The effects of plant debris on phosphorus sorption by anoxic sediment were investigated. Addition of plant debris significantly enhanced the decrease of soluble relative phosphorus (SRP) in overlying water at both 10 and 30 °C during the 30-day investigation. Both cellulose and glucose, two typical plant components, also clearly enhanced the SRP decrease in anoxic overlying water. The measurement of phosphorus (P) fractions in sediment revealed that the levels of unstable P forms were decreased by plant debris addition, whereas the opposites were true for stable P forms. However, under sterilized condition, plant debris/glucose addition has no effect on the SRP decrease in overlying water. Overall, our results suggested that plant debris improve P sorption into sediment under anoxic condition through a microorganism-mediated mechanism.     

强化混凝法处理煤气冷凝水

以包头钢铁(集团)有限责任公司高炉煤气冷凝水为处理对象,采用强化混凝法进行静态混凝沉淀对比实验。实验结果表明,当聚合氯化铝加入量为20mg/L、高分子纳米除氯剂加入量为2.0mL/L时,处理后出水SS小于10mg/L,浊度小于10NTU,氯离子去除率在80%以上,而且对废水中的其他离子也有一定的去除效果,出水水质基本接近工业冷却循环水回用指标。     

调理料添加比例对菇渣基质发酵效果的影响

为探讨废弃蘑菇基料菇渣改性生产有机栽培基质技术,直接采用菇渣为主要原料,以猪粪作为调理料进行好氧发酵,研究猪粪的不同添加比例对菇渣好氧发酵腐熟条件中的温度、挥发性固体(VS)、p H、全氮、全磷、种子发芽指数(GI)的影响。结果表明,猪粪适宜作为菇渣改性生产有机基质的调理料,发酵过程始终维持含水率在65%左右,3个处理高温持续时间均在5 d以上,满足基质无害化卫生标准要求,发酵完成后p H均符合腐熟基质标准,GI均达到60%以上。而猪粪添加量较少时,可以缩短进入高温发酵期的时间,堆体达到的最高温度较高,堆料腐熟较快,且最有利于氮素的保存和全磷的浓缩。综合以上实验结果表明,在菇渣发酵中添加15%的猪粪有利于改善发酵条件,提高堆体的养分含量。     

Vinegar residue compost as a growth substrate enhances cucumber resistance against the Fusarium wilt pathogen Fusarium oxysporum by regulating physiological and biochemical responses

Environmental Science and Pollution Research - Fusarium wilt caused by the fungus Fusarium oxysporum f. sp. cucumerinum (FOC) is the most severe soil-borne disease attacking cucumber. To assess the...     

十溴联苯醚环境修复技术的研究进展

介绍了溴代阻燃剂十溴联苯醚（BDE-209）环境修复技术的研究进展。从光降解、零价铁降解、生物降解3个方面对BDE-209的降解机理和降解后的产物进行了介绍。BDE-209经光照、厌氧微生物、零价铁的脱溴作用后,降解成低溴代联苯醚产物;好氧微生物利用低溴代联苯醚作为生长碳源,将其在酶的作用下开环降解,进入三羧酸循环或彻底分解成CO₂和H₂O。提出应采用多种方法协同作用,更有效地降解多溴联苯醚化合物。     

Recycling of electrolytic manganese solid waste in autoclaved bricks preparation in China

China has played a dominant role in global electrolytic manganese metal (EMM) production, accounting for over 98 % of the total world capacity since 2008. However, with the rapid development of the EMM industry and depletion of mineral ores, electrolytic manganese solid waste (EMSW) is piling up, so more large-scale landfills are needed. The environmental problems generated by EMSW pose severe threats to soil and ground water, and have become the hot issues in society. The aim is to consume and recycle EMSW, and the primary route is to make autoclaved bricks. However, less attention has been given to the procedure and strength-forming mechanism of EMSW bricks, not to mention the production line of the brick. On the basis of physical and chemical property analysis, the pretreatment process of EMSW was indispensable to solidify/stabilize the heavy metals, such as Mn, Zn, Cd, Pb, etc.. This paper expatiated on the procedure of making EMSW autoclaved bricks, analyzed in detail the strength formed by different cementitious materials with cement properties, and introduced the practical engineering of EMSW autoclaved bricks. The results showed that the pretreatment process with quicklime was effective in solidifying/stabilizing the heavy metals. The compressive strength of EMSW bricks reached 10.05 MPa when quicklime 9 % (w/w) added. Cement may be an ideal cementitious material to create EMSW bricks of high strength in experiments and on the production line. Quicklime and cement used simultaneously produced a lower strength than that when adding cement alone because the gypsum from EMSW and an alkali could generate deleterious effects, e.g., expansion or burst. In the production line of EMSW bricks, an appropriate mix proportion to make high-quality autoclaved bricks was determined: EMSW 30–40 %, cement 10–20 %, and aggregates 40–60 %. The low content of heavy metals tested by toxicity leaching may deduce that the EMSW autoclaved bricks have low environmental risk. However, long-term environmental risk evaluation will be needed, requiring more tests and leaching modeling. Employing EMSW to make high-quality autoclaved bricks may be a promising waste-to-resource strategy.     

不适宜生长条件对混菌降解苯胺的影响

分别从台州和衢州某化工厂的好氧池中分离筛选得到2株苯胺降解菌TZ1和JH1,经16S rDNA测序鉴定为Comamonas sp.TZ1和Pseudomonas sp.JH1,均具有较强的苯胺降解能力,培养24 h后,可使初始浓度为800 mg/L的苯胺去除率达到96.4%~98.4%。在此基础上,按体积比1∶1将2株菌液进行混合构建了混合菌体系,进而对比考察了苯胺初始浓度、pH、盐度和重金属等环境因子对单一菌和混合菌生长量及降解苯胺效果的影响,重点探讨混合菌对不适宜生长环境的适应性及其对苯胺的降解特性。通过单一菌和混合菌对比实验发现,在适宜苯胺初始浓度、pH和盐度条件下,混合菌的生长量略高于单一菌;在不适宜生长的高浓度苯胺、pH和盐度条件下,混合菌也表现出了更强的适应性和苯胺矿化能力。Zn2+和Cr6+耐受实验则表明,对于Cr6+,混合菌表现出了更强的耐受能力,而对于Zn2+并没有表现出更强的耐受能力。