Development of Lignin and Nanocellulose Enhanced Bio PU Foams for Automotive Parts

The green rigid polyurethane (PU) foam has been developed with 100 % soy polyol after optimization of formulation ingredients and lignin has been introduced and isocyanate content reduced in the green rigid PU foam. The cellulosic nanofibers have also been successfully incorporated and dispersed in green rigid PU foam to improve the rigidity. The influence of nano cellulose fiber modification (enzymatic treatment, hydrophobic modification with latex) on the foam density, open cell content, foam raise height, water vapor, and mechanical properties of rigid PU foam were studied. The foamed structures were examined using scanning electron microscopy to determine the cell size and shape due to the addition of cellulosic nanofibers. The odor test were performed to evaluate the odor concentration 100 % soyol based PU foam including lignin and nanofiber and compared to 100 % synthetic based polyol PU foam. The experimental results indicated that the compression and impact properties improved due to the modification of nano cellulosic fibers. The odor concentration level of nanofiber reinforced rigid PU foam reduced significantly compared to 100 % PU foam due to the replacing of isocyanate content. It can be said that with an appropriate combination of replacing isocyanate by lignin and addition of nanofiber, rigid PU foam properties could be improved.     

盐酸脱附Pb(Ⅱ)负载氨基膦酸树脂的基本性能

氨基膦酸树脂是一种常用的广谱性重金属螯合树脂,对水中的Pb(Ⅱ)具有很好的选择性分离去除能力,但吸附Pb(Ⅱ)后的树脂再生较为困难。系统研究了盐酸脱附Pb(Ⅱ)-负载氨基膦酸树脂D860的基本性能,优化了基本脱附参数。实验表明,采用盐酸作为脱附剂具有较为良好的脱附效果,10%吸附量树脂脱附反应平衡较快仅需10 min,脱附本身受Pb(Ⅱ)在盐酸溶液中的溶解度影响显著。脱附流速从1 BV/h升高到5 BV/h,脱附效果受到的影响很小。升高温度可以提高PbCl2溶解度,进而提高脱附效率。固定床脱附采用1.0 mol/L盐酸,在1 BV/h和303 K条件下,仅需7 BV脱附剂即可实现较高的脱附效率。     

As(V)在金红石TiO_2颗粒表面吸附特性及机理

通过静态动力学和热力学吸附实验,研究了温度、共存离子以及溶质的初始浓度对As(V)在金红石TiO2颗粒表面吸附的影响,探讨了As(V)在金红石TiO2颗粒表面吸附特性及机理。结果表明,在As(V)初始浓度为10 mg/L,pH为7的条件下,25℃时的吸附量0.41 mg/g高于30℃时的吸附量0.31 mg/g,As(V)在金红石TiO2上的吸附为放热过程。CaCl2和MgCl2的添加对As(V)在金红石TiO2表面吸附起到明显的促进作用。T=25℃,Ca2+或Mg2+浓度为10 mmol/L时,As(V)吸附量分别为0.64和0.56 mg/g,Ca2+比Mg2+对As(V)吸附促进作用强。As(V)在金红石TiO2的吸附等温线符合Frendlich方程,Lagergren二级动力学方程能较好地描述As(V)在金红石TiO2颗粒表面吸附的动力学过程。     

气相色谱法测定气田产出水中的甲醇含量

文章建立了使用气相色谱仪分析气田产出水中甲醇含量的方法。通过实验在设定不同分流比的情况下,能有效监测出气田产出水中不同浓度的甲醇含量,此方法灵敏度高,最低检出限为0.02%,测定气田产出水中甲醇加标回收率达到93%～94%。     

广西沿海市政入海排污调查及治理对策

广西沿海市政排污口污水主要来源于城市生活污水和工业废水,2011年监测结果显示全年排放废水7033万t,排放污染物4236t,排污口超标率95.83%,普遍超标因子为磷酸盐、生化需氧量、化学需氧量和氨氮,分别占84.20%、66.67%、52.60%、50.00%。根据调查结果,分析了超标原因,提出了防治对策。     

侧吸导烟技术的经济性分析

介绍了侧吸导烟技术的技术背景,分析计算了焦炉装煤烟尘成分及含量,经对该技术的经济效益进行概算后显示,该技术可以有效改善焦炉区及周边环境,每年还可创造可观的经济效益,是一项值得研究推广的技术。     

树脂固定床吸附含酚废水预测模型研究

针对应用于实际工业化的树脂固定床吸附研究较少,而与之相关的固定床吸附穿透曲线可以用来确定固定床吸附操作参数,为固定床的设计和实际操作提供指导。通过对恒定波振荡理论和吸附等温方程的联合,来预测固定床吸附穿透曲线;并研究了不同操作条件对大孔弱碱树脂吸附对硝基酚穿透曲线预测模型的影响。以期望为树脂固定床的设计和实际工业应用产生指导意义。     

焦炉推焦粉尘治理工艺选择及设备配置

对焦炉推焦时粉尘治理的工艺选择及设备配置进行了探讨,重点论述并分析了焦炉出焦粉尘治理的烟尘收集、烟尘运输、粉尘滤除三个主要环节。     

Cosorption of organic chemicals with different properties: their shared and different sorption sites

Complementary sorption of different chemicals was expected and investigating the relationship between the sorption inhibition of primary sorbate (ΔQ(pri)) and sorption of secondary sorbate (Q(sec)) could provide a new angle to understand coadsorption of different chemicals. This study used bisphenol A (BPA) as the primary adsorbate, sulfamethoxazole (SMX) as the competitor, and carbon nanotubes as model adsorbents to study their complementary and competitive adsorption. At low BPA concentrations, the sorption of SMX (Q(sec)) exceeded BPA sorption inhibition (ΔQ(pri)), indicating that these two chemicals complementarily adsorbed on their respectively preferred sorption sites. At high BPA concentrations, higher ΔQ(pri) was observed in comparison to Q(sec), which may be resulted from different packing efficiencies of the adsorbed SMX and BPA. This study emphasized that both competitive and complementary sorption should be discussed in binary sorption system.     

纤维素降解细菌筛选及降解特性分析

基于获得高效纤维素降解细菌的目的,通过LB培养基的培养以及刚果红培养基的筛选,从牛粪堆肥中筛选获得2株高效纤维素降解细菌。经鉴定,分别为枯草芽胞杆菌(Bacillus subtilis)和地衣芽胞杆菌(Bacillus licheniformis)。所筛选得到的菌种具有很高的滤纸降解能力,可在6d内使滤纸剧烈崩溃,振摇成均匀糊状;其中,地衣芽胞杆菌的羧甲基纤维素钠酶活峰值在发酵第4天达到峰值(237U/g)。