Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.     

三峡水库浮游植物群落特征及水体富营养化评价

基于2003—2017年三峡水库浮游植物群落结构、优势种群的变化和2017年水库干支流水质数据,全面分析浮游植物群落结构和演替特征,并运用综合营养状态指数法对水体富营养化程度进行评价。结果表明,三峡水库浮游植物种类丰富,监测期间共鉴定出浮游植物7门62属,细胞密度在7.5×10~4~2.8×10~7cell/L之间变化,Shannon-Wiener多样性指数为1.0~3.0,在α-中污带和β-中污带之间,说明三峡水库水生态环境健康状况相对较好;三峡水库浮游植物季节性演替特征呈硅藻和甲藻向蓝藻和绿藻演替的趋势,年际变化特征分析发现浮游植物密度在2008年175 m实验蓄水后大量增长,且优势藻类由河道型藻类向湖泊型藻类转化。通过监测数据分析,得出三峡水库干流处于中营养状态,支流在春季主要处于轻度富营养状态,秋季支流比春季支流的富营养化程度低,主要处于中营养状态,总氮(total nitrogen,TN)、总磷(total phosphorus,TP)和透明度(transparency,SD)为水质主要影响因子。     

Compartmentation and effects of lead (Pb) in the collembolan,Folsomia candida

Environmental Science and Pollution Research - The impact of soil lead (Pb) pollution on survival, growth, and reproduction of the collembolan, Folsomia candida, and Pb compartmentation in its gut...     

基于可拓物元模型的安全经济开采评价指标体系的构建及应用

首先根据安全经济开采的内涵,建立以人员安全、设施设备安全、开采环境安全、安全投资和安全管理为主要制约因素的安全经济开采评价模型,并运用改进的层次分析法确定人员可靠度对安全经济开采水平影响最大,开采环境可靠度影响最小。其次,采用函数拟合法、专家打分法、标准化打分法量化安全经济开采水平指标,并将安全经济开采水平划分为3个等级。最后,运用可拓物元模型方法,得出某铁矿安全经济开采水平为二级,无重大经济损失,与实际吻合。     

地下铀矿山留矿法采场受限空间内氡迁移的数值模拟

为研究铀矿山留矿法采场氡迁移规律,依据留矿法采场的构造和物理几何尺寸,建立了受限空间内颗粒堆积型射气介质气体流动的数学模型和氡迁移方程,以10 m和20 m高爆破矿堆为对象,采用计算流体力学(CFD)方法,研究了不同通风条件下采场中氡的迁移规律。结果表明:1)采场下行通风方式降低矿堆上部作业空间氡浓度的效果优于上行通风方式,但对采场运输巷道氡浓度的效果相反;采场排风氡浓度与采场通风风量成反比,氡析出份额与通风风量成正比;2)在相同通风风量下,10 m高爆破矿堆与20 m高爆破矿堆氡析出份额之差随通风风流量增长而逐渐缩小;3)均压通风对渗透率高(k=1×10-8m2)的采场排风氡浓度、矿堆氡析出份额有明显影响。     

加轴压卸围压下含瓦斯煤岩损伤变形的能量演化机制

采动影响下含瓦斯煤岩的损伤变形是一个极其复杂的非线性过程,单纯依靠传统经典弹塑性力学无法准确分析其破坏机理。针对此情况,通过试验研究了不同初始围压条件下含瓦斯煤岩的损伤变形特征,并分析了损伤变形与能量演化规律之间的内在联系。研究表明:初始围压越高,煤样破坏时强度越大,脆性破坏特征越明显,瓦斯流量急剧增加幅度越大,煤样破坏时积累的总能量和弹性应变能越多,且初始围压与弹性能之间满足对数函数关系。采用累积耗散能定义了煤岩损伤变量,并分析了不同阶段损伤与渗透率之间的演化关系。     

Assessment of the uncertainty of using an inverse-dispersion technique to measure methane emissions from animals in a barn and in a small pen

