Linking field experiments to long-term simulation of impacts of nitrogen deposition on heathlands and moorlands

The results from three long-term field manipulation studies of the impacts of increased nitrogen deposition (0–120 kg N ha^?1 yr^?1) on lowland and upland heathlands in the UK were compared, to test if common responses are observed. Consistent increases in Calluna foliar N content and decreases in litter C:N ratios were found across all sites, while increases in N leaching were not observed at any site over the range 0–80 kg ha^?1 yr^?1. However, the response of Calluna biomass did vary between sites, possibly reflecting site differences in nutrient status and management histories. Five versions of a simulation model of heathland responses to N were developed, each reflecting different assumptions about the fate and turnover of soil N. Model outputs supported the deduction from mass balance calculations at two of the field sites that N additions have resulted in an increase in immobilisation; the latter was needed to prevent the model overestimating measured N leaching. However, this version of the model significantly underestimated Calluna biomass. Model versions, which included uptake of organic N by Callunaand re-mobilisation of N from the soil organic store provided some improvement in the fit between modelled and field biomass data, but re-mobilisation also led to an overestimation of N leaching. Quantification of these processes and their response to increased N deposition are therefore critical to interpreting experimental data and predicting the long-term impacts of atmospheric deposition on heathlands and moorlands.     

Electro-dissolution of metal scrap anodes for nickel ion removal from metal finishing effluent

This contribution reports a novel and cost efficient strategy for nickel ion removal from metal finishing effluents by electro-dissolution of scrap aluminium and iron sacrificial anodes. Electro-coagulation of effluent was carried out at 30 mA/cm² current density for 60 min. The nickel ion concentration of electroplating effluent was analysed by Atomic Absorption Spectroscopy. SEM images of iron and aluminium scrap anodes were critically analysed. Parameters such as heavy metal removal, anode dissolution rate with respect to heavy metal removal, reaction kinetics and cost estimation have been elaborately studied. Electro-coagulation at 30 mA/cm² for 60 min using iron and aluminium scrap anodes resulted in 95.9 and 94.1 % nickel ion reduction, respectively, with 0.0094 and 0.0053 g/ppm dissolution rates. The energy consumption for scrap aluminium and iron anodes was 0.0547 kWh/L. Loose internal bonding and spongy surface morphology of used metal scrap render high porosity and active surface area, enhancing reaction rate. Low cost and ready availability of waste scrap makes the process of electro-coagulation economically viable. Thus, the findings from this contribution point decisively at the superiority of waste metal scrap-based anodes for economic and environmentally sustainable heavy metal ion removal from metal finishing effluent.     

Modelling nitrogen fluxes at the landscape scale

The distribution and impacts of different nitrogen pollutants are inextricably linked. To understand the problem fully, the interactions between the different pollutants need to be taken into account. This is particularly important when it comes to abatement techniques, since measures to reduce emissions of one nitrogen pollutant can often lead to an increase in another. This project represents a step towards greater understanding of these issues by linking together new and existing nitrogen flux models into a larger framework. The modelling framework has been constructed and some of the nitrogen flows between fields, farms and the atmosphere have been modelled for a UK study area for typical farm management scenarios.     

Mass balances and life cycle inventory of home composting of organic waste

A comprehensive experimental setup with six single-family home composting units was monitored during 1 year. The composting units were fed with 2.6-3.5 kg organic household waste (OHW) per unit per week. All relevant consumptions and emissions of environmental relevance were addressed and a full life-cycle inventory (LCI) was established for the six home composting units. No water, electricity or fuel was used during composting, so the major environmental burdens were gaseous emissions to air and emissions via leachate. The loss of carbon (C) during composting was 63-77% in the six composting units. The carbon dioxide (CO(2)) and methane (CH(4)) emissions made up 51-95% and 0.3-3.9% respectively of the lost C. The total loss of nitrogen (N) during composting was 51-68% and the nitrous oxide (N(2)O) made up 2.8-6.3% of this loss. The NH(3) losses were very uncertain but small. The amount of leachate was 130 L Mg(-1) wet waste (ww) and the composition was similar to other leachate compositions from home composting (and centralised composting) reported in literature. The loss of heavy metals via leachate was negligible and the loss of C and N via leachate was very low (0.3-0.6% of the total loss of C and 1.3-3.0% of the total emitted N). Also the compost composition was within the typical ranges reported previously for home composting. The level of heavy metals in the compost produced was below all threshold values and the compost was thus suitable for use in private gardens.     

Comparative assessment of municipal sewage sludge incineration,gasification and pyrolysis for a sustainable sludge-to-energy management in Greece

For a sustainable municipal sewage sludge management, not only the available technology, but also other parameters, such as policy regulations and socio-economic issues should be taken in account. In this study, the current status of both European and Greek Legislation on waste management, with a special insight in municipal sewage sludge, is presented. A SWOT analysis was further developed for comparison of pyrolysis with incineration and gasification and results are presented. Pyrolysis seems to be the optimal thermochemical treatment option compared to incineration and gasification. Sewage sludge pyrolysis is favorable for energy savings, material recovery and high added materials production, providing a ‘zero waste’ solution. Finally, identification of challenges and barriers for sewage sludge pyrolysis deployment in Greece was investigated.     

The GaNE programme in a global perspective

This paper provides the background to this special issue, outlining the extent to which the global atmospheric nitrogen cycle has been modified by human activity and outlining the range of effects. The global total emissions of reduced and oxidized nitrogen, amount to 124 Tg N, and exceed those from natural sources (34 Tg N) by almost a factor of four showing the extent to which anthropogenic activity has taken over the global N cycle. Of the 124 Tg N, 70 Tg N is emitted in the oxidized form, largely as NO and 70% of which results directly from anthropogenic activity. The remaining 54 Tg N is emitted as NH₃, (66% anthropogenic). The enhanced nitrogen emissions are associated with a range of local, regional and global issues including, acidification, eutrophication, climate change, human health and tropospheric O₃. The paper also places the Global Nitrogen Enrichment (GaNE) research programme in the UK in a wider perspective.     

Damage to offshore oil and gas facilities following hurricanes Katrina and Rita: An overview

Hurricanes Katrina and Rita hit the centre of the American petrochemical industry, shutting down eight refineries, hundreds of oil-drilling and production platforms, and many other industrial facilities. Furthermore, it triggered unprecedented numbers of hazardous-materials releases from industrial facilities and storage terminals onshore, as well as from oil and gas production facilities offshore in the Gulf of Mexico (GoM). In this paper, we analyse the damage caused by the two hurricanes on the offshore oil and gas industry. Hurricanes Katrina and Rita caused the largest number of destroyed and damaged platforms and pipelines, and the highest number of mobile offshore drilling units set adrift in the history of GoM operations. Following the hurricanes, changes have been proposed to operating and emergency procedures, maintenance requirements, and design practices including mooring practices for mobile offshore drilling units.