Real-world vehicle emissions as measured by in situ analysis of exhaust plumes

Environmental Science and Pollution Research - We conducted a 60-day roadside measurement campaign on a busy street in Münster, Germany, during summer 2016. We used gas and particle...     

移动床生物膜反应器净化模拟水产养殖废水的研究

采用移动床生物膜反应器（MBBR）净化模拟水产养殖废水.结果表明,MBBR净化模拟水产养殖废水效果良好.在水力停留时间（HRT）为8 h,DO为2.0~3.0 mg·L^-1的条件下,反应器启动迅速、运行稳定,能使COD和氨氮去除率均达到80%以上,TP去除率达到50%左右;有机负荷为（0.76±0.03）kg·m^-3·d^-1时,TN及氨氮去除效果最好,去除率分别达到71.73%及98.42%.为达到良好的TN去除效果,有机负荷不宜低于0.5 kg·m^-3·d^-1;DO为（3.00±0.25）mg·L^-1时,TN去除效果最好,最有利于同步硝化反硝化;为保持较高的氨氮去除效率,并减少亚硝态氮积累,DO浓度不应低于2.0 mg·L^-1;HRT过短会使氨氮去除效率降低,且可能出现亚硝态氮积累;采用序批式进水运行方式,对TP的去除效果优于连续进水方式,但运行周期后半段会出现亚硝态氮积累,对鱼类产生危害.     

Fe-Mn/AC催化湿式过氧化氢氧化间甲酚

采用等体积浸渍法制备了一种新型Fe-Mn/AC催化剂,应用于催化湿式过氧化氢氧化(CWPO)间甲酚废水.通过SEM和XRF表征了其表面形态结构和元素组成,通过穆斯堡尔谱分析了催化剂中铁离子的存在形态,结果表明,新型Fe-Mn/AC催化剂中的铁以二价铁、三价铁以及四氧化三铁的形式存在.通过正交实验考察了CWPO降解间甲酚的影响因素,结果表明,各因素对间甲酚转化率影响的大小顺序依次为:底物初始p H值反应温度反应时间催化剂投加量.通过正交实验得到CWPO降解间甲酚的最佳反应条件.当间甲酚浓度为100 mg·L-1、反应温度为40℃、反应时间为40 min、催化剂投加量为0.6 g·L-1及底物初始p H值为3时,间甲酚转化率为99.8%,TOC去除率为28.3%.气相色谱/质谱联用没有检测到中间产物,气相色谱检测到CWPO降解间甲酚中间产物主要为乙酸和丙酸.     

Regional Monitoring of Ambient Air Carbon Monoxide in Fairbanks,Alaska

A method employing the timed fill of Mylar bags was used to obtain average carbon monoxide concentration values for ten locations in the Fairbanks, Alaska, area. The method is shown to be accurate, reliable, and inexpensive. The correlation coefficient between the bag sampling method and a continuous carbon monoxide analyzer was 0.945; correlation of carbon monoxide data from several locations to a reference in downtown Fairbanks showed a general decrease with distance from the reference analyzer. Analysis of data from Fairbanks shows that carbon monoxide concentrations during the winter months may have to be reduced 50-75% to achieve the State and National Ambient Air Quality Standards; the high levels of carbon monoxide are the result of emissions from automobile traffic during periods of severe inversion in the Fairbanks basin.     

A Simple Method of Calculating Dispersion from Urban Area Sources

A simple but physically realistic model is shown to be adequate for estimating pollutant concentrations due to area sources in cities. In this model, the surface concentration is directly proportional to the local area source strength and inversely proportional to the wind speed. The model performs nearly as well as much more complex models that require the use of digital computers.     

Analyzing or explaining beta diversity? Understanding the targets of different methods of analysis

It has been actively discussed recently what statistical methods are appropriate when one is interested in testing hypotheses about the origin of beta diversity, especially whether one should use the raw-data approach (e.g., canonical analysis such as RDA and CCA) or the distance approach (e.g., Mantel test and multiple regression on distance matrices). Most of the confusion seems to stem from uncertainty as to what is the response variable in the different approaches. Here our aim is to clarify this issue. We also show that, although both the raw-data approach and the distance approach can often be used to address the same ecological hypothesis, they target fundamentally different predictions of those hypotheses. As the two approaches shed light on different aspects of the ecological hypotheses, they should be viewed as complementary rather than alternative ways of analyzing data. However, in some cases only one of the approaches may be appropriate. We argue that S. P. Hubbell's neutral theory can only be tested using the distance approach, because its testable predictions are stated in terms of distances, not in terms of raw data. In all cases, the decision on which method is chosen must be based on which addresses the question at hand, it cannot be based on which provides the highest proportion of explained variance in simulation studies.     

Ozone and other air quality-related variables affecting visibility in the southeast United States

An analysis of ozone (O3) concentrations and several other air quality-related variables was performed to elucidate their relationship with visibility at five urban and semi-urban locations in the southeast United States during the summer seasons of 1980-1996. The role and impact of O3 on aerosols was investigated to ascertain a relationship with visibility. Regional trend analysis over the 1980s reveals an increase in maximum O3 concentration coupled with a decrease in visibility. However, a similar analysis for the 1990s shows a leveling-off of both O3 and visibility; in both cases, the results were not statistically significant at the 5% level. A case study of site-specific trends at Nashville, TN, followed similar trends. To better understand the relationships between O3 concentration and visibility, the analysis was varied from yearly through daily to hourly averaged values. This increased temporal resolution showed a statistically significant inverse relationship between visibility and O3. Site-specific hourly r2 values ranged from 0.02 to 0.43. Additionally, by performing back-trajectory analysis, it was found that the visibility degraded by air mass migration over polluted areas.     

The interaction of heavy metals with urban soils: sorption behaviour of Cd, Cu, Cr, Pb and Zn with a typical mixed brownfield deposit

This study investigated the sorption characteristics and release of selected heavy metals (Cd, Cu, Cr, Pb and Zn) from a typical urban soil material from a derelict brownfield site in Western Scotland, UK. The study aimed to evaluate contaminant interactions with an urban substrate, comprising a mix of mineral soil and residue materials (e.g. brick, concrete, wood). This type of material has received little consideration in the literature to date. Soil samples were subject to a sequence of test involving batch equilibration and dynamic leaching, in single (non-competitive) and multi-element (competitive) solutions. The batch experiments were carried out in unadjusted and close to soil field pH conditions (pH 2 and 7, respectively). The equilibrium adsorption capacity for heavy metals was measured and extrapolated using the Langmuir isotherm. The parameters of the isotherms x(m) (the maximum amount adsorbed per unit mass of adsorbent (mg/g)) and b (adsorption constant (m(3)/g)) were calculated for Cd, Cu, Cr, Pb as single-element and multi-element solutions. The adsorption from the single-element solution was more effective than adsorption under multi-element conditions, due to competitive effects. For example, the adsorption of copper from a single-element solution was over four times greater than for a multi-element solution. In the case of Cr and Zn, migration of metal from soil to solution was observed. Adsorption capacity at pH 2 followed the order Cr>Cu>Pb>Cd and at pH 7 Cd>Zn, with precipitation affecting Cu and Pb behaviour. During the column leaching experiment, most of the heavy metals were irreversibly bound to the soil, but in the case of Cr some movement from soil into solution was observed. The results also showed that Cd, Cu, Pb and Zn were removed from the solution and adsorbed on the soil. No significant difference in the metal removal from single- and multi-element solutions was observed. Overall, the urban residue behaved in a similar manner to mineral soils despite a significant component of anthropogenic solid materials.