Dispersion techniques are useful for assessing the effectiveness of management practices in mitigating methane (CH₄) emissions from animal operations. In this paper, the accuracy of an inverse-dispersion technique was examined for two common situations: 1) emissions from animals in a barn and 2) emissions from animals in a pen. For both situations, the accuracy of emission estimates generally increased with increasing fetch (scaled to barn height, h, or to pen width, X_s) between the source and the concentration measurement. The gas recovery ratio increased from 0.66 at 5 h to 0.93–1.03 at 10 h–25 h for the barn, and decreased from 1.59 at 0 X_s to 0.99 at 5 X_s and from 1.54 at 0 X_s to 1.09 at 5 X_s for the two small pen scenarios, due to the declining sensitivity of the dispersion model to errors in wind complexity and errors in the assumed source configuration. However, the relative uncertainty of the measured concentration increased with fetch due to the decreasing gas concentrations. Hence, improving the accuracy of emission estimates is a compromise between the source configuration sensitivity and the concentration measurement sensitivity. Fetches of about twice the size of the pen and about 10 times the height of the barn are suggested.     

钢渣吸附处理苯酚废水的研究

采用恒温振荡的方法,考察了钢渣粒径、吸附温度、振荡速度、溶液pH值、溶液初始浓度对苯酚去除率的影响。结果表明,在粒径为120~180目、pH=4.0、苯酚溶液浓度在500 mg/L以内、苯酚/钢渣质量比为1∶1 000时吸附效果最好。钢渣对苯酚的吸附能较好地符合Langmuir和Freundlich吸附等温线,线性相关系数分别为0.9971和0.9916,吸附机理为表面吸附。     

可用于水体污染控制的氨氮转化菌筛选及部分降解特性的实验研究

从南京禄口水产养殖基地淡水鱼塘取淤泥作为分离菌株的土源,采用选择性富集培养法,从中分离到能以硫酸铵为氮源的菌株7株,对7个菌株进行氨氮降解实验,它们氨氮转化率分别为14.8%、19.7%、53.4%、94.2%、29.1%、63.5%和41.7%,其中AN-4菌株的转化率最高且生长良好。通过AN-4菌株16S rRNA基因序列分析以及生理生化方法,鉴定此菌株为克雷伯氏菌属(Klebsiellasp.)。对菌株AN-4转化氨氮的特性及温度、pH值、氨氮初始浓度和菌株接种量对其氨氮转化率的影响研究,结果表明,菌株AN-4降解氨氮的最适条件为:温度为30℃和pH值为8.0;当氨氮初始浓度为30mg/L时,AN-4菌株在24 h内的氨氮降解率可达85%以上,且能耐受高达200 mg/L的氨氮浓度;AN-4活化菌液浓度为108cfu/mL,当接种量为3×106cfu/mL时,AN-4菌株在24 h内的氨氮降解率为87.75%。综合上述结果,符合淡水养殖水环境条件,说明AN-4菌株适合在水产养殖中应用,为将菌株AN-4应用于水产养殖环境修复提供了理论依据。     

新型活性炭固定化产品的制备及其处理焦化废水的特性

为解决优势菌种工程应用,研究不同固定化方法、载体和结构的固定化产品对焦化废水的降解特性。用活性炭粉末吸附菌种后,与聚乙烯醇和海藻酸钠混合制备了新型固定化球;用聚乙烯醇和海藻酸钠包埋吸附菌种的活性炭纤维毡,与立体弹性塑料填料连用,制备出3种不同形状的活性炭纤维膜片固定化产品复合填料。将游离菌和制备的4种活性炭固定化产品投入A/A/O工艺系统平行实验,考察处理焦化废水的效果。结果表明,活性炭纤维膜片固定化产品复合填料对焦化废水的降解能力优于其他固定化产品:缺氧池出水硝酸盐氮和亚硝酸盐氮浓度分别稳定在1.96 mg/L和0.49 mg/L,未产生氮的累积现象,COD去除率可达到60.92%。好氧池COD和氨氮降解效率分别为78.83%和85.52%,苯酚、氰化物降解效率均为97%以上。