Simulated use and wash-off release of decamethylcyclopentasiloxane used in anti-perspirants

The cyclic volatile methylsiloxane, decamethylcyclopentasiloxane (D₅) is used in a large variety of personal care products. Based on the physical–chemical properties of D₅, it is likely that losses due to volatilisation may strongly influence the levels entering the aquatic environment. The aim of this study was to quantify the amount of D₅ in waste wash water, after typical application and use in a range of deodorant and anti-perspirant (AP) products. Results implied significant losses after a 24 h period (>99.9%), and suggest that the use of D₅ in leave-on products, such as deodorants/AP is not likely to contribute a significant down-the-drain emission source. An illustrative example is presented, based on data reporting the use of D₅ in a range of personal care products (both wash-off and leave-on), which suggests that the contribution of D₅ used in wash-off products to the aquatic environment may be considerably more significant. Limitations associated with our understanding of the actual D₅ inclusion levels in the products, the market share of the products containing D₅, and the variability of consumer habits, are identified as data gaps that need to be addressed in order to better refine down-the-drain emission estimates.     

Biological remediation of explosives and related nitroaromatic compounds

Nitroaromatics form an important group of recalcitrant xenobiotics. Only few aromatic compounds, bearing one nitro group as a substituent of the aromatic ring, are produced as secondary metabolites by microorganisms. The majority of nitroaromatic compounds in the biosphere are industrial chemicals such as explosives, dyes, polyurethane foams, herbicides, insecticides and solvents. These compounds are generally recalcitrant to biological treatment and remain in the biosphere, where they constitute a source of pollution due to both toxic and mutagenic effects on humans, fish, algae and microorganisms. However, relatively few microorganisms have been described as being able to use nitroaromatic compounds as nitrogen and/or carbon and energy source. The best-known nitroaromatic compound is the explosive TNT (2,4,6-trinitrotoluene). This article reviews the bioremediation strategies for TNT-contaminated soil and water. It comes to the following conclusion: The optimal remediation strategy for nitroaromatic compounds depends on many site-specific factors. Composting and the use of reactor systems lend themselves to treating soils contaminated with high levels of explosives (e.g. at former ammunition production facilities, where areas with a high contamination level are common). Compared to composting systems, bioreactors have the major advantage of a short treatment time, but the disadvantage of being more labour intensive and more expensive. Studies indicate that biological treatment systems, which are based on the activity of the fungus Phanerochaete chrysosporium or on Pseudomonas sp. ST53, might be used as effective methods for the remediation of highly contaminated soil and water. Phytoremediation, although not widely used now, has the potential to become an important strategy for the remediation of soil and water contaminated with explosives. It is best suited where contaminant levels are low (e.g. at military sites where pollution is rather diffuse) and where larger contaminated surfaces or volumes have to be treated. In addition, phytoremediation can be used as a polishing method after other remediation treatments, such as composting or bioslurry, have taken place. This in-situ treatment method has the advantage of lower treatment costs, but has the disadvantage of a considerable longer treatment time. In order to improve the cost-efficiency, phytoremediation of nitroaromatics (and other organic xenobiotics) could be combined with bio-energy production. This requires, however, detailed knowledge on the fate of the contaminants in the plants as well as the development of efficient treatment methods for the contaminated biomass that minimise the spreading of the contaminants into the environment during post harvest treatment.     

Effects of soil variability and weather conditions on pesticide leaching--a farm-level evaluation

In line with European regulations, Dutch law imposes an environmental threshold of 0.1 microg L(-1) on pesticide concentrations in ground water. During registration, the risk of exceeding this threshold is assessed through simulations for one or a few standard scenarios that do not reflect spatial variability under field conditions. The introduction of precision agriculture, where soil variability is actively managed, can increase control over pesticide leaching. This study presents a step-wise evaluation of the effects of soil variability and weather conditions on pesticide leaching. The evaluation was conducted on a 100-ha arable farm and aimed at identifying opportunities for precision management. As a first step, a relative risk assessment identified pesticides presenting a relatively high risk to the environment. Second, the effect of weather conditions was analyzed through 20 years of simulations for three distinct soil profiles. Results were summarized in cumulative probability plots to provide a probabilistic characterization of historical weather data. The year matching 90% probability (1981) served as a reference to simulate pesticide leaching from 612 soil profiles. After interpolation, areas where concentrations exceeded the environmental threshold were identified. Out of a total of 19 pesticides, isoproturon [N-dimethyl-N'-(4-(1-methylethyl)phenyl)urea], metribuzin [4-amino-6-tert-butyl-3-(methylthio)-as-triazin-5(4H)-one], and bentazon [2,1,3-benzothiadiazin-4(3H)-one, 3-isopropyl-, 2,2-dioxide] showed the highest risk for leaching. Leaching was strongly affected by soil variability at the within-field, field, and farm levels. Opportunities for precision management were apparent, but depended on the scale level at which environmental thresholds were implemented. When legislation is formulated in this issue, the presented step-wise evaluation can serve as a basis for identification and precision management of high-risk pesticides.     

