用边际费用分析方法研究制定排污收费的新标准

排污收费的有效性主要取决于它的经济刺激作用。本文分析了排污收费的经济学原理,提出了制定排污收费标准更为合理有效的方法──边际费用分析法,定量地描述和分析了排污收费与其经济刺激作用的关系,以天津纪庄子污水处理厂为例,提出应建立的排污收费标准。本文指出,有效地运用排污收费来管理污水的排放,必须实行区域总量控制,制定具有有效的经济刺激作用的排污收费标准。     

脉冲上流式厌氧污泥床反应器的应用

将传统的连续式改为间歇式配水,可改善反应器的水力环境,促进基质与生物体之间的有效接触。脉冲配水使污泥的有机负荷ＣＯＤ达２７．５ｇ／（Ｌ．ｄ）．ＨＲＴ降到约３ｈ,加速了污泥的颗粒化进程,４７ｄ培养出良好的颗粒污泥。脉冲配水不会造成冲击负荷和中间产物积累,也不会造成大量的污泥流失。在高负荷条件下,颗粒污泥中确实出现了大量的八叠甲烷球菌凝块。     

液体吸收-活性炭吸附净化苯乙烯废气

介绍了液体吸收-活性炭吸附净化苯乙烯废气的原理.当吸收液中石油类物质占总体积的40％时吸收率最佳,小试液体吸收段对苯乙烯废气的吸收率在74％-97.6％之间,在工业净化装置中使用该吸收液,对苯乙烯废气的吸收率在60％-97.4％之间.活性炭对苯乙烯的吸附率为自重的30％.工业净化装置中,两种方法并用苯乙烯废气的净化效率在94.8％以上.该方法关键是寻找高效的吸收液和设计实用的净化装置.     

中国地区氧化亚氮排放量及其变化的估算

对我国大气中氧化亚氮的排放源及其大小进行了分析和计算,中国地区氧化亚氮的年排放置为950G_9N_2O-N,约占全球总排放量的6％.天然源和人为源各占我国氧化亚氮排放量的71％和29％.在天然源中以海洋排放为主,人为源中则以煤炭燃烧释放的贡献最大.计算显示今后几年内氧化亚氮排放的年增加量是6G_9N_2O-N.     

铅锌冶炼弃渣有害特征及其浸出行为研究

铅锌弃渣是有色金属工业排出的大宗固体废物之一。其中有铅冶炼系统排铅烟花炉渣,锌系统排锌回转窑渣。铅锌弃渣一般含有多种超过排放标准而目前又尚无成熟工艺提取的有价值和稀贵金属元素。这些废渣的堆存直接影响自然景观,并有可能对环境如土壤、水体和作物等造成危害。因此,考察铅锌渣的有害特征,研究其水浸出行为与规律,对解决铅锌弃渣对环境污染,寻求同行业固体废物的治理途径具有重要的现实意义。     

660MW锅炉燃烧优化调整试验研究

针对某电厂1号锅炉燃烧器改造后锅炉结焦、飞灰及炉渣可燃物含量高、锅炉效率低等问题,在对锅炉结焦原因深入分析的基础.上,进行了燃烧优化调整试验。通过采取降低一次风压、降低煤粉细度等措施,炉内结焦得到了有效控制,飞灰、炉渣可燃物含量从10.37%、4.75%降低至2.99%、0.91%。结果表明:优化调整试验效果明显,煤粉细度、一次风速均可控在合适范围之内,锅炉效率显著提高,有效防止了炉内结焦现象的发生,提高了锅炉运行的安全性和经济性。     

Experimental study on agitated drying characteristics of sewage sludge under the effects of different additive age

Drying experiments of dewatered sewage sludge (DSS) were conducted on a agitated paddle dryer, and the effects of additive agents, i.e., CaO, pulverized coal (PC), heavy oil (HO), and dried sludge ("DS" through back mixing) on the agitated drying characteristics of DSS were investigated. The results indicated that CaO can significantly increase the drying rate of DSS. The drying rate at CaO/DSS (mass ratio) = 1/100 was 135% higher than that of CaO/DSS = 0. Pulverized coal has no obvious effect on drying rate, but the increase of PC/DSS can promote breaking up of sludge lump. Heavy oil was found to be slightly effective in improving the drying rate of DSS in the examined experimental range of HO/DSS = 0-1/20. It is also found thatHOcan reduce the torque of the dryer shaft, due to its lubrication effect. Back mixing of DS was found to be effective in alleviating the unfavorable effect of the lumpy phase by improving the mixing effect of the paddle dryer. There was a marked increase of drying rate with an increase of the DS/DSS in the experimental range of DS/DSS = 0-1/3.     

基于固液分离预处理的餐厨垃圾厌氧发酵

研究不同预处理方法所获餐厨垃圾浆料的半连续式厌氧发酵效果,评价该类餐厨垃圾的产甲烷资源化潜能.结果表明,固液油三相分离预处理后的液相餐厨垃圾作为进料较固液混合相餐厨垃圾在厌氧发酵时具有更高的VS去除率,实际产甲烷潜能和甲烷转化率,分别为91.2％,531.5mLCH4/gVS和54.3％,表明液相餐厨垃圾半连续中温湿式...     

Kinetics of aniline oxidation with chlorine dioxide

For the first time, kinetics of aniline oxidation with chlorine dioxide(ClO2) were investigated systematically by detecting concentration of aniline with HPLC at regular intervals. Results showed that the reaction was first-order both in ClO2 and in aniline, and the oxidation reaction could be described as second-order reaction. Stoichiometric factor η was experimentally determined to be 2.44. The second-order-reaction rate constant k was 0.11L/(mol.s)under condition of pH 6.86 and water temperature(Tw) 287K. Reaction activation energy was 72.31 kJ/mol, indicating that the reaction could take place under usual water treatment conditions. The reaction rate constants in acidic and alkali media were greater than that in neutral medium. Chlorite ion could slightly increase reaction rate in acidic medium. p-aminophenol and azobenzene were detected by GC-MS as intermediates.     

Reverse logistics in the Chinese auto-parts firms: implementation framework development through multiple case studies

In recent years, the implementation of reverse logistics (RL) in automobile manufacturing has drawn extensive interest from the Chinese government that has launched relevant take-back and environmental regulations and pilot projects. This study focuses on RL implementation issues in Chinese auto-parts manufacturing sector. Based on comprehensive literature review and multiple case studies in the Chinese auto-parts firms, this paper proposes a conceptual RL framework and highlights the major implementation issues. The purpose of this paper is to draw an overall picture of RL in the Chinese context, highlighting implementation issues in the auto-parts sector. Our study suggests that Chinese RL implementation requires close government monitoring mechanism and incentives, top management commitment within firms, technology and human capabilities support.