PCBs污染土壤的CaO诱导低温热处理脱氯研究

研究了低温热处理脱氯技术对废弃电容器封存点附近污染土壤中多氯联苯脱氯的效果,考察反应温度、反应时间及CaO添加比例对PCBs去除率、脱氯率的影响以及反应前后土壤中污染物的组分变化。实验土样中PCBs浓度为107.7 mg/g,属于罕见高浓度PCBs污染土壤。当反应温度为400℃、停留时间4h、CaO添加比例为10%,PCBs的去除率为87.7%,脱氯率为85.3%。土壤样品中五氯联苯和四氯联苯反应后含量降低或未检出,部分反应后样品检出一氯联苯和联苯,说明在CaO诱导PCBs低温热处理脱氯反应中存在逐步脱氯/加氢反应途径。     

原铝生产流程温室气体排放主要影响因素的关联度分析

铝是国民经济建设和发展的关键基础材料,然而由其生产过程所产生的大量温室气体排放也逐渐成为政府关注的焦点。本研究计算了我国原铝生产不同年度的生命周期能耗和温室气体排放量,并分析了资源消耗和生产工序能耗等影响因素与温室气体排放的关联性。结果表明,在各年原铝生产的温室气体排放总量中,电力和阳极效应导致的排放所占比重分别为68.5%和7.9%,其他影响因素所占比重均低于6%;与温室气体排放关联度最高的3个影响因素依次是电耗、煤气燃烧和石灰石煅烧,其值分别为0.937、0.899和0.893;在目前铝电耗和阳极效应控制水平提升空间有限的情况下,降低煤气的消耗,提高石灰石的使用效率,是实现原铝生产温室气体减排的有效途径。     

DO浓度对间歇曝气单级自养脱氮系统N2O排放的影响

以单级自养脱氮系统为研究对象,采用有效容积为15 L的SBBR反应器,系统进水NH+4-N浓度约为360 mg/L,控制温度为(30±2)℃,采用间歇曝气方式运行,曝气段DO浓度从2.4~2.6 mg/L逐渐下降到0.9~1.1 mg/L,研究了单级自养脱氮系统的脱氮性能与N2O排放情况。结果表明,反应器曝气段DO浓度从2.4~2.6 mg/L下降到0.9~1.1mg/L,系统TN去除率均达到80%,但在相同运行时间内的TN去除率依次降低,NH+4-N平均反应速率从0.19 mg/(L·min)降低至0.05 mg/(L·min),NO-3-N累计产生量稳定于14.9~16.5 mg/L,NO-2-N浓度在反应器内未产生明显的积累。随着曝气段DO浓度的下降,最大N2O释放速率逐渐降低,N2O累计释放量从73.8 mg下降到61.0 mg,N2O转化率介于2.4%~2.9%。     

气浮技术在膜生物反应器剩余污泥浓缩过程中的应用

污泥浓缩作为污泥处理的关键环节之一,开发高效的污泥浓缩工艺对于降低污泥含水率、提高脱水设备的运行效率、降低脱水能耗具有十分重要的意义。针对MBR污泥浓度高、污泥粒径小、污泥沉降性能较差等特点,故采用传统的重力浓缩和机械浓缩技术很难有效实现污泥浓缩。因此,尝试采用气浮浓缩技术降低污泥含水率的可行性。从气浮浓缩的中试结果来看,较适宜运行参数为:固体负荷为15 kg/(m2·h),水力负荷为1.5 m3/(m2·h),回流比为1,PAM投配率2‰(w/w干固体),溶气压力为0.4 MPa,气固比为0.03。经过中试设备进行气浮浓缩后,污泥含水率降低至96%左右。此外,还研究了采用气液多相泵系统对剩余污泥的浓缩效率,结果显示,该设备的使用相对于传统溶气气浮工艺,其优点表现在占地小、工程造价低以及运行成本低等方面。     

改性丝瓜络纤维对水体日落黄的吸附特性

采用化学改性的方法将丝瓜络制备为阴离子吸附剂,并将其用于水体日落黄(SY)染料的吸附,分别考察了吸附剂的用量、日落黄染料的初始浓度(C0)、p H值、温度(K)、时间(T)5个因素对吸附效果的影响。通过模拟吸附等温曲线、吸附动力学以及热力学方程并通过比表面积(BET)和红外光谱(FTIR)分析改性丝瓜络吸附染料前后和丝瓜络改性前后的变化情况以此探究其吸附机理。结果表明,p H对吸附效果影响不明显;最大吸附量随温度升高而增大,在298 K温度时最大吸附量达到137 mg/g,是未改性丝瓜络的9.78倍。Langmuir方程拟合吸附过程描述最好,吸附类别为化学吸附。吸附过程符合伪二级动力学,是一个自发和吸热的过程。改性丝瓜络可以有效去除水体中的日落黄染料。     