Carbon speciation in municipal solid waste incinerator (MSWI) bottom ash in relation to facilitated metal leaching

The release of inorganic and organic contaminants from municipal solid waste incinerator (MSWI) bottom ash is controlled to a large extent by the release of dissolved organic carbon (DOC), and in particular by the reactive humic (HA) and fulvic acids (FA) subfractions of DOC. The properties of organic matter contributing to the release of DOC, HA and FA are, therefore, important for environmental risk assessment. In this study we have quantitatively measured the carbon speciation, and its relation with the leaching of Cu, in three fresh and carbonated MSWI bottom ash samples. Results show that up to only 25% of loss on ignition (LOI) consists of organic carbon (OC), while about 17% of OC in the three samples consists of HA and FA. Up to 50% of DOC in MSWI bottom ash leachates was identified as fulvic acid (FA). This value is substantially higher than previously estimated for these MSWI bottom ash samples and is consistent with the higher recovery of the new method that was applied. The results of this study imply that methods focusing on specific carbon fractions are more appropriate for assessment of environmentally relevant organic carbon species than the measurement of LOI.     

Steam demand reduction of water–gas shift reaction in IGCC power plants with pre-combustion CO2 capture

This paper presents the results of system assessments that were conducted to compare conventional and advanced water–gas shift reactor sections. The latter are specifically tailored for Integrated Gasification Combined Cycles (IGCC) power plants with pre-combustion CO₂ capture. The advanced shift reactor section comprises four staged reactors with distributed feeds of synthesis gas and quench water in between the reactors. Conventional shift reactor sections consist of two sequential reactors with intermediate cooling, where the entire synthesis gas stream passes both reactors.The advanced shift reactor section reduces the steam requirement of the water–gas shift reaction up to 70% in comparison with conventional configurations, at carbon dioxide capture ratios of approximately 85%. This reduction allows for lower electric efficiency penalties, thus higher net electric outputs for IGCC power plants with CO₂ capture. For each case, the CO₂ capture ratio was optimised for the lowest specific lost work per amount of captured CO₂. Both the number of reactors and the total catalyst volume are higher for the advanced shift reactor sections, resulting in increased capital expenses. In case of four staged reactors, the additional expenses are expected to be outperformed by the increased revenues associated with the higher net electric output.     

Effects of territory quality, food availability and sibling competition on the fledging success of oystercatchers (Haematopus ostralegus)

We investigated the fledging probability of oystercatcher, Haematopus ostralegus, chicks as a function of hatching order, brood size, territory quality and food availability. Sibling dominance was related to the hatching order in both low- (’leapfrogs’) and high-quality (’residents’) territories. Differences in hatchling mass might have aided the establishment of a dominance hierarchy, since breeders produced small late eggs and hatchlings. These mass differences were most pronounced in leapfrogs, and in large broods in years with lower food availability (’poor’ years). Late hatchlings fledged less often and with lower body masses compared to early hatchlings in all situations. Leapfrogs produced smaller broods and hatched their broods more asynchronously in poor years than leapfrogs breeding in years with more available food (’good’ years) and residents breeding in both poor and good years. Large brood sizes resulted in lower survival of hatchlings in poor years. These results favour the ’brood reduction’ hypothesis. However, contrary to the expectations of this hypothesis, hatching order also affected fledging success in residents. Moreover, large brood size resulted in higher survival of hatchlings in good years, particularly in residents. Thus, although large broods experienced losses due to sibling competition in some years, they nevertheless consistently produced more fledglings per brood in all years, both as leapfrogs and residents. We believe this effect is due to parental quality correlating with initial brood size. Most leapfrogs, at best, fledged one chick successfully each year, losing chicks due to starvation. Nevertheless, leapfrog broods were reduced in size after hatching significantly less quickly than resident broods. These results suggest that breeders lay and hatch insurance eggs to compensate for unpredictable losses due to the high predation rates on both nests (ca 50%) and chicks (ca 90%), in accordance with the ’nest failure’ hypothesis. Received: 14 February 2000 / Revised: 27 September 2000 / Accepted: 10 June 2000     

Organochlorine insecticide residues in birds and fish from the Transvaal, South Africa

Fatty extracts of wild birds and fishes were analysed for certain organochlorine insecticides. Nearly all samples contained residues of one or more of the insecticides.     

Twenty years of salt marsh succession on a Dutch coastal barrier island

After a formerly grazed salt marsh was released from cattle grazing, changes in plant species composition were monitored for 20 yr, using vegetation maps and permanent plots. Three areas, differing in age and nutrient status were compared. The number of plant species and plant communities decreased.Elymus athericus (Elytrigia pungens) became dominant in most plant communities after 5–20 yr on the oldest and most productive salt marsh. In younger areas it took more time forE. athericus to become dominant. At least 7 cm of clay seemed to be a prerequisite for this plant species to increase in dominance. The results from monitoring over decades are discussed in view of the knowledge on succession over centuries as derived from a chronosequence.     

Analysis of flame retarded polymers and recycling materials

Recycling activities on polymeric materials are increasing and becoming more and more important in recent years. For polymers containing no flame retardants, suitable recycling strategies already exist. In order to investigate the recyclability of flame retarded polymers that contain brominated flame retardants, a number of samples were analysed as received from a recycling company. Following the identification and sorting of the samples according to type of polymers and flame retardants, material recycling was tested for the flame retarded polymers identified to occur most frequently. The reactivity of the flame retardants during the recycling procedure was studied by analysing for brominated dioxins and furans. The results demonstrate that flame retarded polymers can be recycled under certain experimental conditions.