江汉平原土地利用对钉螺分布的影响研究

分析了江汉平原2009年易于钉螺孳生的3种土地利用类型（滩地、河渠和水田）比例与钉螺密度的关系。首先,在ERDAS9.2和ENVI4.7软件中对江汉平原2009年的Landsat5TM遥感影像进行了预处理。在已有的多期土地利用数据的基础上,借助eCognition软件利用向量相似度指标来提取土地利用变化区域,结合目视解译经验并运用遥感指标通过建立规则集对变化区域进行分类,将变化区域的分类结果更新2000年数据,得到了该区域2009年的土地利用数据。接下来,整理了江汉平原2009年螺情资料并计算出村级钉螺平均密度,绘制了2009年钉螺分布图。将绘制的钉螺分布图与土地利用分类图叠置分析,并结合收集的螺情数据确定了钉螺易于孳生的3种土地利用类型,分别为滩地、河渠和水田。最后,将钉螺密度与这3种土地利用比例进行线性回归分析。研究结果表明,钉螺密度与这三种土地利用类型比例存在线性回归关系,模型精度为R2=0857。该结论对通过遥感影像来估算钉螺密度具有指导意义,另外也可以为湖北省提出合理用地和灭螺并重的土地利用模式提供一定的科学参考     

臭氧氧化—包埋菌流化床生物处理组合工艺深度处理煤气化废水

采用臭氧氧化—包埋菌流化床生物处理组合工艺对煤气化废水进行深度处理。实验结果表明：当臭氧的质量浓度20 mg/L、臭氧进气流量1.5 L/min、臭氧通气时间30 min、包埋菌流化床水力停留时间24 h时,臭氧氧化工序的COD去除率达到30.0%~40.0%,总酚去除率达到100.0%;包埋菌流化床工序的COD去除率达到60.0%以上,氨氮的去除率大于95.0%;经组合工艺处理后,出水COD<60 mg/L,ρ（氨氮）<1.0 mg/L,ρ（总酚）未检出,色度小于50倍,达到GB8978—1996《污水综合排放标准》中的一级排放标准。     

Concentration and health risk evaluation of heavy metals in market-sold vegetables and fishes based on questionnaires in Beijing,China

Concentrations of heavy metals (As, Cd, Pb, Cu, Ni, Fe, Mn, and Zn) in market vegetables and fishes in Beijing, China, are investigated, and their health risk to local consumers is evaluated by calculating the target hazard quotient (THQ). The heavy metal concentrations in vegetables and fishes ranged from not detectable (ND) to 0.21 mg/kg fresh weight (f.w.) (As), ND to 0.10 mg/kg f.w. (Cd), and n.d to 0.57 mg/kg f.w. (Pb), with average concentrations of 0.17, 0.04, and 0.24 mg/kg f.w., respectively. The measured concentrations of As, Cd, Pb, Cu, Ni, Fe, Mn, and Zn are generally lower than the safety limits given by the Chinese regulation safety and quality standards of agriculture products (GB2762-2012). As, Cd, and Pb contaminations are found in vegetables and fishes. The exceeding standard rates are 19 % for As, 3 % for Cd, and 25 % for Pb. Pb contaminations are found quite focused on the fish samples from traditional agri-product markets. The paper further analyzed the health risk of heavy metals in vegetables and fishes respectively from supermarkets and traditional agri-product markets; the results showed that the fishes of traditional agri-product markets have higher health risk, while the supermarkets have vegetables of higher heavy metal risk, and the supervision should be strengthened in the fish supply channels in traditional agri-product markets.     

石墨气体扩散电极的制备与性能优化

电极的制备工艺及参数直接影响电极材料的活性。主要考察了C/PTFE质量比、碾压压力、煅烧温度、造孔剂NH4HCO3及稀土掺杂等因素对电极产出H2O2的影响规律。研究结果表明,电极最佳制备条件为:石墨和PTFE质量比为2∶1、石墨、造孔剂和稀土元素质量比为6∶1∶1、碾压压力10 MPa、煅烧温度330℃。在pH=3、电解质Na2SO4浓度为0.05mol/L条件下,电解2 h后,改性电极产生的H2O2从95 mg/L提高到350 mg/L,提高了268.4%。     

Probing the distribution and contamination levels of 10 trace metal/metalloids in soils near a Pb/Zn smelter in Middle China

The horizontal and vertical distribution patterns and contamination status of ten trace metal/metalloids (Ag, Bi, Co, Cr, Ge, In, Ni, Sb, Sn, Tl) in soils around one of the largest Chinese Pb–Zn smelter in Zhuzhou City, Central China, were revealed. Different soil samples were collected from 11 areas, including ten agricultural areas and one city park area, with a total of 83 surface soil samples and six soil cores obtained. Trace metal/metalloids were determined by inductively coupled plasma–mass spectrometry after digestion by an acid mixture of HF and HNO₃. The results showed that Ag, Bi, In, Sb, Sn, and Tl contents decreased both with the distance to the Pb–Zn smelter as well as the soil depth, hinting that these elements were mainly originated from the Pb–Zn smelting operations and were introduced into soils through atmospheric deposition. Soil Ge was influenced by the smelter at a less extent, while the distributions of Co, Cr, and Ni were roughly even among most sampling sites and soil depths, suggesting that they were primarily derived from natural sources. The contamination status, as revealed by the geo-accumulation index (I _geo), indicated that In and Ag were the most enriched elements, followed by Sb, Bi, and Sn. In general, Cr, Tl, Co, Ni, and Ge were of an uncontaminated status.